波推进方式的研究探讨

本文通过对鱼游动方式的研究，对完全模仿鱼体波浪形运动的问题进行了探讨，实验证明波推进方式确实具有高效率，在某些领域有一定的适用价值。

Accurate level set method for simulations of liquid atomization

Computational fluid dynamics is an efficient numerical approach for spray atomization study, but it is challenging to accurately capture the gas-liquid interface. In this work, an accurate conservative level set method is intro- duced to accurately track the gas-liquid interfaces in liquid atomization. To validate the capability of this method, binary drop collision and drop impacting on liquid film are investigated. The results are in good agreement with experiment observations. In addition, primary atomization （swirling sheet atomization） is studied using this method. To the swirling sheet atomization, it is found that Rayleigh-Taylor instability in the azimuthal direction causes the primary breakup of liquid sheet and complex vortex structures are clustered around the rim of the liq- uid sheet. The effects of central gas velocity and liquid-gas density ratio on atomization are also investigated. This work lays a solid foundation for further studvin~ the mechanism of s^rav atomization.

Vortex-Induced Vibration of Two Parallel Risers:Experimental Test and Numerical Simulation

The vortex-induced vibration of two identical rigidly mounted risers in a parallel arrangement was studied using Ansys-CFX and model tests.The vortex shedding and force were recorded to determine the effect of spacing on the two-degree-of-freedom oscillation of the risers.CFX was used to study the single riser and two parallel risers in 2–8D spacing considering the coupling effect.Because of the limited width of water channel,only three different riser spacings,2D,3D,and 4D,were tested to validate the characteristics of the two parallel risers by comparing to the numerical simulation.The results indicate that the lift force changes significantly with the increase in spacing,and in the case of 3D spacing,the lift force of the two parallel risers reaches the maximum.The vortex shedding of the risers in 3D spacing shows that a variable velocity field with the same frequency as the vortex shedding is generated in the overlapped area,thus equalizing the period of drag force to that of lift force.It can be concluded that the interaction between the two parallel risers is significant when the risers are brought to a small distance between them because the trajectory of riser changes from oval to curve 8 as the spacing is increased.The phase difference of lift force between the two risers is also different as the spacing changes.

Theoretical and Experimental Analysis of Vortex Origin

Several investigations refer to the issue of creation and identification of vortices in flows with different regime and presence of obstacles. Reasons have to do with the crucial role that vortices play in nature and industrial processes （sediment transport, mixing, radiation, noise, etc.）. Despite the contributions, further work is needed in order to perform more analysis of the mathematical arguments used to explain this phenomenon. In this idea order, the paper presents some advances in mathematical analysis and experimental results. In the first section, we do a description of the fluid motion from a fractional view through a sequence of three steps： Darcy＇s law, Navier-Stokes equations and Reynolds equations. Next, a representation of the temporal change of kinetic energy is found, which allows the possibility of the two signs. We obtain a description of the process of vortex creation. A length that represents the transition between flow and vortex intensity is found; then a succession of lengths is established that allows scaling from micro to macro. In the second section, experimental results are present; we consider vortex creation and its detection upstream of a bed form similar to that found in rivers, installed in an open channel, equipped with a water circulation system. For vortex detection, a methodology based on the particle image velocimetry PIV technique is proposed. So, we fulfill two objectives： vortex identification and its passage frequencies behind the bed form installed in the channel. Such procedure allows a computer process time reduction in vortices identification task.

Experimental investigation on control of vortex shedding mode of a circular cylinder using synthetic jets placed at stagnation points

Control of flow around a circular cylinder by synthetic jets has been experimentally investigated in a water tunnel with particle image velocimetry(PIV) technique.The synthetic jets are positioned at both the front and rear stagnation points.With power spectrum analysis,proper orthogonal decomposition(POD) method and other techniques for data processing,particular attention is paid to the control of vortical structures around the circular cylinder,in which the excitation frequency f e is one to three times of the natural frequency f0 and the cylinder Reynolds number and the excitation amplitude are fixed.The influenced-scope of the synthetic jet enlarges as the excitation frequency increases,and thus the synthetic jet dominates the global flow field gradually.For the natural case and the control case at fe/f0=1,the distributions of the first two POD modes and the power spectra for their POD coefficients all exhibit the characteristics of the natural shedding with antisymmetric mode.For fe/f0=2 and fe/f0=3,the variations in the third and fourth POD modes and the corresponding power spectra indicate that the wake vortex shedding mode changes and the dominant frequency becomes the excitation frequency.For fe/f0=2,the wake vortex sheds downstream with either the antisymmetric or the symmetric mode;for fe/f0=3,the synthetic jet vortex pair interacts with the near wake shear layers from both sides to induce a pair of the symmetric wake vortices,which is gradually converted into an antisymmetric mode when shedding downstream.

