CMOS阵列探测器中,像素单元间的串扰会影响其成像质量。为了解不同光源对CMOS电串扰的影响,针对CMOS图像传感器的电串扰特性建立了一个分析模型,结合CMOS图像传感器的工作原理定量计算了单色光、宽谱光源入射条件下的电串扰特性。分析...CMOS阵列探测器中,像素单元间的串扰会影响其成像质量。为了解不同光源对CMOS电串扰的影响,针对CMOS图像传感器的电串扰特性建立了一个分析模型,结合CMOS图像传感器的工作原理定量计算了单色光、宽谱光源入射条件下的电串扰特性。分析结果表明CMOS图像传感器的电串扰随单色光波长、宽谱光源谱宽和中心波长的增大而增大,但中心波长与单色光波长相同的宽谱光源,其对电串扰的影响大于单色光。辐照功率为600μW,单色光波长为1 064 nm,电串扰大小约为50.611 m V;宽谱光源中心波长为1 064 nm,谱宽为400 nm时,电串扰的大小约为50.914 m V,相比于单色光电串扰增加了约0.303 m V。展开更多
RLC model is used to estimate the coupling noise between interconnect wires and make some analysis through the simulation result. Based on the analysis conclusion,some algorithms are developed to adjust the rou ting ...RLC model is used to estimate the coupling noise between interconnect wires and make some analysis through the simulation result. Based on the analysis conclusion,some algorithms are developed to adjust the rou ting result with crosstalk constraint.展开更多
The crosstalk caused by oblique incident ray on a PIN detector array is analyzed. An integral expression of crosstalk factor in relation to incident angle and structure parameters is deduced and the correctness of the...The crosstalk caused by oblique incident ray on a PIN detector array is analyzed. An integral expression of crosstalk factor in relation to incident angle and structure parameters is deduced and the correctness of the deduction is tested and verified.展开更多
This paper presents a method based on a sample-decision(SD) circuit to suppress crosstalk and noise for a high-speed and high-density bus system.A method to count the number of times of SD for different length of tran...This paper presents a method based on a sample-decision(SD) circuit to suppress crosstalk and noise for a high-speed and high-density bus system.A method to count the number of times of SD for different length of transmission lines is presented and a bit error rates(BERs) formula is given by the SD circuit.It is shown that for long transmission line systems,multiple SD circuits can improve the BERs significantly.Circuits simulation for single SD method is also done,it is found that when the amplitude peak values of the superposed crosstalk and noise are less than half of the corresponding signal ones,they will be eliminated completely for the cases investigated.展开更多
This paper deals with the analytical derivation of phasor-domain statistical properties of crosstalk in random wire cables due to the superposition of several sources of electromagnetic interference.In this study,stat...This paper deals with the analytical derivation of phasor-domain statistical properties of crosstalk in random wire cables due to the superposition of several sources of electromagnetic interference.In this study,statistical characterization of crosstalk in cable bundles,which is available in literature for the case of one source of interference,is extended to the case of several sources operating simultaneously.The superposition of crosstalk effects is analysed in statistical terms,also taking into account the correlation between crosstalk contributions.A further random contribution,which is included in the proposed statistical model,is given by the phase relationship between the sources of interference.Analytical approximate expressions for the crosstalk mean value,variance,and probability density function are derived as functions of the cable bundle features and sources.展开更多
A polymer directional coupler （DC） electro-optic switch with push-pull electrodes and rib waveguides is designed based on the conformal transforming method, image method, coupled mode theory, and electro-optic modul...A polymer directional coupler （DC） electro-optic switch with push-pull electrodes and rib waveguides is designed based on the conformal transforming method, image method, coupled mode theory, and electro-optic modulation theory. Its structure and principle are described, the design and optimization are performed, and the characteristics are analyzed, including the coupling length, switching voltage, output power, insertion loss, and crosstalk. To realize normal switching function,the fabrication tolerance,wavelength shift, and coupling loss between a single mode fiber （SMF） and the waveguide are discussed. Simulation results show that the coupling length is 3082μm; the push-pull switching voltage is 2.14V;and the insertion loss and crosstalk are less than 1.14 and -30dB,respectively. The proposed analytical technique on waveguides and electrodes is proven to be accurate and computationally efficient when compared with the beam propa- gation method （BPM） and the experimental results.展开更多
