期刊文献+
共找到6篇文章
< 1 >
每页显示 20 50 100
细菌作用下斑铜矿表面物理化学性质变化 被引量:1
1
作者 赵红波 王军 +3 位作者 邱建强 杨勰 覃文庆 邱冠周 《中南大学学报(自然科学版)》 EI CAS CSCD 北大核心 2015年第1期1-5,共5页
采用相同培养基培养的嗜热硫氧化硫杆菌(Sulfobacillus thermosulfidooxidans,S.t菌)和氧化亚铁钩端螺旋菌(Leptospirillum ferrooxidans,L.f菌)浸出斑铜矿,通过接触角和Zeta电位测定,分析其吸附之后斑铜矿表面物理化学性质的变化,主要... 采用相同培养基培养的嗜热硫氧化硫杆菌(Sulfobacillus thermosulfidooxidans,S.t菌)和氧化亚铁钩端螺旋菌(Leptospirillum ferrooxidans,L.f菌)浸出斑铜矿,通过接触角和Zeta电位测定,分析其吸附之后斑铜矿表面物理化学性质的变化,主要包括表面润湿性和表面电性的变化,并对比分析2种细菌对斑铜矿表面物理化学性质改变的异同。研究结果表明:单独9K培养基对于斑铜矿表面润湿性无明显影响,在2种细菌作用下,由于在浸出过程中斑铜矿表面亲水铜硫化合物和硫酸盐的产生导致斑铜矿表面接触角持续减小;斑铜矿和细菌的Zeta电位随溶液p H的升高而逐渐下降,斑铜矿Zeta电位和等电点分别朝细菌的Zeta电位和等电点方向偏移,表面细菌在斑铜矿表面发生了特性吸附;混合菌作用下斑铜矿Zeta电位和等电点正好介于2种细菌的动电位和等电点之间,说明2种细菌均能同时有效吸附于斑铜矿表面。 展开更多
关键词 细菌 斑铜矿 表面物理化学性质 ZETA电位 接触角
下载PDF
高碳链正负离子表面活性剂复配溶液的表面物理化学性质研究 被引量:3
2
作者 贺贤国 张新蓉 《浙江化工》 CAS 2001年第3期23-26,共4页
研究了负离子表面活性剂C12SNa同正离子表面活性剂(C18H37)2N(CH3)3Cl、C16H33N(CH3)3Cl复配溶液的表面物理化学性质,结果表明复配液具有比单一表面活性剂更高的表面活性,且无论正负离子表面活性剂复配比例如何,表面的吸附量与1∶1复配... 研究了负离子表面活性剂C12SNa同正离子表面活性剂(C18H37)2N(CH3)3Cl、C16H33N(CH3)3Cl复配溶液的表面物理化学性质,结果表明复配液具有比单一表面活性剂更高的表面活性,且无论正负离子表面活性剂复配比例如何,表面的吸附量与1∶1复配液吸咐量相似,即吸附量R+同R-比例为1∶1左右。 展开更多
关键词 阳离子表面活性剂 表面张力 吸附 复配溶液 表面物理化学性质 阴离子表面活性剂
下载PDF
活性炭吸附苯系物性能的研究进展 被引量:1
3
作者 张超锋 李荣 +1 位作者 石先进 黄宇 《地球环境学报》 CSCD 2024年第1期44-58,共15页
人类活动排放的挥发性有机物(VOCs),尤其是苯系物(BTEX),不仅影响空气质量,还会对人体健康产生不同程度的危害。室内苯系物具有浓度低、释放周期长及来源复杂等特点。由于活性炭(AC)优异的孔道结构和易调控的表面化学性质,采用活性炭吸... 人类活动排放的挥发性有机物(VOCs),尤其是苯系物(BTEX),不仅影响空气质量,还会对人体健康产生不同程度的危害。室内苯系物具有浓度低、释放周期长及来源复杂等特点。由于活性炭(AC)优异的孔道结构和易调控的表面化学性质,采用活性炭吸附苯系物是封闭/半封闭空间空气污染控制的最有效策略之一。本文综述了封闭/半封闭空间苯系物的理化特征、活性炭的物理化学性质及其吸附苯系物的影响因素。这些因素主要包括活性炭物理结构、表面化学性质、苯系物分子结构和吸附条件。此外,还进一步探讨了活性炭再生技术,并展望了针对封闭/半封闭空间苯系物污染的活性炭吸附技术的改进策略。 展开更多
关键词 活性炭 吸附 苯系物 表面物理化学性质 再生技术
下载PDF
Effects of surface physicochemical properties on NH_3-SCR activity of MnO_2 catalysts with different crystal structures 被引量:14
4
作者 PiJun Gong JunLin Xie +4 位作者 De Fang Da Han Feng He FengXiang Li Kai Qi 《Chinese Journal of Catalysis》 CSCD 北大核心 2017年第11期1925-1934,共10页
α‐,β‐,δ‐,andγ‐MnO2nanocrystals are successfully prepared.We then evaluated the NH3selective catalytic reduction(SCR)performance of the MnO2catalysts with different phases.The NOx conversion efficiency decrease... α‐,β‐,δ‐,andγ‐MnO2nanocrystals are successfully prepared.We then evaluated the NH3selective catalytic reduction(SCR)performance of the MnO2catalysts with different phases.The NOx conversion efficiency decreased in the order:γ‐MnO2>α‐MnO2>δ‐MnO2>β‐MnO2.The NOx conversion with the use ofγ‐MnO2andα‐MnO2catalysts reached90%in the temperature range of140–200°C,while that based onβ‐MnO2reached only40%at200°C.Theγ‐MnO2andα‐MnO2nanowire crystal morphologies enabled good dispersion of the catalysts and resulted in a relatively high specific surface area.We found thatγ‐MnO2andα‐MnO2possessed stronger reducing abilities and more and stronger acidic sites than the other catalysts.In addition,more chemisorbed oxygen existed on the surface of theγ‐MnO2andα‐MnO2catalysts.Theγ‐MnO2andα‐MnO2catalysts showed excellent performance in the low‐temperature SCR of NO to N2with NH3. 展开更多
关键词 MNO2 Crystal structure Surface‐active oxygen Selective catalytic reduction Physicochemical property
下载PDF
Realization approach of Pd-only three-way catalysts with high catalytic performance and thermal stability 被引量:1
5
