Plasma flow control is an active flow control technology that based on the plasma aerodynamic actuation. It can be used to enhance the aerodynamic characteristics of aircraft and propulsion systems. To study the pheno...Plasma flow control is an active flow control technology that based on the plasma aerodynamic actuation. It can be used to enhance the aerodynamic characteristics of aircraft and propulsion systems. To study the phenomena occurring in plasma aerodynamic actuation and the mechanism of plasma flow control, the induced flow velocity of the plasma aerodynamic actuator is experimentally investigated under a variety of parameter conditions. The results indicate that plasma aerodynamic actuation accelerates the near surface air at velocities of a few meters per second, and there is an angle about 5° between the mainstream and the actuator wall and a spiral vortex is formed when the induced flow is moving along the wall. Besides, with the fixed frequency, the induced flow velocity increases linearly with the applied voltage, but it is insensitive to the frequency when the applied voltage is fixed. And the configuration is an effective factor for the performance of the plasma aerodynamic actuator.展开更多
Aim To study the dielectric properties of diamond film. Methods Dielectric properties (the frequency dependenCe of conductance, permittivity, and loss factor) of diamond film preped by DC are plasma jet chemical vap...Aim To study the dielectric properties of diamond film. Methods Dielectric properties (the frequency dependenCe of conductance, permittivity, and loss factor) of diamond film preped by DC are plasma jet chemical vapor deposition (CVD) were studied. Resuls Dielectric properties of CVD diamond fAn depend mainly on its polycrystalline nature, and the presence of non-diamond disordered graphitic regions and impurities between diamond grains of the film. Annealing at 500℃ leads to the removal of greater part of disordered graphitic regions, but am not remove all disordered graphitic regions and impurities. Conclusion Much work nab to be done tO prepare or post-treat diamond films before using CVD diamond as a substrate for electronic devices.展开更多
In field emission devices, the emission current sometimes degrades with the time. The mechanism of the current degradation is complicated. In this paper, a program is used to simulate the movement of the electron beam...In field emission devices, the emission current sometimes degrades with the time. The mechanism of the current degradation is complicated. In this paper, a program is used to simulate the movement of the electron beam from a field emitter. According to the current distribution and the trajectories of the primary electron beam, it is shown that the residual gas is ionized and the ion pairs are generated. The trajectories of the positive ions are simulated. With the different locations and kinetic energy of i...展开更多
The perovskite-type oxide solid solution Ba0.98Ce0.8Tm0.2O3-α was prepared by high temperature solid-state reaction and its single phase character was confirmed by X-ray diffraction. The conduction property of the sa...The perovskite-type oxide solid solution Ba0.98Ce0.8Tm0.2O3-α was prepared by high temperature solid-state reaction and its single phase character was confirmed by X-ray diffraction. The conduction property of the sample was investigated by alternating current impedance spectroscopy and gas concentration cell methods under different gases atmospheres in the temperature range of 500-900 ℃. The performance of the hydrogen-air fuel cell using the sample as solid electrolyte was measured. In wet hydrogen, the sample is a pure protonic conductor with the protonic transport number of 1 in the range of 500-600 ℃, a mixed conductor of proton and electron with the protonic transport number of 0.945-0.933 above 600 ℃. In wet air, the sample is a mixed conductor of proton, oxide ion, and electronic hole. The protonic transport numbers are 0.010-0.021, and the oxide ionic transport numbers are 0.471-0.382. In hydrogen-air fuel cell, the sample is a mixed conductor of proton, oxide ion and electron, the ionic transport numbers are 0.942 0.885. The fuel cell using Ba0.98Ce0.8Tm0.2O3-α as solid electrolyte can work stably. At 900 ℃, the maximum power output density is 110,2 mW/cm2, which is higher than that of our previous cell using Ba0.98Ce0.8Tm0.2O3-α （x〈≤1, RE=Y, Eu, Ho） as solid electrolyte.展开更多
This article studied experimentally the effect of multi-wall carbon nanotubes （MWCNTs） on the thermo physical properties of ionic liquid-based nanofluids. The nanofluids were composed of ionic liquid, 1-ethyl-3- met...This article studied experimentally the effect of multi-wall carbon nanotubes （MWCNTs） on the thermo physical properties of ionic liquid-based nanofluids. The nanofluids were composed of ionic liquid, 1-ethyl-3- methylimidazolium diethylphosphate [EMIM][DEP], or its aqueous solution[EMIM][DEP]（1） ＋ H20（2） and MWCNTs without any surfactants. The thermal conductivity, viscosity and density of the nanofluids were mea- sured experimentally. The effects of the mass fraction of MWCNTs, temperature and the mole fraction of water on the thermo physical properties of nanofluids were studied. Results show that the thermal conductivity of nanofluids increases within the range of 1.3%-9.7% compared to their base liquids, and have a well linear depen- dence on temperature. The viscosity and density of the nanofluids exhibit a remarkable increase compared with those of the base liquids. Finally, the correlation of the effective thermal conductivity and viscosity of the nanofluids was made using the models in the literatures.展开更多
基金Supported by the National High Technology Reserach and Development Program of China("863"program)(2005AA753031)the New Century Educational Talents Plan of Ministry of Education of China(NCET-05-0907)~~
文摘Plasma flow control is an active flow control technology that based on the plasma aerodynamic actuation. It can be used to enhance the aerodynamic characteristics of aircraft and propulsion systems. To study the phenomena occurring in plasma aerodynamic actuation and the mechanism of plasma flow control, the induced flow velocity of the plasma aerodynamic actuator is experimentally investigated under a variety of parameter conditions. The results indicate that plasma aerodynamic actuation accelerates the near surface air at velocities of a few meters per second, and there is an angle about 5° between the mainstream and the actuator wall and a spiral vortex is formed when the induced flow is moving along the wall. Besides, with the fixed frequency, the induced flow velocity increases linearly with the applied voltage, but it is insensitive to the frequency when the applied voltage is fixed. And the configuration is an effective factor for the performance of the plasma aerodynamic actuator.
