期刊文献+
共找到5篇文章
< 1 >
每页显示 20 50 100
特发性黄斑裂孔术后黄斑中心凹外层显微结构变化与视力的相关性
1
作者 卢凤丽 赵芃芃 +2 位作者 秦梅 张琴 张信哲 《眼科学》 2023年第1期1-10,共10页
目的:通过OCT观察特发性全层黄斑裂孔(IFTMH)患眼术后的视网膜黄斑中心凹外层显微结构变化,并分析其与视力之间的相关性。方法:选取2019年5月至2020年10月在蚌埠医学院第一附属医院眼科就诊诊断为IFTMH的患者,共37例,37眼,均成功行手术... 目的:通过OCT观察特发性全层黄斑裂孔(IFTMH)患眼术后的视网膜黄斑中心凹外层显微结构变化,并分析其与视力之间的相关性。方法:选取2019年5月至2020年10月在蚌埠医学院第一附属医院眼科就诊诊断为IFTMH的患者,共37例,37眼,均成功行手术修复。比较患眼在术前和术后1个月、3个月、6个月、12个月和24个月检查中的最佳矫正视力(BCVA)及OCT中黄斑中心凹外层显微结构变化。根据24个月末次随访的外界膜(ELM)、椭圆体带(EZ)、嵌合体带(IZ)愈合情况,将其分为3组:A组为ELM完整,EZ和IZ连接中断,共有11眼;B组为ELM、EZ完整,IZ连接中断,共有15眼;C组为ELM、EZ、IZ完全恢复,共有11眼。分析视力与黄斑中心凹ELM、EZ、IZ的连续性之间的相关性。结果:在37例37眼中,三组患者年龄、性别、眼别、症状持续时间、术前BCVA、术前裂孔最小径、基底径等差异无统计学意义(P > 0.05),最后一次随访时,三组患眼BCVA之间差异有统计学意义(F = 24.257, P < 0.01),其中C组视力恢复最佳,C组LogMAR BCVA从0.80 ± 0.12改善至0.08 ± 0.09。在术后1个月、3个月、6个月、12个月和24个月的随访中黄斑中心凹显微结构持续重建,ELM、EZ和IZ的缺损直径持续减少,BCVA持续好转,较术前具有统计学差异(P < 0.05)。重建过程由ELM先开始,依次为EZ、IZ。术后24个月BCVA与术前裂孔最小径、基底径、症状持续时间、术前BCVA、术前ELM缺损直径、术前EZ缺损直径、术前IZ缺损直径均呈正相关(r = 0.798, 0.601, 0.683, 0.732, 0.682, 0.695, 0.702, P < 0.01)。结论:IFTMH患眼术后黄斑中心凹光感受器持续重建,重建顺序依次为ELM、EZ、IZ,视力持续提高。同时,外层显微结构的重建程度与术后视力呈正相关。 展开更多
关键词 特发性全层黄斑裂孔 显微结构变化 光学相干断层扫描 最佳矫正视力
下载PDF
加热温度与马铃薯淀粉粒结构变化及食用口感的关系 被引量:3
2
作者 高振江 吴薇 《食品科学》 EI CAS CSCD 北大核心 2003年第4期27-30,共4页
本文介绍了马铃薯烤制过程中,其淀粉粒糊化过程的显微结构变化与温度之间的关系,同时还介绍了烤制马铃薯的口感与马铃薯加热温度之间的关系,确定了适口的最佳温度点。
关键词 加热温度 马铃薯 烤制 淀粉粒 糊化 显微结构变化
下载PDF
Si-Al-Zr-O系非晶晶化过程研究 被引量:4
3
作者 谭小平 梁叔全 +2 位作者 张勇 唐艳 钟杰 《无机材料学报》 SCIE EI CAS CSCD 北大核心 2007年第6期1233-1238,共6页
借助DSC、XRD、SEM和TEM等技术探讨了Si-Al-Zr-O(SAZ)系非晶的原位受控晶化过程.结果表明,SAZ系非晶在900℃左右存在分相,形成富Si区和富Zr、Al区.在920~950℃间,开始成核析出初晶相四方氧化锆,并从富Al区形成Al-Si尖晶石相.当温度升高... 借助DSC、XRD、SEM和TEM等技术探讨了Si-Al-Zr-O(SAZ)系非晶的原位受控晶化过程.结果表明,SAZ系非晶在900℃左右存在分相,形成富Si区和富Zr、Al区.在920~950℃间,开始成核析出初晶相四方氧化锆,并从富Al区形成Al-Si尖晶石相.当温度升高至1000℃时,莫来石晶相开始生成.温度进一步升高,Al-Si尖晶石相消失,四方氧化锆、莫来石成为主晶相,同时生成了方石英.其中,莫来石是通过过渡相Al-Si尖晶石与非晶二氧化硅反应得到. 展开更多
关键词 SAZ系非晶 相演变 显微结构变化
下载PDF
Effects of CO_2 Enrichment on Microstructure and Ultrastructure of Two Species of Freshwater Green Algae 被引量:4
4
作者 夏建荣 高坤山 《Acta Botanica Sinica》 CSCD 2002年第5期527-531,共5页
order to investigate the morphological response of freshwater green algae to elevated CO2 concentration, Chlamydomonas reinhardtii Dang and Scenedesmus obliquus Kutz were cultured with enriched CO2, and their microstr... order to investigate the morphological response of freshwater green algae to elevated CO2 concentration, Chlamydomonas reinhardtii Dang and Scenedesmus obliquus Kutz were cultured with enriched CO2, and their microstructure and ultrastructure were examined