Based on a physical understanding of nonlinearity and mismatch, a novel offset-cancellation technique for low voltage CMOS differential amplifiers is proposed. The technique transfers the offset voltage from the outpu...Based on a physical understanding of nonlinearity and mismatch, a novel offset-cancellation technique for low voltage CMOS differential amplifiers is proposed. The technique transfers the offset voltage from the output to other parts of the differential amplifier and can greatly reduce the input-referred offset voltage without extra power consumption. A 1.8V CMOS differential amplifier is implemented in 0.18μm CMOS process using the proposed technique. The simulation results show that the technique could reduce the input-referred offset voltage of the amplifier by 40% with a 20% load transistor mismatch and a 10% input differential transistor mismatch. Moreover, the proposed technique consumes the least power and achieves the highest integration among various offset-cancellation techniques.展开更多
An improved automatic voltage coordination control strategy (AVCCS) based on ;automatic voltage control (AVC) and battery energy storage control (BESC) is proposed for photovoltaic grid-connected system (PVGS)...An improved automatic voltage coordination control strategy (AVCCS) based on ;automatic voltage control (AVC) and battery energy storage control (BESC) is proposed for photovoltaic grid-connected system (PVGS) to mitigate the voltage fluctuations caused by environmental disturbances. Only AVC is used when small environ- mental disturbances happen, while BESC is incorporated with AVC to restrain the voltage fluctuations when large disturbances happen. An adjustable parameter determining the allowed amplitudes of voltage fluctuations is introduced to realize the above switching process. A benchmark low voltage distribution system including ]?VGS is established by using the commercial software Dig SILENT. Simulation results show that the voltage under AVCCS satisfies the IEEE Standard 1547, and the installed battery capacity is also reduced. Meanwhile, the battery's service life is ex- tended by avoiding frequent charges/discharges in the control process.展开更多
A CMOS active mixer based on voltage control load technique which can operate at 1.0 V supply voltage was proposed, and its operation principle, noise and linearity analysis were also presented. Contrary to the conven...A CMOS active mixer based on voltage control load technique which can operate at 1.0 V supply voltage was proposed, and its operation principle, noise and linearity analysis were also presented. Contrary to the conventional Gilbert-type mixer which is based on RF current-commutating, the load impedance in this proposed mixer is controlled by the LO signal, and it has only two stacked transistors at each branch which is suitable for low voltage applications. The mixer was designed and fabricated in 0.18 tam CMOS process for 2.4 GHz ISM band applications. With an input of 2.44 GHz RF signal and 2.442 GHz LO signal, the measurement specifications of the proposed mixer are: the conversion gain (Gc) is 5.3 dB, the input-referred third-order intercept point (PIIP3) is 4.6 dBm, the input-referred 1 dB compression point (P1dB) is --7.4 dBm, and the single-sideband noise figure (NFSSB) is 21.7 dB.展开更多
The purpose of this article is to present an additional overloading assessment scheme to the current protection scheme, which can be applied in the low voltage distribution network to prevent overloading of network as...The purpose of this article is to present an additional overloading assessment scheme to the current protection scheme, which can be applied in the low voltage distribution network to prevent overloading of network assets. As higher penetration of distributed generators is envisioned among distribution networks, the network operators will have an challenging task in the future to maintain the reliability and quality of supply. The distribution networks are going to be challenged simultaneously by increasing penetration of distributed generators and by increasing loading (inter alia heat pumps, air conditioners or electric vehicles), which will change the operational perspective of the future distribution networks. Presented simulation results show that the increasing penetration of those appliances can jeopardize the functionality of current protection scheme in distribution networks. Therefore, an additional scheme for assessment of network overloading applicable at low voltage distribution networks is proposed and the application of this scheme, supported by smart metering infrastructure, is demonstrated in a case study. The proposed overloading assessment scheme should help the network operators to increase the flexibility of distribution networks, their hosting capacity, safety and reliability.展开更多
