电控信一体化移动式撬体的技术改进方案

油气工程的大多数中小型站场主要处于沙漠以及山地等特殊的地区,涉及了加热防冻设备等设施。油气工程在设计过程中需要考虑到这些复杂的因素,在建筑内合理设置通信系统以及供配电系统等。

QoS-based MAC protocol for cognitive radio networks

In order to improve the throughput performance of the secondary users （SUs） in the cognitive radio （CR） environment, a quality of service （QoS） based media access control （MAC） protocol is proposed. In this protocol, the CR node maps the channel state as a vector, and the transmitter and the receiver obtain the final channel map through an AND operation to prepare for an optional channel set. Data from the upper application layer are classified into two priority levels according to the QoS requirement. The data of each level relate to different contention windows so that the priority of real time data can be guaranteed. A two-dimensional discrete-time Markov chain is utilized to evaluate the system performance, and mathematical expressions of the system throughput are derived. Simulation results show that compared with the IEEE 802. 11 distributed coordination function （DCF）, the proposed MAC protocol can achieve higher throughput.

1.0 V low voltage CMOS mixer based on voltage control load technique

A CMOS active mixer based on voltage control load technique which can operate at 1.0 V supply voltage was proposed, and its operation principle, noise and linearity analysis were also presented. Contrary to the conventional Gilbert-type mixer which is based on RF current-commutating, the load impedance in this proposed mixer is controlled by the LO signal, and it has only two stacked transistors at each branch which is suitable for low voltage applications. The mixer was designed and fabricated in 0.18 tam CMOS process for 2.4 GHz ISM band applications. With an input of 2.44 GHz RF signal and 2.442 GHz LO signal, the measurement specifications of the proposed mixer are： the conversion gain （Gc） is 5.3 dB, the input-referred third-order intercept point （PIIP3） is 4.6 dBm, the input-referred 1 dB compression point （P1dB） is --7.4 dBm, and the single-sideband noise figure （NFSSB） is 21.7 dB.

Non-inverting buck-boost DC-DC converter based on constant inductor current control

The hysteresis control combined with PWM control non-inverting buck-boost was proposed to improve the light load efficiency and power density.The constant inductor current control(CICC)was established to mitigate the dependence on the external components and device variation and make smooth transition between hysteresis control loop and pulse width modulation(PWM)control loop.The small signal model was deduced for the buck and boost operation mode.The inductor current slope control(ICSC)was proposed to implement the automatic mode transition between buck and boost mode in one switching cycle.The results show that the converter prototype has good dynamic response capability,achieving 94%efficiency and 95%peak efficiency at full 10 A load current.

Research on Development Trend of Automobile Electronic Technology

Along with the popularization of artificial intelligence and information technology, the development of automobile industry have been closely combined with information technology, environmental protection and energy saving ideas, promotion and application of electronic control technology, which development cycle becoming shorter and shorter. In this paper, through the analysis of the present application situation and development trend of the automobile electronic technology at present, in order to provide a theoretical reference for the future development of the automobile electronic control technology.

FINDING THE OPTIMAL LENGTH OF DATA FRAME IN PLC COMPUTER NETWORK

The length of data frame is an important parameter in Medium Access Control(MAC) layer protocol. A method of finding the optimal length of data frame when impulsive disturbance is involved in PowerLine Communications (PLC) is proposed. Having analyzed the characteristics of impulsive disturbance in powerline and the collision mechanism between the disturbance and data frame, this letter gives the function of the network channel utilization with the length of data frame in MAC layer and the impulsive disturbance. Our stochastic process simulation shows that it is feasible to get the optimal length of data frame.

Power Control Algorithm of Cognitive Radio Based on Non-Cooperative Game Theory

This paper addresses the power con- trol problems of Cognitive Radio （CR） trader transmission power and interference tempera- ture constraints. First, we propose the interfer- ence constraint which ensures that the Quality of Service （QoS） standards for primary users is considered and a non-cooperative game power control model. Based on the proposed model, we developed a logical utility function based on the Signal-to-Interference-Noise Ratio （S/NR） and a novel algorithm network power control. that is suitable for CR Then, the existence and uniqueness of the Nash Equilibrium （NE） in our utility function are proved by the principle of game theory and the corresponding optimi- zations. Compared to traditional algorithms, the proposed one could converge to an NE in 3-5 iterative operations by setting an appropriate pricing factor. Finally, simulation results ver- ified the stability and superiority of the novel algorithm in flat-fading channel environments.

Research and Development of a Communication Monitor to a Distribution Management System

Based on the existed equipment (the power line carrier, optic fiber, twisted pair and wireless apparatus) being used to the same route in the current communication net of distribution management system (DMS), this paper presents a new kind of communication monitor DMS, which provides a communication monitoring interface and then by DMS, data transfer problem from field terminal unit to junction center station can be solved and the communication channels can also be supervised. At the same time, synthetically using computer communication, internet technology and database technology, this system can realize the real time monitoring and fault locating in the communication network.

