漂白废水中氯化木素的电氧化处理

用二氧化铅作阳极，不锈钢网为阴极，通过电氧化法处理多段漂白废水中的氯化木素。研究发现，废水中氯化木素的浓度及电导率均是随时间先增加后减少；而废水的 COD 和色度在整个过程中一直减少；废水的 pH 在电氧化初期不变，在中后期下降。木素的芳香环在电氧化过程中，会发生开环反应。不同的电解电压对电氧化处理效果有不同的影响。

含氯漂白废水的电氧化处理

以二氧化铅为阳极,不锈钢网为阴极,用电化学氧化法处理多段漂白废水中的有害物质。其中二氧化铅电极是通过在碳棒上电镀而成的。研究发现,废水的电导率和pH值对于不同的废水在电化学氧化过程中的变化是不同的;而废水的COD和色度在整个过程中一直减少;氯化木质素的分子量和分子量分布发生了变化。

线路板废水处理的探讨

本文介绍使用不同的废水处理工艺对线路板废水处理的影响，详细说明使用不同用量的化学物料时废水处理产生的效果和水处理的成本降低。

采用Ti/PbO_2阳极氧化进行污泥预处理的研究

提高市政污泥脱水性能是当前污泥预处理中的热点和难点.本文以毛细吸水时间(CST)作为衡量污泥预处理中脱水性能的指标,选用钛/二氧化铅网状极板为阴、阳电极,研究了电解电压、极板间距、电解质种类及电解质投加量等因素对电化学预处理市政污泥的影响.结果表明,电压对污泥脱水性能影响较大,在电压为20 V、极板间距为2 cm、电解质为0.6 g Na Cl的条件下,电化学处理市政污泥20 min效果最佳,污泥的CST下降率在90%以上.进一步探究表明,电解过程中污泥菌胶团结构首先被破坏,释放大量结合水,且菌胶团内的蛋白质和多聚糖释放到上清液中,二者浓度先升高;随后二者部分氧化分解,浓度降低,从而有效提高市政污泥脱水性能.

Design and fabrication of alumina micro reciprocating engine

Microengines are regarded as the potential replacements for batteries.Aimed at the unsatisfactory thermal property of silicon used in the combustion chambers,ceramics are chosen as the construction material in this paper.The fabrication process where alumina has been chosen as the microengine material is discussed.Vigorous FEA has been carried out,and it is found that the material satisfies the stress and deformation requirements of the design.Then the alumina fabrication process is described.Soft reusable polydimethylsiloxane(PDMS)moulds are produced from SU-8 resist masters,and alumina microengine parts are produced using the PDMS moulds.Images of the ceramic components show that the fabrication satisfies the design requirements.

Enhanced electrocatalytic activity for H_2O_2 production by the oxygen reduction reaction: Rational control of the structure and composition of multi-walled carbon nanotubes

Hydrogen peroxide(H2O2)is a very useful chemical reagent,but the current industrial methods for its production suffer from serious energy consumption problems.Using high-activity and high-selectivity catalysts to electrocatalyze the oxygen reduction reaction(ORR)through a two-electron(2e^-)pathway is a very promising route to produce H2O2.In this work,we obtained partially oxidized multi-walled carbon nanotubes(MWCNTs)with controlled structure and composition by oxidation with concentrated sulfate and potassium permanganate at 40℃ for 1 h(O-CNTs-40-1).The outer layers of O-CNTs-40-1 are damaged with defects and oxygen-containing functional groups,while the inner layers are maintained intact.The optimized structure and composition of the partially oxidized MWCNTs ensure that O-CNTs-40-1 possesses both a sufficient number of catalytic sites and good conductivity.The results of rotating ring disk electrode measurements reveal that,among all oxidized MWCNTs,O-CNTs-40-1 shows the greatest improvement in hydrogen peroxide selectivity(from ~ 30% to ~ 50%)and electron transfer number(from ~ 3.4 to ~ 3.0)compared to those of the raw MWCNTs.The results of electrochemical impedance spectroscopy measurements indicate that both the charge-transfer and intrinsic resistances of O-CNTs-40-1 are lower than those of the raw MWCNTs and of the other oxidized MWCNTs.Finally,direct tests of the H2O2 production confirm the greatly improved catalytic activity of O-CNTs-40-1 relative to that of the raw MWCNTs.

