[Objective] The paper was to study the activity of tyrosinase,so as to provide reference for preventing browning of potatoes as well as fruits and vegetables containing tyrosinase.[Method] With potato as raw material ...[Objective] The paper was to study the activity of tyrosinase,so as to provide reference for preventing browning of potatoes as well as fruits and vegetables containing tyrosinase.[Method] With potato as raw material and Na2HPO4-HCl in buffer solution（pH=7.2）as system,spectrophotometer was used to measure the absorbance of potato extract at 480nm,the curve was established,and the activity of tyrosinase was obtained.[Result] The changes of data were little under the above conditions,and the stability of tyrosinase activity was high.[Conclusion] Using spectrophotometry to determine the tyrosinase activity in potato is simple with high accuracy.展开更多
利用华北地区地震活动性资料,建立了地震危险性计算的一致性模型。在此模型的基础上,得出了北京、天津、唐山和济南等7个城市未来2500年内地震的时空强度分布,并计算了2500年回复周期的地震动峰值加速度(PGA)。结果表明,唐山和太原的PG...利用华北地区地震活动性资料,建立了地震危险性计算的一致性模型。在此模型的基础上,得出了北京、天津、唐山和济南等7个城市未来2500年内地震的时空强度分布,并计算了2500年回复周期的地震动峰值加速度(PGA)。结果表明,唐山和太原的PGA最大(>0.2g),石家庄和北京次之(≈0.17g)。对华北地区2500年地震记录的正演计算结果表明,太原和唐山地区的潜在地震危险最有可能来源于震级在6.0～7.0、震中距离在12～15km的地震活动;而北京、天津和石家庄地区则可能来源于震级在5.5～6.0、震中距离在10km左右的地震活动。采用IBC(International Building Code)方法计算后的结果显示,太原、唐山等地区的PGA与2001年我国地震动峰值加速度值基本一致,与此地区的较高地震活动性特征相符。利用随机震源模型,还给出了影响此7个城市的最大地震记录的加速度、速度及位移时程曲线,这对本区工程建筑的抗震性设计以及对救援设施的选址等有重要作用。展开更多
Objective] Tyrosinase is a kind of polyphenol oxidase used widely, and the study of tyrosinase attracts extensive attention. [Method] ln this experiment, A conversion kinetic curve of dopa solution was obtained using ...Objective] Tyrosinase is a kind of polyphenol oxidase used widely, and the study of tyrosinase attracts extensive attention. [Method] ln this experiment, A conversion kinetic curve of dopa solution was obtained using absorbance of potato extract at 480 nm in Na2HPO4-HCl buffer system at a pH value of 7.2 with the vari-ation rate of absorbance against time （ΔA/Δt） as reaction rate, and the activity of tyrosinase could thus be calculated. [Result] The results showed that at the wave-length, in the Na2HPO4-HCl buffer system with a pH value at 7.2, there was little in-terference to the system, the data showed smal fluctuations, and the activity of ty-rosinase was high and stable, further providing a theoretical foundation for the de-termination and study of factors influencing tyrosinase activity. [Conclusion] The catalytic activity of tyrosinase was studied and determined with buffer solution as substrate with high accuracy and good effect.展开更多
The transverse section of piston skirt is not a standard circle and is with high precision. So the section curve should be interpolated through the high accuracy method of circular arc interpolation before NC machinin...The transverse section of piston skirt is not a standard circle and is with high precision. So the section curve should be interpolated through the high accuracy method of circular arc interpolation before NC machining. In order to smooth the connection of adjacent arcs and shorten the NC machining program, an interpolation method based on Chebyshev theory of function approximation is proposed here. According to the analysis of the interpolation error, the algorithm is simple and with high precision. By this way the fewest interpolating circular arc segments can be got, and the manufacture requirement is satisfied with the circular arc interpolating curves.展开更多
The magnetotelluric sounding method was used to study the active fault in Shenzhen city.Four magnetotelluric profiles with a dense station interval were laid out across the Shenzhen fault zone.The remote reference tec...The magnetotelluric sounding method was used to study the active fault in Shenzhen city.Four magnetotelluric profiles with a dense station interval were laid out across the Shenzhen fault zone.The remote reference technique was used in both data observation and processing to eliminate the electromagnetic noise near the survey sites,and relatively smooth apparent resistivity curves were obtained.TM mode data and two-dimensional inversion method as NLCG were used to obtain the electrical structures underground.According to the surficial geology survey results on regional strata and distribution of magmatic bodies and faults,the electrical structures at depths less than 2000m of each profile were interpreted.Two regional faults,the Henggang-Luohu fault and the Liantang fault,and seven local faults consistent with the electrical boundaries were verified or discovered.The strata in the survey area were then related with the change of resistivity.Electrical horizontal slices of depths less than 5000m indicate that the Henggang-Luohu fault and the Liantang fault bifurcate at the shallow part but tend to merge in the deep part.展开更多
Heat flow is inevitably accompanied by temperature change,thus,the water temperature coseismic response during earthquake activity should also obey the laws of thermodynamics.Taking the M S8.0 Wenchuan,Sichuan,China e...Heat flow is inevitably accompanied by temperature change,thus,the water temperature coseismic response during earthquake activity should also obey the laws of thermodynamics.Taking the M S8.0 Wenchuan,Sichuan,China earthquake and the M9.0Tohoku,Japan earthquake as an example,and based on the data of water temperature coseismic responses observed in well ZK26 in Haikou,Hainan Province,China,we investigate the relationship between well water temperature change and heat transfer in the coseismic response process and the relevant thermodynamic mechanism by using the numerical simulation method for thermodynamic equations.Then,through forward modeling,we obtain several simulation curves of water temperature change in response to earthquakes along the well depth at different times.The simulated curves of water temperature change approximately fit the observed curves.Consequently,based on the variation of temperature,we find that the modes of well water temperature coseismic response( ascending,descending or stable) are related to factors such as the location of sensors,distribution and location of heat sources,the span between sensors and heat sources.展开更多
文摘[Objective] The paper was to study the activity of tyrosinase,so as to provide reference for preventing browning of potatoes as well as fruits and vegetables containing tyrosinase.[Method] With potato as raw material and Na2HPO4-HCl in buffer solution（pH=7.2）as system,spectrophotometer was used to measure the absorbance of potato extract at 480nm,the curve was established,and the activity of tyrosinase was obtained.[Result] The changes of data were little under the above conditions,and the stability of tyrosinase activity was high.[Conclusion] Using spectrophotometry to determine the tyrosinase activity in potato is simple with high accuracy.
