温度对fcc铁中氦行为的影响研究

温度对fcc铁中的氦行为具有重要的影响,编写了居于fcc晶格的面向对象动力学蒙特卡罗程序(Object Kinetic Monte Carlo),采用该程序结合分子动力学(MID)方法对fcc铁中的氯行为进行多尺度模拟,研究了温度对fcc铁中氯行为的影响,给出了不同温度退火过程中氯行为的原子细节.模拟结果表明引入一定量的非热平衡空位可以使模拟结果与文献实验结果有非常好的吻合;室温至1073 K,温度对氯行为影响可以分为四个阶段:第一阶段,298～473 K,正电子长寿命随退火温度增加略有减少,这主要由于非热平衡空位浓度降低;第二阶段,473～673 K,正电子长寿命随退火温度增加而增加,主要由于晶粒内平均氦泡尺寸增加;第三阶段,673～873 K,正电子长寿命随退火温度增加而迅速减少,主要是由于氯泡的平均尺寸减小和晶粒内的空位浓度降低;第四阶段,873～1073 K,正电子长寿命随退火温度增加而迅速增加,与晶粒内氦泡的平均尺寸变大,且空位浓度随温度的增加而指数增加有关.

Corrosion behavior of micro-arc oxidation coating on AZ91D magnesium alloy in NaCl solutions with different concentrations

Ceramic oxide coatings were prepared on AZ91D magnesium alloys in alkaline silicate solution using micro-arc oxidation（MAO） technique.The corrosion behavior of MAO coating on AZ91D magnesium alloys in NaCl solutions with different concentrations（0.1%,0.5%,1.0%,3.5% and 5.0% in mass fraction） was evaluated by electrochemical measurements and immersion tests.The results showed that the corrosion rate of the MAO coated AZ91D increased with increasing chloride ion concentration.The main form of corrosion failure was localized corrosion for the MAO coated AZ91D immersed in higher concentration NaCl solutions（1.0%,3.5% and 5.0%）,while it was general corrosion in dilute NaCl solutions（0.1% and 0.5%）.Two different stages of the failure process of the MAO coated AZ91D could be identified：1） occurrence of the metastable pits and 2） growth of the pits.Different equivalent circuits were also proposed based on the results of electrochemical impedance spectroscopy（EIS） for the MAO coated AZ91D immersed in different concentrations of NaCl solutions for 120 h.

低应力水平下混凝土中氯离子扩散行为多尺度分析方法

混凝土的扩散渗透性能与其微观结构(包括细观尺度上粗骨料颗粒与砂浆之间的界面过渡区及砂浆本身的微观结构等)密切相关。在微观尺度上,砂浆和界面过渡区均可视为由无孔砂浆基质和孔隙水夹杂相组成的两相复合材料,二者的主要区别表现为孔隙率不同。在外荷载作用下,砂浆和界面过渡区的毛细孔隙率及孔隙连通性会发生改变,从而改变混凝土的扩散渗透性能。基于此,该文建立了低应力水平下混凝土中氯离子扩散行为多尺度理论分析方法,获得了混凝土表观扩散系数与外荷载(以体应变表征)及砂浆和界面过渡区当前孔隙率的定量关系。分析所采用的主要参数为砂浆和界面过渡区的毛细孔隙率、无孔砂浆基质和骨料相的力学参数、骨料相和界面过渡区的体积分数、外荷载等。与已有文献数据对比知,该文分析结果与之吻合良好,表明了理论分析方法的合理性与准确性。此外,基于该方法,探讨分析了混凝土微/细观结构对其宏观扩散性能的影响。

Effects of Intraperitoneal Injection of Polychlorinated Biphenyls During Pregnancy on Sexual Behavior of F1 Rats