Experimental study on the hydraulic characteristics of vortex diodes

Vortex diode,as an important component in power fluidics,has been used in nuclear reprocessing engineering where it is desirable to avoid pumps with moving parts.The performance of the fluidic system depends on the matched design parameters of vortex diodes and the supporting facilities.However,no clear guidelines for design and optimization of vortex diodes system are available.Therefore,we carried out detailed experimental study on hydraulic characteristics of the vortex diodes system with changeable parameters to evolve such guidelines.The study covered a wide range of a vortex diode and vortex diodes system.The variation of averaged discharge and volumetric efficiency in respect to air supply pressure,liquid level of water tank and liquid level stroke of gas-liquid energy converter was studies.The experimental results were analyzed to develop design guidelines.The guidelines are shown to be useful for obtaining the design parameters that would yield the desired hydrau- lic performance for the required operating conditions.

Study on the critical submergence of surface vortices and the design of anti-vortex intakes

Surface vortex behavior in front of the tunnel intake was investigated in this paper.The critical submergence of vortex was discussed based on the concept of 'critical spherical sink surface'(CSSS).The vortex formation and evolution at the tunnel intake were analyzed based on the theory of CSSS considering the effect of circulation.A theory was proposed to explain the surface vortex.The theoretical development was verified by the physical model experiments of Xiluodu hydropower station.The radial velocity and vortex circulation were considered as the main factors that influence the formation and evolution of surface vortex.Finally,an anti-vortex intake configuration was proposed to weaken the air-core vortex in front of the tunnel intakes of the hydraulic structures.

Characteristics of Transient Vortices in the Boundary Layer on a Rotating Disk under Orbital Motion

The objective of this study is to experimentally examine the characteristics of transient vortices in the boundary layer on a disk undergoing both rotation and orbital motion. The velocity fluctuations on a rotating, orbiting disk （disk radius equal to orbital radius） are measured by the hot-wire method, and the effects of orbital motion on the transient vortices in the boundary layer are examined. When the ratio of the orbital speed to the speed of rotation is i-0.025, the interval of transient vortices depends on only the orbital radius, regardless of the directions of rota- tion and orbital motion. The rate of low-frequency disturbances increases as the orbital speed increases, and the vortices induced by these low-frequency disturbances travel over the disk and then develop in the region of in- creased velocity. Consequently, no vortices generated on a rotating disk under orbital motion are stationary rela- tive to the disk.

An experimental study on the effects of relative rotation direction on the wake interferences among tandem wind turbines

An experimental study was conducted to investigate the effects of relative rotation direction on the wake interferences among two tandemwind turbines models.While the oncoming flow conditions were kept in constant during the experiments,turbine power outputs,wind loads acting on the turbines,and wake characteristics behind the turbines were compared quantitatively with turbine models in either co-rotating or counter-rotating configuration.The measurement results reveal that the turbines in counter-rotating would harvest more wind energy from the same oncoming wind,compared with the co-rotating case.While the recovery of the streamwise velocity deficits in the wake flows was found to be almost identical with the turbines operated in either co-rotating or counter-rotating,the significant azimuthal velocity generated in the wake flow behind the upstream turbine is believed to be the reason why the counter-rotating turbines would have a better power production performance.Since the azimuthal flow velocity in the wake flow was found to decrease monotonically with the increasing downstream distance,the benefits of the counter-rotating configuration were found to decrease gradually as the spacing between the tandem turbines increases.While the counter-rotating downstream turbine was found to produce up to 20%more power compared with that of co-rotating configuration with the turbine spacing being about 0.7D,the advantage was found to become almost negligible when the turbine spacing becomes greater than 6.5D.It suggests that the counter-rotating configuration design would be more beneficial to turbines in onshore wind farms due to the smaller turbine spacing(i.e.,~3 rotor diameters for onshore wind farms vs.~7 rotor diameters for offshore wind farms in the prevailing wind direction),especially for those turbines sited over complex terrains with the turbine spacing only about 1–2 rotor diameters.

Simulation and experiment of vortex transport properties in a Type Ⅱ superconductor with grain boundary

We firstly described a simulation model to investigate the influence of grain boundary(GB)on the vortex transport properties in YBCO film.It is found that the size of inhomogeneous area caused by GB as well as the average velocity in transverse and longitudinal directions shows an angular dependence when the angle between the GB and the sample edge varies.We have also studied the impact of magnetic field intensity on dynamic behavior of vortex lattice and found that a lower vortex density makes it difficult for the vortex lattice to transfer from pinning state to flow state.As the magnetic field is decreased beyond a critical value,sharp jumps and strong fluctuations were observed in the I-V curve.Finally,we conducted measurements on a thin film YBa2Cu3O7 with an individual artificial grain boundary to support the simulation process.