To improve dynamic and static performances and robustness of the induction motor speed control system based on vector control,an improved fractional-order intelligent proportional integral(IPIλ)controller was applied...To improve dynamic and static performances and robustness of the induction motor speed control system based on vector control,an improved fractional-order intelligent proportional integral(IPIλ)controller was applied to the speed controller of the vector control system,which combined the intelligent fractional integral with the proportion according to the variation of deviation.Compared with proportional integral(PI)and fractional-order proportional integral(FOPI)controllers,the IPIλcontroller achieved better control performance.The stimulation results indicate that the IPIλcontroller can not only track the given speed quickly and accurately,but also have better anti-interference and robustness for load and parameters variations.展开更多
The controlling algorithm was studied for the inverter-driven multi-type air conditioner using electronic expansion valve(EEV) in outdoor unit. The performance of inverter-driven air conditioner with two different uni...The controlling algorithm was studied for the inverter-driven multi-type air conditioner using electronic expansion valve(EEV) in outdoor unit. The performance of inverter-driven air conditioner with two different units was investigated by varying the outdoor ambient temperature and compressor speed. Based on the test results, the effect of EEV opening on the indoor unit exit superheat was discussed. For the specified outdoor ambient temperature scope and the EEV opening, the superheats of indoor units decrease with the outdoor ambient temperature rising. Improper distribution of refrigerant into each indoor unit will causes excessive superheat difference between two indoor units. Suggestions were then given for the controlling of the superheat.展开更多
Conventional vacuum control in a milking system is accomplished by using a vacuum pump, sized for the maximum air flows into the milking system, running at a full speed. The difference between the pump capacity and th...Conventional vacuum control in a milking system is accomplished by using a vacuum pump, sized for the maximum air flows into the milking system, running at a full speed. The difference between the pump capacity and the necessary flow of air is compensated by allowing air to enter the system through a regulator. The solution presented in this paper uses a VFD （variable frequency driver） in order to drive the vacuum pump at a controlled speed, so that the air removed equals the air entering the milking system. The VFD technology is able to adjust the rate of air removal from the milking system, by changing the speed of the vacuum pump motor. The VFD is controlled by a computer using a virtual instrument in order to emulate a PID （proportion integration differentiation） regulator. The tests aimed to evaluate the vacuum regulator characteristics and vacuum stability. A statistical analysis of the experimental results was performed and it showed that there was a significant difference between the experimental results obtained for the two methods of vacuum regulation （with vacuum regulator and VFD controller respectively）. The experimental results proved that the used of the VFD controller led to a higher vacuum stability in terms of the error between the set vacuum value and the achieved values.展开更多
This paper presents a multiple target implementation technique for a doubly fed induction generator （DFIG） under unbalanced and distorted grid voltage based on direct power control （DPC）. Based on the mathematical...This paper presents a multiple target implementation technique for a doubly fed induction generator （DFIG） under unbalanced and distorted grid voltage based on direct power control （DPC）. Based on the mathematical model of DFIG under unbalanced and distorted voltage, the proportional and integral （PI） regulator is adopted to regulate the DFIG average active and reactive powers, while the vector P1 （VPI） resonant regulator is used to achieve three alternative control targets： （1） balanced and sinusoidal stator current; （2） smooth instantaneous stator active and reactive powers; （3） smooth electromagnetic torque and instantaneous stator reactive power. The major advantage of the proposed control strategy over the conventional method is that neither negative and harmonic sequence decomposition of grid voltage nor complicated control reference calculation is required. The insensitivity of the proposed control strategy to DFIG parameter deviation is analyzed. Finally, the DFIG experimental system is developed to validate the availability of the proposed DPC strategy under unbalanced and distorted grid voltage,展开更多
基金National Natural Science Foundation of China(No.61461023)Gansu Provincial Department of Education Project(No.2016B-036)
文摘To improve dynamic and static performances and robustness of the induction motor speed control system based on vector control,an improved fractional-order intelligent proportional integral(IPIλ)controller was applied to the speed controller of the vector control system,which combined the intelligent fractional integral with the proportion according to the variation of deviation.Compared with proportional integral(PI)and fractional-order proportional integral(FOPI)controllers,the IPIλcontroller achieved better control performance.The stimulation results indicate that the IPIλcontroller can not only track the given speed quickly and accurately,but also have better anti-interference and robustness for load and parameters variations.
文摘The controlling algorithm was studied for the inverter-driven multi-type air conditioner using electronic expansion valve(EEV) in outdoor unit. The performance of inverter-driven air conditioner with two different units was investigated by varying the outdoor ambient temperature and compressor speed. Based on the test results, the effect of EEV opening on the indoor unit exit superheat was discussed. For the specified outdoor ambient temperature scope and the EEV opening, the superheats of indoor units decrease with the outdoor ambient temperature rising. Improper distribution of refrigerant into each indoor unit will causes excessive superheat difference between two indoor units. Suggestions were then given for the controlling of the superheat.
文摘Conventional vacuum control in a milking system is accomplished by using a vacuum pump, sized for the maximum air flows into the milking system, running at a full speed. The difference between the pump capacity and the necessary flow of air is compensated by allowing air to enter the system through a regulator. The solution presented in this paper uses a VFD （variable frequency driver） in order to drive the vacuum pump at a controlled speed, so that the air removed equals the air entering the milking system. The VFD technology is able to adjust the rate of air removal from the milking system, by changing the speed of the vacuum pump motor. The VFD is controlled by a computer using a virtual instrument in order to emulate a PID （proportion integration differentiation） regulator. The tests aimed to evaluate the vacuum regulator characteristics and vacuum stability. A statistical analysis of the experimental results was performed and it showed that there was a significant difference between the experimental results obtained for the two methods of vacuum regulation （with vacuum regulator and VFD controller respectively）. The experimental results proved that the used of the VFD controller led to a higher vacuum stability in terms of the error between the set vacuum value and the achieved values.
基金Project supported by the National High-Tech R&D Program(863)of China(No.2011AA050204)the National Natural Science Foundation of China(No.51277159)
文摘This paper presents a multiple target implementation technique for a doubly fed induction generator （DFIG） under unbalanced and distorted grid voltage based on direct power control （DPC）. Based on the mathematical model of DFIG under unbalanced and distorted voltage, the proportional and integral （PI） regulator is adopted to regulate the DFIG average active and reactive powers, while the vector P1 （VPI） resonant regulator is used to achieve three alternative control targets： （1） balanced and sinusoidal stator current; （2） smooth instantaneous stator active and reactive powers; （3） smooth electromagnetic torque and instantaneous stator reactive power. The major advantage of the proposed control strategy over the conventional method is that neither negative and harmonic sequence decomposition of grid voltage nor complicated control reference calculation is required. The insensitivity of the proposed control strategy to DFIG parameter deviation is analyzed. Finally, the DFIG experimental system is developed to validate the availability of the proposed DPC strategy under unbalanced and distorted grid voltage,
