期刊文献+
共找到9篇文章
< 1 >
每页显示 20 50 100
压力蒸汽灭菌包装中心蒸汽饱和度的测量 被引量:1
1
作者 张金涛 邱萍 谢立 《中国消毒学杂志》 CAS 2009年第1期43-45,共3页
目的研究压力蒸汽灭菌包装中心蒸汽饱和度的测量方法。方法采用无线温度与压力记录器测量压力蒸汽灭菌包装中心的温度和舱室蒸汽压力,通过查表和计算得出灭菌包装中心的蒸汽饱和度。结果满装载测试条件下,在灭菌过程中,1号灭菌器有两次... 目的研究压力蒸汽灭菌包装中心蒸汽饱和度的测量方法。方法采用无线温度与压力记录器测量压力蒸汽灭菌包装中心的温度和舱室蒸汽压力,通过查表和计算得出灭菌包装中心的蒸汽饱和度。结果满装载测试条件下,在灭菌过程中,1号灭菌器有两次测试包装中心温度测量平均值明显小于灭菌舱室平均压力对应饱和蒸汽温度值,判定测试包装中心蒸汽未达到饱和程度。第一种挑战性满装载测试条件下,1号灭菌器在灭菌过程中,测试包中心温度平均值明显小于灭菌舱室压力平均值对应饱和蒸汽温度,测试包中心蒸汽亦未达到饱和程度。第二种最有挑战性满装载测试条件下,5号灭菌器中测试包装中心温度平均值,明显低于舱室压力平均值对应饱和蒸汽温度,判定包装中心蒸汽未饱和。结论本研究测量方法能够指示灭菌包装中心蒸汽的饱和度,挑战性满装载试验条件下会影响冷空气排除从而导致蒸汽不饱和。 展开更多
关键词 压力蒸汽灭菌器 蒸汽饱和度 蒸汽 测量
原文传递
稠油蒸汽泡沫共混体系的流变性能研究 被引量:1
2
作者 龙运前 朱维耀 +2 位作者 刘今子 李娟 武男 《西安石油大学学报(自然科学版)》 CAS 北大核心 2012年第3期54-58,3,共5页
为了进一步加强对稠油蒸汽泡沫驱油过程中流体力学性能的认识,在油藏压力7.60 MPa下,利用高温高压流变仪测得了不同条件下稠油蒸汽泡沫共混体系的流变曲线.实验结果表明:稠油蒸汽泡沫驱油体系均为假塑性流体,其流变方程能很好地关联幂... 为了进一步加强对稠油蒸汽泡沫驱油过程中流体力学性能的认识,在油藏压力7.60 MPa下,利用高温高压流变仪测得了不同条件下稠油蒸汽泡沫共混体系的流变曲线.实验结果表明:稠油蒸汽泡沫驱油体系均为假塑性流体,其流变方程能很好地关联幂律模型;随蒸汽相饱和度和泡沫剂浓度升高,体系表观黏度增大;随蒸汽干度和温度升高,体系表观黏度降低;在低剪切速率时,表观黏度和温度关系满足Arrhenius方程,随着剪切速率增大,表观黏度和温度关系逐渐偏离Arrhenius方程;黏流活化能的绝对值随剪切速率增大而降低,在低剪切速率时,表观黏度对于温度变化更敏感. 展开更多
关键词 稠油油藏 蒸汽泡沫驱 流变性能 表观黏度 蒸汽饱和度 蒸汽干度
下载PDF
脉冲中子测井在气/汽层检测中的准确性及影响因素研究
3
作者 胡平樱 何泽伟 马国政 《石油地质与工程》 CAS 2008年第6期117-120,共4页
脉冲中子测井(PN技术)在国内主要用于套管井剩余油饱和度监测及气层检测,在国外其应用已扩展成为蒸汽驱中蒸汽饱和度监测的常用方法。但在气/汽层检测时,井间应用效果不一,而用俘获截面∑来计算蒸汽饱和度,有时也会产生较大误差。通过... 脉冲中子测井(PN技术)在国内主要用于套管井剩余油饱和度监测及气层检测,在国外其应用已扩展成为蒸汽驱中蒸汽饱和度监测的常用方法。但在气/汽层检测时,井间应用效果不一,而用俘获截面∑来计算蒸汽饱和度,有时也会产生较大误差。通过研究国外在该技术上的应用实例,例证了该种误差的存在,并分析了误差原因,验证了主要误差原因在于输入参数的非确定性,蒸汽饱和度计算公式中假设条件的局限性以及中子在含气/汽藏中的不完全传输影响。因此,该技术用于气/汽层时,必须要运用裸眼测井信息及岩心分析资料进行校正;另外,该测井中的视孔隙度方法可作为俘获截面∑方法的有效补充。 展开更多
关键词 脉冲中子测井 气/汽层检测 蒸汽饱和度 俘获截面 室内模拟 视孔隙度
下载PDF
浅谈对夏季商品混凝土早期养护和减少混凝土裂缝的实用方法
4
作者 林锦祥 林鹏 《化工管理》 2013年第12期182-182,共1页
简述混凝土在实际施工过程中在终凝前减少裂缝的几种常用方法。
关键词 大流动性混凝土 蒸汽饱和度 喷淋养护 二次抹压
下载PDF
浅谈对夏季商品混凝土早期养护和减少混凝土裂缝的实用方法
5
作者 林锦祥 林鹏 《化工管理》 2013年第10期70-71,共2页
简述混凝土在实际施工过程中在终凝前减少裂缝的几种常用方法。
关键词 大流动性混凝土 蒸汽饱和度 喷淋养护 二次抹压
下载PDF
分析地热储地球物理监测资料的新技术
6
作者 当舍利行 何雪洲 《水文地质工程地质技术方法动态》 2003年第1期16-17,共2页
关键词 地热 地球物理勘探 压力 温度 蒸汽饱和度
下载PDF
Condensation of Water Vapor on Waterproof Breathable Fabrics
7
作者 周小红 王善元 袁观洛 《Journal of Donghua University(English Edition)》 EI CAS 2003年第2期18-21,共4页
Condensation occurs when the local vapor pressure rises above the saturation vapor pressure at the local temperature in theory. A new measuring apparatus were made to obtain temperature and relative humidity simultane... Condensation occurs when the local vapor pressure rises above the saturation vapor pressure at the local temperature in theory. A new measuring apparatus were made to obtain temperature and relative humidity simultaneously for the purpose of investigating the mechanism of condensation occurred on the fabrics. The experiment conducted at the standard condition of temperature of 20℃ and relative humidity of 65%. The result obtained from experiment showed that condensation could occur under the situation closed to saturation line as the temperature on fabric may be lower than dew point of water vapor in the measuring box depending on the experiment conducted at an ambient environment temperature of 20℃ The range of fabrics studied showed that PTFE laminated fabrics except nylon gingham PTFE laminated fabric facilitates the loss of water vapor and therefore prevent condensation. It is necessary to develop studies from a wide range of fabrics, especially breathable fabrics and under bad experiment condition in order to develop fabrics, which could eliminate condensation, or transport water vapor through the fabric while remaining waterproof. 展开更多
