以ABS/PC塑料板为试验材料,采用DIN EN ISO 2039—1:2003《塑料硬度测定第一部分:球压痕法》中规定的方法,测试塑料板球压痕硬度值;依据JJF 1059.1—2012《测量不确定度评定与表示》,建立数学模型及对不确定度来源量化分析,对ABS/PC塑...以ABS/PC塑料板为试验材料,采用DIN EN ISO 2039—1:2003《塑料硬度测定第一部分:球压痕法》中规定的方法,测试塑料板球压痕硬度值;依据JJF 1059.1—2012《测量不确定度评定与表示》,建立数学模型及对不确定度来源量化分析,对ABS/PC塑料板球压痕硬度测量结果进行了评定。ABS/PC塑料板测定结果为H=121 N/mm^(2),其中扩展不确定度为3.3 N/mm^(2),该不确定度主要来源于重复性测量。展开更多
Under the premise of fully respecting current national standard of table tennis ball,this paper presents an integrated and effective method for testing diameter,roundness and hardness of table tennis ball based on vis...Under the premise of fully respecting current national standard of table tennis ball,this paper presents an integrated and effective method for testing diameter,roundness and hardness of table tennis ball based on vision measurement. Firstly,camera calibration is performed by 40 mm gauge block to capture the images of table tennis ball in static and pressed state in an appropriate lighting condition. Then image binarization and extraction of image contour are carried out. The least square method is used to fit its center. Finally,the diameter,roundness and hardness are calculated. The measurement data are analyzed by using the method presented in this paper for table tennis ball with known parameter data and with unknown parameter data. Experimental results show that this method can improve measurement accuracy and provide a technical basis for the online testing and integration measurement of table tennis ball.展开更多
Objective Both decreased glomemlar filtration rate （GFR） and arterial stiffness were considered as risk factors for atherosclerosis. Previous studies have suggested the association between central arterial stiffness...Objective Both decreased glomemlar filtration rate （GFR） and arterial stiffness were considered as risk factors for atherosclerosis. Previous studies have suggested the association between central arterial stiffness and the degree of GFR loss. Whether decreased GFR contributes to peripheral artery stiffness remains controversial. Moreover, data analyzed from a cohort of Chinese women are rare. Our aim was to explore the relationship between GFR and regional arterial stiffness in Chinese women. Methods In this cross-sectional study, we randomly recruited 1131 adult women residents with GFR 〉 60 mL/min per 1.73 m2 estimated by the Chinese Modification of Diet in Renal Disease equation from three large communities. Central and peripheral arterial stiffness were estimated simultaneously by measuring carotid-femoral pulse wave velocity （PWVcf） and carotid-radial PWV （PWVcr） using a validated automatic device. Augmentation Index at heart rate 75 beats/minutes （AIx-75） was measured by pulse wave analysis as a composite parameter reflecting both large and distal arterial properties. Results The mean estimated GFR （eGFR） of the study group was 100.05 ＋ 23.26 mL/minute per 1.73 m2. Subjects were grouped by tertiles of eGFR level. PWVef and AIx-75 increased ongoing from the top to the bottom eGFR tertile, while the values of PWVcr were comparable. Both univariate Pearson correlations and multiple stepwise regression analyses showed that eGFR significantly correlated to PWVcf, but not to PWVcr and AJx-75. Conclusions In Chinese women with normal to mildly impaired renal function, decreased eGFR affected carotid-to-femoral rather than carotid-to-radial stiffening. This provides rational to conduct future prospective studies to investigate predictors of atherosclerosis in this population.展开更多
Covering a wide range of bulk densities, density profiles for hard-sphere chain fluids (HSCFs) with chain length of 3,4,8,20,32 and 64 confined between two surfaces were obtained by Monte Carlo simulations using exten...Covering a wide range of bulk densities, density profiles for hard-sphere chain fluids (HSCFs) with chain length of 3,4,8,20,32 and 64 confined between two surfaces were obtained by Monte Carlo simulations using extended continuum configurational-bias (ECCB) method. It is shown that the enrichment of beads near surfaces is happened at high densities due to the bulk packing effect, on the contrary, the depletion is revealed at low densities owing to the configurational entropic contribution. Comparisons with those calculated by density functional theory presented by Cai et al. indicate that the agreement between simulations and predictions is good. Compressibility factors of bulk HSCFs calculated using volume fractions at surfaces were also used to test the reliability of various equations of state of HSCFs by different authors.展开更多