A NOVEL PAPR REDUCTION WITH TRELLIS SHAPING FOR NC-OFDM IN COGNITIVE RADIO

In this paper, trellis shaping is applied to reducing the Peak-to-Average Power Ratio(PAPR) of NC-OFDM signals due to the fact that the total number of active subcarriers and their locations might change continuously in a dynamic spectrum access network.A new branch metric of trellis shaping is proposed which reduces the PAPR of OFDM signals through minimizing the variance of the power by VA decoder.The overall performance considerably depends on the type of signal mapping, and therefore a new type of 64QAM mapping method is designed.Simulation results show that this scheme significantly reduces the PAPR.Finally, a significant phenomenon is demonstrated that the PAPR of NC-OFDM signals in which the deactivated carriers is distributed in the Bernoulli distribution has better performance than that of OFDM signals.

Distributed Power Control for Energy Conservation in Hybrid Cellular Network with Device-to-Device Communication

Device-to-Device(D2D) communication has been proposed as a promising implementation of green communication to benefit the existed cellular network.In order to limit cross-tier interference while explore the gain of short-range communication,we devise a series of distributed power control(DPC) schemes for energy conservation(EC)and enhancement of radio resource utilization in the hybrid system.Firstly,a constrained opportunistic power control model is built up to take advantage of the interference avoidance methodology in the presence of service requirement and power constraint.Then,biasing scheme and admission control are added to evade ineffective power consumption and maintain the feasibility of the system.Upon feasibility,a non-cooperative game is further formulated to exploit the profit in EC with minor influence on spectral efficiency(SE).The convergence of the DPC schemes is validated and their performance is confirmed via simulation results.

A Tentative Analysis of the Use of Potential by Commercial Bank in Controlling Credit Scale

This article brings forward the conception of potential and filed potential in bank's competition under the inspiration of law of electric current in electrodynamics. It discusses the impact of potential shifting on commercial bank's credit scale and builds up a model for commercial bank to control the scale by credit pricing and risk policy in a dynamic way, and also gives some advice to domestic commercial bank for improving loan business, aiming to settle down the existing credit management problems.

Hierarchical Code Assignment Algorithm and StateBased CDMA Protocol for UWSN

The characteristics of underwater acoustic channel such as long propagation delay and low bit rate cause the MAC(Medium Access Control) protocols designed for radio channels to be either inapplicable,or have low efficiency for UWSN(Underwater Sensor Network).We propose a hierarchical and distributed code assignment algorithm based on divisive probability function which can avoid conflict between spread codes with high probability,and provide a statebased MAC protocol for UWSN.Without RTS/CTS(Request To Send/Clear To Send) handshaking,each node maintains a neighbor table including state field,and packages are forwarded according to the state of the receiver,so it can avoid the interference caused by transmitting to a sending node in a half-duplex system and improve channel utilization.The design of power control minimizes the nearfar effect inherent in CDMA.Simulation results reveal that state-based CDMA protocol shows outstanding performance in throughput,delivery ratio and resource-consumption.

Investigation of Improved Signal Process and Control Circuit for Color-PDP

We present an alternative current-plasma display panel (AC-PDP) signal process and control circuit that fulfills the signal process and transform function. We proposed a novel driving logical waveform generator based on the SCI interface, which can real-time adjust the parameters to optimize performance of the PDP and facilitate the research and test. The use of nesting state-machine and parameterized design not only improves the resource utilization, but also makes it efficient and readable. The design has been written in synthesizable Verilog and fully verified using Xilinx FPGA device and applied in 42-in AC-PDP module.

Research on CMOS Mm-Wave Circuits and Systems for Wireless Communications

This paper lenges in the design of discusses some chal- millimeter-wave （mln- wave） circuits and systems for 5th generation （5G） wireless systems in CMOS process. The properties of some passive and active devices such as inductors, capacitors, transmission lines, translbrmers and transistors in mm-wave frequency band are discussed. Self-healing technique dealing with PVT variation, res- onant mode switching technique to enhance frequency tuning range of voltage controlled oscillator （VCO） and dual mode technique for power amplifier （PA） efficiency enhancement are introduced. At last, A fully-integrated 60 GHz 5 Gb/s QPSK transceiver with the transmit/receive （T/R） switch in 65nm CMOS process is introduced. The measured error vector magnitude （EVM） of the TX is -21.9 dB while the bit error rate （BER） of the RX with a -52 dBm sine-wave input is below 8e-7 when transmitting/receiving 5 Gb/s data. The transceiver is powered by 1.0 V and 1.2 V supply （except the phase-frequency detector and charge-pump in the frequency synthesizer which are powered by 2.5 V supply） and con- sumes 135 mW in TX mode and 176 mW in RX mode.

