针对在负压干扰条件下,控制器局域网(Control Area Network,CAN)总线接收器存在工作异常以及传输延时较大的问题,设计了一种超宽共模输入范围的可变速率的CAN(CAN with Flexible Data rate,CAN FD)接收器。该设计通过电平移位与共射级...针对在负压干扰条件下,控制器局域网(Control Area Network,CAN)总线接收器存在工作异常以及传输延时较大的问题,设计了一种超宽共模输入范围的可变速率的CAN(CAN with Flexible Data rate,CAN FD)接收器。该设计通过电平移位与共射级相结合的方式,以减少总线信号对输入级静态工作点影响,拓展接收器的负压输入范围;采用电阻分压的方式衰减总线信号电平,以减轻输入级差分对管的耐压负担;引入低温漂电压,以产生高精度的翻转阈值;在输出级模块增添限幅晶体管,以限制接收器输出摆幅,提升传输速度。芯片采用0.18μm 60 V双极、互补、双扩散金属氧化物半导体工艺进行电路设计。仿真结果表明,在5 V电源电压条件下,设计接收器的共模输入范围为-60~60 V,阈值电压为0.71 V,迟滞门限为120 mV,温漂为0.057 mV/℃,平均传输延时小于55 ns。与相关设计相比,设计的接收器具有较宽的共模输入范围,传输延时较小,符合CAN协议规范。展开更多
This paper lenges in the design of discusses some chal- millimeter-wave （mln- wave） circuits and systems for 5th generation （5G） wireless systems in CMOS process. The properties of some passive and active devices ...This paper lenges in the design of discusses some chal- millimeter-wave （mln- wave） circuits and systems for 5th generation （5G） wireless systems in CMOS process. The properties of some passive and active devices such as inductors, capacitors, transmission lines, translbrmers and transistors in mm-wave frequency band are discussed. Self-healing technique dealing with PVT variation, res- onant mode switching technique to enhance frequency tuning range of voltage controlled oscillator （VCO） and dual mode technique for power amplifier （PA） efficiency enhancement are introduced. At last, A fully-integrated 60 GHz 5 Gb/s QPSK transceiver with the transmit/receive （T/R） switch in 65nm CMOS process is introduced. The measured error vector magnitude （EVM） of the TX is -21.9 dB while the bit error rate （BER） of the RX with a -52 dBm sine-wave input is below 8e-7 when transmitting/receiving 5 Gb/s data. The transceiver is powered by 1.0 V and 1.2 V supply （except the phase-frequency detector and charge-pump in the frequency synthesizer which are powered by 2.5 V supply） and con- sumes 135 mW in TX mode and 176 mW in RX mode.展开更多
This paper presents an LC VCO with auto-amplitude control （AAC）, in which pMOS FETs are used,and the varactors are directly connected to ground to widen the linear range of Kvco. The AAC circuitry adds little noise ...This paper presents an LC VCO with auto-amplitude control （AAC）, in which pMOS FETs are used,and the varactors are directly connected to ground to widen the linear range of Kvco. The AAC circuitry adds little noise to the VCO but provides it with robust performance over a wide temperature and carrier frequency range.The VCO is fabricated in a chartered 50GHz 0.35μm SiGe BiCMOS process. The measurements show that it has - 127. 27dBc/Hz phase noise at 1MHz offset and a linear gain of 32.4MHz/V between 990MHz and 1.14GHz.The whole circuit draws 6. 6mA current from 5V supply.展开更多
This paper presents a lOGb/s highspeed equalizer as the frontend of a receiver for backplane communication. The equalizer combines an analog equalizer and a twotap decisionfeedback equal izer in a halfrate structure t...This paper presents a lOGb/s highspeed equalizer as the frontend of a receiver for backplane communication. The equalizer combines an analog equalizer and a twotap decisionfeedback equal izer in a halfrate structure to reduce the intersymbolinterference （ISI） of the communication chan nel. By employing inductive peaking technique for the highfrequency boost circuit, the bandwidth and the boost of the analog equalizer are improved. The decisionfeedback equalizer optimizes the size of the CMLbased circuit such as D flipflops （DFF） and multiplex （MUX）, shortening the feedback path delay and speeding up the operation considerably. Designed in the 0. 181μm CMOS technology, the equalizer delivers 10Gb/s data over 18in FR4 trace with 28dB loss while drawing 27mW from a 1.8V supply. The overall chip area including pads is 0. 6 -0.7mm2.展开更多
Programmable metasurface enables controlling electromagnetic (EM) waves in real time. By programming the states of active device embedded in metasurface element, the EM properties of the digital metasurface can be cha...Programmable metasurface enables controlling electromagnetic (EM) waves in real time. By programming the states of active device embedded in metasurface element, the EM properties of the digital metasurface can be changed quickly without redesigning their structures. However, large numbers of long-distance wires are required to connect the programmable metasurface to provide the coded signals from field programmable gate array (FPGA) when controlling the metasurface at a long distance, which is complicated and inconvenient. Here, we propose an infrared-controlled programmable metasurface that can be programmed remotely. The infrared transceiver is able to switch the coding sequences stored in the FPGA controller, thus controlling the voltage on the varactors integrated in the metasurface. Experiment is performed at microwave frequencies, and the measured results verify that the scattering beams of the metasurface sample can be changed remotely by using infrared ray. The proposed infrared-controlled programmable metasurface opens up avenues for constructing a new class of remotely-tuning dynamic metasurfaces.展开更多
