以深圳市前海湾车辆段和横岗车辆段试车线为例,对其试车过程中的噪声影响源强及传播情况进行实测分析。结果表明,试车线车辆行驶速度约为36 km/h,噪声源强LeqA约为73 d B左右,试车中噪声最大值约为83 d B;试车线内噪声源的传播并不完全...以深圳市前海湾车辆段和横岗车辆段试车线为例,对其试车过程中的噪声影响源强及传播情况进行实测分析。结果表明,试车线车辆行驶速度约为36 km/h,噪声源强LeqA约为73 d B左右,试车中噪声最大值约为83 d B;试车线内噪声源的传播并不完全遵循一般的线性递减规律,在距声源30 m范围内,距声源越近,衰减量越小,反之,主要是由于距离声源越远,受到墙体或立柱等阻挡引起的附加衰减就越大。展开更多
As develops in deep sub micron designs,the interconnect crosstalk becomes much more serious.Espe cially, the coupling inductance can not be ignored in gigahertz designs.So shield insertion is an efficient techniq...As develops in deep sub micron designs,the interconnect crosstalk becomes much more serious.Espe cially, the coupling inductance can not be ignored in gigahertz designs.So shield insertion is an efficient technique to reduce the inductive noise.In this paper,the characteristics of on chip mutual inductance (as well as self) for coplanar,micro stripline and stripline structures are introduced first.Then base on the coplanar interconnect structures,the effective coupling K eff model and the RLC explicit noise model are proposed respectively.The results of experiments show that these two models both have high fidelity.展开更多
The signal integrity problem in 0.18μm CMOS technology is analyzed from simulation.Several rules in this phenomenon are found by analyzing the crosstalk delay and noise,which are helpful for the future circuit design.
A new architecture of CMOS low voltage downconve rsion mixer is presented.With 1.452GHz LO input and 1.45GHz RF input,simulation results show that the conversion gain is 15dB,IIP3 is -4.5dBm,NF is 17dB,the maximum tra...A new architecture of CMOS low voltage downconve rsion mixer is presented.With 1.452GHz LO input and 1.45GHz RF input,simulation results show that the conversion gain is 15dB,IIP3 is -4.5dBm,NF is 17dB,the maximum transient power dissipation is 9.3mW,and DC power dissipation is 9.2mW.The mixer’s noise and linearity analyses are also presented.展开更多
A 2. 4GHz CMOS monolithic transceiver front-end for IEEE 802. llb wireless LAN applications is presented. The receiver and transmitter are both of superheterodyne structure for good system performance. The frontend co...A 2. 4GHz CMOS monolithic transceiver front-end for IEEE 802. llb wireless LAN applications is presented. The receiver and transmitter are both of superheterodyne structure for good system performance. The frontend consists of five blocks., low noise amplifier,down-converter, up-converter, pre-amplifier, and LO buffer. Their input/output impedance are all on-chip matched to 50 Ω except the down-converter which has open-drain outputs. The transceiver RF front-end has been implemented in a 0. 18μm CMOS process. When the LNA and the down-converter are directly connected, the measured noise figure is 5.2dB, the measured available power gain 12. 5dB, the input l dB compression point --18dBm,and the third-order input intercept point --7dBm. The receiver front-end draws 13.6mA currents from the 1.8V power supply. When the up-converter and pre-amplifier are directly connected, the measured noise figure is 12.4dB, the power gain is 23. 8dB, the output ldB compression point is 1.5dBm, and the third-order output intercept point is 16dBm. The transmitter consumes 27.6mA current from the 1.8V power supply.展开更多
In this paper, we propose a cross reference method for nonlinear time series analyzing in semi blind case, that is, the dynamic equations modeling the time series are known but the corresponding parameters are not. ...In this paper, we propose a cross reference method for nonlinear time series analyzing in semi blind case, that is, the dynamic equations modeling the time series are known but the corresponding parameters are not. The tasks of noise reduction and parameter estimation which were fulfilled separately before are combined iteratively. With the positive interaction between the two processing modules, the method is somewhat superior. Some prior work can be viewed as special cases of this general framework. The simulations for noise reduction and parameter estimation of contaminated chaotic time series show improved performance of our method compared with previous work.展开更多
文摘以深圳市前海湾车辆段和横岗车辆段试车线为例,对其试车过程中的噪声影响源强及传播情况进行实测分析。结果表明,试车线车辆行驶速度约为36 km/h,噪声源强LeqA约为73 d B左右,试车中噪声最大值约为83 d B;试车线内噪声源的传播并不完全遵循一般的线性递减规律,在距声源30 m范围内,距声源越近,衰减量越小,反之,主要是由于距离声源越远,受到墙体或立柱等阻挡引起的附加衰减就越大。
文摘As develops in deep sub micron designs,the interconnect crosstalk becomes much more serious.Espe cially, the coupling inductance can not be ignored in gigahertz designs.So shield insertion is an efficient technique to reduce the inductive noise.In this paper,the characteristics of on chip mutual inductance (as well as self) for coplanar,micro stripline and stripline structures are introduced first.Then base on the coplanar interconnect structures,the effective coupling K eff model and the RLC explicit noise model are proposed respectively.The results of experiments show that these two models both have high fidelity.
文摘The signal integrity problem in 0.18μm CMOS technology is analyzed from simulation.Several rules in this phenomenon are found by analyzing the crosstalk delay and noise,which are helpful for the future circuit design.
文摘A new architecture of CMOS low voltage downconve rsion mixer is presented.With 1.452GHz LO input and 1.45GHz RF input,simulation results show that the conversion gain is 15dB,IIP3 is -4.5dBm,NF is 17dB,the maximum transient power dissipation is 9.3mW,and DC power dissipation is 9.2mW.The mixer’s noise and linearity analyses are also presented.
文摘A 2. 4GHz CMOS monolithic transceiver front-end for IEEE 802. llb wireless LAN applications is presented. The receiver and transmitter are both of superheterodyne structure for good system performance. The frontend consists of five blocks., low noise amplifier,down-converter, up-converter, pre-amplifier, and LO buffer. Their input/output impedance are all on-chip matched to 50 Ω except the down-converter which has open-drain outputs. The transceiver RF front-end has been implemented in a 0. 18μm CMOS process. When the LNA and the down-converter are directly connected, the measured noise figure is 5.2dB, the measured available power gain 12. 5dB, the input l dB compression point --18dBm,and the third-order input intercept point --7dBm. The receiver front-end draws 13.6mA currents from the 1.8V power supply. When the up-converter and pre-amplifier are directly connected, the measured noise figure is 12.4dB, the power gain is 23. 8dB, the output ldB compression point is 1.5dBm, and the third-order output intercept point is 16dBm. The transmitter consumes 27.6mA current from the 1.8V power supply.
文摘In this paper, we propose a cross reference method for nonlinear time series analyzing in semi blind case, that is, the dynamic equations modeling the time series are known but the corresponding parameters are not. The tasks of noise reduction and parameter estimation which were fulfilled separately before are combined iteratively. With the positive interaction between the two processing modules, the method is somewhat superior. Some prior work can be viewed as special cases of this general framework. The simulations for noise reduction and parameter estimation of contaminated chaotic time series show improved performance of our method compared with previous work.
