This paper describes pure water making equipment by using applicable datebase, computer languages and drawing software. It gives a general introduction to the systematic designing plan, the division of the different...This paper describes pure water making equipment by using applicable datebase, computer languages and drawing software. It gives a general introduction to the systematic designing plan, the division of the different parts and their functions, and the pure water making technological process.展开更多
A low-power-consumption 9bit 10MS/s pipeline ADC,used in a CMOS image sensor,is proposed. In the design, the decrease of power consumption is achieved by applying low-power-consumption and large-output-swing amplifier...A low-power-consumption 9bit 10MS/s pipeline ADC,used in a CMOS image sensor,is proposed. In the design, the decrease of power consumption is achieved by applying low-power-consumption and large-output-swing amplifiers with gain boost structure, and biasing all the cells with the same voltage bias source, which requires careful layout design and large capacitors. In addition,capacitor array DAC is also applied to reduce power consumption,and low threshold voltage MOS transistors are used to achieve a large signal processing range. The ADC was implemented in a 0.18μm 4M-1 P CMOS process,and the experimental results indicate that it consumes only 7mW, which is much less than general pipeline ADCs. The ADC was used in a 300000 pixels CMOS image sensor.展开更多
A model to derive direct runoff hydrograph for an ungauged basin using the physical properties of the basin is presented. The basin is divided into grid cells and canal elements. Overland flow is generated from each g...A model to derive direct runoff hydrograph for an ungauged basin using the physical properties of the basin is presented. The basin is divided into grid cells and canal elements. Overland flow is generated from each grid cell of the basin by application of continuous effective rainfall of I mm/hr to the basin, The flow generated is routed through downstream grid cells and the canal elements using the kinematic wave approach. The travel time for direct runoff from each grid cell to the basin outlet is calculated and the S-curve is derived for the basin. The S-curve is used to derive the unit hydrograph of a given duration for the basin. The model, referred as Cell-basin model was applied to the Upper Kotmale Basin in Sri Lanka and the model predictions of direct runoff hydrographs for rainfall events agreed with the observations to a reasonable accuracy. Comparison of the unit hydrographs obtained from the model and from the conventional Snyder＇s synthetic unit hydrograph using regionalized parameters assuming the basin as an ungauged basin, with the unit hydrograph derived from the observations showed that the model predicted unit hydrograph was more suitable than that obtained by Snyder＇s method for Sri Lankan up country basins. Thus, the present model is a useful tool to obtain direct runoff hydrograph for ungauged basins.展开更多
Based on the new algorithm for GIS image pixel topographic factors in remote sensing monitoring ofsoil losses, a software was developed for microcomputer to carry out computation at a medium river basin(county). This ...Based on the new algorithm for GIS image pixel topographic factors in remote sensing monitoring ofsoil losses, a software was developed for microcomputer to carry out computation at a medium river basin(county). This paper lays its emphasis on algorithmic skills and programming techniques as well as applicationof the software.展开更多
This study aims to figure out satellite imaging mechanisms for submerged sand ridges in the shallow water region in the case of the flow parallel to the topography corrugation.Solving the disturbance governing equatio...This study aims to figure out satellite imaging mechanisms for submerged sand ridges in the shallow water region in the case of the flow parallel to the topography corrugation.Solving the disturbance governing equations of the shear-flow yields the analytical solutions of the secondary circulation.The solutions indicate that a flow with a parabolic horizontal velocity shear and a sinusoidal vertical velocity shear will induce a pair of vortexes with opposite signs distributed symmetrically on the two sides of central line of a rectangular canal.In the case of the presence of surface Ekman layer with the direction of Ekman current opposite to(coincident with) the mean flow,the two vortexes converge(diverge) at the central line of canal in the upper layer and form a surface current convergent(divergent) zone along the central line of the canal.In the case of the absence of surface Ekman layer,there is no convergent(divergent) zone formed over the sea surface.The theoretical results are applied to interpretations of three convergent cases,one divergent case and statistics of 27 cases of satellite observations in the submerged sand ridge region of the Liaodong Shoal in the Bohai Sea.We found that the long,finger-like,bright patterns on SAR images are corresponding to the locations of the canals(or tidal channels) formed by two adjacent sand ridges rather than the sand ridges themselves.展开更多
