The electro-reduction of chromium oxide（Cr2O3） was investigated in an equimolar mixture of CaCl2-NaCl molten salt at 800℃ for developing a more efficient process for chromium preparation. Cyclic voltammetry and pot...The electro-reduction of chromium oxide（Cr2O3） was investigated in an equimolar mixture of CaCl2-NaCl molten salt at 800℃ for developing a more efficient process for chromium preparation. Cyclic voltammetry and potentiostatic electrolysis were used to study the electro-reduction of the Cr2O3-loaded metallic cavity electrode. In addition, a number of parameters affecting the rate and extent of Cr2O3 electrolysis were considered to better understand the electrolysis process. The results demonstrate that CaCl2-NaCl molten salt is applicable for preparing Cr directly from Cr2O3 and the electrolysis parameters exert great influence on the cathode product. Under optimal experimental conditions, nodular Cr with an oxygen content of 0.5%（mass fraction） was obtained without any chromium carbides detected by XRD. Furthermore, the relatively high solubility of CaO and quite rapid crystal growth result in the formation of large platelet CaCr2O4, and the addition of NaCl to CaCl2 results in several variations on the electrolysis process and the product morphology from pure CaCl2 molten salt.展开更多
A low-cost adsorbent modified kaolin clay(MKC) was synthesized and utilized for Cr(VI) removal from aqueous solution. Adsorption experiments were carried out as a function of adsorbent dosage, solution pH, Cr(VI) mass...A low-cost adsorbent modified kaolin clay(MKC) was synthesized and utilized for Cr(VI) removal from aqueous solution. Adsorption experiments were carried out as a function of adsorbent dosage, solution pH, Cr(VI) mass concentration, contact time, electrolyte, and temperature. It is found that the adsorption efficiency is high within a wide pH range of 2.5-11.5, and equilibrium is achieved within 180 min. Increases in temperature and electrolyte concentration decrease the adsorption. The adsorption follows the pseudo-second-order kinetic model. The Langmuir isotherm shows better fit than Freundlich isotherm. The maximum uptake capacities calculated from the Langmuir model are 15.82, 15.55 and 15.22 mg/g at 298, 308 and 318 K, respectively. Thermodynamic parameters reveals the spontaneous and exothermic nature of the adsorption. The FTIR study indicates that hydroxyl groups, NH4+ ions and NO3- ions on MKC surface play a key role in Cr(VI) adsorption. The Cr(VI) desorbability of 86.53% is achieved at a Na2CO3 solution. The results show that MKC is suitable as a low-cost adsorbent for Cr(VI) removal which has higher adsorption capacity and faster adsorption rate at pH close to that where pollutants are usually found in the environment.展开更多
Aluminum spent potlining (SPL) was employed as both the fluxing agent and a source of carbonaceous reductant for the carbothermic reduction of chromite, aiming to allow effective separation of alloy from the slag comp...Aluminum spent potlining (SPL) was employed as both the fluxing agent and a source of carbonaceous reductant for the carbothermic reduction of chromite, aiming to allow effective separation of alloy from the slag component. The experimental results show that the carbonaceous component of the SPL is more reactive towards chromite reduction compared to graphite. The formation of refractory spinel (MgAl2O4) on chromite particles hinders further reduction and alloy growth. The slag-making components of the SPL (e.g. nepheline and NaF) form molten slags at low temperatures (~1300℃) and partly dissolve the refractory spinel as well as the chromite. Destruction of the spinel layer with enhanced mass transfer greatly improves the alloy growth, which can be further promoted by reduction at a higher temperature (e.g. 1500℃). Ferrochrome alloy particles grow large enough at 1500℃ in the presence of SPL, allowing effective separation from the slag component using elutriation separation.展开更多
