A multi-effect distillation technology for seawater desalination driven by tidal energy and low grade energy is presented.In the system,tidal energy is utilized to supply power instead of coventional electric pumps du...A multi-effect distillation technology for seawater desalination driven by tidal energy and low grade energy is presented.In the system,tidal energy is utilized to supply power instead of coventional electric pumps during the operation,resulting in the decrease of dependence on steady electric power supply and a reduction in the running costs.According to the technological principle,a testing unit is designed and built.The effects of the feed seawater temperature and the heat source temperature on the unit performance are tested and analyzed.The experimental results show that the fresh water output is 27 kg/h when the heating water temperature is 65 ℃ and the absolute pressure is 25 kPa.The experimental and theoretical analysis results indicate that the appropriate heating water temperature is a key factor in ensuring the steady operation of the system.展开更多
A generalized steady-state model is being developed for an internal heat integrated distillation column (IHIDiC). A procedure incorporating the Newton-Raphson method is devised for solving the model equations. Separat...A generalized steady-state model is being developed for an internal heat integrated distillation column (IHIDiC). A procedure incorporating the Newton-Raphson method is devised for solving the model equations. Separation of an ethanol-water binary mixture is simulated and analyzed with the model. Two pinch points are found within the process, making the separation extremely difficult and expensive. Two sharp fronts in the temperature and the composition profiles are being observed. With the introduction of heat integration, satisfactory separation may be obtained in a limited number of stages with lower reflux ratios. Increasing the pressure difference between the rectifying and the stripping sections, however, would bring about a reduced relative volatility between the two components involved, creating adverse separation performances. It is obvious that optimization of the IHIDiC is of prime importance.展开更多
A real-time sensing of the molecular distillation process temperature by a FLUKE brand thermograph Ti50 IR FlexCam and thermography technique was realized. After completion of the molecular distillation, three propert...A real-time sensing of the molecular distillation process temperature by a FLUKE brand thermograph Ti50 IR FlexCam and thermography technique was realized. After completion of the molecular distillation, three properties of heat transport chain cuts and residues obtained in the process were estimated by Differential Scanning Calorimetry （DSC） （specific heat, enthalpy, thermal conductivity）. These properties are of great importance for improving oil characterization and for future modeling and simulation of the molecular distillation process. The results show that through the method of Differential Scanning Calorimetry, profiles have been obtained from the variation of specific heat, enthalpy and thermal condutivity as a function of temperature for samples of cuts from the distillation （ASTM D-2892） and fractions of distillate and residue from the process of molecular distillation.展开更多
The present status of energy consumption ofADU (Atmospheric Distillation Unit)/VDU (VacuumDistillation Unit) in China is discussed, the major problems, such as low end temperature of heat exchange,low heater efficienc...The present status of energy consumption ofADU (Atmospheric Distillation Unit)/VDU (VacuumDistillation Unit) in China is discussed, the major problems, such as low end temperature of heat exchange,low heater efficiency, high fuel consumption, and large consumption of water, electricity and steam areanalyzed, and measures for improvement are proposed.展开更多
This article describes the experimental results obtained by the solar distiller by specifying the radiative properties of materials, the analysis of various types of losses in the system and the establishment of the e...This article describes the experimental results obtained by the solar distiller by specifying the radiative properties of materials, the analysis of various types of losses in the system and the establishment of the energy assessment of the system being the main question to consider. The experiment was undertaken in Tlemcen-Algeria by working out a solar distiller in order to measure the various temperatures of the system. Salt was added to study the negotiable effect of the salinity of water on solar distillation and it is noted that the production of distilled water decreases with salinity. The distiller is forwarded to a constant global solar flow. Experimental results obtained in heat transfer of natural convection in the pure and simultaneous heat and mass transfer, proven that these phenomena are in the boundary layer. This enables people to admit that the existence of a stagnant zone inside of distiller is called the ＂buffer zones＂.展开更多
This study presents theoretical considerations and results of a portable shell and tube heat exchanger in a solar water distiller system. The device is composed of a glass heat exchanger, which served as a condenser f...This study presents theoretical considerations and results of a portable shell and tube heat exchanger in a solar water distiller system. The device is composed of a glass heat exchanger, which served as a condenser for vapor condensing which were produced in black paint solar absorber. It was also composed of a tank for water source and a tank for produced distilled water. Shell and tube was designed and simulated using an implicit numerical scheme. Simulation results showed that accumulated mass water greatly depended on the inlet vapor temperature and volume, heat exchanger material, coolant water temperature and volume. Thus, changing the material from stainless steel to glass in the same condition （vapor temperature, vapor volume, coolant temperature and coolant volume）. These inexpensive shell and tube heat exchangers permitted to produce 40 litre/day, distilled water from vapor with 378 K inlet temperature in atmosphere pressure. If inlet pressure increases, vapor temperature will decline and thereupon, heat exchanger＇s efficiency tangibility will increase.展开更多
基金The Key Basic Program of Science and Technology Commission of Shanghai Municipality(No.08110511700)the ShanghaiLeading Academic Discipline Program(No.S30503)
文摘A multi-effect distillation technology for seawater desalination driven by tidal energy and low grade energy is presented.In the system,tidal energy is utilized to supply power instead of coventional electric pumps during the operation,resulting in the decrease of dependence on steady electric power supply and a reduction in the running costs.According to the technological principle,a testing unit is designed and built.The effects of the feed seawater temperature and the heat source temperature on the unit performance are tested and analyzed.The experimental results show that the fresh water output is 27 kg/h when the heating water temperature is 65 ℃ and the absolute pressure is 25 kPa.The experimental and theoretical analysis results indicate that the appropriate heating water temperature is a key factor in ensuring the steady operation of the system.
