Limited information has been available about the influence of loading density on the performances of Scophthalmus maximus, especially in recirculating aquaculture systems （RAS）. In this study, turbot （13.84±2....Limited information has been available about the influence of loading density on the performances of Scophthalmus maximus, especially in recirculating aquaculture systems （RAS）. In this study, turbot （13.84±2.74 g; average weigh±SD） were reared at four different initial densities （low 0.66, medium 1.26, sub-high 2.56, high 4.00 kg/m^2） for 10 weeks in RAS at 23±1℃ Final densities were 4.67, 7.25, 14.16, and 17.47 kg/m^2, respectively, which translate to 82, 108, 214, and 282 percent coverage of the tank bottom. Density had both negative and independent impacts on growth. The final mean weight, specific growth rate （SGR）, and voluntary feed intake significantly decreased and the coefficient of variation （CV） of final body weight increased with increase in stocking density. The medium and sub-high density groups did not differ significantly in SGR, mean weight, CV, food conversion rate （FCR）, feed intake, blood parameters, and digestive enzymes. The protease activities of the digestive tract at pH 7, 8.5, 9, and 10 were significantly higher for the highest density group, but tended to be lower （not significantly） at pH 4 and 8.5 for the lowest density group. The intensity of protease activity was inversely related to feed intake at the different densities. Catalase activity was higher （but not significantly） at the highest density, perhaps because high density started to induce an oxidative effect in turbot. In conclusion, turbot can be cultured in RAS at a density of less than 17.47 kg/m^2. With good water quality and no feed limitation, initial density between 1.26 and 2.56 kg/m^2 （final： 7.25 and 14.16 kg/m^2） would not negatively affect the turbot cultured in RAS. For culture at higher density, multi-level feeding devices are suggested to ease feeding competition.展开更多
Performance improvement of existing 200 litres capacity natural convection type domestic solar hot water system is attempted.A two-stage centrifugal pump driven by a vertical axis windmill having Savonius type rotor i...Performance improvement of existing 200 litres capacity natural convection type domestic solar hot water system is attempted.A two-stage centrifugal pump driven by a vertical axis windmill having Savonius type rotor is added to the fluid loop.The windmill driven pump circulates the water through the collector.The system with necessary instrumentation is tested over a day.Tests on Natural Circulation System(NCS)mode and Wind Assisted System(WAS)mode are carried out during January,April,July and October,2009.Test results of a clear day are reported.Daily average efficiency of 25-28% during NCS mode and 33-37% during WAS mode are obtained.With higher wind velocities,higher collector flow rates and hence higher efficiencies are obtained.In general,WAS mode provides improvements in efficiency when compared to NCS mode.展开更多
基金Supported by the National Natural Science Foundation of China(No.30972267)the Special Fund for Agro-scientific Research in the Public Interest Project(No.201003024)the Knowledge Innovation Program of Chinese Academy of Sciences(No.KZCX2-EW-Q212)
文摘Limited information has been available about the influence of loading density on the performances of Scophthalmus maximus, especially in recirculating aquaculture systems （RAS）. In this study, turbot （13.84±2.74 g; average weigh±SD） were reared at four different initial densities （low 0.66, medium 1.26, sub-high 2.56, high 4.00 kg/m^2） for 10 weeks in RAS at 23±1℃ Final densities were 4.67, 7.25, 14.16, and 17.47 kg/m^2, respectively, which translate to 82, 108, 214, and 282 percent coverage of the tank bottom. Density had both negative and independent impacts on growth. The final mean weight, specific growth rate （SGR）, and voluntary feed intake significantly decreased and the coefficient of variation （CV） of final body weight increased with increase in stocking density. The medium and sub-high density groups did not differ significantly in SGR, mean weight, CV, food conversion rate （FCR）, feed intake, blood parameters, and digestive enzymes. The protease activities of the digestive tract at pH 7, 8.5, 9, and 10 were significantly higher for the highest density group, but tended to be lower （not significantly） at pH 4 and 8.5 for the lowest density group. The intensity of protease activity was inversely related to feed intake at the different densities. Catalase activity was higher （but not significantly） at the highest density, perhaps because high density started to induce an oxidative effect in turbot. In conclusion, turbot can be cultured in RAS at a density of less than 17.47 kg/m^2. With good water quality and no feed limitation, initial density between 1.26 and 2.56 kg/m^2 （final： 7.25 and 14.16 kg/m^2） would not negatively affect the turbot cultured in RAS. For culture at higher density, multi-level feeding devices are suggested to ease feeding competition.
文摘Performance improvement of existing 200 litres capacity natural convection type domestic solar hot water system is attempted.A two-stage centrifugal pump driven by a vertical axis windmill having Savonius type rotor is added to the fluid loop.The windmill driven pump circulates the water through the collector.The system with necessary instrumentation is tested over a day.Tests on Natural Circulation System(NCS)mode and Wind Assisted System(WAS)mode are carried out during January,April,July and October,2009.Test results of a clear day are reported.Daily average efficiency of 25-28% during NCS mode and 33-37% during WAS mode are obtained.With higher wind velocities,higher collector flow rates and hence higher efficiencies are obtained.In general,WAS mode provides improvements in efficiency when compared to NCS mode.
