水发集团创新国企混改与治理模式

水发集团混合所有制改革不仅实现了自身高质高效发展,也探索总结出可供学习借鉴的国企混改基本路径和方法。党的十九大以来,混合所有制改革激发国有企业活力,有力促进国企做强做优做大,同时也暴露出一些企业“重混轻改”“只投不管”“只管不放”等问题。水发集团有限公司(简称水发集团)创新公司治理、市场运营、激励约束、监管四大机制。

THE VARIATION OF EVAPORATION OVER SOUTH CHINA AND ITS RELATIONSHIPS TO PRECIPITATION

The evaporation rate over South China is estimated based on the Climate Prediction Center Merged Analysis of Precipitation(CMAP)data and the NCEP/DOE reanalysis II data from 1979 to 2007. The temporal variation of evaporation over South China and its relationship to precipitation are discussed. Climatologically,the evaporation rate over South China is the largest in July and smallest in March.In spring and summer,the evaporation rate is approximately one half of the precipitation rate.However,the evaporation rate is approximately equal to the precipitation rate in fall and winter.The year-to-year variation of the evaporation rate over South China is quite in phase with that of the precipitation rate in the period from February to May but out of phase with that of the precipitation rate in early winter.Over South China there is a pronounced decreasing trend in the evaporation in colder seasons and a positive correlation between the evaporation variation and the rainfall variation in spring.In summer,the abnormality of rainfall over South China is closely related to the anomalous evaporation over the northeastern part of the South China Sea and its eastern vicinity.In winter,the rainfall variation in South China has a close linkage with the evaporation variation in a belt area covering the eastern Arabian Sea,the Bay of Bengal,the southeastern periphery of the Plateau,the southern part of South China Sea and the central part of Indonesia.

Exploring heating performance of gas engine heat pump with heat recovery

In order to evaluate the heating performance of gas engine heat pump（GEHP） for air-conditioning and hot water supply, a test facility was developed and experiments were performed over a wide range of engine speed（1400-2600 r/min）, ambient air temperature（2.4-17.8 ℃） and condenser water inlet temperature（30-50℃）. The results show that as engine speed increases from 1400 r/min to 2600 r/min, the total heating capacity and energy consumption increase by about 30% and 89%, respectively; while the heat pump coefficient of performance（COP） and system primary energy ratio（PER） decrease by 44% and 31%, respectively. With the increase of ambient air temperature from 2.4 ℃ to 17.8 ℃, the heat pump COP and system PER increase by 32% and 19%, respectively. Moreover, the heat pump COP and system PER decrease by 27% and 15%, respectively, when the condenser water inlet temperature changes from 30 ℃ to 50 ℃. So, it is obvious that the effect of engine speed on the performance is more significant than the effects of ambient air temperature and condenser water inlet temperature.

Can Hydro-Priming Improve Germination Speed, Vigour and Emergence of Maize Landraces under Water Stress？

We evaluated whether hydro-priming could improve vigour characteristics and seedling emergence of local maize （Zea mays L.） landraces compared to two commercial hybrids under water stress at the University of KwaZulu-Natal, Pietermaritzburg. Seeds from local landraces were produced and characterized according to kernel colour, white （Land A） and purple （Land B）, and compared to two hybrids, SC701 and SR52, which are popular amongst local farmers. Seeds from each variety were soaked in water for 0 hours （unprimed or control）, 12 hours and 24 hours, and germinated in a germination chamber at 25 ℃ for 8 days. Parameters measured included final germination, mean germination time （MGT） and germination velocity index （GVI）. Seedling emergence was performed in seedling trays, using pine bark wetted to 25% or 75% of field capacity （FC）, for 21 days in a temperature-controlled glasshouse （25 ℃day; 15 ℃night; 60% RH）. Parameters measured included final emergence, mean emergence time （MET）, root and shoot lengths, and leaf area. Priming landraces for 12 and 24 hours reduced MGT by 9% and 7%, respectively, compared to 5% in hybrids for both 12 and 24 hours priming. GVI of landraces was improved by 40% following 12 hours of priming. GVI of hybrids was 11% and 7% slower than landraces after priming seeds for 12 and 24 hours, respectively. Priming seeds for 24 hours improved emergence at 25% FC. Priming seeds for 24 hours reduced MET for all varieties. Priming seeds for 12 and 24 hours increased leaf area by 33.8% and 29%, respectively. Hydro-priming seeds for 12 and 24 hours, respectively, improved GVI, reduced MGT and improved emergence and MET of maize landraces under water stress. Performance of hybrid seeds remains superior to that of landraces even after seed treatment to improve germination and vigour. The positive response of landraces to seed treatment, and improved performance under water stress conditions, suggest that there is a need to identify genes for vigour in landrace maize.

