Li-rich layered transitional metal oxide Li1.2(Mn0.54Ni0.16Co0.08)O2 was prepared by sol-gel method and further modified by AlF3 coating via a wet process. The bare and AlF3-coated Li1.2(Mn0.54Ni0.16Co0.08)O2 samples ...Li-rich layered transitional metal oxide Li1.2(Mn0.54Ni0.16Co0.08)O2 was prepared by sol-gel method and further modified by AlF3 coating via a wet process. The bare and AlF3-coated Li1.2(Mn0.54Ni0.16Co0.08)O2 samples were characterized by X-ray diffraction(XRD), scanning electron microscope(SEM), and high resolution transmission electron microscope(HRTEM). XRD results show that the bare and AlF3-coated samples have typical hexagonal α-Na Fe O2 structure, and AlF3-coated layer does not affect the crystal structure of the bare Li1.2(Mn0.54Ni0.16Co0.08)O2. Morphology measurements present that the AlF3 layer with a thickness of 5-7 nm is coated on the surface of the Li1.2(Mn0.54Ni0.16Co0.08)O2 particles.Galvanostatic charge-discharge tests at various rates show that the AlF3-coated Li1.2(Mn0.54Ni0.16Co0.08)O2 has an enhanced electrochemical performance compared with the bare sample. At 1C rate, it delivers an initial discharge capacity of 208.2 m A·h/g and a capacity retention of 72.4% after 50 cycles, while those of the bare Li1.2(Mn0.54Ni0.16Co0.08)O2 are 191.7 m A·h/g and 51.6 %, respectively.展开更多
The hydrothermal synthesis of single-crystallineβ-MnO2 nanorods and their chemical conversion into single-crystalline LiMn2O4 nanorods by a simple solid-state reaction were reported.This method has the advantages of ...The hydrothermal synthesis of single-crystallineβ-MnO2 nanorods and their chemical conversion into single-crystalline LiMn2O4 nanorods by a simple solid-state reaction were reported.This method has the advantages of producing pure,single-phase and crystalline nanorods.The LiMn2O4 nanorods have an diameter of about 300 nm.The discharge capacity and cyclic performance of the batteries were investigated.The LiMn2O4 nanorods show better cyclic performance with a capacity retention ratio of 86.2% after 100 cycles.Battery cyclic studies reveal that the prepared LiMn2O4 nanorods have high capacity with a first discharge capacity of 128.7 mA·h/g.展开更多
A special device was designed to measure temperature difference in this study of heat transfer of water and oil cross flow inside vertical upward tubes. A new heat transfer correlation was obtained for cross flow. The...A special device was designed to measure temperature difference in this study of heat transfer of water and oil cross flow inside vertical upward tubes. A new heat transfer correlation was obtained for cross flow. The experimental results showed that the dependence of heat transfer on Reynolds is much smaller in a narrow space than that in a wide space. It was found that the heat transfer correlation of cross flow in a narrow space is obviously different from that in a wide space, and that the heat transfer correlation obtained in a wide space may not be applicable to the cross-flow heat transfer in a narrow space. Further, the single-phase heat transfer capability of water cross flow was compared with that of oil cross flow. The experimental results showed that the average heat transfer coefficient of water is about 2～3 times that ofoil when they have the same superficial velocity.展开更多
A nano-Li3V2（PO4）3/C powder was successfully prepared by a thermal polymerization method. The particle sizes of the intermediate product powder and the final product Li3V2（PO4）3 are all less than 200 nm. The carbo...A nano-Li3V2（PO4）3/C powder was successfully prepared by a thermal polymerization method. The particle sizes of the intermediate product powder and the final product Li3V2（PO4）3 are all less than 200 nm. The carbon is partially coated on the surface of Li3V2（PO4）3 particles and the rest exists between particles with a total carbon content of 4.6wt%. This nano-Li3V2（PO4）3/C sample shows a discharge capacity of 124 mAh/g with-out capacity fading after 100 cycles at 0.1 C in the voltage rang of 3.0-4.3 V. Excellent rate performance is also achieved with a capacity of 80 mAh/g at 20 C in 3.0-4.3 V and 100 mAh/g at 10 C in 3.0-4.8 V. This study suggests that the thermal polymerization method is suitable to synthesize nano-Li3V2（PO4）3/C materials.展开更多
Integration of fast electrochemical double-layer capacitance and large pseudocapacitance is a practical way to improve the overall capability of supercapacitor,yet remains challenging.Herein,an effective cyanogel synt...Integration of fast electrochemical double-layer capacitance and large pseudocapacitance is a practical way to improve the overall capability of supercapacitor,yet remains challenging.Herein,an effective cyanogel synthetic strategy was demonstrated to prepare ultrathin Ni(OH)2 nanosheets coupling with conductive reduced graphene oxide(rGO)(rGO-Ni(OH)2)at ambient condition.Ultrathin Ni(OH)2 nanosheet with 3–4 layers of edge-sharing octahedral MO6 maximally exposes the active surface of Faradic reaction and promotes the ion diffusion,while the conductive rGO sheet boosts the electron transport during the reaction.Even at 30 A g−1,the optimal sample can deliver a specific capacitance of 1119.52 F g−1,and maintain 82.3%after 2000 cycles,demonstrating much higher electrochemical capability than bare Ni(OH)2 nanosheets.A maximum specific energy of 44.3 W h kg^−1(148.5 W kg^−1)is obtained,when assembled in a two-electrode system rGO-Ni(OH)2//rGO.This study provides an insight into efficient construction of two dimensional hybrid electrodes with high performance for the new-generation energy storage system.展开更多
