Diffusion of Chloride Ions in Soils:I.Influences of Soil Moisture, Bulk Density and Temperature

Diffusion coefficients of chloride ions in four soils of different texture with varying effective moisture content and varying bulk density from 1.1 to 1.6 g cm3 under three different temperatures were determined by the diffusion-cell method using 36Cl-labelled CaCl2 solution. The results showed that activation energy decreased with water content, which indicated that the threshold for diffusion was lower at a higher soil moisture rate. Therefore, the diffusion coefficient (D) of chloride ions in soil increased consistently with soil moisture. Although a near linear increase in the diffusion coefficient with increasing soil moisture or bulk density in all the soils was observed, the increase rate in different soils was not the same. The D value increased with temperature, and with temperature increased by 10℃ in the range from 5 "C to 45℃ theD valve increased by 10%～30%, averaging about 20%.

Water Effect on Amine-Modification of Adsorbents for Separation of CO_2/N_2

The adsorption of CO2can be enhanced through loading amines on adsorbents,therefore,the separation of CO2from other gases is promoted.Water plays an important role in this process.Water increases both the adsorption amount of CO2and the separation coefficient with N2for all amines loaded.However,the effect of loading trialkylamines is not remarkable in the absence of water.The effect of loading dialkylamine does not depend on water,but the adsorbent cannot be regenerated at ambient temperature.In comparison,an adsorbent loading trialkylamine can be regenerated at ambient temperature even in the presence of water with fairly good stability.

Tuning sol size to optimize organosilica membranes for gas separation

A series of organosilica sols are prepared by the polymeric sol–gel method using 1,2-bis(triethoxysilyl)ethane(BTESE)as the precursor.Particle size distributions of the BTESE-derived sols are systematically investigated by carefully adjusting the synthesis parameters(i.e.,water ratios,acid ratios and solvent ratios)in the sol process.In certain conditions,increasing the water ratio or the acid ratio tends to cause larger sol sizes and bimodal particle size distributions.However,higher solvent ratios lead to smaller sol sizes and unimodal particle size distributions.The organosilica membranes prepared from the optimized sols show excellent H_2 permeances(up to 4.2×10^(-7)mol·m^(-2)·s^(-1)·Pa^(-1))and gas permselectitivies(H_2/CO_2 is 9.5,H_2/N_2 is 50 and H_2/CH_4 is 68).This study offers significant insights into the relationship between the sol synthesis parameters,sol sizes and membrane performance.

Durability of sea-sand containing concrete:Effects of chloride ion penetration

This paper describes an orthogonal experiment on the effect of water/cement ratio,water consumption per cubic meter,curing time,and type of sand on the response＂resistance to chloride ion penetration＂.A sea-sand containing concrete was used for the trials.An analysis of chloride ion diffusion coefficients at different factor levels was performed.A predictive model of chloride ion diffusion in concrete is developed through regression analysis.The experimental results show that when the water/cement ratio varies from 0.45 to 0.60,and the water consumption per cubic meter varies from 185 to 215 kg,and the curing time varies from 30 to 180 d then the size of the effects fall in the order（most significant first）： curing time,type of sand,water consumption per cubic meter,and water/cement ratio.Chloride ion penetration is reduced,and better durability of the concrete is observed,with longer curing times,less water consumption per cubic meter,and a smaller water/cement ratio.

Location of anemometer along Lanzhou-Xinjiang railway

Using structured mesh to discretize the calculation region, the wind velocity and pressure distribution in front of the wind barrier under different embankment heights are investigated based on the Detached Eddy Simulation(DES) with standard SpalartAllmaras(SA) model. The Reynolds number is 4.0×105 in this calculation. The region is three-dimensional. Since the wind barrier and trains are almost invariable cross-sections, only 25 m along the track is modeled. The height of embankment ranges from 1 m to 5 m and the wind barrier is 3 m high. The results show that the wind speed changes obviously before the wind barrier on the horizontal plane, which is 4.5 m high above the track. The speed of wind reduces gradually while approaching the wind barrier. It reaches the minimum value at a distance about 5 m before the wind barrier, and increases dramatically afterwards. The speed of wind at this location is linear with the speed of far field. The train aerodynamic coefficients decrease sharply with the increment of the embankment height. And they take up the monotonicity. Meanwhile, when the height increases from 3 m to 5 m, they just change slightly. It is concluded that the optimum anemometer location is nearly 5 m in front of the wind barrier.