This paper presents an integrated power management unit (PMU) for a battery-operated wireless endoscopic system. This PMU is integrated with a baseband chip in standard 0.18μm CMOS technology,promising low cost, ea...This paper presents an integrated power management unit (PMU) for a battery-operated wireless endoscopic system. This PMU is integrated with a baseband chip in standard 0.18μm CMOS technology,promising low cost, ease in PCB design, and a minimum in system size. The optimized power supply architecture is derived from comparison. Circuits of sub blocks are presented in detail. As a result, only five small off-chip capacitances are required by PMU with an overall quiet current consumption of less than 100μA. Moreover,a digital calibration method is adopted to alleviate the effect of process variation. The achieved performance is also demonstrated with corresponding measurement results.展开更多
We herein report the effective performance enhancement of the pentacene-based organic thin film transistors with silicon di- oxide dielectric by inserting a thin metal phthalocyanines interlayer between Au source/drai...We herein report the effective performance enhancement of the pentacene-based organic thin film transistors with silicon di- oxide dielectric by inserting a thin metal phthalocyanines interlayer between Au source/drain electrodes and the pentacene active layer. The threshold voltage decreased remarkably from ca. -20 V to a few volts (below -7.6 V) while the mobility in- creased 1.5-3 times after the insertion of the interlayer of only ca. 2 nm, which could be attributed to the reduction of the car- tier injection barrier. The results suggest a simple and effective way to achieve low-threshold-voltage pentacene-based organic thin film transistors with high mobility on silicon dioxide dielectric.展开更多
This paper reports a new application of permanent magnet actuator for vacuum contactors.A novel permanent magnet(PM) actuator to drive a vacuum contactor with intrinsically safe and low supply voltage is proposed.PM i...This paper reports a new application of permanent magnet actuator for vacuum contactors.A novel permanent magnet(PM) actuator to drive a vacuum contactor with intrinsically safe and low supply voltage is proposed.PM is mounted on the static iron of the contactor to enhance its holding force and reliability.While only one coil is used to break the vacuum contactor,two series coils are deployed to yield a high magnetomotive force to realize the making operation.The electrical circuit equation,mechanical equation and magnetic field are all coupled in the simulation.A prototype is manufactured and tested to validate and showcase the performance of the contactor which is equipped with the proposed PM actuator.展开更多
文摘Based on a physical understanding of nonlinearity and mismatch, a novel offset-cancellation technique for low voltage CMOS differential amplifiers is proposed. The technique transfers the offset voltage from the output to other parts of the differential amplifier and can greatly reduce the input-referred offset voltage without extra power consumption. A 1.8V CMOS differential amplifier is implemented in 0.18μm CMOS process using the proposed technique. The simulation results show that the technique could reduce the input-referred offset voltage of the amplifier by 40% with a 20% load transistor mismatch and a 10% input differential transistor mismatch. Moreover, the proposed technique consumes the least power and achieves the highest integration among various offset-cancellation techniques.
基金Supported by National Basic Research Program of China ("973" Program,No. 2009CB219701 and No. 2010CB234608)Tianjin Municipal Science and Technology Development Program (No. 09JCZDJC25000)Specialized Research Fund for Doctor Discipline of Ministry of Education of China (No. 20090032110064)
文摘An improved automatic voltage coordination control strategy (AVCCS) based on ;automatic voltage control (AVC) and battery energy storage control (BESC) is proposed for photovoltaic grid-connected system (PVGS) to mitigate the voltage fluctuations caused by environmental disturbances. Only AVC is used when small environ- mental disturbances happen, while BESC is incorporated with AVC to restrain the voltage fluctuations when large disturbances happen. An adjustable parameter determining the allowed amplitudes of voltage fluctuations is introduced to realize the above switching process. A benchmark low voltage distribution system including ]?VGS is established by using the commercial software Dig SILENT. Simulation results show that the voltage under AVCCS satisfies the IEEE Standard 1547, and the installed battery capacity is also reduced. Meanwhile, the battery's service life is ex- tended by avoiding frequent charges/discharges in the control process.
