浅议半导体元件温度测量技术

随着温度的增加,处理器的速度、最高工作频率等会下降。因此,掌握对半导体进行准确温度测量的技术是必须的。精确测量半导体器件的工作温度,主要有三种方法:光学法、物理接触法和电学法。

基于Al_2O_3封装薄膜的OLED水汽透过率测试方法及系统研究

水汽透过率(WVTR)是衡量有机电致发光器件(OLED)封装薄膜性能的重要参数之一。本文研究了基于钙电学法的WVTR测试方法,设计并研制了可满足OLED水汽透过率测试精度和功能要求的测试系统,测试精度达1×10-6g·m-2·d-1,量程为10 g·m-2·d-1,可同时完成20个样品的快速、精确测量。利用本系统对采用原子层沉积技术制备的不同厚度Al2O3封装薄膜的WVTR进行了测试研究,结果表明,Al2O3薄膜具有良好的水汽阻挡性能。

刮膜式分子蒸馏装置中的液膜状态实验

采用电学测量法对刮膜式分子蒸馏过程中蒸发壁面上液膜的连续性和液膜厚度进行测量.根据蒸发器壁面上液膜分布对导电性的影响,通过对电压信号的分析,总结出判断壁面液膜连续性的判据:各点的电压必须非零且分布均匀;波动较大.根据液膜厚度与导电溶液电阻值之间的关系,得到了壁面上液膜的平均厚度在0.01,mm数量级;使用响应曲面法对实验数据进行处理,得到并验证了液膜厚度的二阶经验关联式.实验结果表明,对于刮膜式分子蒸馏装置,提高进料速度和转子转速有利于改善壁面上液膜的连续性,而且在不同进料速度下,影响液膜厚度的主要因素不同.研究结果为设计和使用刮膜式分子蒸馏提供了理论依据.

A new measurement method of crack propagation rate for brittle rock under THMC coupling condition

A new electrical method of conductive carbon-film(with waterproof and anticorrosion ability)was proposed to continuously measure crack propagation rate of brittle rock under THMC coupling condition.A self-designed coupling testing system was used to conduct THMC coupling fracture tests of the pre-cracked red sandstone specimens(where the temperature is only changed)by this new electrical method of conductive carbon-film.Calculation results obtained by the energy method coincide well with the test results.And the higher the temperature is,the earlier the crack is initiated and the larger the crack propagation rate and accelerated velocity are,which can prove the validity of the new electrical method.This new electrical method has advantages of continuously measuring crack propagation rate over the conventional electrical,optical and acoustic methods,and can provide important basis for safety assessment and cracking-arrest design of deep rock mass engineering.

Use of microelectrodes for electrochemical measurement of nitric oxide in natural seawater

In this paper, the application of a homemade Nafion and Co(Salen) modified platinum microelec-trode and an ISO-NOPMC microsensor (World Precision Instruments, USA ) to measure nitric oxide in natural seawater is reported. These two microelectrodes are suitable for the measurement. In natural seawater, the sensitivity and stability of the ISO-NOPMC microsensor are higher than that of the homemade Nafion and Co(Salen) modified platinum microelectrode.

New Terms for Compact Form of Electroweak Chiral Lagrangian

The compact form of the electroweak chiral Lagrangian is a reformulation of its original form and is expressed in terms of chiral rotated electroweak gauge fields, which is crucial for relating the information of underlying theories to the coefficients of the low-energy effective Lagrangian. However the compact form obtained in previous works is not complete. In this letter we add several new chiral invariant terms to it and discuss the contributions of these terms to the original electroweak chiral Lagrangian.

CORRELATION INVESTIGATION BETWEEN CONTACT APPROACH SPEED OF HANDHELD METAL ROD AND DISCHARGE PARAMETERS FROM CHARGED HUMAN BODY

Characteristic measurement of contact discharge currents are made through a hand-held metal rod from charged human body. Correlation coefficients are obtained, through Statistic Package for Social Science (SPSS), for various charge voltages, which is based on the effect test of electrode contact approach speeds on discharge current parameters of current peaks, maximum rising slope and spark lengths. Discharge parameters at charge voltage 300V are independent on approach speed. For charge voltages equal to and higher than 500V, the contact approach speed has strong positive cor- relation with discharge parameters of the peak current and the maximum rising slope, whereas has strong negative correlation with the spark length.

Adsorption isotherm mechanism of amino organic compounds as mild steel corrosion inhibitors by electrochemical measurement method

The inhibition ability of 4-amino-5-phenyl-4H-1, 2, 4-trizole-3-thiol （APTT）, ethylenediaminetetra-acetic acid （EDTA） and thiourea （TU） for mild steel corrosion in 1.0 moFL HC1 solution at 30 ℃ was investigated. Tafel polarization and electrochemical impedance spectroscopy （EIS） were used to investigate the influence of these organic compounds as corrosion inhibitors of mild steel in 1.0 mol/L HC1 solution at 30 ℃. The inhibition mechanism was discussed in terms of Langrnuir isotherm model. Results obtained from Tafel polarization and impedance measurements are in a good agreement. The inhibition efficiency increases with the increase of the inhibitor concentration. The adsorption of the inhibitors on the mild steel surface follows Langmuir adsorption isotherm and the free energy of adsorption AGads indicates that the adsorption of APTT, EDTA, and TU molecules is a spontaneous process and a typical chemisorption.

An Electrochemically Assisted Mechanically Controllable Break Junction Approach for Single Molecule Junction Conductance Measurements

We report an electrochemically assisted mechanically controllable break junction （EC-MCBJ） approach to investigating single molecule conductance. Electrode pairs connected with a gold nanobridge were fabricated by electrochemical deposition and then mounted on a homebuilt MCBJ platform. A large number of Au- molecule-Au junctions were produced sequentially by repeated breaking and reconnecting of the gold nanobridge. In order to measure their single molecule conductance, statistical conductance histograms were generated for benzene-l,4-dithiol （BDT） and 4,4＇-bipyridine （BPY）. The values extracted from these histograms were found to be in the same range as values previously reported in the literature. Our method is distinct from the ones used to acquire these previously reported literature values, however, in that it is faster, simpler, more cost-effective, and changing the electrode material is more convenient.