船体板残余应力筛降后的平均应力—平均应变曲线

分析了船体中矩形板残余应力的筛降,得到了在受拉和受压情况下筛降水平的计算公式,并用有限元程序验证了公式的有效性.分析了残余应力筛降后板的平均应力-平均应变关系,采用两种方法分别得到了板的平均应力-平均应变关系的表达式,有限元法计算结果表明,方法2比方法1更合理.

残余应力的筛降效应及其对矩形板强度的影响(英文)

分析了船体板中残余应力的筛降,得到了在受拉和受压情况下的筛降水平的计算公式,并用有限元程序模拟了残余应力的筛降过程,验证了公式的有效性。分析了残余应力的筛降对板的平均应力-平均应变曲线的影响,采用两种方法分别得到了考虑筛降效应的板的平均应力-平均应变曲线的表达式,用有限元法进行了模拟计算,结果表明,分别计算受残余拉应力和残余压应力区的应力得到的平均应力-平均应变曲线和有限元计算结果符合得更好。

降液管长度对分散降液筛板性能的影响

探讨了分散降液筛板塔的降液管,通过计算分析设置了降液管的管径和长度,以"氧气-空气-水"为体系,研究了降液管长度对分散降液筛板的流体力学性能和传质性能的影响,结果表明降液管长度对分散降液筛板的性能具有重要的影响,且降液管长度为20mm的分散降液筛板综合性能较好。

赵家山选煤厂粗煤泥系统改造实践

针对赵家山选煤厂粗煤泥分选系统TBS精矿高灰细泥影响精煤灰分、TBS尾矿产率高且灰分低、粗煤泥设备处理能力不足进行改造。将原设计TBS分选改为TBS+螺旋二级分选;精矿由振动弧形筛改为叠层高频振动细筛脱泥降灰;改变筛下煤泥水流向。改造后中煤产率降低11.30%,精煤产率增加5.60%,矸石(煤泥)产率增加5.70%。

Screening and Isolation of Highly Efficient Cellulose-degrading Microorganisms and Construction of Complex Microbial System

This study almed to screen a highIy efficient ceI uIose-degrading compIex microbial system from soiI and rotten straw and then study its appIication to natural ceI uIose. The isoIated stralns were preIiminariIy screened with Congo red stalning and the ceI uIases activities were determined with DNS method. The non-antagonis-tic highIy efficient ceI uIos-degrading stralns were seIected and cuItured combinedIy for deveIoping a ceI uIose-degrading compIex microbial system. The resuIts showed that the CMC enzyme activity of the mixed cuIture of the three fungi stralns was higher than those of the cuItures of the three singIe stralns. The morphoIogical and moIecuIar bioIogical identification indicated that F1 was Botryosphaeria, F2 was Rhi-zopus oryzae, and F5 was Fusarium oxysporum. When straw was used as carbon source, the CMC enzyme activities of F1, F2 and F5 were 39.2, 31.4 and 40.6 IU/mI, respectiveIy; whiIe the CMC enzyme activity of the mixed cuIture of F1＋F2＋F5 was 50.12 IU/mI, which was increased by 23% compared to that of the singIe straln of F5. The experimental resuIts indicated that the ceI uIose-degrading effect of the compIex microbial system was better than those of the singIe fungi stralns, and the singIe stralns of F1, F2 and F5 had certaln deveIopment potentials.

Isolation,Screening and Primary Identification of a Keratin-degrading Fungus

[Objective] The paper was to provide new germplasm sources for efficient and economical degradation and utilization of animal keratin.[Method] The keratin-degrading fungus was isolated,screened and primarily identified by using the combination method of traditional isolation and screening,solid culture-medium degradation and animal test.[Result] A strain of non-pathogenic filamentous fungi with high degradation efficiency was obtained,which was preliminarily identified to be a species in Mucoraceae.[Conclusion] The discovery of the strain enriched the family members of keratin-degrading fungus,and provided new germplasm resources for degradation and utilization of animal keratin.

Novel method for separation and screening of lubricant-degrading microorganisms and bacterial biodegradation

With the rapid increase of lubricant consumption, oil contamination becomes more serious. Biotreatment is an important method to remove oil contamination with some advantages. In this study, acclimatized oil- contaminated soil and used lubricating oil were sampled to isolate lubricant-degrading strains by several methods. 51 isolates were obtained and 24-well plates were employed to assess bacterial potential in high- throughput screening. The method was noted for the prominence of oil-water two-phase system with saving chemicals, shortening cycles and lessening workloads. In order to decrease inaccuracy, subculture and resting cells were inoculated into mineral salt medium with 200 μ1 oil in well plates for the cultivation at 37 ℃ for 5 and 7 days, and the biodegradation potential was characterized by the changes of oil film and cell density. With appropriate evaluation by shaking flask tests, 5 isolates were retained for their potentials with the maxi- mum biodegradation from 1500 to 2200 mg· L-1 and identified as Acidovorax dtrulli, Pseudomonos balearica, Adnetobacterjohnsonii （two isolates with different biodegradation potentials） and Addovorax avenae using 16S rRNA sequencing analysis. Also, lipase activity was determined using indicator titration and p-nitrophenyl palmitate （p-NPP） methods. The results indicated that only p-NPP was successful to test lipase activity with the range of 1.93-6.29 mg· L-1 Although these five strains could degrade 1000 mg· L-1 lubricating oil in 158-168 h, there existed distinct difference in enzyme activity, which demonstrates that lipase activity could not be used as the criterion to evaluate microbial biodegradation potential for petroleum hydrocarbons.

