A ternary composite of TiO2 and a SiO2-Al2O3 aerogel with good photocatalytic activity was prepared by a simple sol-gel method with TiO2 nanoparticles and SiO2-Al2O3 aerogels derived from industrial fly ash.The struct...A ternary composite of TiO2 and a SiO2-Al2O3 aerogel with good photocatalytic activity was prepared by a simple sol-gel method with TiO2 nanoparticles and SiO2-Al2O3 aerogels derived from industrial fly ash.The structural features of the TiO2/SiO2-Al2O3 aerogel composite were investigated by X-ray powder diffraction,Fourier transform infrared spectroscopy,transmission electron microscopy,gas adsorption measurements and diffuse reflectance UV-visible spectroscopy.The optimal conditions for photocatalytic degradation of 2-sec-butyl-4,6-dinitrophenol（DNBP],included an initial DNBP concentration of 0.167 mmol/L at pH = 4.86 with a catalyst concentration of 6 g/L,under visible light irradiation for 5 h.A plausible mechanism is proposed for the photocatalytic degradation of DNBP.Our composite showed higher photocatalytic activity for DNBP degradation than that of pure TiO2.This indicates that this material can serve as an efficient photocatalyst for degradation of hazardous organic pollutants in wastewater.展开更多
Printing and dyeing industry is a considerable source of environmental contamination. In this study treatment of printing and dyeing wastewater with a new type of sewage treatment agent, fly-ash coated with chitosan p...Printing and dyeing industry is a considerable source of environmental contamination. In this study treatment of printing and dyeing wastewater with a new type of sewage treatment agent, fly-ash coated with chitosan particles （FCCP）, was examined. The effects ofpH, stirring time, sedimentation time and temperature on color, COD, turbidity and NH3-N removal were determined. The optimum dosage of FCCP and the influence of individual factors on removal efficiency were tested. The optimum parameters determined using the L16 （45） orthogonal experiment were as follows： FCCP （weight ratio of chitosan to fly-ash 1：6） dosage, 4 g.L^-1; temperature, 35℃; pH, 4. The stirring time and sedimentation time were 20 min and 5 h, respectively. Under these optimum conditions, the color, COD and NH3-N removal ratios were 97%, 80% and 75%, respectively.展开更多
Influence of ultrafine active mineral (DK mineral) on mechanical property of fly ash based load bearing aerocrete was analyzed. The result shows that the addition of DK mineral in a suitable amount can enhance obvious...Influence of ultrafine active mineral (DK mineral) on mechanical property of fly ash based load bearing aerocrete was analyzed. The result shows that the addition of DK mineral in a suitable amount can enhance obviously the compressive strength of aerocrete. According to the SEM EDS and X ray diffraction analyses, the crystal shapes of hydration products are well developed and interlocked for samples containing DK mineral. Its microstructure is denser than that of the samples without DK mineral. Having a good activation, the DK mineral makes both the type and the quantity of hydrated products be obviously superior to that of the contrast sample.展开更多
Using the method of sedentary thermal experiment, the use of fly ash to remove Zn 2+ ,Cu 2+ and Pb 2+ in waste water was studied. Special attention was paid to the effects of pH and time degree of activity on absorbin...Using the method of sedentary thermal experiment, the use of fly ash to remove Zn 2+ ,Cu 2+ and Pb 2+ in waste water was studied. Special attention was paid to the effects of pH and time degree of activity on absorbing ability. The freundlich model applicable to the absorption data was set. Also the mechanism of absorption and ultra micro structure of fly ash with the help of TEM was put forward.展开更多
基金supported by the National Natural Science Foundation of China(21377018)the Natural Science Foundation of Liaoning Province of China(2013020116)the Fundamental Research Funds for the Central Universities(DUT15ZD240)~~
文摘A ternary composite of TiO2 and a SiO2-Al2O3 aerogel with good photocatalytic activity was prepared by a simple sol-gel method with TiO2 nanoparticles and SiO2-Al2O3 aerogels derived from industrial fly ash.The structural features of the TiO2/SiO2-Al2O3 aerogel composite were investigated by X-ray powder diffraction,Fourier transform infrared spectroscopy,transmission electron microscopy,gas adsorption measurements and diffuse reflectance UV-visible spectroscopy.The optimal conditions for photocatalytic degradation of 2-sec-butyl-4,6-dinitrophenol（DNBP],included an initial DNBP concentration of 0.167 mmol/L at pH = 4.86 with a catalyst concentration of 6 g/L,under visible light irradiation for 5 h.A plausible mechanism is proposed for the photocatalytic degradation of DNBP.Our composite showed higher photocatalytic activity for DNBP degradation than that of pure TiO2.This indicates that this material can serve as an efficient photocatalyst for degradation of hazardous organic pollutants in wastewater.
基金Supported by the Science and Technology Development Foundation of Foshan (No.2005060071)
文摘Printing and dyeing industry is a considerable source of environmental contamination. In this study treatment of printing and dyeing wastewater with a new type of sewage treatment agent, fly-ash coated with chitosan particles （FCCP）, was examined. The effects ofpH, stirring time, sedimentation time and temperature on color, COD, turbidity and NH3-N removal were determined. The optimum dosage of FCCP and the influence of individual factors on removal efficiency were tested. The optimum parameters determined using the L16 （45） orthogonal experiment were as follows： FCCP （weight ratio of chitosan to fly-ash 1：6） dosage, 4 g.L^-1; temperature, 35℃; pH, 4. The stirring time and sedimentation time were 20 min and 5 h, respectively. Under these optimum conditions, the color, COD and NH3-N removal ratios were 97%, 80% and 75%, respectively.
文摘Influence of ultrafine active mineral (DK mineral) on mechanical property of fly ash based load bearing aerocrete was analyzed. The result shows that the addition of DK mineral in a suitable amount can enhance obviously the compressive strength of aerocrete. According to the SEM EDS and X ray diffraction analyses, the crystal shapes of hydration products are well developed and interlocked for samples containing DK mineral. Its microstructure is denser than that of the samples without DK mineral. Having a good activation, the DK mineral makes both the type and the quantity of hydrated products be obviously superior to that of the contrast sample.
文摘Using the method of sedentary thermal experiment, the use of fly ash to remove Zn 2+ ,Cu 2+ and Pb 2+ in waste water was studied. Special attention was paid to the effects of pH and time degree of activity on absorbing ability. The freundlich model applicable to the absorption data was set. Also the mechanism of absorption and ultra micro structure of fly ash with the help of TEM was put forward.
