The hydrolysis of MgH_(2) delivers high hydrogen capacity(15.2 wt%),which is very attractive for real-time hydrogen supply.However,the formation of a surface passivation Mg(OH)_(2) layer and the large excess of H_(2)O...The hydrolysis of MgH_(2) delivers high hydrogen capacity(15.2 wt%),which is very attractive for real-time hydrogen supply.However,the formation of a surface passivation Mg(OH)_(2) layer and the large excess of H_(2)O required to ensure complete hydrolysis are two key challenges for the MgH_(2) hydrolysis systems.Now,a low-cost method is reported to synthesize MgH_(2)@Mg(BH_(4))_(2) composite via ball-milling MgH_(2) with cheap and widely available B_(2)O_(3)(or B(OH)_(3)).By adding small amounts of B_(2)O_(3),the in-situ formed Mg(BH_(4))_(2) could significantly promote the hydrolysis of MgH_(2).In particular,the MgH_(2)–10 wt%B_(2)O_(3) composite releases 1330.7 mL·g^(−1) H_(2)(close to 80%theoretical hydrogen generation H_(2))in H_(2)O and 1520.4 mL·g^(−1) H_(2)(about 95%)in 0.5 M MgCl_(2) in 60 min at 26℃ with hydrolysis rate of 736.9 mL·g^(−1)·min^(−1) and 960.9 mL·g^(−1)·min^(−1) H_(2) during the first minute of the hydrolysis,respectively.In addition,the MgCl_(2) solution allows repeated use by filtering and exhibits high cycle stability(20 cycles),therefore leading to much reduced capacity loss caused by the excess H_(2)O.We show that by introducing B_(2)O_(3) and recycling the 0.5 M MgCl_(2) solution,the system hydrogen capacity can approach 5.9 wt%,providing a promising hydrogen generation scheme to supply hydrogen to the fuel cells.展开更多
UiO-66 is a potential material for adsorption heat transformation(AHT)with high specific surface area,and excellent thermal and chemical stability.However,the low water adsorption capacity of UiO-66 in the low relativ...UiO-66 is a potential material for adsorption heat transformation(AHT)with high specific surface area,and excellent thermal and chemical stability.However,the low water adsorption capacity of UiO-66 in the low relative pressure range(0<P/P_(0)<0.3)limits its application in AHT.We prepare the UiO-66 modified by MgCl_(2)through using the solvothermal method and impregnation method,and study their water vapor adsorption performances and heat storage capacities.Attributed to the extremely high saturated water uptake and excellent hydrophilicity of MgCl_(2),the water adsorption performance of UiO-66 is improved,although the introduction of MgCl_(2)reduces its specific surface area and pore volume.The water adsorption capacity at P/P_(0)=0.3 and the saturated water adsorption capacity of the UiO-66(with MgCl_(2)content of 0.57 wt%)modified by the solvothermal method are 0.27 g/g and 0.57 g/g at 298 K,respectively,which are 68.8%and 32.6%higher than the counterparts of pure UiO-66,respectively.Comparing with pure UiO-66,the water adsorption capacity of the UiO-66(with MgCl_(2)content of 1.02 wt%)modified by the impregnation method is increased by 56.3%and 14.0%at the same pressure,respectively.During 20 water adsorption/desorption cycles,the above two materials show high heat storage densities(~1293 J/g and 1378 J/g).Therein,the UiO-66 modified by the solvothermal method exhibits the excellent cyclic stability.These results suggest that the introduction of an appropriate amount of MgCl_(2)makes UiO-66more suitable for AHT applications.展开更多
The NdCl_3/MgCl_2 bisupported catalyst was prepared by using NdCl_3 ,MgCl_2, (CH_3)_2(CH_2)_2 OH and TiCl_4. It is shown that the structure of bisupported catalyst was different from those of either NdCl_3 or MgCl_2 s...The NdCl_3/MgCl_2 bisupported catalyst was prepared by using NdCl_3 ,MgCl_2, (CH_3)_2(CH_2)_2 OH and TiCl_4. It is shown that the structure of bisupported catalyst was different from those of either NdCl_3 or MgCl_2 single supported catalyst. A peculiar type of kinetic curve for ethylene polymerization was found.展开更多
Several supported zirconocene catalysts were prepared by using MgCl_2·6H_2O as a precursor forproducing an active support. Such catalysts combined with methylaluminoxane (MAO) obtained by reactingMgCl_2·6H_2...Several supported zirconocene catalysts were prepared by using MgCl_2·6H_2O as a precursor forproducing an active support. Such catalysts combined with methylaluminoxane (MAO) obtained by reactingMgCl_2·6H_2O with AlMe_3 show good activity for ethylene polymerization similar to that of anhydrousMgCl_2 supported zirconocene catalyst.展开更多
基金supported by the Basic and Applied Basic Research Foundation of Guangdong Province(No.2022A1515011832 and 2021A1515110676)supported by GDAS’Project of Science and Technology Development(2022GDASZH-2022010104,2022GDASZH-2022030604-04).