文摘Aim To study the dielectric properties of diamond film. Methods Dielectric properties (the frequency dependenCe of conductance, permittivity, and loss factor) of diamond film preped by DC are plasma jet chemical vapor deposition (CVD) were studied. Resuls Dielectric properties of CVD diamond fAn depend mainly on its polycrystalline nature, and the presence of non-diamond disordered graphitic regions and impurities between diamond grains of the film. Annealing at 500℃ leads to the removal of greater part of disordered graphitic regions, but am not remove all disordered graphitic regions and impurities. Conclusion Much work nab to be done tO prepare or post-treat diamond films before using CVD diamond as a substrate for electronic devices.
文摘In field emission devices, the emission current sometimes degrades with the time. The mechanism of the current degradation is complicated. In this paper, a program is used to simulate the movement of the electron beam from a field emitter. According to the current distribution and the trajectories of the primary electron beam, it is shown that the residual gas is ionized and the ion pairs are generated. The trajectories of the positive ions are simulated. With the different locations and kinetic energy of i...
文摘The perovskite-type oxide solid solution Ba0.98Ce0.8Tm0.2O3-α was prepared by high temperature solid-state reaction and its single phase character was confirmed by X-ray diffraction. The conduction property of the sample was investigated by alternating current impedance spectroscopy and gas concentration cell methods under different gases atmospheres in the temperature range of 500-900 ℃. The performance of the hydrogen-air fuel cell using the sample as solid electrolyte was measured. In wet hydrogen, the sample is a pure protonic conductor with the protonic transport number of 1 in the range of 500-600 ℃, a mixed conductor of proton and electron with the protonic transport number of 0.945-0.933 above 600 ℃. In wet air, the sample is a mixed conductor of proton, oxide ion, and electronic hole. The protonic transport numbers are 0.010-0.021, and the oxide ionic transport numbers are 0.471-0.382. In hydrogen-air fuel cell, the sample is a mixed conductor of proton, oxide ion and electron, the ionic transport numbers are 0.942 0.885. The fuel cell using Ba0.98Ce0.8Tm0.2O3-α as solid electrolyte can work stably. At 900 ℃, the maximum power output density is 110,2 mW/cm2, which is higher than that of our previous cell using Ba0.98Ce0.8Tm0.2O3-α （x〈≤1, RE=Y, Eu, Ho） as solid electrolyte.
基金Supported by the National Natural Science Foundation of China(51376036)
文摘This article studied experimentally the effect of multi-wall carbon nanotubes （MWCNTs） on the thermo physical properties of ionic liquid-based nanofluids. The nanofluids were composed of ionic liquid, 1-ethyl-3- methylimidazolium diethylphosphate [EMIM][DEP], or its aqueous solution[EMIM][DEP]（1） ＋ H20（2） and MWCNTs without any surfactants. The thermal conductivity, viscosity and density of the nanofluids were mea- sured experimentally. The effects of the mass fraction of MWCNTs, temperature and the mole fraction of water on the thermo physical properties of nanofluids were studied. Results show that the thermal conductivity of nanofluids increases within the range of 1.3%-9.7% compared to their base liquids, and have a well linear depen- dence on temperature. The viscosity and density of the nanofluids exhibit a remarkable increase compared with those of the base liquids. Finally, the correlation of the effective thermal conductivity and viscosity of the nanofluids was made using the models in the literatures.