文摘利用华北地区地震活动性资料,建立了地震危险性计算的一致性模型。在此模型的基础上,得出了北京、天津、唐山和济南等7个城市未来2500年内地震的时空强度分布,并计算了2500年回复周期的地震动峰值加速度(PGA)。结果表明,唐山和太原的PGA最大(>0.2g),石家庄和北京次之(≈0.17g)。对华北地区2500年地震记录的正演计算结果表明,太原和唐山地区的潜在地震危险最有可能来源于震级在6.0～7.0、震中距离在12～15km的地震活动;而北京、天津和石家庄地区则可能来源于震级在5.5～6.0、震中距离在10km左右的地震活动。采用IBC(International Building Code)方法计算后的结果显示,太原、唐山等地区的PGA与2001年我国地震动峰值加速度值基本一致,与此地区的较高地震活动性特征相符。利用随机震源模型,还给出了影响此7个城市的最大地震记录的加速度、速度及位移时程曲线,这对本区工程建筑的抗震性设计以及对救援设施的选址等有重要作用。
文摘Objective] Tyrosinase is a kind of polyphenol oxidase used widely, and the study of tyrosinase attracts extensive attention. [Method] ln this experiment, A conversion kinetic curve of dopa solution was obtained using absorbance of potato extract at 480 nm in Na2HPO4-HCl buffer system at a pH value of 7.2 with the vari-ation rate of absorbance against time （ΔA/Δt） as reaction rate, and the activity of tyrosinase could thus be calculated. [Result] The results showed that at the wave-length, in the Na2HPO4-HCl buffer system with a pH value at 7.2, there was little in-terference to the system, the data showed smal fluctuations, and the activity of ty-rosinase was high and stable, further providing a theoretical foundation for the de-termination and study of factors influencing tyrosinase activity. [Conclusion] The catalytic activity of tyrosinase was studied and determined with buffer solution as substrate with high accuracy and good effect.
文摘The transverse section of piston skirt is not a standard circle and is with high precision. So the section curve should be interpolated through the high accuracy method of circular arc interpolation before NC machining. In order to smooth the connection of adjacent arcs and shorten the NC machining program, an interpolation method based on Chebyshev theory of function approximation is proposed here. According to the analysis of the interpolation error, the algorithm is simple and with high precision. By this way the fewest interpolating circular arc segments can be got, and the manufacture requirement is satisfied with the circular arc interpolating curves.
基金sponsored by the "Program for Active Fault Detection and Earthquake Risk Assessment in Shenzhen City",China
文摘The magnetotelluric sounding method was used to study the active fault in Shenzhen city.Four magnetotelluric profiles with a dense station interval were laid out across the Shenzhen fault zone.The remote reference technique was used in both data observation and processing to eliminate the electromagnetic noise near the survey sites,and relatively smooth apparent resistivity curves were obtained.TM mode data and two-dimensional inversion method as NLCG were used to obtain the electrical structures underground.According to the surficial geology survey results on regional strata and distribution of magmatic bodies and faults,the electrical structures at depths less than 2000m of each profile were interpreted.Two regional faults,the Henggang-Luohu fault and the Liantang fault,and seven local faults consistent with the electrical boundaries were verified or discovered.The strata in the survey area were then related with the change of resistivity.Electrical horizontal slices of depths less than 5000m indicate that the Henggang-Luohu fault and the Liantang fault bifurcate at the shallow part but tend to merge in the deep part.
基金sponsored by the Spark Program of 2011,China Earthquake Administration(XH1020)the Basic Research Program of the Hainan Province(ZDXM20110107)
文摘Heat flow is inevitably accompanied by temperature change,thus,the water temperature coseismic response during earthquake activity should also obey the laws of thermodynamics.Taking the M S8.0 Wenchuan,Sichuan,China earthquake and the M9.0Tohoku,Japan earthquake as an example,and based on the data of water temperature coseismic responses observed in well ZK26 in Haikou,Hainan Province,China,we investigate the relationship between well water temperature change and heat transfer in the coseismic response process and the relevant thermodynamic mechanism by using the numerical simulation method for thermodynamic equations.Then,through forward modeling,we obtain several simulation curves of water temperature change in response to earthquakes along the well depth at different times.The simulated curves of water temperature change approximately fit the observed curves.Consequently,based on the variation of temperature,we find that the modes of well water temperature coseismic response( ascending,descending or stable) are related to factors such as the location of sensors,distribution and location of heat sources,the span between sensors and heat sources.