A complex process of micro electrolysis and biofilm was developed to continuously treat organic wastew-aters containing heavy metal ions such as Cu2+ and Or3+, and the relevant purifying mechanism was also addressed. ...A complex process of micro electrolysis and biofilm was developed to continuously treat organic wastew-aters containing heavy metal ions such as Cu2+ and Or3+, and the relevant purifying mechanism was also addressed. In detail, organic materials in wastewater could be consumed as nutritious source by biofilm composed of aerobes and anaerobes. However, for heavy metal ions (Cu2+, Cr3+), part was removed by electrodeposition, and some was adsorbed on biofilm. In order to compare with the combined process of micro electrolysis and biofilm, the experimental data of micro electrolysis process (intermittent) or biofilm process (continuous) were provided, and the kinetic data of C6H12O6 (glucose) biodegradation by cultured microbes or acclimated microbes were also obtained. These experimental results indicated that for wastewater initially consisted of CeH12O6 (500mg-L-1), Cu2+ and Cr3+ (10mg-L-1), after treatment, its concentrations of C6H12O6, Cu2+ and Cr3+ were lowered to the level of 55-65mg.L^1, and less than 1mg-L-1, respectively. And the industrial reused water standards could be met by treated wastewater.展开更多
Based on the principle of bacterial leaching and bacterial metallurgy,a novel technology for the detoxification of chromium-containing slag by Achromobacter sp.CH-1 and chromium recovery was proposed.Strain CH-1 cell ...Based on the principle of bacterial leaching and bacterial metallurgy,a novel technology for the detoxification of chromium-containing slag by Achromobacter sp.CH-1 and chromium recovery was proposed.Strain CH-1 cell morphology before and after Cr(Ⅵ) reduction was observed with a scanning electron microscope(SEM),and the reduction product is found to adhere to terminals of CH-1 cells.Energy-dispersive X-ray(EDX) and electron paramagnetic resonance(EPR) analyses reveal that the main component of the reduction product is Cr(Ⅲ).Furthermore,small and large-scale demonstration projects reveal that Achromobacter sp.can be used to detoxify chromium-containing slag and to selectively recover chromium by using this novel technique.Chromium recovery rate increases with decreasing particle sizes of chromium-containing slag and slagheap height.Chromium recovery rates in 10 t/batch and 20 t/batch of on-site demonstration projects for chromium-containing slag detoxification are more than 90%.展开更多
基金Project(2013CB632600)supported by the National Basic Research Program of ChinaProjects(21376251,21406233)supported by the National Natural Science Foundation of ChinaProject supported by the Fund of Hubei Zhenhua Chemical Co.,Ltd.,China
文摘The electro-reduction of chromium oxide（Cr2O3） was investigated in an equimolar mixture of CaCl2-NaCl molten salt at 800℃ for developing a more efficient process for chromium preparation. Cyclic voltammetry and potentiostatic electrolysis were used to study the electro-reduction of the Cr2O3-loaded metallic cavity electrode. In addition, a number of parameters affecting the rate and extent of Cr2O3 electrolysis were considered to better understand the electrolysis process. The results demonstrate that CaCl2-NaCl molten salt is applicable for preparing Cr directly from Cr2O3 and the electrolysis parameters exert great influence on the cathode product. Under optimal experimental conditions, nodular Cr with an oxygen content of 0.5%（mass fraction） was obtained without any chromium carbides detected by XRD. Furthermore, the relatively high solubility of CaO and quite rapid crystal growth result in the formation of large platelet CaCr2O4, and the addition of NaCl to CaCl2 results in several variations on the electrolysis process and the product morphology from pure CaCl2 molten salt.
