期刊文献+
共找到5篇文章
< 1 >
每页显示 20 50 100
基于白光LED的日光光谱拟合及混光设计 被引量:2
1
作者 于慧媛 孙文良 +4 位作者 吴江 王丽萍 曹冠英 张竞辉 邹念育 《大连工业大学学报》 CAS 北大核心 2018年第4期296-300,共5页
通过优化算法得到白光LED和31种单色LED的最优组合,用于模拟日光在380~780nm可见光范围内的光谱,并对最优组合进行混光设计。利用混光原理计算出最优组合中各种LED使用的颗数,合理设计LED位置及排列方式,借助光学模拟仿真软件进行类日... 通过优化算法得到白光LED和31种单色LED的最优组合,用于模拟日光在380~780nm可见光范围内的光谱,并对最优组合进行混光设计。利用混光原理计算出最优组合中各种LED使用的颗数,合理设计LED位置及排列方式,借助光学模拟仿真软件进行类日光光源的光学仿真。仿真结果表明,模拟日光光源色度学参数为色温5 665K,色坐标(0.328 7,0.342 0),显色指数95.3,设计的光源达到类日光光源效果。 展开更多
关键词 白光LED 日光光谱拟合 混光设计 类日光光源
下载PDF
基于LED的医用内窥镜照明系统设计 被引量:5
2
作者 周文光 王春飞 +2 位作者 毛坤剑 陈庆 孔悦 《医疗卫生装备》 CAS 2015年第8期26-28,38,共4页
目的:设计一种基于发光二极管(light emitting diode,LED)的医用内窥镜照明系统,解决传统弧光灯发光效率低、温升高、使用寿命短等不足。方法:以带脉冲宽度调制(pule width modulation,PWM)功能的AD型单片机为核心进行控制,采用特制的RG... 目的:设计一种基于发光二极管(light emitting diode,LED)的医用内窥镜照明系统,解决传统弧光灯发光效率低、温升高、使用寿命短等不足。方法:以带脉冲宽度调制(pule width modulation,PWM)功能的AD型单片机为核心进行控制,采用特制的RGB-LED混光合成白光的方法,通过光纤将合成后的光线传到内窥镜的前端对体内的组织器官进行照明。结果:将该照明系统通过光纤连接至内窥镜主机进行组织照明,光源显色指数高、效果好,可真实再现组织颜色。结论:该内窥镜照明系统发光效率高、功耗低、照明效果好,非常适用于内窥镜诊疗照明。 展开更多
关键词 医用内窥镜 照明系统 发光二极管 混光设计
下载PDF
Design of hybrid damping controller based on multi-target gravitational search optimization algorithm in a multi-machine power system with high penetration of PV park 被引量:1
3
作者 Y.Hashemi H.Shayeghi +1 位作者 M.Moradzadeh A.Safari 《Journal of Central South University》 SCIE EI CAS CSCD 2016年第5期1163-1175,共13页
A mathematical approach was proposed to investigate the impact of high penetration of large-scale photovoltaic park(LPP) on small-signal stability of a power network and design of hybrid controller for these units.A s... A mathematical approach was proposed to investigate the impact of high penetration of large-scale photovoltaic park(LPP) on small-signal stability of a power network and design of hybrid controller for these units.A systematic procedure was performed to obtain the complete model of a multi-machine power network including LPP.For damping of oscillations focusing on inter-area oscillatory modes,a hybrid controller for LPP was proposed.The performance of the suggested controller was tested using a 16-machine 5-area network.The results indicate that the proposed hybrid controller for LPP provides sufficient damping to the low-frequency modes of power system for a wide range of operating conditions.The method presented in this work effectively indentifies the impact of increased PV penetration and its controller on dynamic performance of multi-machine power network containing LPP.Simulation results demonstrate that the model presented can be used in designing of essential controllers for LPP. 展开更多
关键词 hybrid controller multi-objective optimization large-scale photovoltaic park small-signal scrutiny
下载PDF
Design and implementation of ethernet passive electronic network over coax
4
作者 黄晶 Liu Deming 《High Technology Letters》 EI CAS 2013年第3期290-294,共5页
To increase the limit of ethernet over coax (EoC) technology in the bidirectional reform of the hybrid fiber coaxial (HFC) network, an ethernet passive electronic network (EPEN) system based on Coax is proposed ... To increase the limit of ethernet over coax (EoC) technology in the bidirectional reform of the hybrid fiber coaxial (HFC) network, an ethernet passive electronic network (EPEN) system based on Coax is proposed and experimentally demonstrated in this paper. The proposed EPEN exploits the existing capabilities of the MAC layer in the ethernet passive optical network (EPON) for reduction of cost of the HFC network. As the MPCP (multi-point control protocol) is introduced in the EPEN, bandwidth control and higher efficiency can be achieved. The experimental results exhibit the throughput of system up to 100Mbps, which meet the requirements of HFC network. To improve the performance of EPEN, frequency division multiplexing (FDM) can be used for further increase of the throughput and more hardware processing modules in the future. can be implemented to enhance the capacity 展开更多
关键词 ethernet over coax EoC ethernet passive electronic network EPEN) ethernetpassive optical network (EPON) multi-point control protocol (MPCP)
下载PDF
Design and Analysis of PV Hybrid System for Isolated Household Electrification 被引量:1
5
作者 B. Plangklang W. Subsingha S. Hiranvarodom 《Journal of Energy and Power Engineering》 2011年第1期63-69,共7页
This paper describes a design method and construction of a PV hybrid system for household electrification in remote area which has typical important electrical loads for daily life such as television, refrigerator, el... This paper describes a design method and construction of a PV hybrid system for household electrification in remote area which has typical important electrical loads for daily life such as television, refrigerator, electric fan, coffee maker, and radio. The paper presents the design method which is a short and correct method for the PV Hybrid system design. The result of the proposed design method is finally simulated by Homer software to optimize and prove the result. From the simulation, the output shows that the proposed method is proper for using to design the sizing of PV hybrid system. After the design, a PV hybrid system is constructed accordingly to the system design. A PV hybrid prototype is constructed as a small house which is specially constructed for demonstration of the proposed system. The PV hybrid system therefore has the size of PV 1.8 kWp, battery 20 kWh, and diesel generator 3 kW. After a long implementation of the system, the results of monitored data show that the designed PV hybrid system can deliver the power to the house continually 24 hours as it is originally designed. This can ensure that the proposed method of PV hybrid system design is correct and can be used for design the PV hybrid system for electrical utility in the remote area where has no an electric grid. 展开更多
关键词 PV Hybrid monitoring system homer simulation.
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部