In order to quickly explore the quality of cut-off wall in dams, a new method of high-density seismic image was adopted and estimated by model and in-situ wall tests.The vibration exciter was employed and several para...In order to quickly explore the quality of cut-off wall in dams, a new method of high-density seismic image was adopted and estimated by model and in-situ wall tests.The vibration exciter was employed and several parameters such as hypocentral distance, length of signal record and sampling space in signal collection were determined, which are 8 m, 0.25 ms and 128 ms respectively. Through time and frequency field signal analyses, it is concluded that, the smaller arrival times of reflected longitudinal and surface waves, and the higher their main frequencies, the higher the strength of the wall, vice versa. Accordingly the construction quality of the wall can be evaluated quickly by high-density seismic image.展开更多
The turbulent wakes behind trailing edge are analyzed for understanding of the flow mechanisms responsible for the generation of trailing edge noise. The TILS （turbulence integral length scale） of the turbulent wake...The turbulent wakes behind trailing edge are analyzed for understanding of the flow mechanisms responsible for the generation of trailing edge noise. The TILS （turbulence integral length scale） of the turbulent wake of hydrofoil with blunt trailing edge is calculated from TR-PIV （time-resolved particle image velocimetry） data. The temporal auto-correlation method based on Taylor hypothesis and spatial correlation method are used to get the TILS information of the turbulent wake of hydrofoil, respectively The comparison of results by two methods indicates that the spatial correlation method is independent on Taylor hypothesis and suitable to strong turbulence and non-isotropic turbulence.展开更多
Noise and mismatch are important error sources in pipeline ADCs,so careful calculation and system simulation are carried out using Matlab software. To reduce power consumption while not lose performance, the amplifier...Noise and mismatch are important error sources in pipeline ADCs,so careful calculation and system simulation are carried out using Matlab software. To reduce power consumption while not lose performance, the amplifiers with the same structure are biased with one bias circuit, and a cascode compensation is adopted. A 10bit 50MS/s pipeline ADC, which can be used in CMOS image sensor systems with large pixel array,is designed and tested by using 0.35tzm 4M-2P CMOS process. According to test results, power consumption is only 42mW and SINAD is 45.69dB when sampling frequency is 50MHz. A balance between performance and power consumption is achieved.展开更多
文摘This paper describes pure water making equipment by using applicable datebase, computer languages and drawing software. It gives a general introduction to the systematic designing plan, the division of the different parts and their functions, and the pure water making technological process.
文摘A low-power-consumption 9bit 10MS/s pipeline ADC,used in a CMOS image sensor,is proposed. In the design, the decrease of power consumption is achieved by applying low-power-consumption and large-output-swing amplifiers with gain boost structure, and biasing all the cells with the same voltage bias source, which requires careful layout design and large capacitors. In addition,capacitor array DAC is also applied to reduce power consumption,and low threshold voltage MOS transistors are used to achieve a large signal processing range. The ADC was implemented in a 0.18μm 4M-1 P CMOS process,and the experimental results indicate that it consumes only 7mW, which is much less than general pipeline ADCs. The ADC was used in a 300000 pixels CMOS image sensor.
文摘A model to derive direct runoff hydrograph for an ungauged basin using the physical properties of the basin is presented. The basin is divided into grid cells and canal elements. Overland flow is generated from each grid cell of the basin by application of continuous effective rainfall of I mm/hr to the basin, The flow generated is routed through downstream grid cells and the canal elements using the kinematic wave approach. The travel time for direct runoff from each grid cell to the basin outlet is calculated and the S-curve is derived for the basin. The S-curve is used to derive the unit hydrograph of a given duration for the basin. The model, referred as Cell-basin model was applied to the Upper Kotmale Basin in Sri Lanka and the model predictions of direct runoff hydrographs for rainfall events agreed with the observations to a reasonable accuracy. Comparison of the unit hydrographs obtained from the model and from the conventional Snyder＇s synthetic unit hydrograph using regionalized parameters assuming the basin as an ungauged basin, with the unit hydrograph derived from the observations showed that the model predicted unit hydrograph was more suitable than that obtained by Snyder＇s method for Sri Lankan up country basins. Thus, the present model is a useful tool to obtain direct runoff hydrograph for ungauged basins.