基金supported in part by the National Natural Science Foundation of China under Grant 61331003 and Grant 61222405
文摘This paper lenges in the design of discusses some chal- millimeter-wave （mln- wave） circuits and systems for 5th generation （5G） wireless systems in CMOS process. The properties of some passive and active devices such as inductors, capacitors, transmission lines, translbrmers and transistors in mm-wave frequency band are discussed. Self-healing technique dealing with PVT variation, res- onant mode switching technique to enhance frequency tuning range of voltage controlled oscillator （VCO） and dual mode technique for power amplifier （PA） efficiency enhancement are introduced. At last, A fully-integrated 60 GHz 5 Gb/s QPSK transceiver with the transmit/receive （T/R） switch in 65nm CMOS process is introduced. The measured error vector magnitude （EVM） of the TX is -21.9 dB while the bit error rate （BER） of the RX with a -52 dBm sine-wave input is below 8e-7 when transmitting/receiving 5 Gb/s data. The transceiver is powered by 1.0 V and 1.2 V supply （except the phase-frequency detector and charge-pump in the frequency synthesizer which are powered by 2.5 V supply） and con- sumes 135 mW in TX mode and 176 mW in RX mode.
文摘This paper presents an LC VCO with auto-amplitude control （AAC）, in which pMOS FETs are used,and the varactors are directly connected to ground to widen the linear range of Kvco. The AAC circuitry adds little noise to the VCO but provides it with robust performance over a wide temperature and carrier frequency range.The VCO is fabricated in a chartered 50GHz 0.35μm SiGe BiCMOS process. The measurements show that it has - 127. 27dBc/Hz phase noise at 1MHz offset and a linear gain of 32.4MHz/V between 990MHz and 1.14GHz.The whole circuit draws 6. 6mA current from 5V supply.
基金Supported by the National High Technology Research and Development Programme of China(No.2011AA10305)
文摘This paper presents a lOGb/s highspeed equalizer as the frontend of a receiver for backplane communication. The equalizer combines an analog equalizer and a twotap decisionfeedback equal izer in a halfrate structure to reduce the intersymbolinterference （ISI） of the communication chan nel. By employing inductive peaking technique for the highfrequency boost circuit, the bandwidth and the boost of the analog equalizer are improved. The decisionfeedback equalizer optimizes the size of the CMLbased circuit such as D flipflops （DFF） and multiplex （MUX）, shortening the feedback path delay and speeding up the operation considerably. Designed in the 0. 181μm CMOS technology, the equalizer delivers 10Gb/s data over 18in FR4 trace with 28dB loss while drawing 27mW from a 1.8V supply. The overall chip area including pads is 0. 6 -0.7mm2.
基金This work was supported by the National Key Research and Development Program of China(2017YFA0700201,2017YFA0700203 and 2016YFC0800401)National Natural Science Foundation of China(61890544,61522106,61631007,61571117,61731010,61735010,61722106,61701107,and 61701108)+3 种基金Postgraduate Research&Practice Innovation Program of Jiangsu Province(KYCX19_0081)Scientific Research Foundation of Graduate School of Southeast University(YBPY1938)Foundation of National Excellent Doctoral Dissertation of China(201444)the 111 Project(111-2-05).
文摘Programmable metasurface enables controlling electromagnetic (EM) waves in real time. By programming the states of active device embedded in metasurface element, the EM properties of the digital metasurface can be changed quickly without redesigning their structures. However, large numbers of long-distance wires are required to connect the programmable metasurface to provide the coded signals from field programmable gate array (FPGA) when controlling the metasurface at a long distance, which is complicated and inconvenient. Here, we propose an infrared-controlled programmable metasurface that can be programmed remotely. The infrared transceiver is able to switch the coding sequences stored in the FPGA controller, thus controlling the voltage on the varactors integrated in the metasurface. Experiment is performed at microwave frequencies, and the measured results verify that the scattering beams of the metasurface sample can be changed remotely by using infrared ray. The proposed infrared-controlled programmable metasurface opens up avenues for constructing a new class of remotely-tuning dynamic metasurfaces.
