Co-cracking is a process where the mixtures of different hydrocarbon feedstocks are cracked in a steam pyrolysis furnace, and widely adopted in chemical industries. In this work, the simulations of the co-cracking of ...Co-cracking is a process where the mixtures of different hydrocarbon feedstocks are cracked in a steam pyrolysis furnace, and widely adopted in chemical industries. In this work, the simulations of the co-cracking of ethane and propane, and LPG and naphtha mixtures have been conducted, and the software packages of COILSIM1 D and Sim CO are used to account for the cracking process in a tube reactor. The effects of the mixing ratio, coil outlet temperature, and pressure on cracking performance have been discussed in detail. The co-cracking of ethane and propane mixture leads to a lower profitability than the cracking of single ethane or single propane. For naphtha, cracking with LPG leads to a higher profitability than single cracking of naphtha, and more LPG can produce a higher profitability.展开更多
The buoyancy effect on micro hydrogen jet flames in still air was numerially studied.The results show that when the jet velocity is relatively large(V≥0.2 m/s),the flame height,width and temperature decrease,whereas ...The buoyancy effect on micro hydrogen jet flames in still air was numerially studied.The results show that when the jet velocity is relatively large(V≥0.2 m/s),the flame height,width and temperature decrease,whereas the peak OH mass fraction increases significantly under normal gravity(g=9.8 m/s^2).For a very low jet velocity(e.g.,V=0.1 m/s),both the peak OH mass fraction and flame temperature under g=9.8 m/s^2 are lower than the counterparts under g=0 m/s^2.Analysis reveals that when V≥0.2 m/s,fuel/air mixing will be promoted and combustion will be intensified due to radial flow caused by the buoyancy effect.However,the flame temperature will be slightly decreased owing to the large amount of entrainment of cold air into the reaction zone.For V=0.1 m/s,since the heat release rate is very low,the entrainment of cold air and fuel leakage from the rim of tube exit lead to a significant drop of flame temperature.Meanwhile,the heat loss rate from fuel to inner tube wall is larger under g=9.8 m/s^2 compared to that under g=0 m/s^2.Therefore,the buoyancy effect is overall negative at very low jet velocities.展开更多
With 1 185 pi eces of questionnaire, it is found that in China, people take fresh air, odor, e tc., as well as indoor air temperature, humidity, as the most important indoor a ir parameters. It is also found that ther...With 1 185 pi eces of questionnaire, it is found that in China, people take fresh air, odor, e tc., as well as indoor air temperature, humidity, as the most important indoor a ir parameters. It is also found that there is a significant sensitivity differen ce in indoor environment between southerners and northerners in China. People fr om different regions have different demands for their working and living environ ment. Therefore, as a good design of air conditioning system, it is strongly rec ommended that the different demands of people from different regions should be t aken into consideration.展开更多
Various data are used to investigate the characteristics of the surface wind field and rainfall on the East China Sea Kuroshio(ESK) in March and April, 2011. In March, the wind speed maximum shows over the ESK front(E...Various data are used to investigate the characteristics of the surface wind field and rainfall on the East China Sea Kuroshio(ESK) in March and April, 2011. In March, the wind speed maximum shows over the ESK front(ESKF) in the 10 meter wind field, which agrees with the thermal wind effect. A wind curl center is generated on the warm flank of the ESKF. The winds are much weaker in April, so is the wind curl. A rainband exists over the ESKF in both the months. The Weather Research and Forecasting(WRF) model is used for further researches. The winds on the top of the marine atmosphere boundary layer(MABL) indicate that in March, a positive wind curl is generated in the whole MABL over the warm flank of the ESKF. The thermal wind effect forced by the strong SST gradient overlying the background wind leads to strong surface northeasterly winds on the ESKF, and a positive shearing vorticity is created over the warm flank of the ESKF to generate wind curl. In the smoothed sea surface temperature experiment, the presence of the ESKF is responsible for the strong northeast winds in the ESKF, and essential for the distribution of the rainfall centers in March, which confirms the mechanism above. The same simulation is made for April, 2011, and the responses from the MABL become weak. The low background wind speed weakens the effect of the thermal wind, thus no strong Ekman pumping is helpful for precipitation. There is no big difference in rainfall between the control run and the smooth SST run. Decomposition of the wind vector shows that local wind acceleration induced by the thermal wind effect along with the variations in wind direction is responsible for the pronounced wind curl/divergence over the ESKF.展开更多
High-purity straight and discrete multiwalled boron nitride nanotubes （BNNTs） were grown via a boron oxide vapor reaction with ammonia using LiNO3 as a promoter. Only a trace amount of boron oxide was detected as an...High-purity straight and discrete multiwalled boron nitride nanotubes （BNNTs） were grown via a boron oxide vapor reaction with ammonia using LiNO3 as a promoter. Only a trace amount of boron oxide was detected as an impurity in the BNNTs by energy-dispersive X-ray （EDX） and Raman spectroscopies. Boron oxide vapor was generated from a mixture of B, FeO, and MgO powders heated to 1,150 ℃, and it was transported to the reaction zone by flowing ammonia. Lithium nitrate was applied to the upper side of a BN bar from a water solution. The bar was placed along a temperature gradient zone in a horizontal tubular furnace. BNNTs with average diameters of 30-50 nm were mostly observed in a temperature range of 1,280-1,320 ℃. At higher temperatures, curled polycrystalline BN fibers appeared. Above 1,320 ℃, the number of BNNTs drastically decreased, whereas the quantity and diameter of the fibers increased. The mechanism of BNNT and fiber growth is proposed and discussed.展开更多
基金Supported by the National Natural Science Foundation of China(21276078)Shanghai Key Technologies R&D Programe(12dz1125100)+1 种基金Natural Science Foundation of Shanghai(13ZR1411300)Shanghai Leading Academic Discipline Project(B504)
文摘Co-cracking is a process where the mixtures of different hydrocarbon feedstocks are cracked in a steam pyrolysis furnace, and widely adopted in chemical industries. In this work, the simulations of the co-cracking of ethane and propane, and LPG and naphtha mixtures have been conducted, and the software packages of COILSIM1 D and Sim CO are used to account for the cracking process in a tube reactor. The effects of the mixing ratio, coil outlet temperature, and pressure on cracking performance have been discussed in detail. The co-cracking of ethane and propane mixture leads to a lower profitability than the cracking of single ethane or single propane. For naphtha, cracking with LPG leads to a higher profitability than single cracking of naphtha, and more LPG can produce a higher profitability.
