The design and implementation of a novel ADC architecture called ring-ADC for digital voltage regulator module controllers are presented. Based on the principle of voltage-controlled oscillators＇ transform from volta...The design and implementation of a novel ADC architecture called ring-ADC for digital voltage regulator module controllers are presented. Based on the principle of voltage-controlled oscillators＇ transform from voltage to frequency,the A/D conversion of ring-ADC achieves good linearity and precise calibration against process variations compared with the delay-line ADC. A differential pulse counting discriminator also helps decrease the power consumption of the ring-ADC. It is fabricated with a Chartered 0.35μm CMOS process, and the measurement results of the integral and differential nonlinearity performance are 0.92LSB and 1.2LSB respectively. The maximum gain error measured in ten sample chips is ± 3.85%. With sampling rate of 500kHz and when the voltage regulator module （VRM） works in steady state, the ring-ADC＇s average power consumption is 2.56mW. The ring-ADC is verified to meet the requirements for digital VRM controller application.展开更多
The simulation of the early-time High-altitude Electromagnetic Pulse （HEMP） environment （El） with bicone-cage antenna in free space requires utilization of the spherical wave to reproduce the boundless plane wave....The simulation of the early-time High-altitude Electromagnetic Pulse （HEMP） environment （El） with bicone-cage antenna in free space requires utilization of the spherical wave to reproduce the boundless plane wave. The transient radiation of the antenna above the lossy ground is computed using the Finite-Difference Time-Domain （FDTD） method The determining factors of the field waveform are explored and analysed on the basis of the physical evolution process of the transient radiation. The typical waveform of the electric field and the field distribution characteristics, both of which are important for HEMP simulator design and the effect tests, are presented. The study indicates that the simulation should be analysed from the perspective of both environment building and simulator applications.展开更多
In order to search for a suitable anode material used in zinc electrowinning in place of Pb-Ag alloy,Al/Pb-PANI（polyaniline）-WC（tungsten carbide） composite inert anodes were prepared on aluminum alloy substrate by...In order to search for a suitable anode material used in zinc electrowinning in place of Pb-Ag alloy,Al/Pb-PANI（polyaniline）-WC（tungsten carbide） composite inert anodes were prepared on aluminum alloy substrate by double pulse electrodeposition（DPE） of PANI and WC particles with Pb2＋ from an original plating bath.Thereafter,anodic polarization curves,cyclic voltammetry curves and Tafel polarization curves for the composite inert anodes obtained under different PANI concentrations in the original plating bath were measured,and the microstructural features were also investigated by scanning electron microscopy（SEM）.The results show that Al/Pb-PANI-WC composite inert anode obtained under PANI concentration of 20 g/L in the original plating bath possesses uniform microstructures and composition distributions,higher electrocatalytic activity,better reversibility of electrode reaction and corrosion resistance in a synthetic zinc electrowinning electrolyte of 50 g/L Zn2＋,150 g/L H2SO4 at 35 °C.Compared with Pb-1%Ag alloy,the overpotential of oxygen evolutions for the composite inert anode are decreased by 185 mV and 166 mV,respectively,under 500 A/m2 and 1000 A/m2.展开更多
The novel covalently modified glassy carbon electrode with poly(xylitol) was prepared using an electropolymerization technique for the simultaneous determination of uric acid(UA), xanthine(XA) and hypoxanthine(HX). Th...The novel covalently modified glassy carbon electrode with poly(xylitol) was prepared using an electropolymerization technique for the simultaneous determination of uric acid(UA), xanthine(XA) and hypoxanthine(HX). This new electrode presents an excellent electrocatalytic activity towards the oxidation of UA, XA and HX by cyclic voltammetry(CV) method. The oxidation peaks of the three compounds were well defined and had enhanced the peak currents. The separation potentials of the oxidation peak potentials for UA-XA and XA-HX were 380 and 370 mV in CV, respectively. Using differential pulse voltammetry(DPV) method, the calibration curves in the ranges of 5-55, 1.3-75.3 and 4-59 μmol/L were obtained for HX, XA and UA, respectively. The lowest detection limits(S/N=3) were 4.5, 0.75 and 3.75 μmol/L for HX, XA and UA, respectively. The practical application of the modified electrode was demonstrated by the determination of UA, XA, HX in human urine samples.展开更多
We demonstrated a monolithic, compact, diode-pumped gain-switched Nd:YVO4 laser at 1.064 μm wavelength with controllable repetition rate of 1 Hz to 25 kHz. Stable gain-switched pulse train with maximum repetition rat...We demonstrated a monolithic, compact, diode-pumped gain-switched Nd:YVO4 laser at 1.064 μm wavelength with controllable repetition rate of 1 Hz to 25 kHz. Stable gain-switched pulse train with maximum repetition rate of 25 kHz and pulse width of 16 ns was obtained.展开更多
An Ytterbium-doped mode-locked fiber laser using the polarization sensitive isolator and polarization controllers (PC) is reported. In the normal dispersion, the fiber laser can oscillate at the multi-pulse states by ...An Ytterbium-doped mode-locked fiber laser using the polarization sensitive isolator and polarization controllers (PC) is reported. In the normal dispersion, the fiber laser can oscillate at the multi-pulse states by adjusting the position of the PC. On the condition that the polarization state isn’t changed, the outputs of Ytterbium-doped mode-locked fiber laser change from single pulse to multi-pulse by increasing the pump power. The fiber laser can achieve different multi-pulse output by adjusting the PC1 and PC2 carefully.展开更多
By field experiment in Sandaozhuang W-Mo mining area in Luanchuan of Henan Province, the authors analyzed the Experimental result of reverse circulation bit on the basis of different structures and obtained the follow...By field experiment in Sandaozhuang W-Mo mining area in Luanchuan of Henan Province, the authors analyzed the Experimental result of reverse circulation bit on the basis of different structures and obtained the following conclusion: the design parameter of reverse circulation bit, the number, diameter and angle of the spurt hole can influence on the reverse circulation effect. The bit with inner spurt hole is better obviously than that one without inner spurt hole in reverse circulation, one or two right and the best choice of inner spurt hole is that the diameter is Φ8, the angle is 30° dip up and the suitable number is two to three.展开更多
文摘The design and implementation of a novel ADC architecture called ring-ADC for digital voltage regulator module controllers are presented. Based on the principle of voltage-controlled oscillators＇ transform from voltage to frequency,the A/D conversion of ring-ADC achieves good linearity and precise calibration against process variations compared with the delay-line ADC. A differential pulse counting discriminator also helps decrease the power consumption of the ring-ADC. It is fabricated with a Chartered 0.35μm CMOS process, and the measurement results of the integral and differential nonlinearity performance are 0.92LSB and 1.2LSB respectively. The maximum gain error measured in ten sample chips is ± 3.85%. With sampling rate of 500kHz and when the voltage regulator module （VRM） works in steady state, the ring-ADC＇s average power consumption is 2.56mW. The ring-ADC is verified to meet the requirements for digital VRM controller application.
