期刊文献+
共找到2篇文章
< 1 >
每页显示 20 50 100
Improved recovery of a low-grade refractory gold ore using flotation–preoxidation–cyanidation methods 被引量:7
1
作者 Faraz Soltani Hossna Darabi +1 位作者 Rezgar Badri Piroz Zamankhan 《International Journal of Mining Science and Technology》 SCIE EI 2014年第4期537-542,共6页
In this work, different flotation–preoxidation–cyanidation methods are considered for treating a lowgrade refractory gold ore. On the one hand, the results of selective flotation show that 22% and 31.1%of total Sb a... In this work, different flotation–preoxidation–cyanidation methods are considered for treating a lowgrade refractory gold ore. On the one hand, the results of selective flotation show that 22% and 31.1%of total Sb and As, respectively, remained in the final tailings and only about 28% of the total Au remained for further cyanidation processes. On the other hand, in bulk method of flotation the maximum Au recovery of 90.6% achieved after 60 min of flotation at the grind size with K80 of 146 micron. In addition, the bulk flotation method resulted in the concentrate with low concentrations of Sb and As elements. To improve the recovery of low-grade refractory gold ores, flotation should be followed by roasting, biological, or pressure oxidation processes so that the gold could be liberated prior to cyanidation processes. It is also found that the pressure oxidation pre-treatment of the concentrates prior to cyanidation may yield high gold recoveries of over than 83%. In these processes, recoveries are controlled by the temperature and the oxygen partial pressure in the solvent. However, by utilizing the bio-oxidation technique, the oxidation of sulfur to sulfate cannot be completed and, consequently, the gold recovery may be limited to only 72.2%. 展开更多
关键词 Low-grade refractory gold ore Pre-treating Flotation Pre-oxidation
下载PDF
某含铜难处理金矿提金试验 被引量:7
2
作者 袁喜振 孙春宝 +5 位作者 李绍英 赵留成 李根壮 邓祥意 张炜 郭林中 《有色金属(冶炼部分)》 CAS 北大核心 2014年第11期43-47,共5页
分别采用直接氰化法、浮选—氰化法和碘化法处理某含铜难处理金矿,并考察了搅拌强度、浸出时间和矿浆温度对碘化浸金效果的影响。结果表明,采用直接氰化法在氰化钠用量为10kg/t时,金浸出率为82%左右,铜浸出率为40%左右;利用浮选—氰化... 分别采用直接氰化法、浮选—氰化法和碘化法处理某含铜难处理金矿,并考察了搅拌强度、浸出时间和矿浆温度对碘化浸金效果的影响。结果表明,采用直接氰化法在氰化钠用量为10kg/t时,金浸出率为82%左右,铜浸出率为40%左右;利用浮选—氰化法得到的浮选精矿中金、铜品位分别为36.9g/t和4.69%,金、铜回收率分别为57.41%和62.35%,浮选精矿中砷品位达到4.2%,浮选尾矿氰化金的浸出率为65.96%;碘化试验中金浸出率达到85.3%,铜浸出率低于1%。碘化法比较适宜处理该金矿,其最佳工艺条件为:搅拌强度400r/min、浸出时间2h、矿浆温度298K。 展开更多
关键词 直接氰化法 浮选-氰化法 碘化法 难处理金矿 浸出率
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部