The Spatial Equivalence Between Wavelet Decomposition and Phase Space Embedding of EEG

Using both the wavelet decomposition and the phase space embedding, the phase trajectories of electroencephalogram (EEG) is described. It is illustrated based on the present work,that is,the wavelet decomposition of EEG is essentially a projection of EEG chaotic attractor onto the wavelet space opened by wavelet filter vectors, which is in correspondence with the phase space embedding of the same EEG. In other words, wavelet decomposition and phase space embedding are equivalent in methodology. Our experimental results show that in both the wavelet space and the embedded space the structure of phase trajectory of EEG is similar to each other. These results demonstrate that wavelet decomposition is effective on characterizing EEG time series.

The Information Security of Digital Control Systems for Nuclear Power Plants

The NPP （nuclear power plant） being vital objects of an energy infrastructure must be protected against malicious actions affecting their safety, and cyber security plays a key part in attaining this goal. The paper considers, implemented by the authors within the project of advanced digital control system for NPP with the reactor VVER-1000, a system of unauthorized access protection, partially built up on the technology of AA （active audit） and expert system. The AA technology is based on response of the system on deviation of current signature of the automated process control system from stable state rather than on a certain signature of attack and relies on the estimation of the behavioral models of the particular digital control system. The advent of active audit reflects the current situation in the digital control systems where complex distributed platforms are used to construct automated process control system. The active audit allows one to make the digital control system functionally closed, provided that it is determinate. The methodology of the active audit does not give u external （barrier） and traditional （password, antivirus） methods of unauthorized access protection. These methods can be used when it is appropriate to achieve a required protection level.

A MEMS stronglink with multi-try function used for PC startup in authentication system

The stronglink with muhi-try function based on MEMS technology and the PC startup in authentication system have been designed and fabricated. The generation principle and structure of UQS code are introduced, which consists of two groups of metal counter-meshing gears, two pawl/ratchet mechanisms, two driving micromotors and two resetting micromotors. The energy-coupling element is a photoelectric sensor with a circular and notched plate. It is fabricated using the UV-LiGA process and precision mechanical engineering. The PC startup authentication system is controlled by BIOS program, which is written into the chip according with special format. The program in BIOS output signals controls the running of stronglink to finish the process of authentication. The device can run more than 10000 times before a stop. The driving voltage is 12 V, and the normal decoding time is 3 s.

Design of Communication and Control System for Motor based on DSP

The article is designed hardware platform of TMS320F2812 primary control chip based on the motor drive controller outputs and input signal, the use of DSP technology, together with the corresponding peripheral driver circuit, a signal processing circuit and other processing module, the design and realize a piece of printed circuit board to achieve the required functionality. Systems software modules is implement hardware configuration and achieve control strategies in the DSP CCS compiler environment and using C and assembly language. Through CAN controller that comes with the DSP programming, achieved its CAN signal transmission and reception.

A Magnetron Power Supply with Transition-Mode Zero-Voltage-Switching Inverter

This paper presents a transition-mode zero-voltage-switching inverter for the cooker magnetron of household microwave ovens. The inverter drives a leakage transformer to generate the required high voltage and stabilized current. For achieving zero-voltage switching, a transition-mode driver L6561 is utilized to detect the ending of transformer resonance and drive an insulated-gate-bipolar-transistor. As transistor is conducted, rectified direct-current voltage drives the transformer. While transistor is cut off, transformer resonates with a parallel capacitor. Transistor conduction time and magnetron power are controlled with a 16-bit digital signal controller dsPIC30F4011. For widening the working range, transistor conduction time is set to be inversely changed with line-frequency input voltage. To demonstrate the analysis and design of this paper, a 1 kW inverter circuit is built. Experimental results show the feasibility and usefulness of the designed magnetron power supply.

Analytical Modeling and Experimental Validation of Electromagnetic Field Radiated by In-house PLC Lines

Broadband PLC （power line communication） technology is a main factor of the development of digital convergence in the indoor network. It uses the already existing power cable infrastructure for communication purposes. The EM （electromagnetic） field radiating from the cable could, however, disturb other communication systems, and thus should be evaluated. The MoM （method of moment） and the FEM （finite element method） have been studied to estimate the EVI field emitted from the power cable. However, the M oM is difficult to treat the dielectric material of the cable and the FEM is time consuming. This paperpresents a new approach to estimate the radiated EM fields caused by PLC sy stems from the CM current along the cable, based on the transmission line theory. The proposed model has the advantage of using the measured primary parameters of the cable. An experimental analysis of the EM radiation distribution is also presented. A comparison showed that the model results agree quite well with the measurements performed in this study.