文摘The simulation of the early-time High-altitude Electromagnetic Pulse （HEMP） environment （El） with bicone-cage antenna in free space requires utilization of the spherical wave to reproduce the boundless plane wave. The transient radiation of the antenna above the lossy ground is computed using the Finite-Difference Time-Domain （FDTD） method The determining factors of the field waveform are explored and analysed on the basis of the physical evolution process of the transient radiation. The typical waveform of the electric field and the field distribution characteristics, both of which are important for HEMP simulator design and the effect tests, are presented. The study indicates that the simulation should be analysed from the perspective of both environment building and simulator applications.
基金Project (51004056) supported by the National Natural Science Foundation of ChinaProject (KKZ6201152009) supported by the Opening Foundation of Key Laboratory of Inorganic Coating Materials, ChinaProjects (2011239, 2011240) supported by Analysis and Measurement Research Fund of Kunming University of Science and Technology,China
文摘In order to search for a suitable anode material used in zinc electrowinning in place of Pb-Ag alloy,Al/Pb-PANI（polyaniline）-WC（tungsten carbide） composite inert anodes were prepared on aluminum alloy substrate by double pulse electrodeposition（DPE） of PANI and WC particles with Pb2＋ from an original plating bath.Thereafter,anodic polarization curves,cyclic voltammetry curves and Tafel polarization curves for the composite inert anodes obtained under different PANI concentrations in the original plating bath were measured,and the microstructural features were also investigated by scanning electron microscopy（SEM）.The results show that Al/Pb-PANI-WC composite inert anode obtained under PANI concentration of 20 g/L in the original plating bath possesses uniform microstructures and composition distributions,higher electrocatalytic activity,better reversibility of electrode reaction and corrosion resistance in a synthetic zinc electrowinning electrolyte of 50 g/L Zn2＋,150 g/L H2SO4 at 35 °C.Compared with Pb-1%Ag alloy,the overpotential of oxygen evolutions for the composite inert anode are decreased by 185 mV and 166 mV,respectively,under 500 A/m2 and 1000 A/m2.
基金Project(201215135) supported by the Natural Science Foundation of Jilin Province,China
文摘The novel covalently modified glassy carbon electrode with poly(xylitol) was prepared using an electropolymerization technique for the simultaneous determination of uric acid(UA), xanthine(XA) and hypoxanthine(HX). This new electrode presents an excellent electrocatalytic activity towards the oxidation of UA, XA and HX by cyclic voltammetry(CV) method. The oxidation peaks of the three compounds were well defined and had enhanced the peak currents. The separation potentials of the oxidation peak potentials for UA-XA and XA-HX were 380 and 370 mV in CV, respectively. Using differential pulse voltammetry(DPV) method, the calibration curves in the ranges of 5-55, 1.3-75.3 and 4-59 μmol/L were obtained for HX, XA and UA, respectively. The lowest detection limits(S/N=3) were 4.5, 0.75 and 3.75 μmol/L for HX, XA and UA, respectively. The practical application of the modified electrode was demonstrated by the determination of UA, XA, HX in human urine samples.
文摘We demonstrated a monolithic, compact, diode-pumped gain-switched Nd:YVO4 laser at 1.064 μm wavelength with controllable repetition rate of 1 Hz to 25 kHz. Stable gain-switched pulse train with maximum repetition rate of 25 kHz and pulse width of 16 ns was obtained.
基金supported by the National Science Foundationof China ( grating No. 60577019 and No. 60137010)
文摘An Ytterbium-doped mode-locked fiber laser using the polarization sensitive isolator and polarization controllers (PC) is reported. In the normal dispersion, the fiber laser can oscillate at the multi-pulse states by adjusting the position of the PC. On the condition that the polarization state isn’t changed, the outputs of Ytterbium-doped mode-locked fiber laser change from single pulse to multi-pulse by increasing the pump power. The fiber laser can achieve different multi-pulse output by adjusting the PC1 and PC2 carefully.
基金Project of China Geological Survey (No. 200120170130)
文摘By field experiment in Sandaozhuang W-Mo mining area in Luanchuan of Henan Province, the authors analyzed the Experimental result of reverse circulation bit on the basis of different structures and obtained the following conclusion: the design parameter of reverse circulation bit, the number, diameter and angle of the spurt hole can influence on the reverse circulation effect. The bit with inner spurt hole is better obviously than that one without inner spurt hole in reverse circulation, one or two right and the best choice of inner spurt hole is that the diameter is Φ8, the angle is 30° dip up and the suitable number is two to three.
