油库计量管理

随着我国经济的快速发展,油品的需求量越来越大,油库在保存各种油品时,对数量和质量的控制是工作的重点。1油品数量管理程序1.1入库数量管理-卸船入库1.1.1客户卸船入库,入库量原则上以罐的收油量为准。有合同规定的,按合同约定的方式为准。1.1.2如客户委托了第三方计量,计量部应配合第三方检罐前后量,并向第三方了解检船量。如客户委托我司计量,计量部除检罐前后量外,还需要检船量。

老化油脱水处理存在的问题及解决办法探析

本文主要讲述老化油脱水处理中存在的问题以及原因,并提出解决对策,希望对石油开采中存在的老化油脱水处理问题有所帮助。

Screening and Application of Oilseed Rape Varieties with High Yield and High Harvest Index

28 oilseed rape Pol CMS three-line hybrid combinations diallel-crossed were compared in the yield and harvest index and analyzed on the correlation between the experimental yields and harvest indexes in this study. The correlation coeffcient was only 0.365 4, lower than a signifcant level, which indicated that there was no signifcant positive （or negative） correlation between the economic yields and the harvest indexes in oilseed rape. Among them, 8 hybrid combinations including 7 with a harvest index〉0.30 and one with a harvest index〈0.27 increased signifcantly in the yields compared with the control, and then were screened for production experiment. Under different cultivation methods, all the 8 combinations had a stable harvest index, and the combinations with higher harvest indexes also had a stable performance in yields. An oilseed rape variety Fengyou 737 with higher yield and harvest index selected through a further screening was grown with the harvest indexhigher than 0.33 whether transplanted or directly seeded in Yangtze River Basin Demonstration Area, demonstrating stable high yields as well as good ecological adaptability. The combination of yield and harvest index in the study is conducive to breeding a new oilseed rape variety with stable yields and good tolerance to close planting.

Laboratory Research on Tahe AR Fluid Coking on Weak Acid Catalysts

Fluid coking on micro-spherical particles with acid sites on them could produce more light oils from Tahe AR.The conversion rate could increase by about 20% on the catalyst B compared to that obtained on the catalyst A and the light oil yield could increase by about 12%.The yield of gasoline and diesel was more than 50% from Tahe AR over the catalyst B.Tests on acidity of the catalyst B by pyridine FT-IR spectrometry showed that the total acid content and the ratio of weak acid number to total acid number were higher than other catalysts.

Competitive Adsorption of Anticorrosion and Antiwear Additives

Simulated adsorptive experiments using the axletree and lubricating oil containing anticorrosion additive were conducted,and the UV absorbance of the lubricating oil before and after the adsorptive experiments was measured.Through the UV spectral measurements the difference in UV absorbance of the lubricating oil before and after the adsorptive experiments was identified,the adsorbed quantity of anticorrosion additive in the interfacial film between lubricating oil and bearing was calculated using the Lambert-Bell principle to verify the adsorption of corrosion inhibitor on the surface of friction pairs.Adsorption experiments on lubricating oil containing both antiwear and anticorrosion additives were carried out and the UV absorbance of lubricating oil samples before and after the experiments was measured to determine the difference in the UV absorbance among lubricating oil samples with the same mass fraction of anticorrosion additive and different mass fractions of antiwear additive.By measuring the ultraviolet spectral absorbance of lubricating oil samples and calculating the adsorbed quantity of anticorrosion additive in the interfacial film it was possible to determine the influence of antiwear additive on the quantity of adsorbed anticorrosion additive on the surface of friction pairs and verify the competitive adsorption relationship between the antiwear additive and the anticorrosion additive.

