A 2GHz Low Power Differentially Tuned CMOS Monolithic LC-VCO

A 2GHz differentially tuned CMOS monolithic LC-VCO is designed and fabricated in a 0.18μm CMOS process. The VCO has a 16.15% tuning range （from 1. 8998 to 2. 2335GHz） through a combination of analog and digital tuning techniques （4-bit binary switch-capacitor array）. The measured phase noise is - 118.17dBc/Hz at a 1MHz offset from a 2. 158GHz carrier. With the presented improved switch,the phase noise varies no more than 3dB at different digital control bits. The phase noise changes only by about 2dB in the tuning range because of the pn-junctions as the varactors. The VCO draws a current of about 2. lmA from a 1.8V power supply and works normally with a 1.5V power supply.

Flow Regime Identification of Gas-liquid Two-phase Flow Based on HHT

A new method to identify flow regime in two-phase flow was presented, based on signal processing of differential pressure using Hilbert Huang transform （HHT）. Signals obtained from a Venturi meter were decomposed into different intrinsic mode functions （IMFs） with HHT, then the energy fraction of each intrinsic mode and the mean value of residual function were calculated, from which the rules of flow regime identification were summarized. Experiments were carried out on two-phase flow in the horizontal tubes with 50mm and 40mm inner diameter, while water flowrate was in the range of 1.3m^3.h^-1 to 10.5m^3.h^-1, oil flowrate was from 4.2m^3.h^-1 to 7.0m^3.h^-1 and gas flowrate from 0 to 15m^3.h^-1. The results show that the proposed rules have high precision for single phase, bubbly, and slug, plug flow regirne identification, which are independent of not only properties of two-phase fluid. In addition, the method can meet the need of industrial application because of its simple calculation.

Dynamical chiral symmetry breaking in QED_3

In order to examine how a propagator behaves in non-perturbative theories and how its behavior is influenced by the choice of a covariant gauge a truncated Dyson-Schwinger equation is used to numerically investigate the properties of fermions and bosons in 3D quantum electrodynamics QED and a series of self-consistent solutions for the fermion propagator in the Nambu and Wigner phases are obtained. These numerical solutions show that the propagator behaves very differently in the Landau gauge domain and in the infrared energy region outside it.By using the propagators in the Nambu and Wigner phases under various gauges it is further investigated how the fermion equivalent pressure difference and fermion condensation change with the gauge parameters.These results indicate that the phase transition described by the CJT equivalent potential and the chiral phase transition described by the chiral condensation are not completely identical.

Pressure Drop Fluctuations in Periodically Fluctuating Pipe Flow

Experiments were conducted to study characteristics of flow when flow is fluctuating.The experimental results showed a phase difference between the flow rate and the pressure drop fluctuations.This phase difference between the fluctuating flow rate and pressure drop was analyzed for laminar flow.Analysis showed that the phase difference changes with the period of the flow fluctuation, the pipe radius, the density and the dynamic viscosity of the liquid.Fluctuating pipe flow was then numerically simulated.Results of the numerical simulation were compared with theoretical values and experimental results.It was shown that, when the flow rate fluctuates with time as a sine wave, the pressure drop fluctuates with the same periodicity, and there is a phase difference between them.

Solubility of red palm oil in supercritical carbon dioxide： Measurement and modelling

The solubility of red palm oil （RPO） in supercritical carbon dioxide （scCO2） was determined using a dynamic method at 8.5-25 MPa and, 313.15-333.15 K and at a fixed scCO2 flow rate of 2.9 g. mn -1 using a full factorial design. The solubility was determined under low pressures and temperatures as a preliminary study for RPO par- ticle formation using scCO2. The solubility of RPO was 0.5-11.3 mg. （g CO2） -1 and was significantly affected by the pressure and temperature. RPO solubility increased with pressure and decreased with temperature. The Adachi-Lu model showed the best-fit for RPO solubility data with an average relative deviation of 14% with a high coefficient of determination, R2 of 0.9667, whereas the Peng-Robinson equation of state thermodynamic model recorded deviations of 17%-30%.

Vibration compaction characteristics of rock filling embankment

The dynamic model experiment of the rock filling embankment was carried out to investigate the vibration compaction mechanism. The rock filling materials were compacted by the plate-vibrated compactor, and the characteristics of the rock filling materials, such as settlement, pressure change and response waveform, were measured by the dynamic earth pressure gauge and aceelerometer. Moreover, a new method for detecting the compactness of the rock filling embankment was proposed based on the maximum dry density and modulus of deformation. The results show that the process of vibration compaction includes compact, elastic deformation and loose stages, and the vibratory pressure transfers to the surroundings from the vibration center in non-linear rule. Furthermore, the test results obtained by the present method are basically in agreement with those obtained by the traditional method, and the maximum relative error between them is about 0.5%.

Driving characteristics of octagon-type ultrasonic motor

Structure of the octagon-type ultrasonic motor was proposed and designed so as to allow the motor to drive small actuator. The stator of the motor consisted of the octagon shape elastic body and four rectangular plate ceramics. The four ceramics were attached to outer surfaces of the octagon elastic body. The same phase voltages were applied to the ceramics on horizontal surfaces, and 90° phase difference voltages were applied to the ceramics on vertical surfaces. When the AC voltage with 90° phase difference was applied in ceramics, the elliptical displacement of unimorph bars was generated by generating bending vibration. To find the maximum displacement model that generates elliptical displacement at the centers of the inner surfaces, the finite element analysis program ATILA was used. The analyzed results were compared to the experimental results. As a result, the speed and torque are increased linearly by increasing the input voltage and the speed of motors can be controlled by changing the applied voltages.

Functional nanogenerators as vibration sensors enhanced by piezotronic effects

ZnO nanomaterials have been shown to have novel applications in optoelectronics, energy harvesting and piezotronics, due to their coupled semiconducting and piezoelectric properties. Here a functional nanogenerator （FNG） based on ZnO nanowire arrays has been fabricated, which can be employed to detect vibration in both self-powered （SP） and external-powered （EP） modes. In SP mode, the vibration responses of the FNG can be measured through converting mechanical energy directly into an electrical signal. The FNG shows consistent alternating current responses （relative error 〈 0.37%） at regular frequencies from 1 to 15 Hz. In EP mode, the current responses of FNG are significantly enhanced via the piezotronic effect. Under a forward bias of 3 V, the sensor presented a sensitivity of 3700% and an accurate measurement （relative error 〈 0.91%） of vibration frequencies in the range 0.05-15 Hz. The results show that this type of functional nanogenerator sensor can detect vibration in both SP and EP modes according to the demands of the applications.

Design and realization of random measurement scheme for compressed sensing

Design and realization of random measurement scheme for compressed sensing （CS） are presented in this paper, and lower limits of the measurement number are achieved when the precise reconstruction is realized. Four kinds of random measurement matrices are designed according to the constraint conditions of random measurement. The performance is tested employing the algorithm of stagewise orthogonal matching pursuit （STOMP）. Results of the experiment show that lower limits of the measurement number are much better than the results described in Refs.[ 13-15]. When the ratios of measurement to sparsity are 3.8 and 4.0, the mean relative errors of the reconstructed signals are 8.57 × 10^-13 and 2.43 × 10^-14, respectively, which confh-rns that the random measurement scheme of this paper is very effective.