Recovery of carbon monoxide from flue gases by reactive absorption in ionic liquid imidazolium chlorocuprate(I): Mass transfer coefficients

Recovery of carbon monoxide from flue gases by selective absorption of carbon monoxide in an imidazolium chlorocuprate（l） ionic liquid is considered in this work as an alternative to the use of molecular volatile solvents such as aromatic hydrocarbons. The present work evaluates the CO mass transfer rates from the gas phase to the ionic liquid solutions in the absence of chemical reaction. To that end, carbon dioxide was employed as an inert model gas and absorption experiments were performed to assess the influence of different process variables in a batch reactor with fiat gas-liquid interface. The experimental mass transfer coefficients showed significant var- iation with temperature, （3.4-10.9） × 10^-7 m·s^-1 between 293 and 313 K; stirring speed, （10.2- 33.1）× 10^-7 m.s 1 between 100 and 300 r·min^-1; and concentration of copper（1）, （6.6-10.2） × 10^-7 m·s^-1 between 0.25 and 2 mol· L^- 1. In addition, the mass transfer coefficients were eventually found to follow a poten- tial proportionality of the type kL ∝μ^-0.5 and the dimensionless correlation that makes the estimation of the mass transfer coefficients possible in the studied range of process variables was obtained： Sh=10^-2.64 Re^1.07 , Sc^0.75,These results constitute the first step in the kinetic analysis of the reaction between CO and imidazolium chlorocuprate（I） ionic liquid that determines the design of the separation units.

Exponential stability for networked control systems based on the model of nonlinear discrete-time system with time-varying delay

An uncertain nonlinear discrete-time system model with time-varying input delays for networked control systems (NCSs) is presented. The problem of exponential stability for the system is considered and some new criteria of exponential stability are obtained based on norm inequality methods. A numerical example is given todemonstrate that those criteria are useful to analyzing the stability of nonlinear NCSs.

拉曼型光致离化系统中的暗态效应

利用Ｗｉｇｎｅｒ－Ｗｅｉｓｓｋｏｐｆ近似研究了光致离化系统中的暗态效应。在双模量子化光场的驱动下，三个束缚态形成一个暗态。即使在ｔ→∞的条件下，原子在该暗态上也能保持一定的占居数。还给出了光子数对原子在束缚态上的占居数的影响。

Determination of consolidation behaviour of clay slurries

The main objective of this study was to determine the consolidation behaviour of clay slurries.A finegrained clay with high consistency limits(W_L = 180%,w_P= 120%) was investigated using conventional oedometer and bench-top centrifuge tests.Results indicated that the slurry had an apparent preconsolidation(due to initial conditions,electrochemical interactions,tortuous drainage,and thixotropic strength) from e = 5.7 to e = 5.5 followed by virgin compression.Likewise,the low hydraulic conductivity(10^(-10)-10^(-12) m/s) was due to low porosity(small pore throats) and high tortuosity(long flow paths).Unlike consolidation of soils,the c_v and m_v decreased with increasing σ' but increased with increasing e and k.The data from the two tests correlated well in the range of σ' = 10-65 kPa,e = 5.5-3.86,k= 1.7 × 10^(-10)-5×10^(-11) m/s,F_c = 1-40 MN.New equations were developed to correlate the consolidation parameters(e,σ',k) with F_c.The deviation of k beyond 40 MN(e = 4.65) was due to deviation from the initial straight line portion of the settlement curve in the centrifuge test.

