贵州高原缺水地区钻探水(源)泵的选用

为了解决贵州高原缺水地区钻探施工用水问题,多采用高扬程、远距离的输水方式。但由于水(源)泵选型不合理、设计不科学等因素造成输水系统不能正常工作。通过分析几种泵的构造和工作原理,结合本区的实际情况对泵的特殊要求提出了钻探水(源)泵的选用方法,从而解决输送难题。

Variation characteristics of aquifer parameters induced by groundwater source heat pump operation under variable flow

The variation characteristics of aquifer parameters,induced by groundwater source heat pump(GWSHP) operation under variable flow,were theoretically analyzed through a case study,in which the characteristics of building air conditioning load were considered.The results,compared with the constant flow operation,indicate that the influence on the variations of porosity,hydraulic conductivity and confined water head is decreased by 48%,51% and 71%,respectively,under variable flow operation.The security of variable flow operation is superior to that of constant flow.It is also concluded that the climate region and function of the buildings are primary factors which affect the suitability of variable flow operation in GWSHP.

Parallel Operation Characteristics Analysis of Sewage Source Heat Pump Units in Winter

Sewage source heat pump unit operates under partial load most of the time, and study on the law of coefficient of performance (COP) of the unit varying with load ratio can provide basis for the heat pump units running in high efficiency. A mathematical model determining COP, evaporation temperature and condensation temperature of a single unit was proposed. Under the condition of uniform load distribution, the model was established according to different ways of bearing partial load with the same type multi...

Heat transfer analysis and experimental verification of cast heat exchanger

From the viewpoints of environmental conservation and energy efficiency,seawater-source heat pump system(SWHP) to provide district cooling and heating is applied in coastal areas.Based on the system,a heat transfer model was established for cast heat exchanger(CHE) adopted by SWHP systems.The CHE consists of pipes immersed in the seawater and used for transferring heat between the seawater and the heat exchanger pipes of SWHP system.An experimental study was carried out to test the validity of the model.A program was developed in VB language and the effects of inlet temperature,flow rate of the secondary refrigerant and length of CHE on the results were investigated.The results of the numerical simulation are in consistence with the experiments in both winter and summer conditions.As a result,application of SWHP systems with CHE in coastal areas in China is feasible due to the favorable geographical conditions and environment.

Experimental study on viscosity characteristic of sewage in urban untreated sewage source heat pump system

To confirm the rheological characteristic of sewage in the research and application of urban sewage source heat pump system, the viscosity of sewage was investigated. The tube-type rheometer was used in this experimental study, and the sewage was treated as homogeneous non-Newtonian fluid. In addition, the relational expression between viscosity parameters was developed, and the function of apparent viscosity was obtained. It is concluded that the viscosity characteristic of sewage is influenced largely by complex mixture in sewage, and the sewage has the characteristic of sheared densification fluid.

Strong self-flushing technique for heat exchanger of sewage source heat pump system

To better remove the contamination on the surface of a heat-exchanger in urban sewage source heat pump system （USSHPS）, this paper analyzes the feasibility of strong self-flushing on the basis of experiments and presents a new on-line self-flushing technique, which alternately flushes part of heat transfer tubes. In addition, operation principles and the structure of the new heat-exchanger are introduced and the feasible economi- cal and technological cleaning plans are given by design calculation and scheme comparison. The result shows that keeping each tube washed for one minute with 5 m/s, the operating cost is lower than ￥5 and when one flushing pump ahemately flushes 10-20 heat exchangers, the saved costs of flushing 10 tubes alternately are over 4 times of the increased costs.

Coupled Seepage and Heat Transfer Intake Model

In the beach well intake system, heat is transferred from soil to fluid when seawater is filtered through the aquifer, providing higher temperature source water to the seawater source heat pump (SWHP) system in winter. A 3-D coupled seepage and heat transfer model for studying beach well intake system is established by adopting the computer code FLUENT. Numerical results of this model are compared with the experimental results under the same conditions. Based on the experiment-verified coupled model, numerical simulation of the supply water tem-perature is studied over a heating season. Results show that the minimum temperature of supply water is 275.2 K when this intake system continuously provides seawater with flow rate of 35 m3/h to SWHP. Results also indicate that the supply water temperature is higher than seawater, and that the minimum temperature of supply water lags behind seawater, ensuring effective and reliable operation of SWHP.

Development of Instantaneous Hot Water Dispenser Based on Water Source Heat Pump

Natural energy use is important to reduce the energy consumption of buildings. However, further reducing energy consumption with traditional systems is difficult. Therefore, we proposed a MMHP （multi-source and multi-use heat pump） to achieve higher efficiency than traditional systems. The MMHP system connects multiple heat sources such as solar heat, the ground, and air and multiple heat uses such as cooling, heating, and a hot water dispenser with a water loop. Each type of heat use side can utilize heat efficiently. However, there is a distinct lack of highly efficient hot water dispensers available. Therefore, we developed the IHWD WS （instantaneous hot water dispenser based on a water source） heat pump. In this study, we developed a prototype of the IHWD WS heat pump. The coefficient of performance of the IHWD WS heat pump was 5.2-8.5 throughout a year. When it is improved, COP （coefficient of performance） is expected to be 9.3-9.9.

