断面法冲淤计算公式选用及合理的相邻断面面积变化率

河道(水库)冲淤量计算是研究河道演变规律和河道治理的重要手段,断面法冲淤量计算目前广泛应用,但梯形法和锥体法存在一定的差异,其原因是没有针对具体河段找出差异存在的原因,科学地分析及选用计算公式,特别是相邻断面面积变化率对计算成果的影响没有引起足够的重视。在研究上述问题的基础上,提出了相邻断面面积变化率的定量指标。

芜湖皖28井水位异常综合分析

针对2011年芜湖皖28井水位破年变异常,系统梳理该井相关资料,利用水位变幅、相关性分析及相对变差率进行分析。结果表明,该项异常信度较高,反映区域构造活动信息,是周边几次中等强度地震的共同前兆。通过剩余曲线、从属函数等数学方法,对该井历年水位观测数据进行异常识别。研究表明,该井水位异常主要表现为短期异常特征,与该井孔西北、西南侧中等地震有较好的对应关系。

Building dynamic thermal simulation of low-order multi-dimensional heat transfer

Multi-dimensional heat transfers modeling is crucial for building simulations of insulated buildings,which are widely used and have multi-dimensional heat transfers characteristics.For this work,state-model-reduction techniques were used to develop a reduced low-order model of multi-dimensional heat transfers.With hot box experiment of hollow block wall,heat flow relative errors between experiment and low-order model predication were less than 8% and the largest errors were less than 3%.Also,frequency responses of five typical walls,each with different thermal masses or insulation modes,the low-order model and the complete model showed that the low-order model results agree very well in the lower excitation frequency band with deviations appearing only at high frequency.Furthermore,low-order model was used on intersection thermal bridge of a floor slab and exterior wall.Results show that errors between the two models are very small.This low-order model could be coupled with most existing simulation software for different thermal mass envelope analyses to make up for differences between the multi-dimensional and one-dimensional models,simultaneously simplifying simulation calculations.

拉萨地磁台地下水位分析与预测指标初步建立

拉萨地磁台井水位受降雨及外界干扰影响较明显,文章通过科学的方法排除干扰和降雨影响,提取异常信息、初步建立测向指标,为今后地震前兆异常信息更加准确提供服务。

Comparison between sequential and single extraction procedures for metal speciation in fresh and dried Sedum Plumbizincicola

Sequential and single extraction procedures were applied to both fresh and dried Sedum Plumbizincicola leaves and stems.The extractants, different from those of soil, sediment or sewage sludge metal fractions, were water, 80%(v/v) ethanol, 1 mol/L Na Cl,2% HAc and 0.6 mol/L HCl. Zn, Cd and Cu in the extracts and samples were measured by flame atomic adsorption spectrometry. In sequential extraction procedures, water soluble form and ethanol soluble form are the main fractions for Zn, while water soluble form and Na Cl soluble form for Cd, and comparatively uniform distribution for Cu with the residue form most and HCl soluble form second. Single extraction procedures are used to compare the extraction efficiencies of the five reagents to screen appropriate extractants and operating conditions for liquid extraction to deal with large amount of harvested metal-contained biomass, which will pose a threat to the environment if treated improperly. The sequences of extraction efficiencies are HCl>Na Cl≈HAc>Water≈Ethanol for Zn and HCl≈Na Cl≈HAc>Water>Ethanol for Cd. As for Cu, all the five extractants cannot effectively extract Cu, but HCl achieves a higher efficiency(>70% in fresh samples, and 45%-60% in dried samples). Besides, extraction efficiencies for most extractants in fresh samples are higher than those in dried samples, and extraction efficiencies of stems and leaves for the five extractants are close. The two extraction procedures can obtain high degree of accuracy with the relative standard deviation(RSD)lower than 10%, and metal recoveries are controlled between 80%-120% with most of 90%-110%.

Beam Parameters for End Diffraction of TE_0 Mode of Planar Waveguide

The relation between diffractive beam parameters and normalized frequency is analyzed that leads to two improved Tormulas for two kinds of mode-field halT-widths and several formulas for divergence angle as well as beam propagation factor. The numerical calculation indicates that the maximal relative error is less than 0.5% within a reasonable parameter range.

Optimization of Sample Pretreatment for Determination of Polycyclic Aromatic Hydrocarbons in Estuarine Sediments by Gas Chromatography

This study examined levels of polycyclic aromatic hydrocarbons (PAHs) in estuarine sediments in Licun (Qingdao, China) by gas chromatography under optimized conditions for sample pretreatment via ultrasonic extraction, column chromatography, and thin layer chromatography. Methanol and dichloromethane (DCM)/methanol (2:1, v/v) were used in ultrasonic extraction, and DCM was used as eluate for column chromatography. The developing system consisted of n-hexane and DCM at a ratio of 9:1 (v/v), with DCM as the extraction solvent for PAHs-containing silica gel scraped off the plate. When the spiking level is 100 ng, total recoveries of spiked matrices for four target PAHs (phenanthrene, anthracene, pyrene and chrysene) were 83.7%, 76.4%, 85.8%, and 88.7%, respectively, with relative standard deviation (RSD) between 5.0% and 6.5% (n = 4). When the spiking level is 1000 ng, associated total recoveries were 78.6%, 72.7%, 82.7% and 85.3%, respectively, with RSD between 4.4% and 5.3% (n = 4). The opti-mized method was advantageous for determination of PAHs in complex matrix due to its effective sample purification.