This paper is concerned with a class of degenerate and nondegenerate stable diffusion models.By using the upper and lower solution method and Schauder fixed point principle,the author studies the existence of positive...This paper is concerned with a class of degenerate and nondegenerate stable diffusion models.By using the upper and lower solution method and Schauder fixed point principle,the author studies the existence of positive solutions for these stable_diffusion models under some conditions.展开更多
The Al-Cu wheel adopting the new Al alloy was prepared by the liquid-die forging,and the mechanical properties,composition distribution,microstructure and fracture behavior were investigated.The results showed that se...The Al-Cu wheel adopting the new Al alloy was prepared by the liquid-die forging,and the mechanical properties,composition distribution,microstructure and fracture behavior were investigated.The results showed that serious Cu segregation was found in the wheel specimen;the microstructure of the Al-Cu wheel was comprised of the casting microstructure and a small amount of the deformed microstructure;the best heat treatment and water quenching system were found to solution treated at(530±5)℃ for 4 h followed by(535±5)℃ for 24 h and aging treated at(155±5)℃ for 4 h;the fracture morphologies of the samples heated under T 6 and T 5-1 heat treatment showed flat,tough nest,and poor plastic characteristics;the fracture morphologies of the samples heated under T 4 heat treatment exhibited complete resilience,but no residual metallographic characteristic;the sample treated under T 4 protocol had the best elongation;the fracture failure was mainly due to the formation of the CuAl_(2)(θ)phases;and the fracture mechanism of the Al-Cu wheel was intergranular fracture.展开更多
Mesoscopic characteristics of a clayey soil specimen subjected to macroscopic loading are examined using a medi- cal-use computerized tomography (CT) instrument. Disturbed state concept (DSC) theory is based on the ut...Mesoscopic characteristics of a clayey soil specimen subjected to macroscopic loading are examined using a medi- cal-use computerized tomography (CT) instrument. Disturbed state concept (DSC) theory is based on the utilization of the hard- ening model. DSC indirectly describes material behavior by claiming that the actual response of the material is expressed in terms of the relative intact (RI) response and the fully adjusted (FA) response. The occurrence of mesoscopic structural changes of material has similarities with the occurrence of a macroscopic response of the material under loadings. In general, the relative changing value of a softening material is three to five times more than that of a hardening material. Whether special zones exist or not in a specimen cross section does not affect the following conclusion: hardening material and softening material show me- chanical differences with CT statistical indices values prominently changing, and the change is related to the superposing of a disturbance factor. A new disturbance factor evolution function is proposed. Thus, mesoscopic statistical indices are introduced to describe macroscopic behavior through the new evolution function. An application of the new evolution function proves the effectiveness of the amalgamation of a macroscopic and a mesoscopic experimental phenomenon measurement methods.展开更多
A hybrid automaton modeling approach that incorporates state space partitioning, phase dynamic modeling and control law synthesis by control strategy is utilized to develop a hybrid automaton model of molten carbonate...A hybrid automaton modeling approach that incorporates state space partitioning, phase dynamic modeling and control law synthesis by control strategy is utilized to develop a hybrid automaton model of molten carbonate fuel cell (MCFC) stack shutdown. The shutdown operation is divided into several phases and their boundaries are decided according to a control strategy, which is a set of specifications about the dynamics of MCFC stack during shutdown. According to the control strategy, the specification of increasing stack temperature is satisfied in a phase that can be modeled accurately. The model for phase that has complex dynamic is approximated. The duration of this kind of phase is decreased to minimize the error caused by model approximation.展开更多
In this paper, the studies show that the framework of the original organizational models based on the philosophy view is constructed. The driving forces are also expatiated in the paper. Matching with the time and spa...In this paper, the studies show that the framework of the original organizational models based on the philosophy view is constructed. The driving forces are also expatiated in the paper. Matching with the time and space in which the organization exists, fitted with the extra environment, making the organization take effect and properly controlling the important potential factors for the organizations further are the four driving forces development. The supporting pillars are cooperation in the competition, communication, negotiation and proper equal culture environment. At last, the researches point out that organization is a process, while organizational model is only a tool for us to realize the world.展开更多
Based on the flux tube model, the effects of the confining potentials of different configurations, namely the △-type and the Y-type, on the spectra of baryons are studied on SUSF（6） basis. The baryon spectra are ob...Based on the flux tube model, the effects of the confining potentials of different configurations, namely the △-type and the Y-type, on the spectra of baryons are studied on SUSF（6） basis. The baryon spectra are obtained in a unified manner. Our result shows that by employing either the △-mode or the Y-mode confining potential, one can achieve reasonable baryon spectra. The △-mode may be mostly effective for the short- and medium-distances, while the Y-mode may offer more contributions to the spectra for long-distances. Although the binding energies in baryon spectra may deviate by a few to several tens MeV for different modes, it is hard to determine either one to be dominant by simply evaluating the baryon spectra. One may need to invoke the baryon decay process to make further judgement.展开更多
The control of ultra-supercritical(USC) power unit is a difficult issue for its characteristic of the nonlinearity, large dead time and coupling of the unit. In this paper, model predictive control(MPC) based on multi...The control of ultra-supercritical(USC) power unit is a difficult issue for its characteristic of the nonlinearity, large dead time and coupling of the unit. In this paper, model predictive control(MPC) based on multi-model and double layered optimization is introduced for coordinated control of USC unit. The linear programming(LP) combined with quadratic programming(QP) is used in steady optimization for computation of the ideal value of dynamic optimization. Three inputs(i.e. valve opening, coal flow and feedwater flow) are employed to control three outputs(i.e. load, main steam temperature and main steam pressure). The step response models for the dynamic matrix control(DMC) are constructed using the three inputs and the three outputs. Piecewise models are built at selected operation points. Double-layered multi-model predictive controller is implemented in simulation with satisfactory performance.展开更多
文摘This paper is concerned with a class of degenerate and nondegenerate stable diffusion models.By using the upper and lower solution method and Schauder fixed point principle,the author studies the existence of positive solutions for these stable_diffusion models under some conditions.