50 time-mated pregnant rats were divided into five groups and injected daily from gestational days 7 to 18 with either 2,2＇ ,4,4＇-tetrachlorobiphenyl （PCB 47） at the dosage of 1.00 or 20.00 mg/kg body weight; or 3,3＇ ,4,4＇-tetrachlorobiphenyl （PCB 77） at the dosage of 0.25 or 1.00 mg/kg body weight; or sesame oil （control） to investigate the effects of fetal and lactational PCB exposure on reproductive behavior in male and female laboratory rats. Offspring were then tested for male sexual behavior： mount frequency, MF; mount latency, ML; intromission frequency, IF; intromission latency, IL; ejaculation latency, EL; post ejaculatory interval, PEI; hit rate and female sexual behavior; approach latency, AL; mount return latency, MRL; intromission return latency, IRL; post ejaculatory refractory period, PER; lordosis quotient, LQ. Measures were made at the age of postnatal days 70 to 91, and 97 to 101, respectively. The results showed that exposure to both PCB 77 and PCB 47 significandy reduced the LQ （84.4% for control, 76.0%, 67.8% for PCB 47 groups and 64.4%, 53.3% for PCB 77 groups; P〈0.05） in the female offspring. There were no significant effects on AL, MR, IRL, PER （P〉0.05） of the female offspring, or on MF, ML, IF, IL, EL, PEI and hit rate （P〉0.05） of the male offspring.

Effect of ammonium chloride on leaching behavior of alkaline anion and sodium ion in bauxite residue

This study focused on leaching behavior of alkaline anion and sodium in bauxite residue through ammonium chloride treatment.The results showed that the pH of bauxite residue decreased from 10.49 to 8.93,total alkaline anion(HCO3^-,CO3^2-,OH^-,AlO2^-)concentration reduced from 38.89 to 25.50 mmol/L,leaching rate of soluble sodium was 80.86%with ammonium chloride addition of 0.75%,liquid/solid(L/S)ratio of 3(mL/g),temperature of 30°C and reaction time of 18 h;L/S ratio was the main factor affecting the removal of alkaline anion and the leaching of sodium.Furthermore,ammonium chloride promoted the dissolution of diaspore and changed the micro/morphological characteristics with the increase of massive structure.The findings of this work will contribute to achieve soil-formation of bauxite residue.

Thermogravimetric-Mass Spectrometric Study of the Pyrolysis Behavior of PVC

The pyrolysis characteristics of PVC were systematically investigated using a Netzschne TG thermo-balance coupled to a quadrupole mass spectrometer. The pyrolysis conditions were 0.1 MPa of Ar, a heating rate of 10 ℃/min and a final temperature of 1000℃. Both the thermogravimetric properties and the simultaneous evolution of gaseous products during pyrolysis were studied. The TG/DTG results showed that as the pyrolysis temperature increases the weight loss and weight loss rate of PVC increases. Near 412℃ the weight loss rate attained its peak value. At higher temperatures the rate of loss gradually decreases. The gases evolved during thermogravimetric analysis were analyzed by a mass spectrometer, monitoring the relative intensity of HC1, C6H6, light hydrocarbon and chlorine-containing gases The evolution curves showed that HC1, C6H6, light hydrocarbon and chlorine-containing gases all peak at about 416℃. This is consistent with the fact that the weight loss curves also peak at about 412℃. The extensive HCl evolution is consistent with the high chlorine content of PVC. The formation of these gases can be explained by considering these reactions： dehydrochlorination, intramolecular cyclization and the addition of HCl to unsaturated hydrocarbons.

Behavior of silver and lead in selective chlorination leaching process of gold-antimony alloy

The behavior of silver and lead in the selective chlorination leaching process of gold-antimony alloy was analyzed in detail and appropriate recovery methods were developed.A reduction method by adding gold-antimony alloy powder was adopted to recover silver according to the thermodynamics calculation.The reducing rate of silver can exceed 99%at 80℃for 1.5 h when the dosage of gold-antimony alloy powder is 10%.The dissolution equilibrium curved surfaces of PbSO4 and PbCl2 under different conditions were drawn.The experimental results are well consistent with theoretical analysis that indicate lead may be precipitated in the form of lead chloride.The grade of gold in the residue can be further concentrated to 94.5%after being washed with hot water. These two methods have been applied successfully in the practice.