文摘CMOS阵列探测器中,像素单元间的串扰会影响其成像质量。为了解不同光源对CMOS电串扰的影响,针对CMOS图像传感器的电串扰特性建立了一个分析模型,结合CMOS图像传感器的工作原理定量计算了单色光、宽谱光源入射条件下的电串扰特性。分析结果表明CMOS图像传感器的电串扰随单色光波长、宽谱光源谱宽和中心波长的增大而增大,但中心波长与单色光波长相同的宽谱光源,其对电串扰的影响大于单色光。辐照功率为600μW,单色光波长为1 064 nm,电串扰大小约为50.611 m V;宽谱光源中心波长为1 064 nm,谱宽为400 nm时,电串扰的大小约为50.914 m V,相比于单色光电串扰增加了约0.303 m V。
文摘RLC model is used to estimate the coupling noise between interconnect wires and make some analysis through the simulation result. Based on the analysis conclusion,some algorithms are developed to adjust the rou ting result with crosstalk constraint.
文摘The crosstalk caused by oblique incident ray on a PIN detector array is analyzed. An integral expression of crosstalk factor in relation to incident angle and structure parameters is deduced and the correctness of the deduction is tested and verified.
基金Supported by the National Natural Science Foundation of China(No.61171039,61072059)
文摘This paper presents a method based on a sample-decision(SD) circuit to suppress crosstalk and noise for a high-speed and high-density bus system.A method to count the number of times of SD for different length of transmission lines is presented and a bit error rates(BERs) formula is given by the SD circuit.It is shown that for long transmission line systems,multiple SD circuits can improve the BERs significantly.Circuits simulation for single SD method is also done,it is found that when the amplitude peak values of the superposed crosstalk and noise are less than half of the corresponding signal ones,they will be eliminated completely for the cases investigated.
文摘This paper deals with the analytical derivation of phasor-domain statistical properties of crosstalk in random wire cables due to the superposition of several sources of electromagnetic interference.In this study,statistical characterization of crosstalk in cable bundles,which is available in literature for the case of one source of interference,is extended to the case of several sources operating simultaneously.The superposition of crosstalk effects is analysed in statistical terms,also taking into account the correlation between crosstalk contributions.A further random contribution,which is included in the proposed statistical model,is given by the phase relationship between the sources of interference.Analytical approximate expressions for the crosstalk mean value,variance,and probability density function are derived as functions of the cable bundle features and sources.
基金the National Natural Science Foundation of China(No.60706011)the Doctoral Program for New Teachers of the Ministry of Education of China(No.20070183087)the State Key Development Program for Basic Research of China(No.2006CB302803)~~
文摘A polymer directional coupler （DC） electro-optic switch with push-pull electrodes and rib waveguides is designed based on the conformal transforming method, image method, coupled mode theory, and electro-optic modulation theory. Its structure and principle are described, the design and optimization are performed, and the characteristics are analyzed, including the coupling length, switching voltage, output power, insertion loss, and crosstalk. To realize normal switching function,the fabrication tolerance,wavelength shift, and coupling loss between a single mode fiber （SMF） and the waveguide are discussed. Simulation results show that the coupling length is 3082μm; the push-pull switching voltage is 2.14V;and the insertion loss and crosstalk are less than 1.14 and -30dB,respectively. The proposed analytical technique on waveguides and electrodes is proven to be accurate and computationally efficient when compared with the beam propa- gation method （BPM） and the experimental results.
