This article presents an acetylene production process by partial oxidation/combustion of natural gas. The thermodynamic performance and exergy analysis in the process are investigated using the flow-sheeting program A...This article presents an acetylene production process by partial oxidation/combustion of natural gas. The thermodynamic performance and exergy analysis in the process are investigated using the flow-sheeting program Aspen Plus. The results indicate that the most important destruction of exergy is found to occur in the reactor and water quenching scrubber, amounting to 8.23% and 10.39%, respectively, of the entire system. Based on the results of thermodynamic and exergy analysis, the acetylene reactor has been retrofitted. The improvement ratios of molar 02 to CH4 and molar CO to CN4 are 0.65 and 0.20, respectively. An improvement of the acetylene production system is proposed. Adopting the improvement operation conditions and using oil to realize the reaction heat recovery, the feedstock of natural gas is reduced by 9.88% and the exergy loss in the retrofitting process is decreased by 19.71% compared to the original process.展开更多
A novel bifunctional dye containing spirobenzopyran and cinnamoyl moiety has been prepared and its photochromic behavior following irradiation at different wavelengths of monochrome UV light was investigated. The colo...A novel bifunctional dye containing spirobenzopyran and cinnamoyl moiety has been prepared and its photochromic behavior following irradiation at different wavelengths of monochrome UV light was investigated. The colourless bifunctional dye in film or solution exhibits unusual photochromism through structural and geometrical transformation from spirobenzopyran to merocyanine accompanying with photocrosslinking reaction in cinnamoyl moieties. Two kinds of photochemical reaction were achieved by irradiation at the different wavelengths of monochrome UV light (275 nm, 365 nm) selectively. The photochromic process of the bifunctional dye was discussed and the dynamic behaviors of the decolorization process were investigated.展开更多
The appropriate production of liquefied natural gas(LNG)with least consuming energy and maximum efficiency is quite important.In this paper,LNG production cycle by means of APCI Process has been studied.Energy equilib...The appropriate production of liquefied natural gas(LNG)with least consuming energy and maximum efficiency is quite important.In this paper,LNG production cycle by means of APCI Process has been studied.Energy equilibrium equations and exergy equilibrium equations of each equipment in the APCI cycle were established.The equipments are described using rigorous thermodynamics and no significant simplification is assumed.Taken some operating parameters as key parameters,influences of these parameters on coefficient of performance(COP)and exergy efficiency of the cascading cycle were analyzed.The results indicate that COP and exergy efficiency will be improved with the increasing of the inlet pressure of MR(mixed refrigerant)compressors,the decreasing of the NG and MR after precooling process,outlet pressure of turbine,inlet temperature of MR compressor and NG temperature after cooling in main cryogenic heat exchanger(MCHE).The COP and exergy efficiency of the APCI cycle will be above 2% and 40%,respectively,after optimizing the key parameters.展开更多
Gas wiping is a decisive operation in hot-dip galvanizing process. In special, it has a crucial influence on the thickness and uniformity in coating film, but may be subsequently responsible for the problem of splashi...Gas wiping is a decisive operation in hot-dip galvanizing process. In special, it has a crucial influence on the thickness and uniformity in coating film, but may be subsequently responsible for the problem of splashing. The progress of industry demands continuously the reduction of production costs which may relate directly with the increase of coating speed, and the speed up of coating results in the increase of stagnation pressure in gas wiping system in final. It is known that the increase of stagnation pressure may accompany a harmful problem of splashing in general. Together with these, also, from the view point of energy consumption, it is necessary to design a nozzle optimally. And there is known that the downward tilting of nozzle using in air knife system is effective to prevent in somewhat the harmful problem of splashing. In these connections, first, we design a nozzle with constant expansion rate. Next, for the case of actual coating conditions in field, the effects of tilting of the constant expansion rate nozzle are investigated by numerical analysis. Under the present numerical conditions, it was turned out that the nozzle of constant expansion rate of p = having a downward jet angle of 5^0 is the most effective to diminish the onset of splashing, while the influence of small tilting of the nozzle on impinging wall pres- sure itself is not so large.展开更多
基金Supported by the National Natural Science Foundation of China （90210032, 50576001）.
文摘This article presents an acetylene production process by partial oxidation/combustion of natural gas. The thermodynamic performance and exergy analysis in the process are investigated using the flow-sheeting program Aspen Plus. The results indicate that the most important destruction of exergy is found to occur in the reactor and water quenching scrubber, amounting to 8.23% and 10.39%, respectively, of the entire system. Based on the results of thermodynamic and exergy analysis, the acetylene reactor has been retrofitted. The improvement ratios of molar 02 to CH4 and molar CO to CN4 are 0.65 and 0.20, respectively. An improvement of the acetylene production system is proposed. Adopting the improvement operation conditions and using oil to realize the reaction heat recovery, the feedstock of natural gas is reduced by 9.88% and the exergy loss in the retrofitting process is decreased by 19.71% compared to the original process.
文摘A novel bifunctional dye containing spirobenzopyran and cinnamoyl moiety has been prepared and its photochromic behavior following irradiation at different wavelengths of monochrome UV light was investigated. The colourless bifunctional dye in film or solution exhibits unusual photochromism through structural and geometrical transformation from spirobenzopyran to merocyanine accompanying with photocrosslinking reaction in cinnamoyl moieties. Two kinds of photochemical reaction were achieved by irradiation at the different wavelengths of monochrome UV light (275 nm, 365 nm) selectively. The photochromic process of the bifunctional dye was discussed and the dynamic behaviors of the decolorization process were investigated.
文摘The appropriate production of liquefied natural gas(LNG)with least consuming energy and maximum efficiency is quite important.In this paper,LNG production cycle by means of APCI Process has been studied.Energy equilibrium equations and exergy equilibrium equations of each equipment in the APCI cycle were established.The equipments are described using rigorous thermodynamics and no significant simplification is assumed.Taken some operating parameters as key parameters,influences of these parameters on coefficient of performance(COP)and exergy efficiency of the cascading cycle were analyzed.The results indicate that COP and exergy efficiency will be improved with the increasing of the inlet pressure of MR(mixed refrigerant)compressors,the decreasing of the NG and MR after precooling process,outlet pressure of turbine,inlet temperature of MR compressor and NG temperature after cooling in main cryogenic heat exchanger(MCHE).The COP and exergy efficiency of the APCI cycle will be above 2% and 40%,respectively,after optimizing the key parameters.
文摘Gas wiping is a decisive operation in hot-dip galvanizing process. In special, it has a crucial influence on the thickness and uniformity in coating film, but may be subsequently responsible for the problem of splashing. The progress of industry demands continuously the reduction of production costs which may relate directly with the increase of coating speed, and the speed up of coating results in the increase of stagnation pressure in gas wiping system in final. It is known that the increase of stagnation pressure may accompany a harmful problem of splashing in general. Together with these, also, from the view point of energy consumption, it is necessary to design a nozzle optimally. And there is known that the downward tilting of nozzle using in air knife system is effective to prevent in somewhat the harmful problem of splashing. In these connections, first, we design a nozzle with constant expansion rate. Next, for the case of actual coating conditions in field, the effects of tilting of the constant expansion rate nozzle are investigated by numerical analysis. Under the present numerical conditions, it was turned out that the nozzle of constant expansion rate of p = having a downward jet angle of 5^0 is the most effective to diminish the onset of splashing, while the influence of small tilting of the nozzle on impinging wall pres- sure itself is not so large.
