华北平原冬小麦生长期典型农田热、碳通量特征与过程模拟

以位山试验站典型农田为对象,利用位山站2005-10-10～2006-06-10日的实验观测数据,探讨了冬小麦整个生长期农田的热、碳通量特征,并运用SiB2(simple biosphere model Version2)模型对热、碳通量进行了模拟分析,结果表明,农田的热、碳通量在冬小麦生长过程中表现出明显的日变化,这些通量的最大值基本出现在正午前后;热、碳通量的日际变化也较明显,其中净辐射与潜热通量在冬小麦不同生长期表现为:越冬期<拔节抽穗期<灌浆成熟期;感热通量表现为:拔节抽穗期<灌浆成熟期<越冬期;而CO2通量为:越冬期<灌浆成熟期<拔节抽穗期.对以上通量及地表温度的模拟表明,SiB2模型能较好地模拟冬小麦生长期中农田热、碳通量及地表温度,净辐射、潜热通量、感热通量、CO2通量与地表温度的模拟值与观测值的一致性较好,线性相关系数R2分别达0.985、0.637、0.481、0.725、0.499与0.877,其中感热通量与CO2通量模拟偏差较大.另外,按冬小麦生长期分阶段对农田以上分量模拟结果表明,SiB2模型在冬小麦拔节抽穗期模拟效果最好,并发现模型对叶面积指数敏感.

Simulation of CO_2 and sensible/latent heat fluxes exchange between land surface and atmosphere over cropland and grassland in semi-arid region,China

A comparison between simulated land surface fluxes and observed eddy covariance （EC） measurements was conducted to validate Integrated Biosphere Simulator （IBIS） at Tongyu field observation station （44°25＇N, 122°52＇E） in Jilin Province, China. Results showed that the IBIS model could reproduce net ecosystem CO2 exchange （NEE）, sensible and latent heat fluxes reasonably, as indicated by correlation coefficients exceeding the significant level of 0.05. It was also evident that the NEE and sensible heat fluxes were characterized by diurnal and seasonal variation both in the grassland and the cropland ecosystems, while the latent heat fluxes correlated with evapotranspiration, only took on the diurnal variation during the growing season. Moreover, both sensible heat fluxes and the latent heat fluxes were larger in the cropland ecosystem than that in the degraded grassland ecosystem. This different characteristic was possibly correlated with vegetation growing situation in the two kinds of ecosystems. A close agreement between observation and simulation on NEE, sensible heat fluxes and latent heat flux was obtained both in the degraded grassland and the cropland ecosystems. In addition, the annual NEE in the model was overestimated by 23.21% at the grassland and 27.43% at the cropland, sensible heat flux with corresponding 9.90% and 11.98%, respectively, and the annual latent heat flux was underestimated by 4.63% and 3.48%, respectively.

Effects of continuous casting mould fluxes on reducing longitudinal and star cracks on a slab surface

In the continuous casting production of medium carbon steel (whose mass fraction of carbon is 0.09 % to 0.16 %) and high strength low alloy steel (whose mass fraction of Mn is 0.90 % to 1.40 %), flecks occurring the most often are usually longitudinal and star cracks. In additional to the employment of a galvanized plate mould, two kinds of fluxes with special properties were studied and used to harmonize the conflicts between the function of heat transfer and lubrication. An industrial application revealed that the crystallizing temperature (Tc) and crystal ratio (R) of fluxes have a crucible effect on impeding the occurrence of above defects on a slab surface. In the case of slab section (180 to 240) mm(1000 to 1400) mm and casting speed Vc of (0.7 to 1.2) m/min, the optimized parameters of fluxes are Tc of (1170 to 1190) ℃, R of 80 % to 95 % for medium carbon steel, and Tc of (1100 to 1150) ℃, plus R of 40 % to 60 % for high strength low alloy steel.

Deterioration in Heat Transfer of Endothermal Hydrocarbon Fuel

Numerical studies under supercritical pressure are carried out to study the heat transfer characteristics in a single-root coolant channel of the active regenerative cooling system of the scramjet engine, using actual physical properties of pentane. The relationships between wall temperature and inlet temperature, mass flow rate, wall heat flux, inlet pressure, as well as center stream temperature are obtained. The results suggest that the heat transfer deterioration occurs when the fuel temperature approaches the pseudo-critical temperature, and the wall temperature increases rapidly and heat transfer coefficient decreases sharply. The decrease of wall heat flux, as well as the increase of mass flow rate and inlet pressure makes the starting point of the heat transfer deterioration and the peak point of the wall temperature move backward. The wall temperature increment induced by heat transfer deterioration decreases, which could reduce the severity of the heat transfer deterioration. The relational expression of the heat transfer deterioration critical heat flux derives from the relationship of the mass flow rate and the inlet pressure.