Treatment of chitin-producing wastewater by micro-electrolysis-contact oxidization

The technique of micro-electrolysis-contact oxidization was exploited to treat chitin-producing wastewater. Results showed that Fe-C micro-electrolysis can remove about 30% CODcr, raise pH from 0.7 to 5.5. The CODcr removal efficiency by biochemical process can be more than 80%. During a half year抯 operation, the whole system worked very stably and had good results, as proved by the fact that every quality indicator of effluent met the expected discharge stan-dards; which means that chitin wastewater can be treated by the technique of micro-electrolysis, contact oxidization.

An ab initio study on single electron transfer between ClO_2 and phenol

The SET mechanism between chlorine dioxide （ClO2） and phenol was studied by using ab initio method at 4-31G* level. Geometries of the reactants, intermediate and products of the reaction were optimized and the single point energy calculations of the species were performed. The relative structure data of the reactants, intermediate and products are given.The SET mechanism between ClO2and phenol was confirmed by ab initio calculations. The reaction is exothermic about 200 88 kJ/mol.

Mechanism of oxidation of low rank coal by nitric acid

The pretreatment of low rank coal with nitric acid oxidation can promote its bio-liquefaction. However, the detailed mechanism of which remains an unresolved problem. In the present work, the characteristics of Fushun coal before and after oxidation by nitric acid were investigated combined with elemental composition, pore volume and pore size, Zeta potential, FT-IR, and 13C solid NMR spectrum analysis. The results show that the inorganic substance inlaid in coal are dissolved by ni- tric acid, which results in the decrease of coal ash content and increase of pore volume and pore size. Furthermore, there exist obvious chemical reactions between nitric acid and the functional groups of coal including aromatic ring carboxylation, side chain alkyl of aromatic ring oxidation and aromatic ring nitration. Among these reactions, some led to the increase in content of carboxyl, aliphatic carbon connected with O and humic acid carbon, while others caused the reduction of aromaticity, methyl carbon, substituted aryl carbon and side chain.

Magnetic field assisted electrocatalytic oxidation of organic pollutants in electroplating wastewater

To degrade the organic compounds in the electroplating wastewater,magnetic field was tentatively introduced into electrocatalytic oxidation on Ti-PbO2 anode.The magnetic field assisted electrocatalytic oxidation can promote anion movement and the generation of active species,resulting more organic compounds to be oxidized and degraded.Oxidation parameters such as treatment time,current density and initial pH of the wastewater were systematically discussed and optimized.The mineralization of organic compounds is improved by over 15% under a magnetic density of 22 mT while the current density is 50 A/m2,pH is 1.8 and the reaction time is 1.5 h.The results indicate that the magnetic field assisted electrocatalytic oxidation has considerable potential in electroplating wastewater treatment.

Effects of oxidation treatment on properties of SiO_(2f)/SiO_2-BN composites

The silica fiber reinforced silica and boron nitride-based composites （SiO2f/SiO2-BN） were prepared firstly via the sol-gel method and then the urea route, and the effects of oxidation treatment on the component, structure, mechanical and dielectric properties of the composites were investigated. The results show that the oxidation treatment at 450 ℃ will not impair the structure of boron nitride, and carbon is the main impurity with the excessive urea. The density of SiO2f/SiO2-BN composites is 1.81 g/cm3, and the flexural strength and elastic modulus are 113.9 MPa and 36.5 GPa, respectively. After oxidation treatment, the density varies to 1.80 g/cm3, and the flexural strength and elastic modulus are decreased to 58.9 MPa and 9.4 GPa, respectively. The mechanical properties of the composites are severely damaged, but they still exhibit a good toughness. The composites show excellent dielectric properties with the dielectric constant and loss tangent being 3.22 and 0.003 9, respectively, which indicates that the oxidation treatment is ineffective to improve the dielectric properties of SiOzf/SiO2-BN composites.

