The high-temperature oxidation behaviour of the Inconel 625 alloy at 950℃ was investigated after different ageing treatments.The effect of heat treatment on the oxidation behaviour of the alloy was analysed by charac...The high-temperature oxidation behaviour of the Inconel 625 alloy at 950℃ was investigated after different ageing treatments.The effect of heat treatment on the oxidation behaviour of the alloy was analysed by characterizing the structure and elemental distribution before and after oxidation.The results reveal that the two ageing treatments at 650℃ for 500 h and at 750℃ for 400 h both reduced the oxidation mass gain.After oxidation at 950℃,an outer Cr_(2)O_(3) layer and inner Al_(2)O_(3) are identified as the main oxidation products.Moreover,Nb_(2)O_(5) andδ(Ni_(3)Nb)phases precipitated after oxidation.The ageing treatments cause the rapid generation of a dense Cr_(2)O_(3) layer on the surface,which prevents the diffusion of oxygen into the matrix,reduce the Al_(2)O_(3) inward growth depth,and improve the oxidation resistance of the alloy.展开更多
The recent introduction of direct-acting antiviral drugs(DAAs) for treatment of the hepatitis C virus(HCV) has greatly improved the management of HCV for infected patients. These viral protein inhibitors act rapidly, ...The recent introduction of direct-acting antiviral drugs(DAAs) for treatment of the hepatitis C virus(HCV) has greatly improved the management of HCV for infected patients. These viral protein inhibitors act rapidly, allowing HCV clearance and increasing the sustained virological response rates. However, hepatitis B virus(HBV) reactivation has been reported in HCV/HBV co-infected patients. Hepatitis B reactivation refers to an abrupt increase in the HBV and is welldocumented in patients with previously undetected HBV DNA due to inactive or resolved HBV infection. Reactivation can occur spontaneously, but in most cases, it is triggered by various factors. Reactivation can be transient, without clinical symptoms; however, it usually causes a hepatitis flare. HBV reactivation may occur regardless of HCV genotype and type of DAA regimen. HBV screening is strongly recommended for co-infected HCV/HBV patients before initiation and during DAA therapy regardless of HBV status, HCV genotype and class of DAAs used. HBV reactivation can be prevented with pretreatment screening and prophylactic treatment when necessary. Additional data are required to evaluate the underlying mechanisms of HBV reactivation in this setting.展开更多
A DMVOCC-MVDA （distributed multiversion optimistic concurrency control with multiversion dynamic adjustment） protocol was presented to process mobile distributed real-time transaction in mobile broadcast environment...A DMVOCC-MVDA （distributed multiversion optimistic concurrency control with multiversion dynamic adjustment） protocol was presented to process mobile distributed real-time transaction in mobile broadcast environments. At the mobile hosts, all transactions perform local pre-validation. The local pre-validation process is carried out against the committed transactions at the server in the last broadcast cycle. Transactions that survive in local pre-validation must be submitted to the server for local final validation. The new protocol eliminates conflicts between mobile read-only and mobile update transactions, and resolves data conflicts flexibly by using multiversion dynamic adjustment of serialization order to avoid unnecessary restarts of transactions. Mobile read-only transactions can be committed with no-blocking, and respond time of mobile read-only transactions is greatly shortened. The tolerance of mobile transactions of disconnections from the broadcast channel is increased. In global validation mobile distributed transactions have to do check to ensure distributed serializability in all participants. The simulation results show that the new concurrency control protocol proposed offers better performance than other protocols in terms of miss rate, restart rate, commit rate. Under high work load （think time is ls） the miss rate of DMVOCC-MVDA is only 14.6%, is significantly lower than that of other protocols. The restart rate of DMVOCC-MVDA is only 32.3%, showing that DMVOCC-MVDA can effectively reduce the restart rate of mobile transactions. And the commit rate of DMVOCC-MVDA is up to 61.2%, which is obviously higher than that of other protocols.展开更多
