与强度有关的多光子JC模型

给出了计算与强度有关的多光子过程一般模型演化的基本方法 ,并由系统的某些对称性可确定强度耦合函数 f (n)

Uniform AlF_3 thin layer to improve rate capability of LiNi_(1/3)Co_(1/3) Mn_(1/3)O_2 material for Li-ion batteries

LiNi1/3Co1/3Mn1/3O2 was coated with uniform nano-sized AlF3 layer by chemical precipitation method to improve its rate capability.The samples were characterized by X-ray diffractometry (XRD),transmission electron microscopy (TEM),energy dispersive spectroscopy (EDS),charge-discharge cycling,cyclic voltammetry (CV),and electrochemical impedance spectroscopy (EIS).Uniform coated layer with a thickness of about 3 nm was observed on the surface of LiNi1/3Co1/3Mn1/3O2 particle by TEM.At 0.5C and 2C rates,1.5% (mass fraction) AlF3-coated LiNi1/3Co1/3Mn1/3O2/Li in 2.8-4.3 V versus Li/Li+ after 80 cycles showed less than 3% of capacity fading,while those of the bare one were 16.5% and 45.9%,respectively.At 5C rate,the capacity retention of the coated sample after 50 cycles maintained 91.4% of the initial discharge capacity,while that of the bare one decreased to 52.6%.EIS result showed that a little change of charge transfer resistance of the coated sample resulting from uniform thin AlF3 layer was proposed as the main reason why its rate capability was improved obviously.CV result further indicated a greater reversibility for the electrode processes and better electrochemical performance of AlF3-coated layer.

Effect of Ti on microstructure, mechanical properties and corrosion resistance of Zr-Ta-Ti alloys processed by spark plasma sintering

The microstructure,mechanical properties and corrosion resistance of Zr-30%Ta and Zr-25%Ta-5%Ti alloy prepared by spark plasma sintering(SPS)technology were investigated.The experimental results showed that the Zr-Ta-Ti alloys made by the SPS processing have a low level of porosity with the relative density of 96%−98%.The analyses of XRD and TEM revealed that the Zr-30Ta alloy consists ofα+βphase,and the Zr-25Ta-5Ti alloy belongs to the nearβtype alloy containing a small amount ofαandωphases.With the addition of Ti,the elastic modulus of the alloys was decreased from(99.5±7.2)GPa for Zr-30Ta alloy to(73.6±6.3)GPa for Zr-25Ta-5Ti alloy.Furthermore,it is shown that,in comparison to CP-Ti and Ti-6Al-4V alloy,the Zr-Ta-Ti alloy produced in this work offers an improved corrosion resistance due to the more stable ZrO2 and Ta2O5 generated in the passivation film on the surface of the alloys.This study demonstrates that Zr-Ta-Ti alloys are a promising candidate of novel metallic biomaterials.

Microstructure, sintering behavior and mechanical properties of SiC/MoSi_2 composites by spark plasma sintering

SiC/MoSi2 composites were synthesized at different temperatures by spark plasma sintering using Mo, Si and SiC powders as raw materials. The phase composition, microstructure and mechanical properties of the as-prepared composites were investigated and the sintering behavior was also discussed. Results show that SiC/MoSi2 composites are composed of MoSi2, SiC and trace amount of Mo4.8Si3C0.6 phase and exhibit a fine-grain texture. During the synthesis process, there was an evolution from solid phase sintering to liquid phase sintering. When sintered at 1600 °C, the SiC/MoSi2 composites present the most favorable mechanical properties, the Vickers hardness, bending strength and fracture toughness are 13.4 GPa, 674 MPa and 5.1 MPa·m^1/2, respectively, higher 44%, 171%, 82% than those of monolithic MoSi2. SiC can withstand the applied stress as hard phase and retard the rapid propagation of cracks as second phase, which are beneficial to the improved mechanical properties of Si C/MoSi2 composites.