基金Project(61166004) supported by the National Natural Science Foundation of ChinaProject(09ZCGHHZ00200) supported by the International Scientific and Technological Cooperation Program of Science and Technology Plan of Tianjin,ChinaProject(UF10028Y)supported by the Doctoral Scientific Research Foundation for Guilin University of Electronic Technology,China
文摘A CMOS active mixer based on voltage control load technique which can operate at 1.0 V supply voltage was proposed, and its operation principle, noise and linearity analysis were also presented. Contrary to the conventional Gilbert-type mixer which is based on RF current-commutating, the load impedance in this proposed mixer is controlled by the LO signal, and it has only two stacked transistors at each branch which is suitable for low voltage applications. The mixer was designed and fabricated in 0.18 tam CMOS process for 2.4 GHz ISM band applications. With an input of 2.44 GHz RF signal and 2.442 GHz LO signal, the measurement specifications of the proposed mixer are: the conversion gain (Gc) is 5.3 dB, the input-referred third-order intercept point (PIIP3) is 4.6 dBm, the input-referred 1 dB compression point (P1dB) is --7.4 dBm, and the single-sideband noise figure (NFSSB) is 21.7 dB.
文摘The purpose of this article is to present an additional overloading assessment scheme to the current protection scheme, which can be applied in the low voltage distribution network to prevent overloading of network assets. As higher penetration of distributed generators is envisioned among distribution networks, the network operators will have an challenging task in the future to maintain the reliability and quality of supply. The distribution networks are going to be challenged simultaneously by increasing penetration of distributed generators and by increasing loading (inter alia heat pumps, air conditioners or electric vehicles), which will change the operational perspective of the future distribution networks. Presented simulation results show that the increasing penetration of those appliances can jeopardize the functionality of current protection scheme in distribution networks. Therefore, an additional scheme for assessment of network overloading applicable at low voltage distribution networks is proposed and the application of this scheme, supported by smart metering infrastructure, is demonstrated in a case study. The proposed overloading assessment scheme should help the network operators to increase the flexibility of distribution networks, their hosting capacity, safety and reliability.
基金the National Natural Science Foundation of China(No.60475018)~~
文摘This paper presents an integrated power management unit (PMU) for a battery-operated wireless endoscopic system. This PMU is integrated with a baseband chip in standard 0.18μm CMOS technology,promising low cost, ease in PCB design, and a minimum in system size. The optimized power supply architecture is derived from comparison. Circuits of sub blocks are presented in detail. As a result, only five small off-chip capacitances are required by PMU with an overall quiet current consumption of less than 100μA. Moreover,a digital calibration method is adopted to alleviate the effect of process variation. The achieved performance is also demonstrated with corresponding measurement results.
基金financially supported by the National Basic Research Program of China (973 Program) (Grant No. 2007CB936302)the National Natural Science Foundation of China (Grant No. 20833002)
文摘We herein report the effective performance enhancement of the pentacene-based organic thin film transistors with silicon di- oxide dielectric by inserting a thin metal phthalocyanines interlayer between Au source/drain electrodes and the pentacene active layer. The threshold voltage decreased remarkably from ca. -20 V to a few volts (below -7.6 V) while the mobility in- creased 1.5-3 times after the insertion of the interlayer of only ca. 2 nm, which could be attributed to the reduction of the car- tier injection barrier. The results suggest a simple and effective way to achieve low-threshold-voltage pentacene-based organic thin film transistors with high mobility on silicon dioxide dielectric.
基金jointly supported by the National Natural Science Foundation of China (Grant No. 50907007)the Specialized Research Fund for the Doctoral Program of Higher Education (Grant No. 20090092120041)+1 种基金the Natural Science Foundation of Jiangsu Province (Grant No. BK2010197)the Key Projects in the Changzhou Science & Technology Pillar Program (Grant No. CE20110024)
文摘This paper reports a new application of permanent magnet actuator for vacuum contactors.A novel permanent magnet(PM) actuator to drive a vacuum contactor with intrinsically safe and low supply voltage is proposed.PM is mounted on the static iron of the contactor to enhance its holding force and reliability.While only one coil is used to break the vacuum contactor,two series coils are deployed to yield a high magnetomotive force to realize the making operation.The electrical circuit equation,mechanical equation and magnetic field are all coupled in the simulation.A prototype is manufactured and tested to validate and showcase the performance of the contactor which is equipped with the proposed PM actuator.