Optimization of volume to point conduction problem based on a novel thermal conductivity discretization algorithm

A conduction heat transfer process is enhanced by filling prescribed quantity and optimized-shaped high thermal conductivity materials to the substrate. Numerical simulations and analyses are performed on a volume to point conduction problem based on the principle of minimum entropy generation. In the optimization, the arrangement of high thermal conductivity materials is variable, the quantity of high thermal-conductivity material is constrained, and the objective is to obtain the maximum heat conduction rate as the entropy is the minimum.A novel algorithm of thermal conductivity discretization is proposed based on large quantity of calculations.Compared with other algorithms in literature, the average temperature in the substrate by the new algorithm is lower, while the highest temperature in the substrate is in a reasonable range. Thus the new algorithm is feasible. The optimization of volume to point heat conduction is carried out in a rectangular model with radiation boundary condition and constant surface temperature boundary condition. The results demonstrate that the algorithm of thermal conductivity discretization is applicable for volume to point heat conduction problems.

Electroanalytical studies on electrically conductive polyaniline： Nylon-6,6 composite film

Electrically conductive composite films ofpolyaniline and nylon-6.6 are prepared by diffusing aniline followed by oxidative polymerization of aniline into nylon-6.6 matrix. In order to determine the diffusion coefficient for the chloride ion diffusion into the composite matrix electrochemically, galvanostatic pulse method is used and the diffusion coefficient is estimated to be -6.48× 10^-17 cm^2s^-1. The results are discussed in view of them being potential replacement materials for battery. electrodes and sensors devices.

Surface-gel-conversion synthesis of submicron-thick MFI zeolite membranes to expedite shape-selective separation of hexane isomers

Ultrathin zeolite membranes are of paramount importance in accelerating gas transport during membrane separation,and lowering down their membrane thicknesses to submicron scale is deemed to be very challenging.Herein,we develop an advanced approach of surface gel conversion for synthesis of submicron-thick pure silica MFI(silicalite-1)zeolite membranes.Viscous gel is prepared by finely adjusting the precursor composition,enabling its reduced wettability.The unfavorable wetting of the support surface can effectively prevent gel penetration into alumina support voids.Aided by the seeds,the surface gel is directly and fully crystallized into an MFI zeolite membrane with minimal water steam.A membrane with a thickness of 500 nm is successfully acquired and it is free of visible cracks.Additionally,the as-synthesized membranes exhibit rapid and selective separation of hexane isomers by virtue of unprecedentedly high n-hexane permeance of 24.5×10^−7 mol m^−2 s^−1 Pa^−1 and impressive separation factors of 13.3-22.6 for n-hexane over its isomers.This developed approach is of practical interest for sustainable synthesis of high-quality zeolite membranes.

A priori error estimates of finite volume element method for hyperbolic optimal control problems

In this paper,optimize-then-discretize,variational discretization and the finite volume method are applied to solve the distributed optimal control problems governed by a second order hyperbolic equation.A semi-discrete optimal system is obtained.We prove the existence and uniqueness of the solution to the semidiscrete optimal system and obtain the optimal order error estimates in L ∞(J;L 2)-and L ∞(J;H 1)-norm.Numerical experiments are presented to test these theoretical results.

Using the GPS observations to reconstruct the ionosphere three-dimensionally with an ionospheric data assimilation and analysis system(IDAAS)

Using an international reference ionosphere(IRI)model as a background ionosphere and applying the Kalman filter to update the state with observations,we develop an ionosphere data assimilation analysis system(IDAAS)to reconstruct a three-dimensional(3D)ionosphere with the GPS slant TEC and ionosonde data over east-south Asia.The preliminary results with the GPS data collected over east-south Asia on 30 June 2005 showed that inversed slant TEC has very good correlation with the observations both for the GPS sites being and not being involved in reconstruction.The inversed NmF2 and vertical TEC both demonstrate great improvement of agreement with those observed from ionosondes and TOPEX satellite independently.