Effect of Cl￣ on Behavior of Fertilizer Nitrogen, Nnmberof Microorganisms and Enzyme Activities in Soils

Pot experiments were conducted to study the effect of Cl￣- on transformation of fertilizer N, number ofmicroorganisms and enzyme activities in soils. It is indicated that Cl￣- did not show significant influenceon total number of bacteria, actinomyces and fungi, but significantly reduced the number of nitrosobacteria,which led to decrease of NO content in the soil. Application of Cl￣- to soil could significantly enhance theactivities of phosphatase and urease in the coastal saline soil and orthic aquisols. In hilly red soil, however,the application of Cl￣- at the rate of 500-1000 mg Cl￣- kg￣(-1) soil significantly decreased the activity of thetwo enzymes mentioned above.

Corrosion behavior of AZ31 magnesium alloy in simulated acid rain solution

The corrosion mechanism of AZ31 magnesium alloy used as automobile components and the influence of the concentration of Cl- ion in simulated acid rain(SAR)were studied by electrochemical tests and SEM.The results show that pitting corrosion happens around the AlMn phases locating at the grain boundary.The corrosion of AZ31 magnesium alloy in SAR is controlled by the rate of anodic dissolution and hydrogen evolution,and the corrosion rate of AZ31 increases with increasing concentration of Cl- ion.However,the Cl- ion in SAR is not the main influencing factor inducing the pitting corrosion.

Thermodynamic behaviors of SiCl_2 in silicon deposition by gas phase zinc reduction of silicon tetrachloride

The modified Siemens process,which is the major process of producing polycrystalline silicon through current technologies,is a high temperature,slow,semi-batch process and the product is expensive primarily due to the large energy consumption.Therefore,the zinc reduction process,which can produce solar-grade silicon in a cost effective manner,should be redeveloped for these conditions.The SiCl2 generation ratio,which stands for the degree of the side reactions,can be decomposed to SiCl4 and ZnCl2 in gas phase zinc atmosphere in the exit where the temperature is very low.Therefore,the lower SiCl2 generation ratio is profitable with lower power consumption.Based on the thermodynamic data for the related pure substances,the relations of the SiCl2 generation ratio and pressure,temperature and the feed molar ratio（n（Zn）/n（SiCl4） are investigated and the graphs thereof are plotted.And the diagrams of Kpθ-T at standard atmosphere pressure have been plotted to account for the influence of temperature on the SiCl2 generation ratio.Furthermore,the diagram of Kpθ-T at different pressures have also been plotted to give an interpretation of the influence of pressure on the SiCl2 generation ratio.The results show that SiCl2 generation ratio increases with increasing temperature,and the higher pressure and excess gas phase zinc can restrict SiCl2 generation ratio.Finally,suitable operational conditions in the practical process of polycrystalline silicon manufacture by gas phase zinc reduction of SiCl4 have been established with 1200 K,0.2 MPa and the feed molar ratio（n（Zn） /n（SiCl4）） of 4 at the entrance.Under these conditions,SiCl2 generation ratio is very low,which indicates that the side reactions can be restricted and the energy consumption is reasonable.

Influence of NaCl deposition on atmospheric corrosion behavior of AZ91 magnesium alloy

Corrosion behavior of AZ91 magnesium alloy under NaCl particle deposition condition was investigated by gravimetric method and surface analysis technique.It was found that the mass gain increased rapidly at the beginning of exposure and then slowly with time.The corrosion morphologies were observed and the results showed that NaCl deposition resulted in the occurrence of localized corrosion.The composition of corrosion product was analyzed using X-ray photo electron spectroscopy.It was suggested that the corrosion product was a mixture of oxide and hydroxide of magnesium and aluminum.

Effect of Chloride Content on Bond Behavior Between FRP and Concrete

For reinforced concrete structures located along the seaside, the penetration of chloride ions into concrete may be a threat to the durability of the structures. Experimental investigations were carried out to study the effect of chloride content on the bond behavior between concrete and fiber reinforced polymer (FRP) plates. Direct shear tests were conducted on the FRP strengthened concrete members. Before testing, the specimens were immersed in NaCl solutions with concentrations ranging from 3%—15% for di...