文摘Based on the new algorithm for GIS image pixel topographic factors in remote sensing monitoring ofsoil losses, a software was developed for microcomputer to carry out computation at a medium river basin(county). This paper lays its emphasis on algorithmic skills and programming techniques as well as applicationof the software.
基金supported by Academician Foundation of China (for Yuan and Zheng)Shanghai Science and Technology Committee Program - Special for EXPO under Grant No.10DZ0581600 and Grant SHUES2011A07 from Shanghai Institute of Urban Ecology and Sustainability(for Zhao)+1 种基金partially supported by US National Sci-ence Foundation Award 0962107 (for Zheng and Liu)Award 1061998 (for Zheng)
文摘This study aims to figure out satellite imaging mechanisms for submerged sand ridges in the shallow water region in the case of the flow parallel to the topography corrugation.Solving the disturbance governing equations of the shear-flow yields the analytical solutions of the secondary circulation.The solutions indicate that a flow with a parabolic horizontal velocity shear and a sinusoidal vertical velocity shear will induce a pair of vortexes with opposite signs distributed symmetrically on the two sides of central line of a rectangular canal.In the case of the presence of surface Ekman layer with the direction of Ekman current opposite to(coincident with) the mean flow,the two vortexes converge(diverge) at the central line of canal in the upper layer and form a surface current convergent(divergent) zone along the central line of the canal.In the case of the absence of surface Ekman layer,there is no convergent(divergent) zone formed over the sea surface.The theoretical results are applied to interpretations of three convergent cases,one divergent case and statistics of 27 cases of satellite observations in the submerged sand ridge region of the Liaodong Shoal in the Bohai Sea.We found that the long,finger-like,bright patterns on SAR images are corresponding to the locations of the canals(or tidal channels) formed by two adjacent sand ridges rather than the sand ridges themselves.
文摘In order to quickly explore the quality of cut-off wall in dams, a new method of high-density seismic image was adopted and estimated by model and in-situ wall tests.The vibration exciter was employed and several parameters such as hypocentral distance, length of signal record and sampling space in signal collection were determined, which are 8 m, 0.25 ms and 128 ms respectively. Through time and frequency field signal analyses, it is concluded that, the smaller arrival times of reflected longitudinal and surface waves, and the higher their main frequencies, the higher the strength of the wall, vice versa. Accordingly the construction quality of the wall can be evaluated quickly by high-density seismic image.
文摘The turbulent wakes behind trailing edge are analyzed for understanding of the flow mechanisms responsible for the generation of trailing edge noise. The TILS （turbulence integral length scale） of the turbulent wake of hydrofoil with blunt trailing edge is calculated from TR-PIV （time-resolved particle image velocimetry） data. The temporal auto-correlation method based on Taylor hypothesis and spatial correlation method are used to get the TILS information of the turbulent wake of hydrofoil, respectively The comparison of results by two methods indicates that the spatial correlation method is independent on Taylor hypothesis and suitable to strong turbulence and non-isotropic turbulence.
文摘Noise and mismatch are important error sources in pipeline ADCs,so careful calculation and system simulation are carried out using Matlab software. To reduce power consumption while not lose performance, the amplifiers with the same structure are biased with one bias circuit, and a cascode compensation is adopted. A 10bit 50MS/s pipeline ADC, which can be used in CMOS image sensor systems with large pixel array,is designed and tested by using 0.35tzm 4M-2P CMOS process. According to test results, power consumption is only 42mW and SINAD is 45.69dB when sampling frequency is 50MHz. A balance between performance and power consumption is achieved.