Effects of Cultivar, Frying Temperature and Slice Thickness on Oil Uptake and Sensory Quality of Potato Crisps Processed from Four Kenyan Potato Cultivars

The effects of potato cultivar, frying temperature and slice thickness on oil uptake and sensory quality of potato crisps were investigated in four Kenyan cultivars. Potato tubers were peeled, washed and cut into slices of thickness 1.0 mm, 1.5 mm and 2.0 mm. Each size was fried at a constant temperature of 170 ℃ for 3-5 minutes. For frying temperature evaluation, the potatoes for all cultivars were cut into a uniform thickness of 1.5 mm and fried at temperatures of 160, 170 and 180 ℃ for 2-5 minutes. Crisps made from the four cultivars differed significantly （P 〈 0.05） in oil absorbed which ranged from 35.12% in Dutch Robyjn to 36.52% in clone 391,691.96. Tuber dry matter differed significantly （P 〈 0.05） among the cultivars ranging from 20.99% in clone 391691.96 to 25.29% in variety Dutch Robyjn. Tuber dry matter content was found to be negatively correlated to oil content of crisps; oil content increased with decrease in dry matter content. For each cultivar, the oil content of crisps differed significantly （P 〈 0.05） with temperatures and was higher at frying temperatures of 160 ℃ and lowest at 180 ℃, respectively. The oil content was significantly （P 〈 0.05） higher in slices of 1.0 mm thick than in slices of 1.5 mm and 2.0 mm; the amount ofoil absorbed decreased with increase in slice thickness. There was significant correlation （P 〈 0.05, r = -0.834） between oil content as determined in the laboratory and sensory scores. Results showed that high dry matter, slice thickness and temperature of frying resulted in reduced oil absorption by crisps during processing.

Oil Gels Based on Styrene Butadiene Rubber

Four oil absorbents based on styrene butadiene (SBR), i.e., pure SBR (PS), 4. tert-butylstyrene-SBR (PBS), EPDM-SBR network (PES) and 4.tert-butylstyrene-EPDMSBR (PBES), were produced from crosslinking polymerization of uncured styrene butadiene rubber (SBR), 4-tert-butylstyrene (tBS) and ethylene-propylenc-diene terpolymer (EPDM). The reaction took place in toluene using benzoyl peroxide (BPO) as an initiator. Uncured SBR was used as both a pre-polymer and a crosslink agent in this work, and the crosslinked polymer was identified by IR spectroscopy. The oil absorbency of the crosslinked polymer was evaluated with the method ASTM (F726-81). The order of maximum oil absorbency was PBES>PBS>PES>PS. The maximum values of oil absorbency of PBES and PBS were 74.0g/g and 69.5g/g, respectively. Gel fractions and swelling kinetic constants, however, had the opposite sequences. The swelling kinetic constant of PS evaluated by an experimental equation was 49. 97×10^(-2)h^(-1).

Finite element simulation on percolation of low permeability reservoir with permeability anisotropy

In low permeability porous media which permeability anisotropy is ubiquitous,the percolation of fluid no longer follows linear Darcy’s Law.Oil-water two phase flow equation of low permeability reservoir with permeability anisotropy is established based on generalized Darcy’s law and starting pressure gradient,corresponding finite element program is developed and simulated based on the Finite Element Program Generator system (FEPG).The results show that energy-gathering exists in the flow event of flowing area front in low permeability reservoir.In the process of energy-gathering,the flow velocity changed little but increased rapidly as soon as the pressure gradient exceeded the starting pressure gradient of the reservoir,then gradually stabilized.The greater the starting pressure gradient is,the greater the near wellbore pressure drop is,the smaller the area influenced by the reservoir pressure changes caused by water injection and oil recovery.The greater the starting pressure gradient is,the lower the water saturation in same point of the reservoir is,the smaller the water flood swept area is.There will be more difficulties in water injection to the same extent.

Control strategy for energy recovery system in hybrid forklift

After analyzing the working condition of the conventional diesel forklift,an energy recovery system in hybrid forklift is considered and its simulation model is built.Then,the control strategy for the proposed energy recovery system is discussed,which is validated and evaluated by simulation.The simulation results show that the proposed control strategy can achieve balance of the power and keep the state of charge(SOC) of ultra capacitor in a reasonable range,and the fuel consumption can be reduced by about 20.8% compared with the conventional diesel forklift.Finally,the feasibility of the simulation results is experimentally verified based on the lifting energy recovery system.

