Ultrasonic field was applied in the treatment of oil emulsification wastewater by ZrO2 ceramic mem-brane. The permeate flux, rejection ratio in the filtration process and recovery ratio of flux in the membrane cleanin...Ultrasonic field was applied in the treatment of oil emulsification wastewater by ZrO2 ceramic mem-brane. The permeate flux, rejection ratio in the filtration process and recovery ratio of flux in the membrane cleaning process were measured. Great improvement in the permeate flux and rejection ratio have been observed for the membrane process enhanced by the ultrasonic field. The permeate flux of water through the membrane was about 210L.m^-2.h^-1 and the oil rejection ratio was over 99.9% under the optimal ultrasonic treatment conditions, which were 8W of ultrasonic power, 7cm of ultrasonic probe length introduced into the membrane channel and the same ultrasonic radiation direction as the wastewater flow. The resistance of the membrane process was compared between the cases with and without ultrasound, and the total resistance was reduced 68% by the use of ultrasound, Four methods including water cleaning, water cleaning under sonication, chemical cleaning and chemical cleaning under sonication were used to recover membrane flux. It was found that the flux recovery ratio increased with the increase of ultrasonic cleaning power. In addition, the use of chemical agents combining with ultrasonic irradiation showed a synergistic effect, which resulted in the highest cleaning efficiency and the shorter cleaning time.展开更多
A new reactor with integrated conventional slurry stirred reactor and ceramic external membrane emulsification system, was introduced in this paper. Toluene and toluene containing surfactant was separately used as dis...A new reactor with integrated conventional slurry stirred reactor and ceramic external membrane emulsification system, was introduced in this paper. Toluene and toluene containing surfactant was separately used as dispersed phase for preparation of emulsions. Two kinds of emulsions were prepared and compared. The volume average sizes of prepared emulsions were 3.53μm and 3.6μm respectively. The results showed that the droplet sizes of two kinds of emulsions were similar, but the monodispersed emulsion was only obtained with addition of surfactant into the dispersed phase.展开更多
In order to reveal the relationship between the penecontemporaneous karstification and sedimentary microtopography in sequence stratigraphy,the sequence stratigraphic framework of Lianglitage formation in Upper Ordovi...In order to reveal the relationship between the penecontemporaneous karstification and sedimentary microtopography in sequence stratigraphy,the sequence stratigraphic framework of Lianglitage formation in Upper Ordovician is studied according to the well drilling,logging,geophysical data,detailed observations of core and the paleontology.The Lianglitage formation belongs to the sequence Ⅳ of Ordovician.The second member of Lianglitage formation is prograde sedimentation in highstand systems tract,and is favorable for developing reef flat.The development scale and thickness of reef flat are controlled by the variation of secondary sea level.The types and characteristics of karst in the highstand systems tract show that the late highstand systems tract is dissolved and cemented by the meteoric fresh water and mixed water.Penecontemporaneous karstification is developed at the top of parasequence and high place of geomorphology.Atmospheric diagenetic lens is formed.The developing regulations and controlling factors of penecontemporaneous karstification can provide new clues to the prediction and exploration of favorable reservoir in this area.展开更多
A novel method to prepare macroporous TiO2 ceramic, based on membrane emulsification was reported.To solve the paradox between the instability of nonaqueous emulsion and long emulsification time required by themembran...A novel method to prepare macroporous TiO2 ceramic, based on membrane emulsification was reported.To solve the paradox between the instability of nonaqueous emulsion and long emulsification time required by themembrane emulsification, a two-stage ceramic membrane jet-flow emulsification .was. proposed. Discussion wasconducted on the evolution of droplet size with time, which followed the Ostwalcl npemng theory. And a monodispersed nonaqueous emulsion with an average droplet size of 1.6μm could beprepared. Using the emulsion, as atemplate, TiO2 ceramics with an average pore size ot 1.1 μm were obtaineed. Tne material could be prospectivelyused for preparation of catalysts, adsorbents, and membranes.展开更多
With the continuous development of human civilization, modem design has also made great progress. The design thinking tends more to adapting to human self-demand, in order to achieve the purpose of serving for people...With the continuous development of human civilization, modem design has also made great progress. The design thinking tends more to adapting to human self-demand, in order to achieve the purpose of serving for people' s daily life. Therefore, the humanized design concept of modem society is proposed, and in many fields, the humanized design thinking has become mature. This paper mainly takes systematic and overall analysis of the application of humanized design thinking in ceramic modeling, in order to provide relevant reference for the majority of peers.展开更多
基金Supported by the Special Funds for Major State Basic Research Program of China (973 Program, No.2003CB615707) and the National Natural Science Foundation of China (No.20436030).