文摘The hydrolysis of MgH_(2) delivers high hydrogen capacity(15.2 wt%),which is very attractive for real-time hydrogen supply.However,the formation of a surface passivation Mg(OH)_(2) layer and the large excess of H_(2)O required to ensure complete hydrolysis are two key challenges for the MgH_(2) hydrolysis systems.Now,a low-cost method is reported to synthesize MgH_(2)@Mg(BH_(4))_(2) composite via ball-milling MgH_(2) with cheap and widely available B_(2)O_(3)(or B(OH)_(3)).By adding small amounts of B_(2)O_(3),the in-situ formed Mg(BH_(4))_(2) could significantly promote the hydrolysis of MgH_(2).In particular,the MgH_(2)–10 wt%B_(2)O_(3) composite releases 1330.7 mL·g^(−1) H_(2)(close to 80%theoretical hydrogen generation H_(2))in H_(2)O and 1520.4 mL·g^(−1) H_(2)(about 95%)in 0.5 M MgCl_(2) in 60 min at 26℃ with hydrolysis rate of 736.9 mL·g^(−1)·min^(−1) and 960.9 mL·g^(−1)·min^(−1) H_(2) during the first minute of the hydrolysis,respectively.In addition,the MgCl_(2) solution allows repeated use by filtering and exhibits high cycle stability(20 cycles),therefore leading to much reduced capacity loss caused by the excess H_(2)O.We show that by introducing B_(2)O_(3) and recycling the 0.5 M MgCl_(2) solution,the system hydrogen capacity can approach 5.9 wt%,providing a promising hydrogen generation scheme to supply hydrogen to the fuel cells.
基金Project supported by the National Natural Science Foundation of China(Grant No.51836009)。
文摘UiO-66 is a potential material for adsorption heat transformation(AHT)with high specific surface area,and excellent thermal and chemical stability.However,the low water adsorption capacity of UiO-66 in the low relative pressure range(0<P/P_(0)<0.3)limits its application in AHT.We prepare the UiO-66 modified by MgCl_(2)through using the solvothermal method and impregnation method,and study their water vapor adsorption performances and heat storage capacities.Attributed to the extremely high saturated water uptake and excellent hydrophilicity of MgCl_(2),the water adsorption performance of UiO-66 is improved,although the introduction of MgCl_(2)reduces its specific surface area and pore volume.The water adsorption capacity at P/P_(0)=0.3 and the saturated water adsorption capacity of the UiO-66(with MgCl_(2)content of 0.57 wt%)modified by the solvothermal method are 0.27 g/g and 0.57 g/g at 298 K,respectively,which are 68.8%and 32.6%higher than the counterparts of pure UiO-66,respectively.Comparing with pure UiO-66,the water adsorption capacity of the UiO-66(with MgCl_(2)content of 1.02 wt%)modified by the impregnation method is increased by 56.3%and 14.0%at the same pressure,respectively.During 20 water adsorption/desorption cycles,the above two materials show high heat storage densities(~1293 J/g and 1378 J/g).Therein,the UiO-66 modified by the solvothermal method exhibits the excellent cyclic stability.These results suggest that the introduction of an appropriate amount of MgCl_(2)makes UiO-66more suitable for AHT applications.
文摘The NdCl_3/MgCl_2 bisupported catalyst was prepared by using NdCl_3 ,MgCl_2, (CH_3)_2(CH_2)_2 OH and TiCl_4. It is shown that the structure of bisupported catalyst was different from those of either NdCl_3 or MgCl_2 single supported catalyst. A peculiar type of kinetic curve for ethylene polymerization was found.
文摘Several supported zirconocene catalysts were prepared by using MgCl_2·6H_2O as a precursor forproducing an active support. Such catalysts combined with methylaluminoxane (MAO) obtained by reactingMgCl_2·6H_2O with AlMe_3 show good activity for ethylene polymerization similar to that of anhydrousMgCl_2 supported zirconocene catalyst.
