A new method for the voidage measurement of gas-oil two-phase flow was proposed.The voidage measurement was implemented by the identification of flow pattern and a flow pattern specific voidage measure- ment model.The...A new method for the voidage measurement of gas-oil two-phase flow was proposed.The voidage measurement was implemented by the identification of flow pattern and a flow pattern specific voidage measure- ment model.The flow pattern identification was achieved by combining the fuzzy pattern recognition technique and the crude cross-sectional image reconstructed by the simple back projection algorithm.The genetic algorithm and the partial least square method were applied to develop the voidage measurement models.Experimental results show that the proposed method is effective.It can overcome the influence of flow pattern on the voidage measure- ment,and also has the advantages of simplicity and speediness.展开更多
This paper presents the characteristics of a double helix capacitance sensor for measurement of the liquid holdup in horizontal oil–water two-phase flow. The finite element method is used to calculate the sensitivity...This paper presents the characteristics of a double helix capacitance sensor for measurement of the liquid holdup in horizontal oil–water two-phase flow. The finite element method is used to calculate the sensitivity field of the sensor in a pipe with 20 mm inner diameter and the effect of sensor geometry on the distribution of sensitivity field is presented. Then, a horizontal oil–water two-phase flow experiment is carried out to measure the response of the double helix capacitance sensor, in which a novel method is proposed to calibrate the liquid holdup based on three pairs of parallel-wire capacitance probes. The performance of the sensor is analyzed in terms of the flow structures detected by mini-conductance array probes.展开更多
Based on the conductance fluctuation signals measured from vertical upward oil-gas-water three-phase flow experiment, time frequency representation and surrogate data method were used to investigate dynamical characte...Based on the conductance fluctuation signals measured from vertical upward oil-gas-water three-phase flow experiment, time frequency representation and surrogate data method were used to investigate dynamical characteristics of oil-in-water type bubble and slug flows. The results indicate that oil-in-water type bubble flow will turn to deterministic motion with the increase of oil phase fraction f o and superficial gas velocity U sg under fixed flowrate of oil-water mixture Q mix . The dynamics of oil-in-water type slug flow becomes more complex with the increase of U sg under fixed flowrate of oil-water mixture. The change of f o leads to irregular influence on the dynamics of slug flow. These interesting findings suggest that the surrogate data method can be a faithful tool for characterizing dynamic characteristics of oil-in-water type bubble and slug flows.展开更多
Spray structure and atomization characteristics were investigated through a comparison of a porous and a shear coaxial injector. The porous injector shows better atomization performance than the shear coaxial injector...Spray structure and atomization characteristics were investigated through a comparison of a porous and a shear coaxial injector. The porous injector shows better atomization performance than the shear coaxial injector. To in- crease atomization performance and mixing efficiency of two-phase jets, a coaxial porous injector which can be applicable to liquid rocket combustors was designed and tested. The characteristics of atomization and spray from a porous and a shear coaxial injector were characterized by the momentum flux ratio. The breakup mechanism of the porous injector is governed by Taylor-Culick flow and axial shear forces. Momentum of injected gas flow through a porous material which is composed of sintered metal is radically transferred to the center of the liquid column, and then liquid column is effectively broken up. Although the shapes of spray from porous and shear co- axial jets were similar for various momentum ratio, spray structures such as spray angle and droplet sizes were different. As increasing the momentum flux ratio, SMD from the porous injector showed smaller value than the shear coaxial injector展开更多
基金Supported by the National lqatural Science Foundation of China (Nos.50576084 and 60532020).
文摘A new method for the voidage measurement of gas-oil two-phase flow was proposed.The voidage measurement was implemented by the identification of flow pattern and a flow pattern specific voidage measure- ment model.The flow pattern identification was achieved by combining the fuzzy pattern recognition technique and the crude cross-sectional image reconstructed by the simple back projection algorithm.The genetic algorithm and the partial least square method were applied to develop the voidage measurement models.Experimental results show that the proposed method is effective.It can overcome the influence of flow pattern on the voidage measure- ment,and also has the advantages of simplicity and speediness.
基金Supported by the National Natural Science Foundation of China(50974095,41174109,61104148)the National Science and Technology Major Projects(2011ZX05020-006)
文摘This paper presents the characteristics of a double helix capacitance sensor for measurement of the liquid holdup in horizontal oil–water two-phase flow. The finite element method is used to calculate the sensitivity field of the sensor in a pipe with 20 mm inner diameter and the effect of sensor geometry on the distribution of sensitivity field is presented. Then, a horizontal oil–water two-phase flow experiment is carried out to measure the response of the double helix capacitance sensor, in which a novel method is proposed to calibrate the liquid holdup based on three pairs of parallel-wire capacitance probes. The performance of the sensor is analyzed in terms of the flow structures detected by mini-conductance array probes.
基金Supported by the National Natural Science Foundation of China (50974095, 41174109)Gao Zhongke (高忠科) was also supported by the National Natural Science Foundation of China (61104148)+2 种基金the National Science and Technology Major Projects (2011ZX05020-006)Specialized Research Fund for the Doctoral Program of Higher Education of China(20110032120088)the Independent Innovation Foundation of Tianjin University
文摘Based on the conductance fluctuation signals measured from vertical upward oil-gas-water three-phase flow experiment, time frequency representation and surrogate data method were used to investigate dynamical characteristics of oil-in-water type bubble and slug flows. The results indicate that oil-in-water type bubble flow will turn to deterministic motion with the increase of oil phase fraction f o and superficial gas velocity U sg under fixed flowrate of oil-water mixture Q mix . The dynamics of oil-in-water type slug flow becomes more complex with the increase of U sg under fixed flowrate of oil-water mixture. The change of f o leads to irregular influence on the dynamics of slug flow. These interesting findings suggest that the surrogate data method can be a faithful tool for characterizing dynamic characteristics of oil-in-water type bubble and slug flows.
基金supported by the National Research Foundation of Korea(NRF)grant funded by the Korean Government(MEST)(NRF-2011-0015435 and NRF-2012M 1A3A3A02033146)
文摘Spray structure and atomization characteristics were investigated through a comparison of a porous and a shear coaxial injector. The porous injector shows better atomization performance than the shear coaxial injector. To in- crease atomization performance and mixing efficiency of two-phase jets, a coaxial porous injector which can be applicable to liquid rocket combustors was designed and tested. The characteristics of atomization and spray from a porous and a shear coaxial injector were characterized by the momentum flux ratio. The breakup mechanism of the porous injector is governed by Taylor-Culick flow and axial shear forces. Momentum of injected gas flow through a porous material which is composed of sintered metal is radically transferred to the center of the liquid column, and then liquid column is effectively broken up. Although the shapes of spray from porous and shear co- axial jets were similar for various momentum ratio, spray structures such as spray angle and droplet sizes were different. As increasing the momentum flux ratio, SMD from the porous injector showed smaller value than the shear coaxial injector