纺织厂车间热湿分控设计法探讨

倡议把车间热湿负荷分开计算，在扩大送风功效的同时增设车间给湿系统，给车间空气加湿，热湿分控法能够减少空调工程投资，节省空调运行能耗和简化温湿度调节工作。

Some Trials of Typical Typhoon Tracks Using the Adjoint Method

In this paper, the adjoint method is applied to the statistical-dynamic model （SD-90） for the prediction of typhoon tracks along with the regularization thinking and optimal control techniques. The adjoint model and the gradient of objective function are deduced with the continual model respectively. For 4 typical typhoons, the forces and the initial velocity can be retrieved well, and the tracks of these typhoons are accurately fitted for an appropriate regularization parameter and optimal control parameter.

Morphology Control of Anatase TiO2 by Surfactant-assisted Hydrothermal Method

By hydrolysing titanium isopropoxide in a long hydrocarbon chain surfactant-containing solution, TiO2 fine particles with a diversity of well-defined morphologies was synthesized in this study by a hydrothermal route. The structural change during the formation process was monitored by scanning electron microscopy, transmission electron microscopy and X-ray diffraction analysis. TiO2 with various morphologies such as particle, sheet, rod, tube and flower-like shape was obtained by carefully controlling the preparation conditions. The experimental results show that the pH value is crucial for shape control of the produced TiO2 because it can change the charge state of the surfactant in the solution and the adsorption potential of the surfactant on the TiO2 surface. The shape evolvement of anatase TiO2 was elucidated by quenching the reaction at different stage and the formation mechanism of different shaped TiO2 was suggested.

Morphology-controlled synthesis and photocatalytic properties of K_(1.9)Na_(0.1)Ta_2O_6·2H_2O

The controllable synthesis of tantalate K1.9Na0.1Ta2O6·2H2O has been successfully achieved by a two-step technique,namely,the molten salt and hydrothermal methods,at a low temperature. By simply varying the KOH concentration in the hydrothermal process,K1.9Na0.1Ta2O6·2H2O particles with spherical,cuboctahedral,and durian-like morphologies were synthesized. The photocatalytic activity of the obtained samples for the degradation of rhodamine B was studied under ultraviolet light,which indicates that the photocatalytic properties of the samples are highly dependent on their morphologies. The K1.9Na0.1Ta2O6·2H2O nanospheres,with rough surfaces and the highest specific surface area,exhibit the best performance. The present work provides a unique approach for the controlled synthesis of tantalate photocatalysts,which are difficult to achieve through other synthetic approaches.

Numerical simulation and model of control-efficiency of thermal crown of work rolls in cold rolling

Aiming at accuracy control of the thermal crown of work rolls in cold rolling,new parameters such as regulation domain and control-efficiency factors were proposed and a numerical analysis model of the thermal crown of work rolls was established using finite difference method to study roll's thermal deformation.Based on simulation results,the influences of control-efficiency factors on thermal crown are presented and the thermal crown of work rolls is analyzed after taking sub-cooling of sprinkling beam into consideration.It has been found that the control-efficiency factor of any position on the roll's surface is linear function of the temperature and the control ability of water temperature is stronger than other control parameters.In addition,the verification of the model has been carried out based on the producing technology data in some factories and the numerical simulation results coincide well with the experimental data.Therefore,this work has important value for on-line control of roll's crown in cold rolling.

Work Boilers in the Real Heat Loads

Analysis was performed on the boiler for solid fuels in a corresponding real-thermal load. The tests were conducted with the use of a low-temperature top-loading KWSM water boiler. For control of the burning process, three control algorithms were used as implemented in microprocessor temperature controls. The analysis aimed at determination of influence of the control algorithm upon quality of the buming process in conditions of actual demand for thermal energy. The detailed analysis of operating parameters in relation to the variable thermal load of the boiler provided necessary information and made it possible to state that control algorithms do influence quality of the controlled process. Particular attention was paid to a situation, in which demand for thermal energy is decreased.