Nitrite Accumulation during the Denitrification Process in SBR for the Treatment of Pre-treated Landfill Leachate

The nitrite accumulation in the denitrification process is investigated with sequencing batch reactor （SBR） treating pre-treated landfill leachate in anoxic/anaerobic up-flow anaerobic sludge bed I（UASB）. Nitrite accumulates obviously at different initial nitrate concentrations （64.9,54.8,49.3 and 29.5 mg·L^-1 ） and low temperatures, and the two break points on the oxidation-reduction potential （ORP） profile indicate the completion of nitrate and nitrite reduction. Usually, the nitrate reduction rate is used as the sole parameter to characterize the denitrification rate, and nitrite is not even measured. For accuracy, the total oxidized nitrogen （nitrate ＋ nitrite） is used as a measure, though details characterizing the process may be overlooked. Additionally, batch tests are conducted to investigate the effects of C/N ratios and types of carbon sources on the nitrite accumulation during the denitrification. It is observed that carbon source is sufficient for the reduction of nitrate to nitrite, but for further reduction of nitrite to nitrogen gas, is deficient when C/N is below the theoretical critical level of 3.75 based on the stoichiometry of denitrification. Five carbon sources used in this work, except for glucose, may cause the nitrite accumulation. From experimental results and cited literature, it is concluded that Alcaligene species may be contained in the SBR activated-sludge system.

Effects of sodium tungstate on properties of micro-arc coatings on magnesium alloys

Anodic coatings were prepared by micro-arc oxidation on AZ91HP magnesium alloys in a base solution containing 10 g/L NaOH and 12 g/L phytic acid with addition of 0-8 g/L sodium tungstate.The effects of sodium tungstate on the coating thickness, mass gain,surface morphology and corrosion resistance were studied by eddy current instrument,electronic scales,scanning electron microscope and immersion tester.With the addition of sodium tungstate,the electrolytic conductivity increases and the final voltage decreases.The sodium tungstate has a minor effect on the coating thickness,but lightens the coating color.With increasing sodium tungstate concentration,the size of micropores on the coatings is enlarged and the corrosion resistance of the anodized samples decreases.

Signal Processing Circuit Design of Infrared Detection System with SO2 Concentration Based on Correlation Filter Technology

Signals from infrared detector are very weak in SO2 concentration measuring system.In order to improve the sensitivity of detection,combining with filter correlation technology and infrared absorption principle,the weak signal processing circuit is designed according to correlation detection technology.Under laboratory conditions,system performance of SO2 concentration is tested,and the experimental data are analyzed and processed.Then relationship of SO2 concentration and the measuring voltage is provided to prove that the design improves measuring sensitivity of the system.

Green Synthesis of RuO2 Electrode for Electrochemical Water Treatment

Nowadays, the electrochemical water treatments are very important methods used for the removal of organic and inorganic impurities from fresh, drinking water and wastewater. The method consists of carrying out the oxidation reaction at the anode where pollutants are transferred into non-toxic substances, by decomposing into simpler compounds or transferring into oxidation form. RuO2-based Dimensional Stable Anode （DSA） is a technologically good and important electrode for water treatment because of its unique characteristics such as high thermal and chemical stability, low resistivity and low overpotential. This paper reviews the methods for fabricating RuO2-based electrodes that can be used in electrochemical water treatment. Depending on the different fabrication routes, RuO2 electrodes will possess the different electro-catalytic property and stability.

Inactivating SARS-CoV-2 by electrochemical oxidation

Fully inactivating SARS-Co V-2, the virus causing coronavirus disease 2019, is of key importance for interrupting virus transmission but is currently performed by using biologically or environmentally hazardous disinfectants. Herein, we report an eco-friendly and efficient electrochemical strategy for inactivating the SARS-Co V-2 using in-situ formed nickel oxide hydroxide as anode catalyst and sodium carbonate as electrolyte. At a voltage of 5 V, the SARS-Co V-2 viruses can be rapidly inactivated with disinfection efficiency reaching 95% in only 30 s and 99.99% in 5 min. Mass spectrometry analysis and theoretical calculations indicate that the reactive oxygen species generated on the anode can oxidize the peptide chains and induce cleavage of the peptide backbone of the receptor binding domain of the SARS-Co V-2 spike glycoprotein, and thereby disables the virus. This strategy provides a sustainable and highly efficient approach for the disinfection of the SARS-CoV-2 viruliferous aerosols and wastewater.