The effect of T6I6 treatment on the dynamic mechanical and microstructure behaviour of Al-Si-Mg-Cu cast alloy was investigated using split Hopkinson pressure bar(SHPB), transmission electron microscopy(TEM), and highr...The effect of T6I6 treatment on the dynamic mechanical and microstructure behaviour of Al-Si-Mg-Cu cast alloy was investigated using split Hopkinson pressure bar(SHPB), transmission electron microscopy(TEM), and highresolution transmission electron microscopy(HRTEM). Besides, the impact resistances of T6I6 and T6 motor shells of new energy vehicles made of Al-Si-Mg-Cu cast alloy were compared using a trolley crash test. The results indicated that the main strengthening-phases of the T6 peak-aged and T6I6 peak-aged alloy were GP zone and β″ precipitates. T6I6treatment can increase the density and size of β″ precipitates in peak-aged alloy and enhance both its tensile strength(σb)and elongation(δ). The dynamic toughness values of T6I6 samples are 50.34 MJ/m^(3) at 2000 s^(-1) and 177.34 MJ/m^(3) at 5000 s^(-1) which are 20% and 12% higher than those of T6 samples, respectively. Compared with a T6 shell, the overall deformation of T6I6 shell is more uniform during the crash test. At an impact momentum of 3.5×10;kg·m/s, the T6I6shell breaks down at 0.38 s which is 0.10 s later than the T6 shell.展开更多
The solution of linear equation group can be applied to the oil exploration, the structure vibration analysis, the computational fluid dynamics, and other fields. When we make the in-depth analysis of some large or ve...The solution of linear equation group can be applied to the oil exploration, the structure vibration analysis, the computational fluid dynamics, and other fields. When we make the in-depth analysis of some large or very large complicated structures, we must use the parallel algorithm with the aid of high-performance computers to solve complex problems. This paper introduces the implementation process having the parallel with sparse linear equations from the perspective of sparse linear equation group.展开更多
Micro-rockets for propulsion of small spacecrafts exhibit significant differences with regard to their macroscale counterparts,mainly caused by the role of the viscous dissipation and heat transfer processes in the mi...Micro-rockets for propulsion of small spacecrafts exhibit significant differences with regard to their macroscale counterparts,mainly caused by the role of the viscous dissipation and heat transfer processes in the micron-sized scale.The goal of this work is to simulate the transient operation of a micro-rocket to investigate the effects of viscous heating on the flow and performance for four configurations of the expanding gas and wafer material.The modelling follows a multiphysics approach that solves the fluid and solid regions fully coupled.A contin- uum-based description that incorporates the effects of gas rarefaction through the micro-nozzle,viscous dissipa- tion and heat transfer at the solid-gas interface is presented.Non-equilibrium is addressed with the implementa- tion of a 2nd-order slip-model for the velocity and temperature at the walls.The results stress that solid-fluid cou- pling exerts a strong influence on the flowfield and performance as well as the effect of the wafer during the first instants of the transient in micro-rockets made of low and high thermal conductivity materials.展开更多
基金financially supported by the National Science and Technology Major Project of China (Nos.MJ-2018-G-48,J2019-Ⅵ-0023-0140)the Research Fund of the State Key Laboratory of Solidification Processing (NPU),China (No.2022-TS-04)。
文摘The high-temperature oxidation behaviour of the Inconel 625 alloy at 950℃ was investigated after different ageing treatments.The effect of heat treatment on the oxidation behaviour of the alloy was analysed by characterizing the structure and elemental distribution before and after oxidation.The results reveal that the two ageing treatments at 650℃ for 500 h and at 750℃ for 400 h both reduced the oxidation mass gain.After oxidation at 950℃,an outer Cr_(2)O_(3) layer and inner Al_(2)O_(3) are identified as the main oxidation products.Moreover,Nb_(2)O_(5) andδ(Ni_(3)Nb)phases precipitated after oxidation.The ageing treatments cause the rapid generation of a dense Cr_(2)O_(3) layer on the surface,which prevents the diffusion of oxygen into the matrix,reduce the Al_(2)O_(3) inward growth depth,and improve the oxidation resistance of the alloy.
文摘The recent introduction of direct-acting antiviral drugs(DAAs) for treatment of the hepatitis C virus(HCV) has greatly improved the management of HCV for infected patients. These viral protein inhibitors act rapidly, allowing HCV clearance and increasing the sustained virological response rates. However, hepatitis B virus(HBV) reactivation has been reported in HCV/HBV co-infected patients. Hepatitis B reactivation refers to an abrupt increase in the HBV and is welldocumented in patients with previously undetected HBV DNA due to inactive or resolved HBV infection. Reactivation can occur spontaneously, but in most cases, it is triggered by various factors. Reactivation can be transient, without clinical symptoms; however, it usually causes a hepatitis flare. HBV reactivation may occur regardless of HCV genotype and type of DAA regimen. HBV screening is strongly recommended for co-infected HCV/HBV patients before initiation and during DAA therapy regardless of HBV status, HCV genotype and class of DAAs used. HBV reactivation can be prevented with pretreatment screening and prophylactic treatment when necessary. Additional data are required to evaluate the underlying mechanisms of HBV reactivation in this setting.
