Seventy-nine strains of bioflocculant-producing bacteria were isolated from 3 activated sludge samples. Among them, strain MYC was found to have the highest and stable flocculating rate for both kaolin clay suspension...Seventy-nine strains of bioflocculant-producing bacteria were isolated from 3 activated sludge samples. Among them, strain MYC was found to have the highest and stable flocculating rate for both kaolin clay suspension and oil-field produced water. The bacterial strain was identified as Klebsiella sp. MYC according to its morphological and biochemical characteristics and 16SrDNA sequence. The optimal medium for bioflocculant production by this bacterial strain was composed of cane sugar 20 g L^-1, KH2PO4 2 g L^-1, K2HPO4 5 g L^- 1, （ NH4）2SO4 0.2 g L^-1, urea 0.5 g L^- 1 and yeast extract 0.5 g L^- 1, the initial pH being 5.5. When the suspension of kaolin clay was treated with0.5% of Klebsiella sp. MYC culture broth, the flocculating rate reached more than 90.0% in the presence of 500mg L^-1 CaCI2, while the flocculating rate for oil-field produced water was near 80.0% in a pH range of 7.0 - 9.0 with the separation of oil and suspended particles from the oil-field produced water under similar conditions. The environment-friendly nature of the bioflocculant and high flocculating rate of the strain make the bioflocculant produced by Klebsiella sp. MYC an attractive bioflocculant in oil-field produced water treatment.展开更多
The petroleum acids in crude oil were separated by extraction with column chromatogram and anion exchange resin. The separation effect and the related composition and structure of petroleum acids were obtained by usin...The petroleum acids in crude oil were separated by extraction with column chromatogram and anion exchange resin. The separation effect and the related composition and structure of petroleum acids were obtained by using IR (Infra-Red) spectra techniques. The separated petroleum acids can under special conditions react with methanol to form corresponding esters, which can be analyzed by CI (chemical ionization)-MS (mass spectrometry). The characteristic ion peaks m/z (M+15)+ of naphthenic acid esters combined with z-series formula CnH2n+zO2 of naphthenic acids can be used to classify naphthenic acids into fatty acids, mono-cyclic, bi-cyclic, tri-cyclic, and higher polycyclic acids. The analytical results can give the molecular weight and the carbon number distribution of petroleum acids contained in crude oil. The results of study indicate that this method is simple, rapid and easy in operation.展开更多
After conducting a lot of screening experiments the appropriate flocculating formulations for treating high-concentration wastewater discharged from a certain refinery were selected. The oil removal rate and COD remov...After conducting a lot of screening experiments the appropriate flocculating formulations for treating high-concentration wastewater discharged from a certain refinery were selected. The oil removal rate and COD removal achieved by these flocculating formulations were better than that achieved by the conventional compound formulation consisting of polyaluminium chloride(PAC) and polyacrylamide(PAA) . Addition of an oil/water separating agent to the formulation could improve its oil removal performance to facilitate the oil/water separation of the oil-in-water emulsion in the high-concentration wastewater along with improved adaptability of the formulation to the wastewater containing high concentration of pollutants. This flocculating agent has promising prospects for commercial application.展开更多
The aim of the present work is to remove heavy metals （copper, manganese, and zinc） from industrial wastewater of Baiji refinery using GAC （granular activated carbon）. The most important factors affecting adsorpti...The aim of the present work is to remove heavy metals （copper, manganese, and zinc） from industrial wastewater of Baiji refinery using GAC （granular activated carbon）. The most important factors affecting adsorption process have been studied, which are granular activated carbon thickness, H, inlet pollutant concentration, Cv, and liquid hourly space velocity, LHSV. All experiments were performed under constant temperature at 25℃ and pH = 7. The experimental apparatus was designed and constructed to enable controlling of the operating conditions. Employing five levels for each of H and LHSV and three levels for Co required 75 runs for each metal. Box-Wilson method was used to reduce the number of experiments to 15 for each metal. The results indicated that copper, manganese, and zinc can be completely removed from wastewater using activated carbon. However, breakthrough time for zinc is low. It is also shown that breakthrough time （TB） and exhaustion time （TE） are inversely proportional with pollutant concentration and LHSV （liquid hour space velocity） while it is directly proportional with the thickness of activated carbon column.展开更多
TOR （Tema oil refinery） is the only petroleum refinery in Ghana. To assess the quality of the wastewater, wastewater samples taken from three points of discharge into the treatment plant and the treated effluent wer...TOR （Tema oil refinery） is the only petroleum refinery in Ghana. To assess the quality of the wastewater, wastewater samples taken from three points of discharge into the treatment plant and the treated effluent were analyzed for physico-chemical characteristics. The levels of the pH, temperature, conductivity, COD （Chemical Oxygen Demand）, TDS （Total Dissolved Solids）, TSS （Total Suspended Solids） and phenol were assessed from January to June, 2011. The results obtained indicate varied levels of contaminants in both the untreated and treated wastewater. The average values of the treated effluent parameters analyzed were 38 ℃, 6,258 μs.cm-1, 314 mg-L-1, 115 mg.L-1, 2,689 mg-L-1 and 1 mg.L-1 for the temperature, conductivity, COD, TDS, TSS and phenol, respectively. The results suggest that both the raw wastewater and the treated effluent did not meet the discharge limit set by Ghana Environmental Protection Agency. Therefore, the treated effluent required additional treatment before it can be discharged into the environment. This suggests that the wastewater treatment plant of TOR is ineffective for the type of wastewater produced.展开更多
