The effect of interface reaction on the fractal dimensions of fracture surface in aluminum borate whisker-reinforced aluminum alloy 6061 composite was investigated. The composite was fabricated by squeeze-casting tech...The effect of interface reaction on the fractal dimensions of fracture surface in aluminum borate whisker-reinforced aluminum alloy 6061 composite was investigated. The composite was fabricated by squeeze-casting technique. The fracture surfaces created in tensile test were measured by vertical sectioning method. Fractal phenomena were found in two plots, in which the measuring units were from 3 to 15 μm and 1 to 5 μm, respectively. The relation was established between the tensile properties and fractal dimension with measuring units of 3-15 μm. The results show that the ultimate tensile strength increases while the fracture surface roughness increases with fractal dimension increasing due to the change in fracture mode depending on the degree of interface reaction status induced by heat treatment. But when the measuring units are 1-5 μm, fractal dimension does not change with heat treatment.展开更多
The dry sliding wear behavior of AA6061/ZrB2 in-situ composite prepared by the reaction of inorganic salts K2ZrF6 and KBF4 with molten aluminum was investigated.An attempt was made to develop a mathematical model to p...The dry sliding wear behavior of AA6061/ZrB2 in-situ composite prepared by the reaction of inorganic salts K2ZrF6 and KBF4 with molten aluminum was investigated.An attempt was made to develop a mathematical model to predict the wear rate of AA6061/（0-10%） ZrB2 in-situ composites.Four-factor,five-level central composite rotatable design was used to minimize the number of experiments.The factors considered are sliding velocity,sliding distance,normal load and mass fraction of ZrB2 particles.The effect of these factors on the wear rate of the fabricated composite was analyzed and the predicted trends were discussed by observing the wear surface morphologies.The in-situ formed ZrB2 particles enhance the wear performance of the composite.The wear rate of the composite bears a proportional relationship with the sliding velocity,sliding distance and normal load.展开更多
基金Project (20070213042) supported by Specialized Research Fund for the Doctoral Program of Higher Education, China
文摘The effect of interface reaction on the fractal dimensions of fracture surface in aluminum borate whisker-reinforced aluminum alloy 6061 composite was investigated. The composite was fabricated by squeeze-casting technique. The fracture surfaces created in tensile test were measured by vertical sectioning method. Fractal phenomena were found in two plots, in which the measuring units were from 3 to 15 μm and 1 to 5 μm, respectively. The relation was established between the tensile properties and fractal dimension with measuring units of 3-15 μm. The results show that the ultimate tensile strength increases while the fracture surface roughness increases with fractal dimension increasing due to the change in fracture mode depending on the degree of interface reaction status induced by heat treatment. But when the measuring units are 1-5 μm, fractal dimension does not change with heat treatment.
文摘The dry sliding wear behavior of AA6061/ZrB2 in-situ composite prepared by the reaction of inorganic salts K2ZrF6 and KBF4 with molten aluminum was investigated.An attempt was made to develop a mathematical model to predict the wear rate of AA6061/（0-10%） ZrB2 in-situ composites.Four-factor,five-level central composite rotatable design was used to minimize the number of experiments.The factors considered are sliding velocity,sliding distance,normal load and mass fraction of ZrB2 particles.The effect of these factors on the wear rate of the fabricated composite was analyzed and the predicted trends were discussed by observing the wear surface morphologies.The in-situ formed ZrB2 particles enhance the wear performance of the composite.The wear rate of the composite bears a proportional relationship with the sliding velocity,sliding distance and normal load.