A ternary Ni2FeSb shape memory alloy was fabricated by powder metallurgy route. Sintering kinetics was estimated from dilatometry tests; whereas the microstructure and morphology of the powder and consolidated bulk sa...A ternary Ni2FeSb shape memory alloy was fabricated by powder metallurgy route. Sintering kinetics was estimated from dilatometry tests; whereas the microstructure and morphology of the powder and consolidated bulk samples were evaluated by XRD and SEM, respectively. Microhardness tests were performed on the surface of sintered samples. The results indicated that milling time has an effect on the shape and particle size as well as the homogeneity of the crystalline structures of the powders. Samples with longer milling time presented higher relative densities, better distribution of the elements on the alloy as well as the L21 and martensite phases, which will give the shape memory effect. The estimated activation energy values ranged from 109 to 282 kJ/mol at temperatures between 750 and 1273 K, indicating that sintering is controlled mainly by volume diffusion. Microhardness was improved by increasing the milling time and the heating rate.展开更多
A theoretical method was proposed to extend a bridge density functional approximation （BDFA） for the non-uniform hard sphere fluid to the non-uniform Lennard-Jones （LJ） fluid. The DFT approach for LJ fluid is simp...A theoretical method was proposed to extend a bridge density functional approximation （BDFA） for the non-uniform hard sphere fluid to the non-uniform Lennard-Jones （LJ） fluid. The DFT approach for LJ fluid is simple, quantitatively accurate in a wide range of coexistence phase and external field parameters. Especially, the DFT approach only needs a second order direct correlation function （DCF） of the coexistence bulk fluid as input, and is therefore applicable to the subcritical temperature region. The present theoretical method can be regarded as a non-uniform counterpart of the thermodynamic perturbation theory, in which it is not at the level of the free energy but at the level of the second order DCF.the National Natural Science Foundation of China （No. 20546004） and the Natural Science Foundation of Education Department of Hunan Province （No.04C711）.展开更多
The work in this study is focused on investigation of composite nickel coatings. The coatings were deposited on ductile cast iron samples of different composition by electroless method EFTTOM NICKEL with addition of s...The work in this study is focused on investigation of composite nickel coatings. The coatings were deposited on ductile cast iron samples of different composition by electroless method EFTTOM NICKEL with addition of strengthening nanodiamond particles （2-4 nm）, The samples were prepared by casting and austempering. The microstructure, microhardness and wear resistance of the coatings were investigated. The thickness of the coatings was also determined （8-10μm）. Metallographic analyses, SEM （scanning electron microscopic） investigation, microhardness measurements by knoop method, wear resistance tests were carried out. The coatings with and without heat treatment at 290℃, 6 h were tested. Duplication of microhardness value and improvement of the coating＇s properties of heat treated coatings were observed.展开更多
文摘以ABS/PC塑料板为试验材料,采用DIN EN ISO 2039—1:2003《塑料硬度测定第一部分:球压痕法》中规定的方法,测试塑料板球压痕硬度值;依据JJF 1059.1—2012《测量不确定度评定与表示》,建立数学模型及对不确定度来源量化分析,对ABS/PC塑料板球压痕硬度测量结果进行了评定。ABS/PC塑料板测定结果为H=121 N/mm^(2),其中扩展不确定度为3.3 N/mm^(2),该不确定度主要来源于重复性测量。
文摘Under the premise of fully respecting current national standard of table tennis ball,this paper presents an integrated and effective method for testing diameter,roundness and hardness of table tennis ball based on vision measurement. Firstly,camera calibration is performed by 40 mm gauge block to capture the images of table tennis ball in static and pressed state in an appropriate lighting condition. Then image binarization and extraction of image contour are carried out. The least square method is used to fit its center. Finally,the diameter,roundness and hardness are calculated. The measurement data are analyzed by using the method presented in this paper for table tennis ball with known parameter data and with unknown parameter data. Experimental results show that this method can improve measurement accuracy and provide a technical basis for the online testing and integration measurement of table tennis ball.