文摘Seventy-nine strains of bioflocculant-producing bacteria were isolated from 3 activated sludge samples. Among them, strain MYC was found to have the highest and stable flocculating rate for both kaolin clay suspension and oil-field produced water. The bacterial strain was identified as Klebsiella sp. MYC according to its morphological and biochemical characteristics and 16SrDNA sequence. The optimal medium for bioflocculant production by this bacterial strain was composed of cane sugar 20 g L^-1, KH2PO4 2 g L^-1, K2HPO4 5 g L^- 1, （ NH4）2SO4 0.2 g L^-1, urea 0.5 g L^- 1 and yeast extract 0.5 g L^- 1, the initial pH being 5.5. When the suspension of kaolin clay was treated with0.5% of Klebsiella sp. MYC culture broth, the flocculating rate reached more than 90.0% in the presence of 500mg L^-1 CaCI2, while the flocculating rate for oil-field produced water was near 80.0% in a pH range of 7.0 - 9.0 with the separation of oil and suspended particles from the oil-field produced water under similar conditions. The environment-friendly nature of the bioflocculant and high flocculating rate of the strain make the bioflocculant produced by Klebsiella sp. MYC an attractive bioflocculant in oil-field produced water treatment.
文摘The petroleum acids in crude oil were separated by extraction with column chromatogram and anion exchange resin. The separation effect and the related composition and structure of petroleum acids were obtained by using IR (Infra-Red) spectra techniques. The separated petroleum acids can under special conditions react with methanol to form corresponding esters, which can be analyzed by CI (chemical ionization)-MS (mass spectrometry). The characteristic ion peaks m/z (M+15)+ of naphthenic acid esters combined with z-series formula CnH2n+zO2 of naphthenic acids can be used to classify naphthenic acids into fatty acids, mono-cyclic, bi-cyclic, tri-cyclic, and higher polycyclic acids. The analytical results can give the molecular weight and the carbon number distribution of petroleum acids contained in crude oil. The results of study indicate that this method is simple, rapid and easy in operation.
文摘After conducting a lot of screening experiments the appropriate flocculating formulations for treating high-concentration wastewater discharged from a certain refinery were selected. The oil removal rate and COD removal achieved by these flocculating formulations were better than that achieved by the conventional compound formulation consisting of polyaluminium chloride(PAC) and polyacrylamide(PAA) . Addition of an oil/water separating agent to the formulation could improve its oil removal performance to facilitate the oil/water separation of the oil-in-water emulsion in the high-concentration wastewater along with improved adaptability of the formulation to the wastewater containing high concentration of pollutants. This flocculating agent has promising prospects for commercial application.
文摘The aim of the present work is to remove heavy metals （copper, manganese, and zinc） from industrial wastewater of Baiji refinery using GAC （granular activated carbon）. The most important factors affecting adsorption process have been studied, which are granular activated carbon thickness, H, inlet pollutant concentration, Cv, and liquid hourly space velocity, LHSV. All experiments were performed under constant temperature at 25℃ and pH = 7. The experimental apparatus was designed and constructed to enable controlling of the operating conditions. Employing five levels for each of H and LHSV and three levels for Co required 75 runs for each metal. Box-Wilson method was used to reduce the number of experiments to 15 for each metal. The results indicated that copper, manganese, and zinc can be completely removed from wastewater using activated carbon. However, breakthrough time for zinc is low. It is also shown that breakthrough time （TB） and exhaustion time （TE） are inversely proportional with pollutant concentration and LHSV （liquid hour space velocity） while it is directly proportional with the thickness of activated carbon column.
文摘TOR （Tema oil refinery） is the only petroleum refinery in Ghana. To assess the quality of the wastewater, wastewater samples taken from three points of discharge into the treatment plant and the treated effluent were analyzed for physico-chemical characteristics. The levels of the pH, temperature, conductivity, COD （Chemical Oxygen Demand）, TDS （Total Dissolved Solids）, TSS （Total Suspended Solids） and phenol were assessed from January to June, 2011. The results obtained indicate varied levels of contaminants in both the untreated and treated wastewater. The average values of the treated effluent parameters analyzed were 38 ℃, 6,258 μs.cm-1, 314 mg-L-1, 115 mg.L-1, 2,689 mg-L-1 and 1 mg.L-1 for the temperature, conductivity, COD, TDS, TSS and phenol, respectively. The results suggest that both the raw wastewater and the treated effluent did not meet the discharge limit set by Ghana Environmental Protection Agency. Therefore, the treated effluent required additional treatment before it can be discharged into the environment. This suggests that the wastewater treatment plant of TOR is ineffective for the type of wastewater produced.