文摘A generalized steady-state model is being developed for an internal heat integrated distillation column (IHIDiC). A procedure incorporating the Newton-Raphson method is devised for solving the model equations. Separation of an ethanol-water binary mixture is simulated and analyzed with the model. Two pinch points are found within the process, making the separation extremely difficult and expensive. Two sharp fronts in the temperature and the composition profiles are being observed. With the introduction of heat integration, satisfactory separation may be obtained in a limited number of stages with lower reflux ratios. Increasing the pressure difference between the rectifying and the stripping sections, however, would bring about a reduced relative volatility between the two components involved, creating adverse separation performances. It is obvious that optimization of the IHIDiC is of prime importance.
文摘A real-time sensing of the molecular distillation process temperature by a FLUKE brand thermograph Ti50 IR FlexCam and thermography technique was realized. After completion of the molecular distillation, three properties of heat transport chain cuts and residues obtained in the process were estimated by Differential Scanning Calorimetry （DSC） （specific heat, enthalpy, thermal conductivity）. These properties are of great importance for improving oil characterization and for future modeling and simulation of the molecular distillation process. The results show that through the method of Differential Scanning Calorimetry, profiles have been obtained from the variation of specific heat, enthalpy and thermal condutivity as a function of temperature for samples of cuts from the distillation （ASTM D-2892） and fractions of distillate and residue from the process of molecular distillation.
文摘The present status of energy consumption ofADU (Atmospheric Distillation Unit)/VDU (VacuumDistillation Unit) in China is discussed, the major problems, such as low end temperature of heat exchange,low heater efficiency, high fuel consumption, and large consumption of water, electricity and steam areanalyzed, and measures for improvement are proposed.
文摘This article describes the experimental results obtained by the solar distiller by specifying the radiative properties of materials, the analysis of various types of losses in the system and the establishment of the energy assessment of the system being the main question to consider. The experiment was undertaken in Tlemcen-Algeria by working out a solar distiller in order to measure the various temperatures of the system. Salt was added to study the negotiable effect of the salinity of water on solar distillation and it is noted that the production of distilled water decreases with salinity. The distiller is forwarded to a constant global solar flow. Experimental results obtained in heat transfer of natural convection in the pure and simultaneous heat and mass transfer, proven that these phenomena are in the boundary layer. This enables people to admit that the existence of a stagnant zone inside of distiller is called the ＂buffer zones＂.
文摘This study presents theoretical considerations and results of a portable shell and tube heat exchanger in a solar water distiller system. The device is composed of a glass heat exchanger, which served as a condenser for vapor condensing which were produced in black paint solar absorber. It was also composed of a tank for water source and a tank for produced distilled water. Shell and tube was designed and simulated using an implicit numerical scheme. Simulation results showed that accumulated mass water greatly depended on the inlet vapor temperature and volume, heat exchanger material, coolant water temperature and volume. Thus, changing the material from stainless steel to glass in the same condition （vapor temperature, vapor volume, coolant temperature and coolant volume）. These inexpensive shell and tube heat exchangers permitted to produce 40 litre/day, distilled water from vapor with 378 K inlet temperature in atmosphere pressure. If inlet pressure increases, vapor temperature will decline and thereupon, heat exchanger＇s efficiency tangibility will increase.
