Microbial cellulose （MC） membranes produced by Acetobacter xylinum NUST4.1,were used as flexible substrates for the fabrication of transparent indium tin oxide （ITO） electrodes.Transparent and conductive ITO thin ...Microbial cellulose （MC） membranes produced by Acetobacter xylinum NUST4.1,were used as flexible substrates for the fabrication of transparent indium tin oxide （ITO） electrodes.Transparent and conductive ITO thin films were deposited on MC membrane at room temperature using radio frequency （RF） magnetron sputtering.The optimum ITO deposition conditions were achieved by examining crystalline structure,surface morphology and op-toelectrical characteristics with X-ray diffraction （XRD）,scanning electron microscopy （SEM）,atomic force mi-croscopy （AFM）,and UV spectroscopy.The sheet resistance of the samples was measured with a four-point probe and the resistivity of the film was calculated.The results reveal that the preferred orientation of the deposited ITO crystals is strongly dependent upon with oxygen content （O2/Ar,volume ratio） in the sputtering chamber.And the ITO crystalline structure directly determines the conductivity of ITO-deposited films.High conductive [sheet resis-tance ～120 Ω·square-1 （Ω·sq-1）] and transparent （above 76%） ITO thin films （240 nm thick） were obtained with a moderate sputtering power （about 60 W） and with an oxygen flow rate of 0.25 ml·min-1 （sccm） during the deposi-tion.These results show that the ITO-MC electrodes can find their potential application in optoelectrical devices.展开更多
基金Supported by the National Natural Science Foundation of China （10776014） Nanjing University of Science and Technology （NUST） Research Funding
文摘Microbial cellulose （MC） membranes produced by Acetobacter xylinum NUST4.1,were used as flexible substrates for the fabrication of transparent indium tin oxide （ITO） electrodes.Transparent and conductive ITO thin films were deposited on MC membrane at room temperature using radio frequency （RF） magnetron sputtering.The optimum ITO deposition conditions were achieved by examining crystalline structure,surface morphology and op-toelectrical characteristics with X-ray diffraction （XRD）,scanning electron microscopy （SEM）,atomic force mi-croscopy （AFM）,and UV spectroscopy.The sheet resistance of the samples was measured with a four-point probe and the resistivity of the film was calculated.The results reveal that the preferred orientation of the deposited ITO crystals is strongly dependent upon with oxygen content （O2/Ar,volume ratio） in the sputtering chamber.And the ITO crystalline structure directly determines the conductivity of ITO-deposited films.High conductive [sheet resis-tance ～120 Ω·square-1 （Ω·sq-1）] and transparent （above 76%） ITO thin films （240 nm thick） were obtained with a moderate sputtering power （about 60 W） and with an oxygen flow rate of 0.25 ml·min-1 （sccm） during the deposi-tion.These results show that the ITO-MC electrodes can find their potential application in optoelectrical devices.
