Micro-arc oxidation （MAO） process was carried out on AZ91D alloy in alkaline borate solution using an alternative square-wave power source with different parameters. The effects of voltage, frequency and duty cycle ...Micro-arc oxidation （MAO） process was carried out on AZ91D alloy in alkaline borate solution using an alternative square-wave power source with different parameters. The effects of voltage, frequency and duty cycle on the coatings were investigated by orthogonal experiment. It is found that the thickness of coatings increases with the increase of voltage and duty cycle, but decreases with the increase of frequency. The structure and morphology of the coatings also depend on voltage, frequency and duty cycle. The coatings become more porous and crack with increasing voltage and duty cycle. The coating is thin and transparent when the voltage is lower than 120 V. The corrosion resistances of different coatings were evaluated by polarization curves and electrochemical impedance spectroscopy （EIS） in 3.5% NaCl （mass fraction） solution. When the optimized values of voltage, frequency and duty cycle are 140 V, 2 000 Hz and 0.4, respectively, the anodic coating shows the best corrosion resistance.展开更多
Based on orthogonal experiments,the effects of voltage,frequency,duty ratio and their interactions on the thickness and corrosion resistance of coatings prepared by plasma electrolytic oxidation(PEO)on aluminum in an ...Based on orthogonal experiments,the effects of voltage,frequency,duty ratio and their interactions on the thickness and corrosion resistance of coatings prepared by plasma electrolytic oxidation(PEO)on aluminum in an alkaline silicate-containing electrolyte were investigated.The thicknesses of these coatings were obtained by measuring their cross-section using Image J software.Their corrosion resistances were evaluated in HCl and NaCl media through spot test and electrochemical test.The results show that the experimental design of this study is the key to investigate the interactions among these electrical parameters.Additionally,not only each independent factor,but also their interactions exhibit a remarkable influence on the coatings.The combination of high voltage,low frequency and large duty ratio significantly increases the coating thickness and content of the corrosion resistance phase,and thus improves the corrosion resistance of the coating in HNO3 medium.Conversely,the coating possessing the densest microstructure and best corrosion resistance in NaCl medium is obtained when low voltage and high frequency match with a small duty ratio.展开更多
A rectangle capacity patch was adopted as the resonance unit of the Log Periodic Dipole Antenna (LPDA) so as to realize the miniaturization of this aerial in this paper. Fifteen rectangle capacity patch units of diffe...A rectangle capacity patch was adopted as the resonance unit of the Log Periodic Dipole Antenna (LPDA) so as to realize the miniaturization of this aerial in this paper. Fifteen rectangle capacity patch units of different parameters were analyzed in this paper and three design laws of size-reduction were found. Accord-ing to these design laws, a 70% miniaturization ratio LPDA was designed and fabricated. The Voltage Standing Wave Ratio (VSWR) and pattern of the fabricated LPDA were measured. The results indicate that this size-reduction method do not deteriorate performance.展开更多
A novel design of multiplex differential voltage comparators(MDVC) is presented for reducing current and power dissipation. According to the special properties of relational operation and logical operation, parts of t...A novel design of multiplex differential voltage comparators(MDVC) is presented for reducing current and power dissipation. According to the special properties of relational operation and logical operation, parts of the comparators are redundant in some instances, and thus can be turned off. By selecting and switching the current routes, several effective differential pairs are biased by a single tail current stage-by-stage and the redundant comparators are turned off by cutting their tail currents. As a result, the quiescent current and power consumption are greatly decreased. The switching of current is achieved by the input differential pair transistors themselves and hence no extra switches are required. When a MDVC is used in a flash analog-to-digital converter(ADC), its current dissipation is much lower than that of the conventional comparators. This architecture can also be used in window-comparators, maximum or minimum comparators, and comparators for logical operations. The power dissipation in all these cases could be reduced significantly.展开更多
基金Project (50801056) supported by the National Natural Science Foundation of ChinaProject (2005DKA10400-Z20) supported by the National R&D Infrastructure and Facility Development Program of ChinaProject supported by the Zijin Project of Zhejiang University, China
文摘Micro-arc oxidation （MAO） process was carried out on AZ91D alloy in alkaline borate solution using an alternative square-wave power source with different parameters. The effects of voltage, frequency and duty cycle on the coatings were investigated by orthogonal experiment. It is found that the thickness of coatings increases with the increase of voltage and duty cycle, but decreases with the increase of frequency. The structure and morphology of the coatings also depend on voltage, frequency and duty cycle. The coatings become more porous and crack with increasing voltage and duty cycle. The coating is thin and transparent when the voltage is lower than 120 V. The corrosion resistances of different coatings were evaluated by polarization curves and electrochemical impedance spectroscopy （EIS） in 3.5% NaCl （mass fraction） solution. When the optimized values of voltage, frequency and duty cycle are 140 V, 2 000 Hz and 0.4, respectively, the anodic coating shows the best corrosion resistance.
基金Project(1111RJDA011)supported by the Creative Research Group Fund of Gansu Province,ChinaProject(SKLAB02015006)supported by the State Key Laboratory Open Fund of Advanced Processing and Recycling of Nonferrous Metals,China。
文摘Based on orthogonal experiments,the effects of voltage,frequency,duty ratio and their interactions on the thickness and corrosion resistance of coatings prepared by plasma electrolytic oxidation(PEO)on aluminum in an alkaline silicate-containing electrolyte were investigated.The thicknesses of these coatings were obtained by measuring their cross-section using Image J software.Their corrosion resistances were evaluated in HCl and NaCl media through spot test and electrochemical test.The results show that the experimental design of this study is the key to investigate the interactions among these electrical parameters.Additionally,not only each independent factor,but also their interactions exhibit a remarkable influence on the coatings.The combination of high voltage,low frequency and large duty ratio significantly increases the coating thickness and content of the corrosion resistance phase,and thus improves the corrosion resistance of the coating in HNO3 medium.Conversely,the coating possessing the densest microstructure and best corrosion resistance in NaCl medium is obtained when low voltage and high frequency match with a small duty ratio.
文摘A rectangle capacity patch was adopted as the resonance unit of the Log Periodic Dipole Antenna (LPDA) so as to realize the miniaturization of this aerial in this paper. Fifteen rectangle capacity patch units of different parameters were analyzed in this paper and three design laws of size-reduction were found. Accord-ing to these design laws, a 70% miniaturization ratio LPDA was designed and fabricated. The Voltage Standing Wave Ratio (VSWR) and pattern of the fabricated LPDA were measured. The results indicate that this size-reduction method do not deteriorate performance.
基金National Natural Science Foundation of China(60172004)PhD Subject Research Foundation of Ministry of Education of China(20010701003)
文摘A novel design of multiplex differential voltage comparators(MDVC) is presented for reducing current and power dissipation. According to the special properties of relational operation and logical operation, parts of the comparators are redundant in some instances, and thus can be turned off. By selecting and switching the current routes, several effective differential pairs are biased by a single tail current stage-by-stage and the redundant comparators are turned off by cutting their tail currents. As a result, the quiescent current and power consumption are greatly decreased. The switching of current is achieved by the input differential pair transistors themselves and hence no extra switches are required. When a MDVC is used in a flash analog-to-digital converter(ADC), its current dissipation is much lower than that of the conventional comparators. This architecture can also be used in window-comparators, maximum or minimum comparators, and comparators for logical operations. The power dissipation in all these cases could be reduced significantly.