Complete oxidation of 1,4-dioxane over zeolite-13X-supported Fe catalysts in the presence of air

Zeolite-13X-supported Fe（Fe/zeolite-13X） catalysts with various Fe contents were prepared by the wet impregnation method.The catalysts were characterized by N2 adsorption-desorption isotherms to estimate the Brunauer-Emmett-Teller surface areas and Barrett-Joyner-Hanlenda pore size distributions.X-ray diffraction,scanning electron microscopy,temperature-programmed reduction,and temperature-programmed desorption of NH3 were used to investigate the textural properties of the Fe/zeolite-13 X catalysts.Their catalytic activities were determined for the complete oxidation of1,4-dioxane using air as the oxidant in a fixed-bed flow reactor in the temperature range 100-400℃.The influences of various process parameters,such as reaction temperature,metal loading,and gas hourly space velocity（GHSV）,on the dioxane removal efficiency by catalytic oxidation were investigated.The stability of the catalyst was tested at 400℃ by performing time-on-stream analysis for 50 h.The Fe/zeolite-13 X catalyst with 6 wt%Fe exhibited the best catalytic activity among the Fe/zeolite-13 X catalysts at 400℃ and a GHSV of 24000 h^（-1）,with 97%dioxane conversion and95%selectivity for the formation of carbon oxides（CO and CO2）.Trace amounts（ 3%） of acetaldehyde,ethylene glycol monoformate,ethylene glycol diformate,1,4-dioxane-2-ol,1,4-dioxane-2-one,and 2-methoxy-1,3-dioxalane were also formed as degradation products.A plausible degradation mechanism is proposed based on the products identified by GC-MS analysis.

Screening and identification of cellulose-degradation strain M1 and its characteristics of cellulase

In this paper, in order to get the target microbe which has high cellulose bio-degradation ability, we collected soil samples from environment rich in cellulose. Carboxymethyl cellulose sodium gel plate and filter paper plate were used for microbe screening, and finally we got a strain named MI which has the highest cellulase producing ability, and it has been identified as Penicilium oxalicum by morphological and molecular biological identification. We have studied cellulose degradation ability of this strain under different conditions such as pH value, temperature and inoculating time. The results showed that CMCase which belongs to acid enzyme, could achieve its maximum enzyme activity 489.96 U/ml when the optimal pH value was 4. The FPAase could achieve its maximum enzyme activity 1,595.45 U/ml when the optimal pH value was 4, too. The optimal ferment temperature of CMCase is 50℃ when achieved the maximum of enzyme activity at the second day, whereas the FPAase could reach its tip top on the third day, So the optimal ferment temperature of FPAase is also 50℃.

Removal of reactive bright-red X-3B in water by Ti/13X molecular sieves

The compound materials （shorted by Ti/13X） of doping of TiO2 into 13X molecular sieves has-been achieved by methods namely impregnation. Technical parameters of preparation for Ti/13X were determined by removal efficiency of simulation dyeing wastewater containing reactive bright-red X-3B （shorted by X-3B）. In various preparation parameters, the influence of Ti loaded on 13X molecular sieves on X-3B removal efficiency is most important. The optimum condition for volume of TiCI4 loaded on 13X molecular sieves is 8 ml at 95.9%, produced sample referred as M8. M8 was characterized using X-Ray Diffraction （XRD）, Scanning Electron Microscope （SEM）. XRD patterns of M8 revealed the incorporation of titanium into framework of 13X molecular sieves, due to the presence ofTiO2 anatase phase. SEM image showed that M8 has a large number of wormhole-like channels, in comparison with that of 13X molecular sieves. The photocatalytic tests were carried out for degradation of X-3B. The results showed that the dosage of Ti/13X, reaction time, pH, and concentration of X-3B influence the X-3B removal efficiency. The optimum conditions of photodegradation as the following： MS/X-3B ratio, Conc. is 0.3 g/l, reaction time is 120 rain, pH is 2-6. The photodegradation reaction of Ti/13X with X-3B followed first order kinetics. The rate constants and t1/2 for M8 sample at 0.3 g/l M8/ X-3B solution ratio were 430 min^-1 and 16 min, respectively.