Molecular cloning and function analysis of insulin-like growth factorbinding protein 1a in blunt snout bream(Megalobrama amblycephala)

Insulin-like growth factor-binding protein 1 （IGFBP-1）, a hypoxia-induced protein, is a member of the IGFBP family that regulates vertebrate growth and development. In this study, full-length IGFBP-la cDNA was cloned from a hypoxia-sensitive Cyprinidae fish species, the blunt snout bream （Megalobrama arnblycephala）. IGFBP-la was expressed in various organs of adult blunt snout bream, including strongly in the liver and weakly in the gonads. Under hypoxia, IGFBP-la mRNA levels increased sharply in the skin, liver, kidney, spleen, intestine and heart tissues of juvenile blunt snout bream, but recovered to normal levels after 24-hour exposure to normal dissolved oxygen. In blunt snout bream embryos, IGFBP-la mRNA was expressed at very low levels at both four and eight hours post-fertilization, and strongly at later stages. Embryonic growth and development rates decreased significantly in embryos injected with IGFBP-la mRNA. The average body length of IGFBP-la-overexpressed embryos was 82.4% of that of the control group, and somite numbers decreased to 85.2%. These findings suggest that hypoxia-induced IGFBP-la may inhibit growth in this species under hypoxic conditions.

Clinical course of sub-centimeter-sized nodules detected during surveillance for hepatocellular carcinoma

AIM: To evaluate the outcome of sub-centimeter-sized nodules (SCSNs) detected during surveillance for hepatocellular carcinoma (HCC) in patients at risk. METHODS: We retrospectively analyzed a total of 142 patients with liver cirrhosis or chronic hepatitis B or C without a prior history of HCC in whom a SCSN was detected during HCC surveillance. We calculated the rate of HCC development from SCSNs in the study population and analyzed the differences in the baseline clinical characteristics and imaging features between the patients with SCSNs that eventually developed into HCC and patients with SCSNs that did not develop into HCC.RESULTS: During 667 person-years of follow-up, HCC developed in 33 patients. The calculated HCC development rate was 4.9% per year. The cumulative one-, two-, three- and five-year HCC development rates were 5.6%, 10.6%, 14.1% and 20.4%, respectively. Upon baseline comparison, the HCC group was older (54.4 ± 8.3 years vs 48.9 ± 9.4 years; P = 0.003) and had lower albumin levels (3.56 ± 0.58 g/dL vs 3.84 ± 0.55 g/dL; P = 0.012) and higher baseline alpha-fetoprotein (AFP) levels (8.5 ng/mL vs 5.4 ng/mL; P = 0.035) compared to the non-HCC group. Nodule pattern and initial radiologic diagnosis also differed between the two groups. Multivariate analysis revealed that age [P = 0.012, odds ratio (OR) =1.075, 95% confidence interval (CI) =1.016-1.137], sex (P = 0.009, OR = 3.969, 95% CI: 1.403-11.226), and baseline AFP level (P = 0.024, OR = 1.039, 95% CI: 1.005-1.073) were independent risk factors for developing HCC. CONCLUSION: The overall risk of HCC development in patients with SCSNs is similar to that in liver cirrhosis patients. Patients with these risk factors need to be closely monitored during follow-up.

Pressure drop of the film-enlarged tube bundles in air-water two-phase cross flow in evaporative air cooler

An experiment was carried out to investigate the relation of the maximum velocity of air passing through narrowest passage, mass flux of spray water in one square meter in one hour and the pressure drop of tube bundles. Twelve equations were obtained for the relation. The results show that the pressure drop of the tube bundles increases with increase of the maximum velocity of air and the mass flux of spray water. Comparing the pressure drop of the bare tube bundles with that of the film-enhanced tube bundles, it is found that the pressure drop of the film-enhanced tube bundles is lower about 11% and the surface roughness of the film-enhanced plates is a main factor that influences the pressure drop. The data and method obtained in the paper can be used to compute the pressure drop of the film-enhanced tube bundles and is helpful for selection of fan.

Advance Electronic Load Controller for Micro Hydro Power Plant

Most of the MHP （micro hydro power） plants use ELC （electronic load controller） for speed control. Various types of ELC have been developed so far. A dummy ballast load is connected across each phase of generator terminals and ELC controls the power consumed by the ballast load to result in constant speed operation. The ELC developed so far uses thyristor switches in each phase to control ballast load power. The ELC senses the system frequency and comparing it with reference frequency, it generates a common value of firing angle for all three thyristor pairs of each phase. The performance of such ELC is not perfect for unbalanced consumers load connected in each phase, which overloads the generator. This paper presents an advanced type of ELC which senses frequency as well as consumer＇s load current of each phase and fires the thyristor pairs with different value of firing angles for different phases. This solves the problem of overloading of the generator with unbalanced consumer＇s load. Simutink model is developed to perform transient analysis of the proposed scheme and the prototype of hardware is also fabricated. The simulation results and experimental results are presented.