Electrochemical mechanism of rusticyanin (Rus.) isolated from A.ferrooxidans measured by Rus.-ZnS-QDs/L-Cys/Au electrode

Electrochimcal behaviors of rusticyanin （Rus.） isolated from Acidithiobacillus ferrooxidans were investigated through Rus.-ZnS-QDs/L-Cys/Au electrode. The cyclic voltammetric results indicate that rusticyanin immobilized on the surface of Rus.-ZnS-QDs/L-Cys/Au electrode can undergo a direct quasi-reversible electrochemical reaction. The immobilized rusticyanin is not denatured and still retains its activity in the temperature range of 19-43 ℃. The reduction ability of the protein increases and its oxidation ability becomes weak with the increase of pH from 6.0 to 7.8. Fe^2＋ ions in the solution can promote the electron transfer kinetics of the immobilized rusticyanin and make its peak potentials （φp） markedly move negatively.

Formation of a Quasi-Stationary Discharge in the Explosive-Emission Electron Sources

Formation of a quasi-stationary discharge or quasi-stationary emission mode in the explosive-emission electron sources is related to the current limitation resulting from the emissive ability saturation of cathode plasma with its expansion. The paper shows that in the process of the discharge current stabilization in the explosive-emission sources with the point- or blade-type emitters the essential role belongs to the electron beam space charge. Availability of the space charge results in limitation of the current growth velocity at the initial discharge phase and, hence, restricts the emissive ability of the cathode plasma and contributes to its saturation. In the vacuum diodes with multiemitter cathodes, the space charge availability increases the cathode operation stability and can provide obtaining of quasi-stationary beam current values or close to them resulting in formation of a plasma emission surface at the cathode close to the continuous one.

Zero steady-states electrical energy consumption clutch system

A new clutch configuration with dual diaphragm spring is proposed. It is proper designed for electric and hybrid powertrain system. With this design, the clutch engagement is controlled by current in electrornagnet coil. For special characteristic of dual diaphragm spring, the clutch does not consume energy in steady state after engaging or disengaging. To validate the feasibility of this design, author builds the mathematical model and imports it into MATLAB Simulink. The simulation shows the behavior of clutch in different control strategies.

On Issues of Large-Scale and Long-Distance Transmission of Wind Power

While having constantly developed for five years,China's wind power meets its bottleneck of further development in fast-growing areas due to the insufficient market accommodation.In contrast,the Central China and the East China have experienced the shortage of coal,oil and natural gas for power generation in recent winters.Hence,how to handle the discrepancy between insufficient accommodation and short energy supply has become the focus of attention both domestically and abroad.Taking Jiuquan Wind Power Base as an example,the reverse distribution between the energy resources and the consumer market,the wind power accommodation and the energy transmission are analyzed;the necessity and feasibility of long-distance power transmission are also discussed,which presents a technical roadmap for the long-distance transmission of thermal and wind power in combination.

Discharge Stabilization and Obtaining of Quasi-Stationary Electron Beams in Explosive-Emission Sources

Quasistationary discharge mode setting in the explosive-emission sources is related to the saturation of the cathode plasma emissive ability resulting in the decrease of the velocity of plasma propagation into the interelectrode gap. It was shoran previously that the electron beam space charge providing the current rise slowing-down is of great importance in the process of the discharge mode stabilization. The paper considers a possibility of the discharge protraction at the expense of decrease of the ion charge order in the plasma composition and application of the directed plasma flows. The data concerning obtainig of micro- and millisecond electron beams in the explosive-emission sources are presented as well.

Hierarchically porous carbon/red phosphorus composite for high-capacity sodium-ion battery anode

Red phosphorus has received remarkable attention as a promising anode material for sodium ion batteries(NIBs) due to its high theoretical capacity. However, its practical application has been impeded by its intrinsic low electronic conductivity and large volume variations during sodiation/desodiation process. Here, we design a composite to confine nanosized red phosphorus into the hierarchically porous carbon(HPC) walls by a vaporization-condensation strategy. The mass loading of P in the HPC/P composite is optimized to deliver a reversible specific capacity of 2,202 m Ah/gpbased on the mass of red P(836 m Ah/gcompositebased on the total composite mass), a high capacity retention over 77% after100 cycles, and excellent rate performance of 929 m Ah/gpat 2 C. The hierarchical porous carbon serves as the conductive networks, downsize the red phosphorus to nanoscale, and provide free space to accommodate the large volume expansions. The suppressed mechanical failure of the red phosphorus also enhances the stability of solid-electrolyte interface(SEI) layer, which is confirmed by the microscopy and impedance spectroscopy after the cycling tests. Our studies provide a feasible approach for potentially viable high-capacity NIB anode.