作者 Yutao Ren Qun Shen +4 位作者 Yun Guo Yanqin Wang Yanglong Guo Xueqing Gong Guanzhong Lu 《Science China Chemistry》 SCIE EI CAS CSCD 2015年第1期123-130,共8页
Pd-only three-way catalyst (TWC), Pd supported on washcoating (the mixture of alumina and Ce-Zr solid solution)/cordierite, was prepared and its catalytic performance and the operation window (2-value) at 450 ℃... Pd-only three-way catalyst (TWC), Pd supported on washcoating (the mixture of alumina and Ce-Zr solid solution)/cordierite, was prepared and its catalytic performance and the operation window (2-value) at 450 ℃ were evaluated with the simulated automotive exhaust feed gas. Surfactants such as Tween-80 and Span-20 were added in the process of preparing the catalyst in order to improve the thermal stability and catalytic performance of Pd-only TWC. The fresh and aged catalysts at 1000 ℃ for 4 h were characterized by low-temperature N2 adsorption, XRD, XPS, and H2-TPR techniques. The results show that the presence of surfactants in the synthesis slurry could influence the physicochemical properties of the final Pd-only TWC. The FTS catalyst prepared with the mixed surfactant of Tween-80 and Span-20 exhibited excellent three-way catalytic performance. After being aged at 1000℃ for 4 h, the catalytic performances of Pd-only TWCs slightly decreased, but the FTS catalyst still demonstrated higher catalytic performance and better thermal stability compared with the Pd-only catalysts prepared with single surfactant or without any surfactant. And the FTS catalyst has a wider 2 value (operation window) than other catalysts, even after being aged at 1000℃. 展开更多
关键词 three-way catalyst Pd-only catalyst catalyst preparation mixed surfactants high thermal stability
原文传递
Growth of 2D MoP single crystals on liquid metals by chemical vapor deposition
6
作者 Feifei Cao Shuting Zheng +7 位作者 Jingjing Liang Zhi Li Bin Wei Yiran Ding Zhongchang Wang Mengqi Zeng Nan Xu Lei Fu 《Science China Materials》 SCIE EI CAS CSCD 2021年第5期1182-1188,共7页
Two-dimensional(2 D) transition metal phosphides(TMPs) are predicted with many novel properties and various applications. As a member of TMPs family, molybdenum phosphide(MoP) exhibits many exotic physicochemical prop... Two-dimensional(2 D) transition metal phosphides(TMPs) are predicted with many novel properties and various applications. As a member of TMPs family, molybdenum phosphide(MoP) exhibits many exotic physicochemical properties. However, the synthesis of high-quality2 D MoP single crystals is not reported due to the lack of reliable fabrication method, which limits the exploration of 2 D MoP. Here, we report the growth of high-quality ultrathin MoP single crystals with thickness down to 10 nm on liquid metals via chemical vapor deposition(CVD). The smooth surface of liquid Ga is regarded as a suitable growth substrate for producing 2 D MoP single crystals. The Mo source diffuses toward the Ga surface due to the high surface energy to react with phosphorus source, thus to fabricate ultrathin MoP single crystals. Then, we study the second harmonic generation(SHG) of 2 D MoP for the first time due to its intrinsic noncentrosymmetric structure. Our study provides an new approach to synthesize and explore other 2 D TMPs for future applications. 展开更多
关键词 2D materials transition metal phosphides molybdenum phosphides liquid metals chemical vapor deposition
原文传递
上一页 1 下一页 到第
使用帮助 返回顶部