基金Project(51576084)supported by the National Natural Science Foundation of China。
文摘The buoyancy effect on micro hydrogen jet flames in still air was numerially studied.The results show that when the jet velocity is relatively large(V≥0.2 m/s),the flame height,width and temperature decrease,whereas the peak OH mass fraction increases significantly under normal gravity(g=9.8 m/s^2).For a very low jet velocity(e.g.,V=0.1 m/s),both the peak OH mass fraction and flame temperature under g=9.8 m/s^2 are lower than the counterparts under g=0 m/s^2.Analysis reveals that when V≥0.2 m/s,fuel/air mixing will be promoted and combustion will be intensified due to radial flow caused by the buoyancy effect.However,the flame temperature will be slightly decreased owing to the large amount of entrainment of cold air into the reaction zone.For V=0.1 m/s,since the heat release rate is very low,the entrainment of cold air and fuel leakage from the rim of tube exit lead to a significant drop of flame temperature.Meanwhile,the heat loss rate from fuel to inner tube wall is larger under g=9.8 m/s^2 compared to that under g=0 m/s^2.Therefore,the buoyancy effect is overall negative at very low jet velocities.
文摘With 1 185 pi eces of questionnaire, it is found that in China, people take fresh air, odor, e tc., as well as indoor air temperature, humidity, as the most important indoor a ir parameters. It is also found that there is a significant sensitivity differen ce in indoor environment between southerners and northerners in China. People fr om different regions have different demands for their working and living environ ment. Therefore, as a good design of air conditioning system, it is strongly rec ommended that the different demands of people from different regions should be t aken into consideration.
文摘Various data are used to investigate the characteristics of the surface wind field and rainfall on the East China Sea Kuroshio(ESK) in March and April, 2011. In March, the wind speed maximum shows over the ESK front(ESKF) in the 10 meter wind field, which agrees with the thermal wind effect. A wind curl center is generated on the warm flank of the ESKF. The winds are much weaker in April, so is the wind curl. A rainband exists over the ESKF in both the months. The Weather Research and Forecasting(WRF) model is used for further researches. The winds on the top of the marine atmosphere boundary layer(MABL) indicate that in March, a positive wind curl is generated in the whole MABL over the warm flank of the ESKF. The thermal wind effect forced by the strong SST gradient overlying the background wind leads to strong surface northeasterly winds on the ESKF, and a positive shearing vorticity is created over the warm flank of the ESKF to generate wind curl. In the smoothed sea surface temperature experiment, the presence of the ESKF is responsible for the strong northeast winds in the ESKF, and essential for the distribution of the rainfall centers in March, which confirms the mechanism above. The same simulation is made for April, 2011, and the responses from the MABL become weak. The low background wind speed weakens the effect of the thermal wind, thus no strong Ekman pumping is helpful for precipitation. There is no big difference in rainfall between the control run and the smooth SST run. Decomposition of the wind vector shows that local wind acceleration induced by the thermal wind effect along with the variations in wind direction is responsible for the pronounced wind curl/divergence over the ESKF.
文摘High-purity straight and discrete multiwalled boron nitride nanotubes （BNNTs） were grown via a boron oxide vapor reaction with ammonia using LiNO3 as a promoter. Only a trace amount of boron oxide was detected as an impurity in the BNNTs by energy-dispersive X-ray （EDX） and Raman spectroscopies. Boron oxide vapor was generated from a mixture of B, FeO, and MgO powders heated to 1,150 ℃, and it was transported to the reaction zone by flowing ammonia. Lithium nitrate was applied to the upper side of a BN bar from a water solution. The bar was placed along a temperature gradient zone in a horizontal tubular furnace. BNNTs with average diameters of 30-50 nm were mostly observed in a temperature range of 1,280-1,320 ℃. At higher temperatures, curled polycrystalline BN fibers appeared. Above 1,320 ℃, the number of BNNTs drastically decreased, whereas the quantity and diameter of the fibers increased. The mechanism of BNNT and fiber growth is proposed and discussed.