关键词 CONDENSATION waterproof breathable fabrics SATURATION
下载PDF
Investigations on the Heat Flux Rates in Superheated Water Jet Evaporators
8
作者 Sami Mutair Yasuvuki Ikegami 《Journal of Energy and Power Engineering》 2013年第1期26-31,共6页
When a liquid undergoes sudden reduction in the surrounding pressure below its saturation pressure, the liquid then enters in a metastable state. In order to regain equilibrium, part of the liquid evaporates quickly i... When a liquid undergoes sudden reduction in the surrounding pressure below its saturation pressure, the liquid then enters in a metastable state. In order to regain equilibrium, part of the liquid evaporates quickly in a phenomenon called "flash evaporation", and the excess sensible heat contained in the liquid is converted into latent heat of vaporization. Therefore, temperatures of both the liquid and the generated vapor decline to the saturation temperature for the reduced pressure. As the heat and mass transfer occur in direct contact between the liquid and its own vapors, the process involves a very high heat transfer rate which makes it suitable for exchanging heat between sources of relatively small temperature difference. Moreover, dispensability of the heat exchange surfaces in this process is a considerable advantage as these surfaces constitute major part of the total system expenses in addition to the associated maintenance problems, especially when dealing with corrosive fluids such like seawater in the thermal desalination processes and in the OTEC (ocean thermal energy conversion) systems. This paper reports on the heat flux variation profiles during the flash evaporation of superheated water jets at various flow conditions. Heat flax was found to grow with time attaining a peak value before it starts to decrease monotonically. 展开更多
关键词 DESALINATION heat flux OTEC superheated jet.
下载PDF
Experimental Investigation on Heat Transfer Coefficient during Upward Flow Condensation of R410A in Vertical Smooth Tubes 被引量:4
9
作者 YANG Yunxiao JIA Li 《Journal of Thermal Science》 SCIE EI CAS CSCD 2015年第2期155-163,共9页
This paper presents an experimental investigation on condensation of R410 A upward flow in vertical tubes with the same inner diameter of 8.02 mm and different lengths of 300 mm, 400 mm, 500 mm and 600 mm. Condensatio... This paper presents an experimental investigation on condensation of R410 A upward flow in vertical tubes with the same inner diameter of 8.02 mm and different lengths of 300 mm, 400 mm, 500 mm and 600 mm. Condensation experiments were performed at mass fluxes of 103-490 kg m-2s-1. The saturation temperatures of experimental condition were 31℃, 38℃and 48℃, alternatively. The average vapor quality in the test section is between 0.91 and 0.98. The effects of tube length, mass flux and condensation temperature on condensation were discussed. Four correlations used for the upward flow condensation were compared with the experimental data obtained from various experimental conditions. A modified correlation was proposed within a ±15% deviation range. 展开更多
关键词 CONDENSATION R410A Flow upward Heat transfer coefficient REFRIGERANT
原文传递
上一页 1 下一页 到第
使用帮助 返回顶部