水平管气-液两相变质量流的均相流模型

与常规管中气-液两相流动不同,水平管气-液两相变质量流动存在沿程管壁入流。在水平管单相变质量流动试验研究的基础上,考虑了管壁入流对管壁摩阻系数的影响,提出了孔缝管管壁摩阻系数相关式。将气-液两相混合物看作均匀介质,使水平管气-液两相变质量流的均相流模型的基本模型等同于单相变质量流的流动模型,重点研究了气-液两相变质量流均相流模型中流动参数的混合规则,提出了新的气-液两相粘度混合规则。对气-液两相变质量流的均相流模型进行了试验验证,研究结果表明,气-液两相变质量流的均相流模型预测结果可以满足工程计算精度的要求。

水平管气液两相环状流小破口泄漏相分离预测

多相流体通过管壁破口会发生相分离,导致泄漏流体的气液相比例与主管出现差异。为预测水平管环状流泄漏相分离特性,综合考虑了周向液膜分布不均匀影响,建立了不同方位破口相分离特性预测模型。在气液两相流实验环道上进行了泄漏特性实验研究,测量了环状流型下与管底部周向夹角分别为0°、45°、90°的破口泄漏的相分离特性,实验段直径为40 mm,破口为圆孔直径2.5 mm。结果表明,泄漏的气、液相流量与相应的主管气液相流量的比值主要由自破口处的气液相分布决定。在实验范围内模型预测结果与实验值吻合良好。

An Experimental Study on the Flow Characteristics of OilWater Two-Phase Flow in Horizontal Straight Pipes

The flow patterns and their transitions of oil-water two-phase flow in horizontal pipes were studied. The experiments were conducted in two kinds of horizontal tubes, made of plexiglas pipe and stainless steel pipe with 40 mm ID respectively. No. 46 mechanical oil and tap water were used as working fluids. The superflcial velocity ranges of oil and water were: 0.04-1.2m·s-1 and 0.04-2.2m·s-1, respectively. The flow patterns were identified by visualization and by transient fluctuation signals of differential pressure drop. The flow patterns were defined according to the relative distribution of oil and water phases in the pipes. Flow pattern maps were obtained for both pipelines. In addition, semi-theoretical transition criteria for the flow patterns were proposed, and the proposed transitional criteria are in reasonable agreement with available data in liquid-liquid systems.

Development of Liquid Slug Length in Gas-Liquid Slug Flow along Horizontal Pipeline: Experiment and Simulation

The liquid slug length distribution is crucial for designing the downstream processing system with mul-tiphase pipeline. Experiments were conducted in a 133m long horizontal test loop. The measurements were per-formed by conductivity probes to determine the liquid slug length distribution. The data covered both the slug and plug flow regimes. From experimental results, the mean liquid slug lengths were relatively insensitive to gas and liquid flow rates in the higher mixture velocity range. But in the lower mixture velocity range, the mean liquid slug length decreased and then increased with mixture velocity. It shows that the development length of slug flow was longer than x/D=1157. A slug tracking model was adapted to study the evolution of liquid slug length distribution in a horizontal pipeline. In the present model, the wake effect of elongated bubble and the pressure drop due to accel-eration are taken into account and random slug lengths are introduced at the entrance. The results of the model are compared with the measured slug length distributions of slug flow regime. It shows that the predicted mean and maximum slug lengths are in agreement with the experimental data at x/D=1157 and the form of the slug length distributions is also predicted well by the model.

Local Measurement of Gas-Liquid Bubbly Flow with a Double-Sensor Probe

A double-sensor probe was used to measure local interfacial parameters of a gas-liquid bubbly flow in a horizontal tube. The parameters included void fraction, interfacial concentration, bubble size distribution, bubble frequency and bubble interface velocity. The authors paid special attention to the probe design and construction for minimizing measurement errors. Measures were also taken in the design of sensor ends for preventing corrosions in the flow. This is an effort to improve the current double-sensor probe technique to meet the ever-increasing needs to local parameter measurements in gas-liquid two-phase flows.

A Hydrodynamic Modei for Slug Frequency in Horizontal Gas-Liquid Two-Phase Flow

The prediction of slug frequency has important significance on gas-liquid two-phase flow. A hydrody-namic modei was put forward to evaluate slug frequency for horizontal two-phase flow, based on the dependence of slug frequency on the frequency of unstable interfacial wave. Using air and water, experimental verification of the modei was carried out in a large range of flow parameters. Six electrical probes were installed at different positions of a horizontal plexiglass pipe to detect slug frequency development. The pipe is 30m long and its inner diameter is 24 mm. It is observed experimentally that the interfacial wave frequency at the inlet is about l to 3 times the frequency of stable slug. The slug frequencies predicted by the modei fit well with Tronconi (1990) modei and the experimental data. The combination of the hydrodynamic modei and the experimental data results in a conclusion that the frequency of equilibrium liquid slug is approximately half the miniraum frequency of interfacial wave.

Local Flow Regime Transition Criteria of Gas-Liquid Two-phase Flow in Vertical Upward Tube with a Horizontal Rod

The upward multiphase cross flow and heat transfer in the vertical tube may occur in oil production and chemical facilities. In this study, the local flow patterns of an upward gas-water two phase cross flow in a vertical tube with a horizontal rod have been investigated with an optical probe and the digital high speed video system. The local flow patterns are defined as the bubble, slug, churn and annular flow patterns. Optical probe signals are ana- lyzed in terms of probability density function, and it is proved that the local flow patterns can be recognized by this method. The transition mechanisms between the different flow patterns have been analyzed and the corresponding transitional models are proposed. Finally, local flow pattern maps of the upward gas-water two-phase flow in the vertical tube with a horizontal rod are constructed.

Experimental Acoustic Determination of the Void Fraction in Two-Phase Flow in Horizontal Pipelines

In multi-phase flows, the phases can flow and arranged in different spatial configurations in the pipe, which called flow patterns. This type of flow is found in the oil, chemical and nuclear industries. For example, in the production and transport of oil and gas, the identification of the flow patterns are essential for answering those questions which are related to the economic return of the field, such as, measuring the volumetric flow, determining the pressure drop along the flow lines, production management and supervision. In offshore production, these factors are very important. This paper presents a new method for measuring the void fraction in horizontal pipelines, taking the air as gas in water-air two-phase flow. Through acoustic analysis of the frequency response of the pipe, the method gets the parameters to changes in runoff regime, in an experimental arrangement constructed on a small scale. The main advantages are the non-intrusive characteristic and easy to implement. The paper is composed of a qualitative experimental evaluation and transducers （microphone） which are used to analyze variations in the response accompanying variations in void and flow pattern changes. Changes are imposed and controlled by a two-phase flow experimental simulation rig, including a measurement cell constituted of an external casing that can isolate the measurement from the environmental background noise fitted with acoustic pressure transducers radially arranged, and the impact of a monitored excitation mechanism. The signals which captured by the microphones are processed and analyzed by checking their frequency contents changes according to the amount of air in the mixture.