基金Project(2019 YFC 1511400)supported by the National Key Technologies R&D Program of China。
文摘The Al-Cu wheel adopting the new Al alloy was prepared by the liquid-die forging,and the mechanical properties,composition distribution,microstructure and fracture behavior were investigated.The results showed that serious Cu segregation was found in the wheel specimen;the microstructure of the Al-Cu wheel was comprised of the casting microstructure and a small amount of the deformed microstructure;the best heat treatment and water quenching system were found to solution treated at(530±5)℃ for 4 h followed by(535±5)℃ for 24 h and aging treated at(155±5)℃ for 4 h;the fracture morphologies of the samples heated under T 6 and T 5-1 heat treatment showed flat,tough nest,and poor plastic characteristics;the fracture morphologies of the samples heated under T 4 heat treatment exhibited complete resilience,but no residual metallographic characteristic;the sample treated under T 4 protocol had the best elongation;the fracture failure was mainly due to the formation of the CuAl_(2)(θ)phases;and the fracture mechanism of the Al-Cu wheel was intergranular fracture.
文摘Mesoscopic characteristics of a clayey soil specimen subjected to macroscopic loading are examined using a medi- cal-use computerized tomography (CT) instrument. Disturbed state concept (DSC) theory is based on the utilization of the hard- ening model. DSC indirectly describes material behavior by claiming that the actual response of the material is expressed in terms of the relative intact (RI) response and the fully adjusted (FA) response. The occurrence of mesoscopic structural changes of material has similarities with the occurrence of a macroscopic response of the material under loadings. In general, the relative changing value of a softening material is three to five times more than that of a hardening material. Whether special zones exist or not in a specimen cross section does not affect the following conclusion: hardening material and softening material show me- chanical differences with CT statistical indices values prominently changing, and the change is related to the superposing of a disturbance factor. A new disturbance factor evolution function is proposed. Thus, mesoscopic statistical indices are introduced to describe macroscopic behavior through the new evolution function. An application of the new evolution function proves the effectiveness of the amalgamation of a macroscopic and a mesoscopic experimental phenomenon measurement methods.
文摘A hybrid automaton modeling approach that incorporates state space partitioning, phase dynamic modeling and control law synthesis by control strategy is utilized to develop a hybrid automaton model of molten carbonate fuel cell (MCFC) stack shutdown. The shutdown operation is divided into several phases and their boundaries are decided according to a control strategy, which is a set of specifications about the dynamics of MCFC stack during shutdown. According to the control strategy, the specification of increasing stack temperature is satisfied in a phase that can be modeled accurately. The model for phase that has complex dynamic is approximated. The duration of this kind of phase is decreased to minimize the error caused by model approximation.
文摘In this paper, the studies show that the framework of the original organizational models based on the philosophy view is constructed. The driving forces are also expatiated in the paper. Matching with the time and space in which the organization exists, fitted with the extra environment, making the organization take effect and properly controlling the important potential factors for the organizations further are the four driving forces development. The supporting pillars are cooperation in the competition, communication, negotiation and proper equal culture environment. At last, the researches point out that organization is a process, while organizational model is only a tool for us to realize the world.
基金The project supported by the Special Scientific Research Foundation for Doctoral Programs of Universities of China.
文摘Based on the flux tube model, the effects of the confining potentials of different configurations, namely the △-type and the Y-type, on the spectra of baryons are studied on SUSF（6） basis. The baryon spectra are obtained in a unified manner. Our result shows that by employing either the △-mode or the Y-mode confining potential, one can achieve reasonable baryon spectra. The △-mode may be mostly effective for the short- and medium-distances, while the Y-mode may offer more contributions to the spectra for long-distances. Although the binding energies in baryon spectra may deviate by a few to several tens MeV for different modes, it is hard to determine either one to be dominant by simply evaluating the baryon spectra. One may need to invoke the baryon decay process to make further judgement.
基金Supported by the National Natural Science Foundation of China(60974119)
文摘The control of ultra-supercritical(USC) power unit is a difficult issue for its characteristic of the nonlinearity, large dead time and coupling of the unit. In this paper, model predictive control(MPC) based on multi-model and double layered optimization is introduced for coordinated control of USC unit. The linear programming(LP) combined with quadratic programming(QP) is used in steady optimization for computation of the ideal value of dynamic optimization. Three inputs(i.e. valve opening, coal flow and feedwater flow) are employed to control three outputs(i.e. load, main steam temperature and main steam pressure). The step response models for the dynamic matrix control(DMC) are constructed using the three inputs and the three outputs. Piecewise models are built at selected operation points. Double-layered multi-model predictive controller is implemented in simulation with satisfactory performance.