基金Project(21071153)supported by the National Natural Science Foundation of China
文摘Li-rich layered transitional metal oxide Li1.2(Mn0.54Ni0.16Co0.08)O2 was prepared by sol-gel method and further modified by AlF3 coating via a wet process. The bare and AlF3-coated Li1.2(Mn0.54Ni0.16Co0.08)O2 samples were characterized by X-ray diffraction(XRD), scanning electron microscope(SEM), and high resolution transmission electron microscope(HRTEM). XRD results show that the bare and AlF3-coated samples have typical hexagonal α-Na Fe O2 structure, and AlF3-coated layer does not affect the crystal structure of the bare Li1.2(Mn0.54Ni0.16Co0.08)O2. Morphology measurements present that the AlF3 layer with a thickness of 5-7 nm is coated on the surface of the Li1.2(Mn0.54Ni0.16Co0.08)O2 particles.Galvanostatic charge-discharge tests at various rates show that the AlF3-coated Li1.2(Mn0.54Ni0.16Co0.08)O2 has an enhanced electrochemical performance compared with the bare sample. At 1C rate, it delivers an initial discharge capacity of 208.2 m A·h/g and a capacity retention of 72.4% after 50 cycles, while those of the bare Li1.2(Mn0.54Ni0.16Co0.08)O2 are 191.7 m A·h/g and 51.6 %, respectively.
基金Project(2008AA031205)supported by the National High-tech Research and Development Program of China
文摘The hydrothermal synthesis of single-crystallineβ-MnO2 nanorods and their chemical conversion into single-crystalline LiMn2O4 nanorods by a simple solid-state reaction were reported.This method has the advantages of producing pure,single-phase and crystalline nanorods.The LiMn2O4 nanorods have an diameter of about 300 nm.The discharge capacity and cyclic performance of the batteries were investigated.The LiMn2O4 nanorods show better cyclic performance with a capacity retention ratio of 86.2% after 100 cycles.Battery cyclic studies reveal that the prepared LiMn2O4 nanorods have high capacity with a first discharge capacity of 128.7 mA·h/g.
文摘A special device was designed to measure temperature difference in this study of heat transfer of water and oil cross flow inside vertical upward tubes. A new heat transfer correlation was obtained for cross flow. The experimental results showed that the dependence of heat transfer on Reynolds is much smaller in a narrow space than that in a wide space. It was found that the heat transfer correlation of cross flow in a narrow space is obviously different from that in a wide space, and that the heat transfer correlation obtained in a wide space may not be applicable to the cross-flow heat transfer in a narrow space. Further, the single-phase heat transfer capability of water cross flow was compared with that of oil cross flow. The experimental results showed that the average heat transfer coefficient of water is about 2～3 times that ofoil when they have the same superficial velocity.
文摘A nano-Li3V2（PO4）3/C powder was successfully prepared by a thermal polymerization method. The particle sizes of the intermediate product powder and the final product Li3V2（PO4）3 are all less than 200 nm. The carbon is partially coated on the surface of Li3V2（PO4）3 particles and the rest exists between particles with a total carbon content of 4.6wt%. This nano-Li3V2（PO4）3/C sample shows a discharge capacity of 124 mAh/g with-out capacity fading after 100 cycles at 0.1 C in the voltage rang of 3.0-4.3 V. Excellent rate performance is also achieved with a capacity of 80 mAh/g at 20 C in 3.0-4.3 V and 100 mAh/g at 10 C in 3.0-4.8 V. This study suggests that the thermal polymerization method is suitable to synthesize nano-Li3V2（PO4）3/C materials.
基金the National Natural Science Foundation of China(21875133)Xijiang R&D Team(Wang X),the Science and Technology Program of Guangzhou(2019050001)Science and Technology Commission of Shanghai Municipality(19ZR1479500)。
文摘Integration of fast electrochemical double-layer capacitance and large pseudocapacitance is a practical way to improve the overall capability of supercapacitor,yet remains challenging.Herein,an effective cyanogel synthetic strategy was demonstrated to prepare ultrathin Ni(OH)2 nanosheets coupling with conductive reduced graphene oxide(rGO)(rGO-Ni(OH)2)at ambient condition.Ultrathin Ni(OH)2 nanosheet with 3–4 layers of edge-sharing octahedral MO6 maximally exposes the active surface of Faradic reaction and promotes the ion diffusion,while the conductive rGO sheet boosts the electron transport during the reaction.Even at 30 A g−1,the optimal sample can deliver a specific capacitance of 1119.52 F g−1,and maintain 82.3%after 2000 cycles,demonstrating much higher electrochemical capability than bare Ni(OH)2 nanosheets.A maximum specific energy of 44.3 W h kg^−1(148.5 W kg^−1)is obtained,when assembled in a two-electrode system rGO-Ni(OH)2//rGO.This study provides an insight into efficient construction of two dimensional hybrid electrodes with high performance for the new-generation energy storage system.