文摘Objective Both decreased glomemlar filtration rate （GFR） and arterial stiffness were considered as risk factors for atherosclerosis. Previous studies have suggested the association between central arterial stiffness and the degree of GFR loss. Whether decreased GFR contributes to peripheral artery stiffness remains controversial. Moreover, data analyzed from a cohort of Chinese women are rare. Our aim was to explore the relationship between GFR and regional arterial stiffness in Chinese women. Methods In this cross-sectional study, we randomly recruited 1131 adult women residents with GFR 〉 60 mL/min per 1.73 m2 estimated by the Chinese Modification of Diet in Renal Disease equation from three large communities. Central and peripheral arterial stiffness were estimated simultaneously by measuring carotid-femoral pulse wave velocity （PWVcf） and carotid-radial PWV （PWVcr） using a validated automatic device. Augmentation Index at heart rate 75 beats/minutes （AIx-75） was measured by pulse wave analysis as a composite parameter reflecting both large and distal arterial properties. Results The mean estimated GFR （eGFR） of the study group was 100.05 ＋ 23.26 mL/minute per 1.73 m2. Subjects were grouped by tertiles of eGFR level. PWVef and AIx-75 increased ongoing from the top to the bottom eGFR tertile, while the values of PWVcr were comparable. Both univariate Pearson correlations and multiple stepwise regression analyses showed that eGFR significantly correlated to PWVcf, but not to PWVcr and AJx-75. Conclusions In Chinese women with normal to mildly impaired renal function, decreased eGFR affected carotid-to-femoral rather than carotid-to-radial stiffening. This provides rational to conduct future prospective studies to investigate predictors of atherosclerosis in this population.
基金Supported by the National Science Foundation of China (No. 29736170, No. 20025618) and the Doctoral Research Foundation by Ministry of Education of China (No. 1999025103). Additional support provided by the Visiting Researcher Foundation of University La
文摘Covering a wide range of bulk densities, density profiles for hard-sphere chain fluids (HSCFs) with chain length of 3,4,8,20,32 and 64 confined between two surfaces were obtained by Monte Carlo simulations using extended continuum configurational-bias (ECCB) method. It is shown that the enrichment of beads near surfaces is happened at high densities due to the bulk packing effect, on the contrary, the depletion is revealed at low densities owing to the configurational entropic contribution. Comparisons with those calculated by density functional theory presented by Cai et al. indicate that the agreement between simulations and predictions is good. Compressibility factors of bulk HSCFs calculated using volume fractions at surfaces were also used to test the reliability of various equations of state of HSCFs by different authors.
基金PROMEP/103.5/13/6992 and the CIC of the UMSNH for the financial supportCONACYT under the project CB-2011-167111
文摘A ternary Ni2FeSb shape memory alloy was fabricated by powder metallurgy route. Sintering kinetics was estimated from dilatometry tests; whereas the microstructure and morphology of the powder and consolidated bulk samples were evaluated by XRD and SEM, respectively. Microhardness tests were performed on the surface of sintered samples. The results indicated that milling time has an effect on the shape and particle size as well as the homogeneity of the crystalline structures of the powders. Samples with longer milling time presented higher relative densities, better distribution of the elements on the alloy as well as the L21 and martensite phases, which will give the shape memory effect. The estimated activation energy values ranged from 109 to 282 kJ/mol at temperatures between 750 and 1273 K, indicating that sintering is controlled mainly by volume diffusion. Microhardness was improved by increasing the milling time and the heating rate.
文摘A theoretical method was proposed to extend a bridge density functional approximation （BDFA） for the non-uniform hard sphere fluid to the non-uniform Lennard-Jones （LJ） fluid. The DFT approach for LJ fluid is simple, quantitatively accurate in a wide range of coexistence phase and external field parameters. Especially, the DFT approach only needs a second order direct correlation function （DCF） of the coexistence bulk fluid as input, and is therefore applicable to the subcritical temperature region. The present theoretical method can be regarded as a non-uniform counterpart of the thermodynamic perturbation theory, in which it is not at the level of the free energy but at the level of the second order DCF.the National Natural Science Foundation of China （No. 20546004） and the Natural Science Foundation of Education Department of Hunan Province （No.04C711）.
文摘The work in this study is focused on investigation of composite nickel coatings. The coatings were deposited on ductile cast iron samples of different composition by electroless method EFTTOM NICKEL with addition of strengthening nanodiamond particles （2-4 nm）, The samples were prepared by casting and austempering. The microstructure, microhardness and wear resistance of the coatings were investigated. The thickness of the coatings was also determined （8-10μm）. Metallographic analyses, SEM （scanning electron microscopic） investigation, microhardness measurements by knoop method, wear resistance tests were carried out. The coatings with and without heat treatment at 290℃, 6 h were tested. Duplication of microhardness value and improvement of the coating＇s properties of heat treated coatings were observed.