文摘Ultrasonic field was applied in the treatment of oil emulsification wastewater by ZrO2 ceramic mem-brane. The permeate flux, rejection ratio in the filtration process and recovery ratio of flux in the membrane cleaning process were measured. Great improvement in the permeate flux and rejection ratio have been observed for the membrane process enhanced by the ultrasonic field. The permeate flux of water through the membrane was about 210L.m^-2.h^-1 and the oil rejection ratio was over 99.9% under the optimal ultrasonic treatment conditions, which were 8W of ultrasonic power, 7cm of ultrasonic probe length introduced into the membrane channel and the same ultrasonic radiation direction as the wastewater flow. The resistance of the membrane process was compared between the cases with and without ultrasound, and the total resistance was reduced 68% by the use of ultrasound, Four methods including water cleaning, water cleaning under sonication, chemical cleaning and chemical cleaning under sonication were used to recover membrane flux. It was found that the flux recovery ratio increased with the increase of ultrasonic cleaning power. In addition, the use of chemical agents combining with ultrasonic irradiation showed a synergistic effect, which resulted in the highest cleaning efficiency and the shorter cleaning time.
基金the National Basic Research Program of China (No. 2003CB615700) the National Natural Science Foundation of China (No. 20125618).
文摘A new reactor with integrated conventional slurry stirred reactor and ceramic external membrane emulsification system, was introduced in this paper. Toluene and toluene containing surfactant was separately used as dispersed phase for preparation of emulsions. Two kinds of emulsions were prepared and compared. The volume average sizes of prepared emulsions were 3.53μm and 3.6μm respectively. The results showed that the droplet sizes of two kinds of emulsions were similar, but the monodispersed emulsion was only obtained with addition of surfactant into the dispersed phase.
基金Project(2008ZX05004-004)supported by the State Key Scientific Research Programs,ChinaProject(SZD0414)supported by the Sichuan Province Key Discipline Construction Project,ChinaProject(KZCX2-YW-Q05-01)supported by the Chinese Academy of Sciences Innovation Engineering Directional Project
文摘In order to reveal the relationship between the penecontemporaneous karstification and sedimentary microtopography in sequence stratigraphy,the sequence stratigraphic framework of Lianglitage formation in Upper Ordovician is studied according to the well drilling,logging,geophysical data,detailed observations of core and the paleontology.The Lianglitage formation belongs to the sequence Ⅳ of Ordovician.The second member of Lianglitage formation is prograde sedimentation in highstand systems tract,and is favorable for developing reef flat.The development scale and thickness of reef flat are controlled by the variation of secondary sea level.The types and characteristics of karst in the highstand systems tract show that the late highstand systems tract is dissolved and cemented by the meteoric fresh water and mixed water.Penecontemporaneous karstification is developed at the top of parasequence and high place of geomorphology.Atmospheric diagenetic lens is formed.The developing regulations and controlling factors of penecontemporaneous karstification can provide new clues to the prediction and exploration of favorable reservoir in this area.
基金Supported by the National High Technology Research and Development Program of China (863 program, No.2006AA03Z534), the Postdoctoral Science Foundation of China (No.20060400927), the National Basic Research Program of China (No.2003CB6157070), the National Natural Science Foundation of China (No.20436030), Natural Science Foundation of Jiangsu Province (No.BK2006566), and Jiangsu Planned Projects for Postdoctoral Research Funds (No.0601023B).
文摘A novel method to prepare macroporous TiO2 ceramic, based on membrane emulsification was reported.To solve the paradox between the instability of nonaqueous emulsion and long emulsification time required by themembrane emulsification, a two-stage ceramic membrane jet-flow emulsification .was. proposed. Discussion wasconducted on the evolution of droplet size with time, which followed the Ostwalcl npemng theory. And a monodispersed nonaqueous emulsion with an average droplet size of 1.6μm could beprepared. Using the emulsion, as atemplate, TiO2 ceramics with an average pore size ot 1.1 μm were obtaineed. Tne material could be prospectivelyused for preparation of catalysts, adsorbents, and membranes.
文摘With the continuous development of human civilization, modem design has also made great progress. The design thinking tends more to adapting to human self-demand, in order to achieve the purpose of serving for people' s daily life. Therefore, the humanized design concept of modem society is proposed, and in many fields, the humanized design thinking has become mature. This paper mainly takes systematic and overall analysis of the application of humanized design thinking in ceramic modeling, in order to provide relevant reference for the majority of peers.