基金Project(2012BAJ24B03)supported by the National Science and Technology Support Program of China
文摘A low-cost adsorbent modified kaolin clay(MKC) was synthesized and utilized for Cr(VI) removal from aqueous solution. Adsorption experiments were carried out as a function of adsorbent dosage, solution pH, Cr(VI) mass concentration, contact time, electrolyte, and temperature. It is found that the adsorption efficiency is high within a wide pH range of 2.5-11.5, and equilibrium is achieved within 180 min. Increases in temperature and electrolyte concentration decrease the adsorption. The adsorption follows the pseudo-second-order kinetic model. The Langmuir isotherm shows better fit than Freundlich isotherm. The maximum uptake capacities calculated from the Langmuir model are 15.82, 15.55 and 15.22 mg/g at 298, 308 and 318 K, respectively. Thermodynamic parameters reveals the spontaneous and exothermic nature of the adsorption. The FTIR study indicates that hydroxyl groups, NH4+ ions and NO3- ions on MKC surface play a key role in Cr(VI) adsorption. The Cr(VI) desorbability of 86.53% is achieved at a Na2CO3 solution. The results show that MKC is suitable as a low-cost adsorbent for Cr(VI) removal which has higher adsorption capacity and faster adsorption rate at pH close to that where pollutants are usually found in the environment.
基金funded by NRCan under the Rare Earth Elements and Chromite R&D Program
文摘Aluminum spent potlining (SPL) was employed as both the fluxing agent and a source of carbonaceous reductant for the carbothermic reduction of chromite, aiming to allow effective separation of alloy from the slag component. The experimental results show that the carbonaceous component of the SPL is more reactive towards chromite reduction compared to graphite. The formation of refractory spinel (MgAl2O4) on chromite particles hinders further reduction and alloy growth. The slag-making components of the SPL (e.g. nepheline and NaF) form molten slags at low temperatures (~1300℃) and partly dissolve the refractory spinel as well as the chromite. Destruction of the spinel layer with enhanced mass transfer greatly improves the alloy growth, which can be further promoted by reduction at a higher temperature (e.g. 1500℃). Ferrochrome alloy particles grow large enough at 1500℃ in the presence of SPL, allowing effective separation from the slag component using elutriation separation.
基金Supported by the Natural Science Foundation of Tianjin,China(No.013802911).
文摘A complex process of micro electrolysis and biofilm was developed to continuously treat organic wastew-aters containing heavy metal ions such as Cu2+ and Or3+, and the relevant purifying mechanism was also addressed. In detail, organic materials in wastewater could be consumed as nutritious source by biofilm composed of aerobes and anaerobes. However, for heavy metal ions (Cu2+, Cr3+), part was removed by electrodeposition, and some was adsorbed on biofilm. In order to compare with the combined process of micro electrolysis and biofilm, the experimental data of micro electrolysis process (intermittent) or biofilm process (continuous) were provided, and the kinetic data of C6H12O6 (glucose) biodegradation by cultured microbes or acclimated microbes were also obtained. These experimental results indicated that for wastewater initially consisted of CeH12O6 (500mg-L-1), Cu2+ and Cr3+ (10mg-L-1), after treatment, its concentrations of C6H12O6, Cu2+ and Cr3+ were lowered to the level of 55-65mg.L^1, and less than 1mg-L-1, respectively. And the industrial reused water standards could be met by treated wastewater.
文摘Based on the principle of bacterial leaching and bacterial metallurgy,a novel technology for the detoxification of chromium-containing slag by Achromobacter sp.CH-1 and chromium recovery was proposed.Strain CH-1 cell morphology before and after Cr(Ⅵ) reduction was observed with a scanning electron microscope(SEM),and the reduction product is found to adhere to terminals of CH-1 cells.Energy-dispersive X-ray(EDX) and electron paramagnetic resonance(EPR) analyses reveal that the main component of the reduction product is Cr(Ⅲ).Furthermore,small and large-scale demonstration projects reveal that Achromobacter sp.can be used to detoxify chromium-containing slag and to selectively recover chromium by using this novel technique.Chromium recovery rate increases with decreasing particle sizes of chromium-containing slag and slagheap height.Chromium recovery rates in 10 t/batch and 20 t/batch of on-site demonstration projects for chromium-containing slag detoxification are more than 90%.
