期刊文献+
共找到4篇文章
< 1 >
每页显示 20 50 100
多输入多输出网络控制系统时延同步研究 被引量:1
1
作者 孙海燕 侯朝桢 《弹箭与制导学报》 CSCD 北大核心 2005年第S9期258-260,287,共4页
针对单输入单输出和多输入多输出网络控制系统中存在的时延抖动和时延偏移问题,提出了在控制器和执行器前设置缓冲区的方法。通过设置缓冲区.可以减小时延抖动和时延偏移,使之限制在一个合理的范围内,从而减小其对网络控制系统性能的影... 针对单输入单输出和多输入多输出网络控制系统中存在的时延抖动和时延偏移问题,提出了在控制器和执行器前设置缓冲区的方法。通过设置缓冲区.可以减小时延抖动和时延偏移,使之限制在一个合理的范围内,从而减小其对网络控制系统性能的影响,使系统保持稳定.达到时延同步的目的。仿真示例验证了该方法的有效性。 展开更多
关键词 网络控制系统 时延同步 时延抖动 时延偏移
下载PDF
多媒体同步系统中补偿缓冲区的设计 被引量:2
2
作者 许延 常义林 刘增基 《西安电子科技大学学报》 EI CAS CSCD 北大核心 2003年第3期315-319,398,共6页
多媒体系统中端到端的时延抖动常常导致媒体播放的不连续,为了保持媒体内及媒体间的时间关系,通常在信宿端设置缓冲区来补偿时延抖动,将时延抖动和时延偏移限制在一定的范围内.文中分析了时延抖动的统计特性,它近似于高斯分布,在此基础... 多媒体系统中端到端的时延抖动常常导致媒体播放的不连续,为了保持媒体内及媒体间的时间关系,通常在信宿端设置缓冲区来补偿时延抖动,将时延抖动和时延偏移限制在一定的范围内.文中分析了时延抖动的统计特性,它近似于高斯分布,在此基础上提出了一种缓冲区的设计方法.另外给出了包含音频和视频多媒体播放系统的同步应用,利用Chernoff不等式,推导出所需缓冲区大小的计算公式.模拟结果表明,用该方法确定的缓冲区完全能够满足用户提出的可感知的服务质量(P QoS),而且具有较高的缓冲区利用率. 展开更多
关键词 多媒体同步系统 时延抖动 缓冲区 时延偏移 P_QoS Chernoff不等式
下载PDF
Interrupt CW Approach for IF Video Signal Real Time Simulating and Its Validity
3
作者 朱灿焰 龙腾 +1 位作者 何佩琨 毛二可 《Journal of Beijing Institute of Technology》 EI CAS 2000年第1期73-79,共7页
To determine the feasibility and practicability of interrupt continuous wave (CW) approach proposed for real time simulating radar intermediate frequency(IF) video signal, theoretical analysis and computer simulation... To determine the feasibility and practicability of interrupt continuous wave (CW) approach proposed for real time simulating radar intermediate frequency(IF) video signal, theoretical analysis and computer simulation were used. Phases at two linked points between the end and beginning of adjoined frames are always consistent; the bias Doppler frequency for the time delay of A/D sampling start responds to that for target acceleration. No digital phase compensation is required at continuous points, and the interrupt CW approach has apparently practical values. 展开更多
关键词 intermediate frequency(IF) video signal generating in low IF(LIF) domain interrupt continuous wave (CW) phase shift A/D sampling delay error
下载PDF
Analysis of Systematic Error Influences on Accuracy of Airborne Laser Scanning Altimetry
4
作者 ZHANGXiaohong LIUJingnan 《Geo-Spatial Information Science》 2004年第3期218-224,共7页
The error sources related to the laser rangefinder, GPS and INS are analyzed in details. Several coordinates systems used in airborne laser scanning are set up, and then the basic formula of system is given. This pape... The error sources related to the laser rangefinder, GPS and INS are analyzed in details. Several coordinates systems used in airborne laser scanning are set up, and then the basic formula of system is given. This paper emphasizes on discussing the kinematic offset correction between GPS antenna phase center and laser fired point. And kinematic time delay influence on laser footprint position, the ranging errors, positioning errors, attitude errors and integration errors of the system are also explored. Finally, the result shows that the kinematic time delay can be neglected as compared with other error sources. The accuracy of the coordinates is not only influenced by the amplitude of the error, but also controlled by the operation parameters such as flight height, scanning angle amplitude and attitude magnitude of the platform. 展开更多
关键词 airborne laser scanning altimetry kinematic offset corrections kinematictime delays error analysis imitation calculation
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部