by microscopy and electron microscopy. The effect of CO2 enrichment to 186 mumol/L, was insignificant on the shape and size of C. reinhardtii, but significant in reducing the volume of S. obliquus. High-CO2 increased the amount of chloroplast. The pyrenoids occurred in low-CO2-grown cells but not in high-CO2-grown ones and more starch granules were observed in the former. 展开更多
关键词 Chlamydomonas reinhardtii CO2 MICROSTRUCTURE PYRENOID Scenedesmus obliquus starch granules ULTRASTRUCTURE
下载PDF
Influence of minor Sc additions on grain refinement and microstructure characteristics of a high Zn-containing Al-Zn-Mg-Cu-Zr alloy 被引量:3
5
作者 WEN Kai LI Xi-wu +5 位作者 XIONG Bai-qing LIU Hong-lei WANG Ying-jun LI Zhi-hui ZHANG Yong-an LI Ya-nan 《Journal of Central South University》 SCIE EI CAS CSCD 2022年第3期780-794,共15页
In the present work, scandium elements with a series of contents(0.06 wt.%, 0.10 wt.%, 0.14 wt.%,0.17 wt.%, 0.20 wt.% and 0.25 wt.%) were added in a high Zn-containing Al-Zn-Mg-Cu-Zr alloy and the corresponding as-cas... In the present work, scandium elements with a series of contents(0.06 wt.%, 0.10 wt.%, 0.14 wt.%,0.17 wt.%, 0.20 wt.% and 0.25 wt.%) were added in a high Zn-containing Al-Zn-Mg-Cu-Zr alloy and the corresponding as-cast microstructure characteristics including grains and phases were thoroughly investigated. The results indicated that fine grain boundaries existed in these alloys and fine MgZn2phases discontinuously distributed on them. Besides,AlZnMgCu eutectic phases and Sc, Zr-containing phases with flocculent morphology were observed. As scandium contents vary from 0.06 wt.% to 0.17 wt.%, the average grain size continuously decreased and its equiaxial characteristics were strengthened. Meanwhile, the content of AlZnMgCu eutectic phase showed a decrease trend. When scandium contents were 0.20 wt.% and 0.25 wt.%, no further enhancement on grain refinement was observed, so as to the reduction of AlZnMgCu eutectic phase content. Besides, Sc, Zr-containing phases with blocky morphology were observed and the alloy with a scandium content of 0.25 wt.% possessed a larger amount of blocky Sc, Zr-containing phase than the alloy with a scandium content of 0.20 wt.%. Grain refinement and reduction of AlZnMgCu eutectic phase content associated with scandium addition were discussed. 展开更多
关键词 Al-Zn-Mg-Cu-Zr alloy high zinc content microstructure Sc addition grain refinement phase evolution
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部