In order to investigate the effect of variation in the distribution of gas on explosion propagation characteristics in coal mines, experiments were carried out in two different channels with variation in gas concentra...In order to investigate the effect of variation in the distribution of gas on explosion propagation characteristics in coal mines, experiments were carried out in two different channels with variation in gas concentration and geometry. Flame and pressure transducers were used to track the explosion front velocity. The flame speed (Sf) showed a slight downward trend while the methane concentration varied from 10% to 3% in the experimental channel. The peak overpressure (Pmax) dropped dramatically when compared with normal conditions. As well, the values of Pmax and Sf decreased when the methane concentration dropped from 8% to 6%. The flame speed in the channel, connected to a cylinder with a length varying from 0.5 to 2 m, was greater than that in the normal channel. The peak overpressure was also higher than that under normal conditions because of a higher flame speed and stronger pressure piling up. The values of Pmax and Sf increased with an increase in cylinder length. The research results indicate that damage caused by explosions can be reduced by decreasing the gas concentration, which should be immediately detected in roadways with large cross-sections because of the possibility of greater destruction caused by more serious explosions.展开更多
A numerical study of the counterflow diffusion flames of methane/air at both subcritical and supercritical pressures,which have very important applications in the air-breathing rocket and advanced gas turbine engines,...A numerical study of the counterflow diffusion flames of methane/air at both subcritical and supercritical pressures,which have very important applications in the air-breathing rocket and advanced gas turbine engines,is conducted to obtain fundamental understanding of the flame characteristics.The analysis is based on a general mathematical formulation and accommodates a unified treatment of general fluids thermodynamics and accurate calculations of thermophysical properties.Results reveal that the maximum flame temperature occurs on the fuel-rich side for low-pressure conditions and shifts toward the stoichiometric position when the pressure increases.The maximum flame temperature increases with an increasing pressure,but decreases with an increasing strain rate.The flame width is inversely proportional to the square root of the product of the pressure and strain rate as■■1 p·a2/1.The total heat release rate varies with the pressure and strain rate in a relationship of Q release ■(p·a)0.518.An increased pressure leads to a slightly more complete combustion process near the stoichiometric position,but its effect on NO production is minor.Under the test conditions,variations of the strain rate have significant impacts on the formation of major pollutants.An increased strain rate leads to the decreased mole fraction of CO in the fuel-rich region and significantly reduced NO near the stoichiometric position.展开更多
Soot prediction in a combustion system has become a subject of attention, as many factors influence its accuracy. An accurate temperature prediction will likely yield better soot predictions, since the inception, grow...Soot prediction in a combustion system has become a subject of attention, as many factors influence its accuracy. An accurate temperature prediction will likely yield better soot predictions, since the inception, growth and de- struction of the soot are affected by the temperature. This paper reported the study on the influences of turbulence closure and surface growth models on the prediction of soot levels in turbulent flames. The results demonstrated that a substantial distinction was observed in terms of temperature predictions derived using the k-c and the Rey- nolds stress models, for the two ethylene flames studied here amongst the four types of surface growth rate model investigated, the assumption of the soot surface growth rate proportional to the particle number density, but inde- pendent on the surface area of soot particles,f（As） = pNs, yields in closest agreement with the radial data. Without any adjustment to the constants in the surface growth term, other approaches where the surface growth directly proportional to the surface area and square root of surface area, f （As） = As and f （A,） = √As, result in an un- der-prediction of soot volume fraction. These results suggest that predictions of soot volume fraction are sensitive to the modelling of surface growth.展开更多
Premixed and partially premixed flames (PPFs) of H2/CO/air syngas are studied numerically to investigate the effect of pressure on syngas PPF structure. Chemical characteristics of the syngas flame at different pressu...Premixed and partially premixed flames (PPFs) of H2/CO/air syngas are studied numerically to investigate the effect of pressure on syngas PPF structure. Chemical characteristics of the syngas flame at different pressures are investigated based on reaction limit analysis using a one-dimensional configuration. The results show that CO affects the syngas reaction limits through both physical effects that consist mainly in dilution and chemical effects that are related to both R23 (CO+OH=CO2+H) and HCO pathway. In particular, the HCO pathway weakens the flame at low pressures due to the chain-terminating effect of R25 (HCO+O2=CO+HO2) and R26 (HCO+H=CO+H2), and enhances the flame at high pressures because of the contribution of R25 to the HO2chain-branching process. These CO chemical characteristics are also observed in the premixed zone of 50%H2+50%CO syngas PPFs whereas only R23 is important in the non-premixed zone.展开更多
基金provided by the National Natural Science Foundation of China (No.50574093)the Key Program of the National Nature Science of China (No.50534090)+2 种基金the National Basic Research and Development Program of China (No.2005CB221506)the National Science Foundation for Young Scholars of China (No.50804048)the National Key Technology Research and Development Program (Nos.2006BAK03B04 and 2007 BAK29B01)
文摘In order to investigate the effect of variation in the distribution of gas on explosion propagation characteristics in coal mines, experiments were carried out in two different channels with variation in gas concentration and geometry. Flame and pressure transducers were used to track the explosion front velocity. The flame speed (Sf) showed a slight downward trend while the methane concentration varied from 10% to 3% in the experimental channel. The peak overpressure (Pmax) dropped dramatically when compared with normal conditions. As well, the values of Pmax and Sf decreased when the methane concentration dropped from 8% to 6%. The flame speed in the channel, connected to a cylinder with a length varying from 0.5 to 2 m, was greater than that in the normal channel. The peak overpressure was also higher than that under normal conditions because of a higher flame speed and stronger pressure piling up. The values of Pmax and Sf increased with an increase in cylinder length. The research results indicate that damage caused by explosions can be reduced by decreasing the gas concentration, which should be immediately detected in roadways with large cross-sections because of the possibility of greater destruction caused by more serious explosions.