Transient Exergy Analysis of the Condenser and Evaporator of an Air Source Heat Pump Water Heater

In this study the performance of an ASHPWH （air source heat pump water heater） is assessed from exergy point of view in component wise. In order to investigate the work potential of energy, the destruction on the exergy is analyzed and results are summarized for the components individually. The exergy destruction of the system is studied by considering real paths of the pressure and temperature data which are collected during the experiments of the ASHPWH under varying environmental conditions. In the following step, the evolution of the exergy destruction of the system is calculated by a code which is compiled on MATLAB along these temperature and pressure paths. The obtained results reveal the importance of the transient exergy analysis by providing detailed information about exergy destruction of the system such as where it drives up and reaches up to its max and where it drops down and evolves on a smooth path.

Utilisation of Geothermal Heat Pumps within Permeable Pavements for Sustainable Energy and Water Practices

Geothermal heat pumps （GHPs） are an attractive proposition for renewable energy worldwide as it uses energy naturally stored in the earth. The Earth is a very resourceful form of energy, using the natural solar energy collection and heat storage capabilities as an infinite heat source/heat sink at the base of permeable pavements, which can provide excellent temperature gradients for GHP＇s. Experimental rigs were setup up at The University of Edinbttrgh for a combined permeable pavement and GHP system. At the base of a pavement structure （approximately 1 meter） below the ground＇s surface, temperatures are constant of 10℃ in the U.K all year round. The GHP performance efficiency was analysed by the coefficient of performance （COP） in a heating cycle and the energy efficiency ratio （EER） in a cooling cycle. The mean COP and EER for both systems averaged between 2-4.5 and 3-5 respectively. The combined GHP and pavement structure operated at an optimum efficiency for both heating and cooling cycles and has shown to be unaffected by higher summer or lower winter temperatures. This hybrid system is an attractive renewable energy technology and has additional environmental benefits such as urban runoff reuse and recycling.

Analytical Evaluation of the Energy Losses of an Air Source Heat Pump Water Heater： A Retrofit Type

ASHP （air source heat pump） water heater is a renewable and energy efficient device used for sanitary hot water production. The system comprises of a storage tank and heat pump connected by pipes. These major units can either be compact as in the integrated model or split as in the retro-fit model. In this research, the analysis of energy losses was performed using SIRAC （the Southern African refrigeration and air conditioning） residential split type heat pump of 1.2 kW input power to retrofit a 200 liter high pressure kwikhot storage tank without hot water being drawn off for the entire monitoring period. Likewise to experimentally determine the losses DAS （data acquisition system） was designed and built to measure Ta （ambient temperature; RH-relative humidity）, RH, To （ASHP outlet water temperature）, Ti （ASHP inlet water temperature） and Vh. （volume of water heated by ASHP unit）.The results showed that the heat energy gain to compensate standby losses could range from 1.8 kWh to 2.1 kWh with the corresponding electrical energy used by ASHP water heater ranging from 0.55 kWh to 0.66 kWh. The standby losses depend primarily on the Vh, the Ta and the RH while the influence of （To - Ti） is secondary. The results can be of valuable interest to manufacturer of retrofit ASHP unit for hot water production when matching the electrical energy required to compensate for the standby losses.

Performance analysis of air-water dual source heat pump water heater with heat recovery

A new air-water dual source heat pump water heater with heat recovery is proposed.The heat pump system can heat water by using a single air source,a single water source,or air-water dual sources.The water is first pre-heated by waste hot water,then heated by the heat pump.Waste heat is recovered by first preheating the cold water and as water source of the heat pump.According to the correlated formulas of the coefficient of performance of air-source heat pump and water-source heat pump,and the gain coefficient of heat recovery-preheater,the formulas for the coefficient of performance of heat pump in six operating modes are obtained by using the dimensionless correspondence analysis method.The system characteristics of heat absorption and release associated with the heat recovery-preheater are analyzed at different working conditions.The developed approaches can provide reference for the optimization of the operating modes and parameters.The results of analysis and experiments show that the coefficient of performance of the device can reach 4-5.5 in winter,twice as much as air source heat pump water heater.The utilization of waste heat in the proposed system is higher than that in the system which only uses waste water to preheating or as heat source.Thus,the effect of energy saving of the new system is obvious.On the other hand,the dimensionless correspondence analysis method is introduced to performance analysis of the heat pump,which also has theoretical significance and practical value.