基金Project(20030533011)supported by the National Research Foundation for the Doctoral Program of Higher Education of China
文摘A DMVOCC-MVDA （distributed multiversion optimistic concurrency control with multiversion dynamic adjustment） protocol was presented to process mobile distributed real-time transaction in mobile broadcast environments. At the mobile hosts, all transactions perform local pre-validation. The local pre-validation process is carried out against the committed transactions at the server in the last broadcast cycle. Transactions that survive in local pre-validation must be submitted to the server for local final validation. The new protocol eliminates conflicts between mobile read-only and mobile update transactions, and resolves data conflicts flexibly by using multiversion dynamic adjustment of serialization order to avoid unnecessary restarts of transactions. Mobile read-only transactions can be committed with no-blocking, and respond time of mobile read-only transactions is greatly shortened. The tolerance of mobile transactions of disconnections from the broadcast channel is increased. In global validation mobile distributed transactions have to do check to ensure distributed serializability in all participants. The simulation results show that the new concurrency control protocol proposed offers better performance than other protocols in terms of miss rate, restart rate, commit rate. Under high work load （think time is ls） the miss rate of DMVOCC-MVDA is only 14.6%, is significantly lower than that of other protocols. The restart rate of DMVOCC-MVDA is only 32.3%, showing that DMVOCC-MVDA can effectively reduce the restart rate of mobile transactions. And the commit rate of DMVOCC-MVDA is up to 61.2%, which is obviously higher than that of other protocols.
基金Projects(52075166, 51875197) supported by the National Natural Science Foundation of ChinaProjects(2019RS2064,2019GK5043) supported by the Science and Technology Planning Project of Hunan Province,China。
文摘The effect of T6I6 treatment on the dynamic mechanical and microstructure behaviour of Al-Si-Mg-Cu cast alloy was investigated using split Hopkinson pressure bar(SHPB), transmission electron microscopy(TEM), and highresolution transmission electron microscopy(HRTEM). Besides, the impact resistances of T6I6 and T6 motor shells of new energy vehicles made of Al-Si-Mg-Cu cast alloy were compared using a trolley crash test. The results indicated that the main strengthening-phases of the T6 peak-aged and T6I6 peak-aged alloy were GP zone and β″ precipitates. T6I6treatment can increase the density and size of β″ precipitates in peak-aged alloy and enhance both its tensile strength(σb)and elongation(δ). The dynamic toughness values of T6I6 samples are 50.34 MJ/m^(3) at 2000 s^(-1) and 177.34 MJ/m^(3) at 5000 s^(-1) which are 20% and 12% higher than those of T6 samples, respectively. Compared with a T6 shell, the overall deformation of T6I6 shell is more uniform during the crash test. At an impact momentum of 3.5×10;kg·m/s, the T6I6shell breaks down at 0.38 s which is 0.10 s later than the T6 shell.
文摘The solution of linear equation group can be applied to the oil exploration, the structure vibration analysis, the computational fluid dynamics, and other fields. When we make the in-depth analysis of some large or very large complicated structures, we must use the parallel algorithm with the aid of high-performance computers to solve complex problems. This paper introduces the implementation process having the parallel with sparse linear equations from the perspective of sparse linear equation group.
基金as part of the micropropulsion activities in the Small Satellites Programme,funded by the Spanish Ministry of Defence
文摘Micro-rockets for propulsion of small spacecrafts exhibit significant differences with regard to their macroscale counterparts,mainly caused by the role of the viscous dissipation and heat transfer processes in the micron-sized scale.The goal of this work is to simulate the transient operation of a micro-rocket to investigate the effects of viscous heating on the flow and performance for four configurations of the expanding gas and wafer material.The modelling follows a multiphysics approach that solves the fluid and solid regions fully coupled.A contin- uum-based description that incorporates the effects of gas rarefaction through the micro-nozzle,viscous dissipa- tion and heat transfer at the solid-gas interface is presented.Non-equilibrium is addressed with the implementa- tion of a 2nd-order slip-model for the velocity and temperature at the walls.The results stress that solid-fluid cou- pling exerts a strong influence on the flowfield and performance as well as the effect of the wafer during the first instants of the transient in micro-rockets made of low and high thermal conductivity materials.