基金supported by the National Natural Science Foundation of China(Grant No.11372277)
文摘A numerical study of the counterflow diffusion flames of methane/air at both subcritical and supercritical pressures,which have very important applications in the air-breathing rocket and advanced gas turbine engines,is conducted to obtain fundamental understanding of the flame characteristics.The analysis is based on a general mathematical formulation and accommodates a unified treatment of general fluids thermodynamics and accurate calculations of thermophysical properties.Results reveal that the maximum flame temperature occurs on the fuel-rich side for low-pressure conditions and shifts toward the stoichiometric position when the pressure increases.The maximum flame temperature increases with an increasing pressure,but decreases with an increasing strain rate.The flame width is inversely proportional to the square root of the product of the pressure and strain rate as■■1 p·a2/1.The total heat release rate varies with the pressure and strain rate in a relationship of Q release ■(p·a)0.518.An increased pressure leads to a slightly more complete combustion process near the stoichiometric position,but its effect on NO production is minor.Under the test conditions,variations of the strain rate have significant impacts on the formation of major pollutants.An increased strain rate leads to the decreased mole fraction of CO in the fuel-rich region and significantly reduced NO near the stoichiometric position.
基金financeally supported by Syiah Kuala University,Banda Aceh,Indonesia described through H-Index Research Scheme,Contract No:1445/UN 11/SP/PNBP/2017
文摘Soot prediction in a combustion system has become a subject of attention, as many factors influence its accuracy. An accurate temperature prediction will likely yield better soot predictions, since the inception, growth and de- struction of the soot are affected by the temperature. This paper reported the study on the influences of turbulence closure and surface growth models on the prediction of soot levels in turbulent flames. The results demonstrated that a substantial distinction was observed in terms of temperature predictions derived using the k-c and the Rey- nolds stress models, for the two ethylene flames studied here amongst the four types of surface growth rate model investigated, the assumption of the soot surface growth rate proportional to the particle number density, but inde- pendent on the surface area of soot particles,f（As） = pNs, yields in closest agreement with the radial data. Without any adjustment to the constants in the surface growth term, other approaches where the surface growth directly proportional to the surface area and square root of surface area, f （As） = As and f （A,） = √As, result in an un- der-prediction of soot volume fraction. These results suggest that predictions of soot volume fraction are sensitive to the modelling of surface growth.
基金supported by the National Key Basic Research Program of China(2014CB239603)the National Natural Science Foundation of China(U1738113,91441131)
文摘Premixed and partially premixed flames (PPFs) of H2/CO/air syngas are studied numerically to investigate the effect of pressure on syngas PPF structure. Chemical characteristics of the syngas flame at different pressures are investigated based on reaction limit analysis using a one-dimensional configuration. The results show that CO affects the syngas reaction limits through both physical effects that consist mainly in dilution and chemical effects that are related to both R23 (CO+OH=CO2+H) and HCO pathway. In particular, the HCO pathway weakens the flame at low pressures due to the chain-terminating effect of R25 (HCO+O2=CO+HO2) and R26 (HCO+H=CO+H2), and enhances the flame at high pressures because of the contribution of R25 to the HO2chain-branching process. These CO chemical characteristics are also observed in the premixed zone of 50%H2+50%CO syngas PPFs whereas only R23 is important in the non-premixed zone.