Synergistic effect of atomic layer deposition-assisted cocatalyst and crystal facet engineering in SnS2 nanosheet for solar water oxidation

The severe bulk recombination and sluggish oxygen evolution reaction(OER)dynamics of photoanodes severely restrict the application of photoelectrochemical(PEC)devices.To solve these two problems,crystallographic facet orientation and cocatalyst emergence with a high-quality photoanode/cocatalyst interface were realized through an air annealing-assisted strategy to treat atomic layer deposition(ALD)-modified SnSnanosheet arrays.Based on experimental observations and theoretical calculations,the reduced(001)crystal facet of SnSdecreases the recombination of photogenerated carriers in the bulk and improves the carrier separation of the photoanode.Moreover,the unexpectedly formed ZnTiOSfilm decreases the overpotential of the surface OER,reduces interface recombination,and extends the carrier lifetime.These synergistic effects lead to significantly enhanced PEC performance,with a high photocurrent density of 1.97 mA cm^(-2)at 1.23 V vs.reversible hydrogen electrode(RHE)and a low onset potential of 0.21 V vs.RHE,which are superior to reported mostly SnS-based photoanodes.

Kinetics-controlled growth SnO2 nanorod arrays for superior rate performance of aligned mesocrystalline lithium-ion batteries with

A general method for facile kinetics-controlled growth of aligned arrays of mesocrystalline SnO2 nanorods on arbitrary substrates has been developed by adjusting supersaturation in a unique ternary solvent system comprising acetic acid, ethanol and water. The hydrolysis processes of Sn（IV） as well as the nucleation and growth of SnO2 crystals were carefully controlled in the mixed solvents, leading to an exclusively heterogeneous nucleation on a substrate and the subsequent growth into mesocrystalline nanorod arrays. In particular, aligned arrays of hierarchically structured, [001]-oriented mesocrystalline SnO2 nanorods with four {110} lateral facets can be readily grown on Ti foil as well as many other inert substrates such as fluoride-doped tin oxide （FTO）, Si, graphite, and polytetrafluoroethylene （Teflon）. Due to the unique combination of the mesocrystalline structure and the one-dimensional nanoarray structure, the obtained mesocrystalline SnO2 nanorod arrays grown on metallic Ti substrate exhibited an excellent rate performance with a high initial Coulombic efficiency of 65.6% and a reversible capacity of 720 mA.h/g at a charge/discharge rate of 10 C （namely, 7,820 mA/g） when used as an anode material for lithium-ion batteries.

Self-organized metal-semiconductor epitaxial graphene layer on off-axis 4H-SiC（0001）

The remarkable properties of graphene have shown promise for new perspectives in future electronics, notably for nanometer scale devices. Here we grow graphene epitaxially on an off-axis 4H-SiC（0001） substrate and demonstrate the formation of periodic arrangement of monolayer graphene on planar （0001） terraces and Bernal bilayer graphene on （1120） nanofacets of SiC. We investigate these lateral superlattices using Raman spectroscopy, atomic force microscopy/ electrostatic force microscopy （AFM/EFM） and X-ray and angle resolved photoemission spectroscopy （XPS/ARPES）. The correlation of EFM and ARPES reveals the appearance of permanent electronic band gaps in AB-stacked bilayer graphene on （1120） SiC nanofacets of 150 meV. This feature is confirmed by density functional theory （DFT） calculations. The charge transfer between the substrate and graphene bilayer results in an asymmetric charge distribution between the top and the bottom graphene layers opening an energy gap. This surface organization can be thus defined as self-organized metal-semiconductor graphene.

Advances of graphene application in electrode materials for lithium ion batteries

The demands for better energy storage devices due to fast development of electric vehicles(EVs) have raised increasing attention on lithium ion batteries(LIBs) with high power and energy densities. In this paper, we provide an overview of recent progress in graphene-based electrode materials. Graphene with its great electrical conductivity and mechanical properties have apparently improved the performance of traditional electrode materials. The methods and electrochemical properties of advanced graphene composite as cathode and anode for LIBs are reviewed. Two novel kinds of graphene hybrid materials are specially highlighted: three-dimensional porous and flexible binder-free graphene-based materials. Challenges for LIBs and future research trend in the development of high-performance electrode materials are further discussed.