In the period 2003-2011, lightning over-voltages accounted for about 47% of the total number of distribution transformer failures observed in the service area ofAES Sul, a power company that operates in the state of R...In the period 2003-2011, lightning over-voltages accounted for about 47% of the total number of distribution transformer failures observed in the service area ofAES Sul, a power company that operates in the state of Rio Grande doSul, in South Brazil. This paper presents the results of an investigation on the influence of the distance between transformer and MV arresters on the surges at the transformer windings caused by direct strikes to the MV network. The analysis, performed through simulations using the Alternative Transients Program, shows that in general higher voltages are produced by subsequent strokes. Although in relation to the primary side the surges transferred to the secondary are much less affected by the distance between transformers and primary arresters, such distance should always be kept as short as possible in order to reduce the probability of occurrence of transformer failures due to over-voltages at the MV bushings.展开更多
Acoustic emission monitoring is often used in the diagnosis of electrical and mechanical incipient faults in the high voltage apparatus. Partial discharges are a major source of insulation failure in electric power tr...Acoustic emission monitoring is often used in the diagnosis of electrical and mechanical incipient faults in the high voltage apparatus. Partial discharges are a major source of insulation failure in electric power transformers, and the differentiation from other sources of acoustic emission is of the utmost importance. This paper reports the development of a new sensor concept - a fiber laser sensor based on a phase-shifted chirped fiber grating - for the acoustic emission detection of incipient faults in oil-filled power transformers. These sensors can be placed in the inner surface of the transformer tank wall, not affecting the insulation integrity of the structure and improving fault detection and location. The performance of the sensing head is characterized and compared for different surrounding media： air, water, and oil. The results obtained indicate the feasibility of this sensing approach for the industrial development of practical solutions.展开更多
The generator is the starter device of single stage heat transformer(SSHT) and its characteristics have main effects on the overall efficiency of this kind of absorption machines.This article reports a study of the ge...The generator is the starter device of single stage heat transformer(SSHT) and its characteristics have main effects on the overall efficiency of this kind of absorption machines.This article reports a study of the generation of steam and changes in the concentration of the working solution(Water/Carrol mixture) into a plate heat exchanger as a function of its horizontal and vertical position by gravity effect.It is considered the analysis of six experimental tests;two were evaluated in a plate heat exchanger in a horizontal position and four in a vertical position(90 degree inclination).The generation of steam and increased concentration of the working solution are more sensitive to the vertical position of exchanger than in horizontal position.The results of numerical-experimental analysis indicates that a heat exchanger in horizontal position,the steam generation and the change in the concentration of the working solution occurring in the middle of the plate(or at greater distance depending to the thermodynamic conditions) and instantly in vertical position(at the input of the plate).展开更多
文摘In the period 2003-2011, lightning over-voltages accounted for about 47% of the total number of distribution transformer failures observed in the service area ofAES Sul, a power company that operates in the state of Rio Grande doSul, in South Brazil. This paper presents the results of an investigation on the influence of the distance between transformer and MV arresters on the surges at the transformer windings caused by direct strikes to the MV network. The analysis, performed through simulations using the Alternative Transients Program, shows that in general higher voltages are produced by subsequent strokes. Although in relation to the primary side the surges transferred to the secondary are much less affected by the distance between transformers and primary arresters, such distance should always be kept as short as possible in order to reduce the probability of occurrence of transformer failures due to over-voltages at the MV bushings.
文摘Acoustic emission monitoring is often used in the diagnosis of electrical and mechanical incipient faults in the high voltage apparatus. Partial discharges are a major source of insulation failure in electric power transformers, and the differentiation from other sources of acoustic emission is of the utmost importance. This paper reports the development of a new sensor concept - a fiber laser sensor based on a phase-shifted chirped fiber grating - for the acoustic emission detection of incipient faults in oil-filled power transformers. These sensors can be placed in the inner surface of the transformer tank wall, not affecting the insulation integrity of the structure and improving fault detection and location. The performance of the sensing head is characterized and compared for different surrounding media： air, water, and oil. The results obtained indicate the feasibility of this sensing approach for the industrial development of practical solutions.
基金supporting basic science project 167434:"Analysis of waste energy recovery and sustainable development"
文摘The generator is the starter device of single stage heat transformer(SSHT) and its characteristics have main effects on the overall efficiency of this kind of absorption machines.This article reports a study of the generation of steam and changes in the concentration of the working solution(Water/Carrol mixture) into a plate heat exchanger as a function of its horizontal and vertical position by gravity effect.It is considered the analysis of six experimental tests;two were evaluated in a plate heat exchanger in a horizontal position and four in a vertical position(90 degree inclination).The generation of steam and increased concentration of the working solution are more sensitive to the vertical position of exchanger than in horizontal position.The results of numerical-experimental analysis indicates that a heat exchanger in horizontal position,the steam generation and the change in the concentration of the working solution occurring in the middle of the plate(or at greater distance depending to the thermodynamic conditions) and instantly in vertical position(at the input of the plate).