高γ′含量高温合金整体细晶叶盘铸造凝固行为和组织特征模拟研究

使用ProCAST软件模拟热控法细晶整体叶盘的铸造,将传统的Udimet720Li变形高温合金作为整体叶盘铸造材料,模拟整体叶盘的凝固过程、孔隙率分布、应力分布和晶粒生长情况,研究该高γ′含量高温合金用于细晶整体叶盘铸造的凝固行为和组织特征。整体叶盘的凝固始于叶片尖端,结束于冒口中心位置。整体叶盘的主体区域孔隙率为1.5%~3%,凝固过程中由于缩松偏聚,部分区域会形成孔隙率相对较大的区域。确立评估该材料整体叶盘铸件孔隙缺陷的安全阈值为13 (K·s)^(1/2)/cm,用于评估铸造工艺参数的可行性。整体叶盘各位置的最大切应力、有效塑性应变和热裂指数均为0,但在叶片尖端和边缘棱角区域存在有效应力大于1200 MPa的应力集中现象。整体叶盘平均晶粒尺寸为0.88 mm,满足热控法应达到的水平,但热控法不易控制晶粒度的均匀性,更应该结合动力学方法,提高晶粒度的均匀性。

Thermal control system of Alpha Magnetic Spectrometer

Since its installation on the International Space Station(ISS)in mid-May 2011,the Alpha Magnetic Spectrometer(AMS)has spent over two years on orbit,fully operational,collecting an enormous amount of data including the temperatures from the on-board 1118 sensors for thermal control.A large database is continuously updated and analyzed to understand the thermal behavior of the experiment in the space environment and its interaction with the ISS.This paper specifies the design,building,analysis and testing of the thermal control system and its various components for an overview of the AMS thermal control system and its space environment.Also given are some examples of analysis and correlation of the space environmental and ISS parameters with the thermal behaviors of various AMS components.

Controllable hydrothermal synthesis of nanocrystal TiO_2 particles and their use in dye-sensitized solar cells

A simple method for the controllable hydrothermal synthesis of nanocrystalline anatase TiO2(nc-TiO2) particles involving the selection of suitable organic alkali peptizing agents is reported.A dye-sensitized solar cell(DSSC) with square-like nc-TiO2 particles with side lengths about 8-13 nm-prepared using tetraethylammonium hydroxide(TEAOH)-in the photoelectrode showed higher photovoltaic performance than two other DSSCs with square-like nc-TiO2 particles with side lengths about 7-10 nm-prepared using tetrabutylammonium hydroxide-or elongated nc-TiO2 particles with lengths about 18-35 nm and width about 10 18 nm-prepared using tetramethylammonium hydroxide(TMAOH)-in the photoelectrodes.When a scattering layer prepared from sub-micron size spheres or cone-like nc-TiO2 particles-synthesized using a higher concentration of TMAOH-was added on top of the photoelectrode fabricated from nc-TiO2 synthesized with TEAOH,the energy conversion efficiency of the DSSC was markedly increased from 6.77% to 8.18%.

Design of adiabatic two's complement multiplier-accumulator based on CTGAL

We propose a new design scheme for a Booth encoder based on clocked transmission gate adiabatic logic(CTGAL). In the new design the structural complexity of the Booth encoder is reduced while the speed of the multiplier is improved. The adiabatic two's complement multiplier-accumulator(MAC) is furthermore a design based on the CTGAL. The computer simulation results indicate that the designed circuit has the correct logic function and remarkably less energy consumption compared to that of the MAC based on complementary metal oxide semiconductor(CMOS) logic.

Polymorph and anisotropic Raman spectroscopy of Phz-Hca cocrystals

The nucleation and growth mechanism and polymorph-property correlations in the molecular cocrystal field are widely sought but currently remain unclear. Herein, a new wire-like morphology of phenazine(Phz)-chloranilic acid(H2ca) cocrystal(PHC) is demonstrated for the first time, and the self-assembly of Phz and H2ca is controlled to selectively prepare kinetically stable wires and thermodynamically stable plates. Specifically, low precursor concentration is beneficial for one-dimensional(1D) self-assembly along the [010] crystallographic direction, while only supersaturation can trigger 2D self-assembly along the [100] and [010] directions, respectively. This is understandable in terms of the(020) face showing the largest attachment energy(Eatt) and the(002) face possessing the smallest surface energy(Esurf). Moreover, anisotropic Raman spectra related to the mode symmetry and atomic displacements in two types of PHCs are revealed, and the same Raman-active vibrational bands of PHC wire and plate show different polarization responses, which is intrinsically ascribed to their different molecular orientations.Overall, this is the first case that morphologies of cocrystal are precisely tuned with comprehensive investigations of their anisotropic vibrational characteristics.