Influence of Partial Drying on Oil Uptake ＆ Quality Attributes of French Fries

Today＇s customers are looking for non-fat or low-fat containing products. One of the methods to reduce oil absorption in fried products is partial drying before frying. In this study, influence of partial drying （10 min, 20 min, 30 min） on oil absorption and quality attributes of three potato cultivars （Agria, Satina, kenebek） was evaluated. Our results reveled that in Agria, partial drying leads to an increase in oil absorption compared with non-dried sample （p〈0.05）. In kenebek, partial drying reduced the oil absorption and improved the texture and color of the produced French fries （p〈0.05）. Similar results were observed with Satina as with kenebek. In all three varieties, partial drying increased the dry matter, color quality and required cutting force of the French fries （p〈0.05）.

Radiation Resistance of Tar Fractions of Bituminous Oil

The results of studies of radiation chemical transformations of Balakhani bituminous oil of Azerbaijan are adduced. The IR （infrared） spectra of initial and irradiated samples of tar fractions of bituminous oil are compared. The kinetics of radiation chemical yields of gas products at the irradiation of bituminous oil and its tar fraction have been investigated. Irradiation is conducted in the gamma-ray source of isotope 60Co at the dose rate of P = 0.27 Gy/s and absorbed doses D = 5-163 kGy. It is found that in comparison with oil faction, tar fraction of bituminous oil has a high resistance to radiation.

Nutrient Efficiency of Winter Oilseed Rape in an Intensive Cropping System： A Regional Analysis

Fertilization is essential for oilseed rape because it is sensitivity to nutrient deficiency, especially for winter oilseed rape(Brassica napus L.). To investigate regional nutrient efficiency and nutrient uptake-yield relationship of winter oilseed rape in an intensive cropping system, this study used data from 619 site-year on-farm experiments carried out in the winter oilseed rape planting area of the Yangtze River Basin, China from 2005 to 2010, with large yield in the range of 179–4 470 kg ha^(-1). Currently recommended application rates of N, P and K fertilizers increased rapeseed yield at different levels of soil indigenous nutrient supply(INS) in this region. Boundary values of plant nutrient uptake were established to analyze the nutrient uptake-yield relationship of winter oilseed rape(internal nutrient efficiency), i.e., 128 kg N ha^(-1), 24 kg P ha^(-1), and 122 kg K ha^(-1). The internal nutrient efficiency declined by 48.2%–64.1% when nutrient uptake exceeded the boundary value, resulting in excessive nutrient uptake(i.e., low yield response with high nutrient uptake), especially for K. In the intensive cropping system, agronomic efficiencies of N, P, and K were 5.9, 3.4, and3.6 kg kg^(-1), and recovery efficiencies of N, P, and K were 35.6%, 24.1%, and 36.8%, respectively. These findings showed that the fertilization rate should be optimized by considering INS, nutrient status, and nutrient efficiency of winter oilseed rape. In this study,considering the lower yield improvement to high K uptake levels and low K fertilizer efficiency, application rate of K fertilizer should be reduced since soil K deficiency has already been mitigated.

Quantitative description of steam channels after steam flooding

Steam channeling is one of the main barriers for EOR after steam flooding.In order to enhance the oil recovery in steam flooded reservoirs,steam channel volumes should be precisely known.In this paper,a set of methods has been established in order to study steam channeling quantitatively by using dynamic data.Firstly,steam channeling wells are identified through curves of watercut and temperature.Then,considering the hysteresis phenomenon,channeling relations are identified with the correlation coefficients between injection wells and production wells under different conditions.Lastly,an analytic model,in which steam condensation,pressure and temperature are considered,is established to calculate the steam channel volumes.A production well named L31615 in some block in Henan Oilfield in China is systematically analyzed by using the method established.The whole block is further analyzed,and the distribution map of steam channels and the steam channel volumes are obtained.The results show that steam channeling does not only occur inside a well group,but also sometimes occurs between wells in different well groups.The calculation of the steam channel volumes provides a theoretical basis for bringing a remedial action like plugging into operation.